Caue Conterno Barreira
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Caue Conterno Barreira has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
A. Forner-Cordero
Biomechatronics Laboratory, Escola Politecnica of the University of Sao Paulo, Avda Prof Mello Moraes Sao Paulo, 2231, Brazil
1 shared publication- Arturo Forner-Cordero
Universidade de São Paulo
1 shared publication C. Noriega
Biomechatronics Laboratory, Escola Politecnica of the University of Sao Paulo, Avda Prof Mello Moraes Sao Paulo, 2231, Brazil
1 shared publicationF. Camargo-Junior
Biomechatronics Laboratory, Escola Politecnica of the University of Sao Paulo, Avda Prof Mello Moraes Sao Paulo, 2231, Brazil
1 shared publicationL. F. Sommer
Biomechatronics Laboratory, Escola Politecnica of the University of Sao Paulo, Avda Prof Mello Moraes Sao Paulo, 2231, Brazil
1 shared publication- Patricia Moreno Grangeiro
Instituto de Ortopedia e Traumatologia, Hospital das Clinicas HCFMUSP, Faculdade de Medicina, Universidade de Sao Paulo, Sao Paulo, Brazil
1 shared publication
Latest Publications
- 18 May 2020
- Published by Taylor & Francis in Journal of Medical Engineering & Technology
- Vol. 44 (4) , 198-202
Kinect v2 based system for gait assessment of children with cerebral palsy in rehabilitation settings
Cerebral palsy (CP) describes a group of disorders of movement, posture and balance caused by a non-progressive brain injury in the immature brain. It is the most prevalent cause of chronic motor disability in childhood, and although two thirds of CP children are able to walk, they show gait limitations. In this context, rehabilitation therapy can improve muscle balance and gait. Previous studies showed the importance of gait analysis as part of multidisciplinary tools for effective rehabilitation treatment. However, the high cost and the infrastructure required for the implementation of commercial gait analysis systems as well as the time-consuming preparation procedures, limit the access to this service. A low cost, non-restrictive, portable and of simple operation and installation system was developed based on Kinect v2 sensor. This study aims to validate it for capturing and analysing gait parameters in children with cerebral palsy. Several gait parameters from eleven CP patients with different levels of disability classified as a function of the Gross Motor Function Classification System (GMFCS) from II to III were recorded while they walked on a flat surface. The Kinect-based gait analysis system was compared with video-recording that yielded the same results. These results show the potential of Kinect to analyse gait in frail patient populations unobtrusively and with very low cost. More importantly, regarding to spatial parameters, the Kinect system was useful even for the worst case of GMFCS III that show a large gait variability with abnormal patterns.
- 18 May 2020
- Published by Taylor & Francis in Journal of Medical Engineering & Technology
- Vol. 44 (4) , 198-202
Kinect v2 based system for gait assessment of children with cerebral palsy in rehabilitation settings
Cerebral palsy (CP) describes a group of disorders of movement, posture and balance caused by a non-progressive brain injury in the immature brain. It is the most prevalent cause of chronic motor disability in childhood, and although two thirds of CP children are able to walk, they show gait limitations. In this context, rehabilitation therