Athena E. Metaxas
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Athena E. Metaxas has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Cari S. Dutcher
University of Minnesota
9 shared publications - Nikolas Wilkinson
Department of Chemical Engineering and Materials Science, University of Minnesota – Twin Cities, Minneapolis, USA
3 shared publications Susith Wickramaratne
Univ Minnesota Twin Cities, Dept Chem, 207 Pleasant St SE, Minneapolis, MN 55455 USA
3 shared publicationsTheresa M. Reineke
Univ Minnesota Twin Cities, Dept Chem, 207 Pleasant St SE, Minneapolis, MN 55455 USA
3 shared publications- Frank S. Bates
Department of Chemical Engineering and Materials Science, University of Minnesota
2 shared publications Jiannan Dong
McKetta Chemical Engineering Department, University of Texas, Austin, Texas 78712-1589, United States
2 shared publications
Latest Publications
- 1 December 2020
- Published by Elsevier in Current Opinion in Colloid & Interface Science
- Vol. 50, 101385
Zooming in on the role of surfactants in droplet coalescence at the macroscale and microscale
- 1 December 2020
- Published by Elsevier in Current Opinion in Colloid & Interface Science
- Vol. 50, 101385
Zooming in on the role of surfactants in droplet coalescence at the macroscale and microscale
- 18 November 2020
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 17 (5) , 1246-1257
Ionic strength and polyelectrolyte molecular weight effects on floc formation and growth in Taylor–Couette flows
A Taylor–Couette cell capable of radial injection was used to study the effects of varying solution ionic strength and polyelectrolyte molecular weight on the polyelectrolyte-driven flocculation of bentonite suspensions.
- 18 November 2020
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 17 (5) , 1246-1257
Ionic strength and polyelectrolyte molecular weight effects on floc formation and growth in Taylor–Couette flows
A Taylor–Couette cell capable of radial injection was used to study the effects of varying solution ionic strength and polyelectrolyte molecular weight on the polyelectrolyte-driven flocculation of bentonite suspensions.
- 6 November 2020
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 5 (11) , 113302
Microfluidic filament thinning of aqueous, fibrillar methylcellulose solutions
Methylcellulose (MC), a methoxy-substituted cellulose ether, is widely used as a rheology modifier, binder, and water-retention agent in a variety of food, pharmaceutical, construction, and consumer applications. While soluble in water at low temperatures, MC reversibly transitions to a turbid hydrogel upon heating or upon the addition of NaCl, due to the formation of a fibrillar network. These complex MC solutions and gels experience a range of flow conditions in industrial processes, including shear and extensional flows. While the shear rheological behavior has been well characterized for many MC solutions, the extensional rheological behavior is often more challenging to characterize, particularly for solutions with lower molecular weights, relaxation times, and viscosities. Filament stretching using a flow-focusing microfluidic device is a promising method to resolve extensional properties of lower molecular weight and lower viscosity polymeric solutions, and it is used here to characterize MC solutions at varying NaCl concentrations. The flow-driven apparent extensional viscosity can be calculated from transient filament diameter thinning behavior of 1 wt% MC with a molecular weight of 150 kg/mol. The apparent extensional viscosity increased as the concentration of NaCl increased, from 0.947 ± 0.005 Pa s to 15.1 ± 0.6 Pa s between 0 and 8 wt% NaCl, respectively. The increase in apparent extensional viscosity is attributed to the presence of fibrils in the MC solutions containing NaCl annealed at room temperature, as demonstrated with cryogenic transmission electron microscopy. The study of the extensional behavior of this commercially relevant polymer should enable new ways to process MC, such as fiber spinning and extrusion.
- 6 November 2020
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 5 (11) , 113302
Microfluidic filament thinning of aqueous, fibrillar methylcellulose solutions
Methylcellulose (MC), a methoxy-substituted cellulose ether, is widely used as a rheology modifier, binder, and water-retention agent in a variety of food, pharmaceutical, construction, and consumer applications. While soluble in water at low temperatures, MC reversibly transitions to a turbid hydrogel upon heating or upon the addition of NaCl, due to the formation of a fibrillar network. These complex MC solutions and gels experience a range of flow conditions in industrial processes, including shear and extensional flows. While the shear rheological behavior has been well characterized for many MC solutions, the extensional rheological behavior is often more challenging to characterize, particularly for solutions with lower molecular weights, relaxation times, and viscosities. Filament stretching using a flow-focusing microfluidic device is a promising method to resolve extensional properties of lower molecular weight and lower viscosity polymeric solutions, and it is used here to characterize MC solutions at varying NaCl concentrations. The flow-driven apparent extensional viscosity can be calculated from transient filament diameter thinning behavior of 1 wt% MC with a molecular weight of 150 kg/mol. The apparent extensional viscosity increased as the concentration of NaCl increased, from 0.947 ± 0.005 Pa s to 15.1 ± 0.6 Pa s between 0 and 8 wt% NaCl, respectively. The increase in apparent extensional viscosity is attributed to the presence of fibrils in the MC solutions containing NaCl annealed at room temperature, as demonstrated with cryogenic transmission electron microscopy. The study of the extensional behavior of this commercially relevant polymer should enable new ways to process MC, such as fiber spinning and extrusion.
- 12 May 2020
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 16 (22) , 5273-5281
Microfluidic rheology of methylcellulose solutions in hyperbolic contractions and the effect of salt in shear and extensional flows
Methylcellulose solutions are known to form microfibrils at elevated temperatures or in the presence of salt. The fibrils have a significant impact on the solution's rheological properties. Here, the shear and extensional properties of methylcellulose solutions with added salt are measured using hyperbolic microfluidic channels, allowing for new characterization at lower molecular weights and higher shear and strain rates that are difficult to access by macroscale rheology studies. 1 and 2 wt% methylcellulose solutions with molecular weight of 150 kg mol−1 with NaCl content between 0 to 5 wt% have been characterized. All solutions were found to be shear thinning, with power law thinning behavior at shear rates above 100 s−1. The addition of NaCl up to 5 wt% had only small effects on shear viscosity at the shear rates probed (100 s−1 and 10 000 s−1). Extensional viscosities as low as 0.02 Pa s were also measured. Unlike the results for shear viscosity, the addition of 5 wt% NaCl caused significant changes in extensional viscosity, increasing by up to 10 times, depending on extension rate. Additionally, all solutions tested showed apparent extensional thinning in the high strain rate regime (>100 s−1), which has not been reported in other studies of methylcellulose solutions. These findings may provide insight for those using methylcellulose solutions in process designs involving extensional flows over a wide range of strain rates.
- 12 May 2020
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 16 (22) , 5273-5281
Microfluidic rheology of methylcellulose solutions in hyperbolic contractions and the effect of salt in shear and extensional flows
Methylcellulose solutions are known to form microfibrils at elevated temperatures or in the presence of salt. The fibrils have a significant impact on the solution's rheological properties. Here, the shear and extensional properties of methylcellulose solutions with added salt are measured using hyperbolic microfluidic channels, allowing for new characterization at lower molecular weights and higher shear and strain rates that are difficult to access by macroscale rheology studies. 1 and 2 wt% methylcellulose solutions with molecular weight of 150 kg mol−1 with NaCl content between 0 to 5 wt% have been characterized. All solutions were found to be shear thinning, with power law thinning behavior at shear rates above 100 s−1. The addition of NaCl up to 5 wt% had only small effects on shear viscosity at the shear rates probed (100 s−1 and 10 000 s−1). Extensional viscosities as low as 0.02 Pa s were also measured. Unlike the results for shear viscosity, the addition of 5 wt% NaCl caused significant changes in extensional viscosity, increasing by up to 10 times, depending on extension rate. Additionally, all solutions tested showed apparent extensional thinning in the high strain rate regime (>100 s−1), which has not been reported in other studies of methylcellulose solutions. These findings may provide insight for those using methylcellulose solutions in process designs involving extensional flows over a wide range of strain rates.
- 8 October 2018
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 14 (42) , 8627-8635
In situ polymer flocculation and growth in Taylor–Couette flows
Transient, in situ polymer-particle flocculation and growth was studied as a function of hydrodynamic flow state using a modified Taylor–Couette cell.
- 8 October 2018
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 14 (42) , 8627-8635
In situ polymer flocculation and growth in Taylor–Couette flows
Transient, in situ polymer-particle flocculation and growth was studied as a function of hydrodynamic flow state using a modified Taylor–Couette cell.
- 27 February 2018
- Published by American Chemical Society (ACS) in ACS Macro Letters
- Vol. 7 (3) , 347-352
Extensional Flow Behavior of Methylcellulose Solutions Containing Fibrils
The extensional properties of semidilute aqueous methylcellulose (MC) solutions have been characterized. Pure aqueous MC solutions are shear-thinning liquids at room temperature. With the addition of 8 wt % NaCl, a fraction of MC self-assembles into long fibrils, which modify the rheological properties of the original MC solution. Capillary Breakup Extensional Rheometry (CaBER) was used to characterize salt-free and 8 wt % NaCl solutions of MC at room temperature. The salt-free solutions exhibit only power-law behavior whereas solutions with NaCl exhibit both power-law and elastic regimes. As MC concentration increases, the extensional relaxation time also increases strongly, from 0.04 s at 0.5 wt % to 4 s at 1 wt %. In addition, the apparent extensional viscosity rapidly increases as a function of increasing MC concentration, from 40 Pa·s at 0.5 wt % to 1300 Pa·s at 1 wt %. This behavior is attributed to the presence of fibrils in the MC solutions containing NaCl.
- 27 February 2018
- Published by American Chemical Society (ACS) in ACS Macro Letters
- Vol. 7 (3) , 347-352
Extensional Flow Behavior of Methylcellulose Solutions Containing Fibrils
The extensional properties of semidilute aqueous methylcellulose (MC) solutions have been characterized. Pure aqueous MC solutions are shear-thinning liquids at room temperature. With the addition of 8 wt % NaCl, a fraction of MC self-assembles into long fibrils, which modify the rheological properties of the original MC solution. Capillary Breakup Extensional Rheometry (CaBER) was used to characterize salt-free and 8 wt % NaCl solutions of MC at room temperature. The salt-free solutions exhibit only power-law behavior whereas solutions with NaCl exhibit both power-law and elastic regimes. As MC concentration increases, the extensional relaxation time also increases strongly, from 0.04 s at 0.5 wt % to 4 s at 1 wt %. In addition, the apparent extensional viscosity rapidly increases as a function of increasing MC concentration, from 40 Pa·s at 0.5 wt % to 1300 Pa·s at 1 wt %. This behavior is attributed to the presence of fibrils in the MC solutions containing NaCl.
- 1 January 2018
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 537, 281-286
pH dependence of bentonite aggregate size and morphology on polymer-clay flocculation
- 1 January 2018
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 537, 281-286
pH dependence of bentonite aggregate size and morphology on polymer-clay flocculation
- 1 September 2017
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 529, 1037-1046
Ionic strength dependence of aggregate size and morphology on polymer-clay flocculation
- 1 September 2017
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 529, 1037-1046
Ionic strength dependence of aggregate size and morphology on polymer-clay flocculation
- Open Access
- 1 January 2016
- Published by Elsevier in Colloid and Interface Science Communications
- Vol. 10-11, 1-5
Internal structure visualization of polymer — clay flocculants using fluorescence
- 1 January 2016
- Published by Elsevier in Colloid and Interface Science Communications
- Vol. 10-11, 1-5
Open AccessInternal structure visualization of polymer — clay flocculants using fluorescence
- 23 December 2014
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 54 (16) , 4243-4251
Breakup of Oil Jets into Droplets in Seawater with Environmentally Benign Nanoparticle and Surfactant Dispersants
- 23 December 2014
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 54 (16) , 4243-4251
Breakup of Oil Jets into Droplets in Seawater with Environmentally Benign Nanoparticle and Surfactant Dispersants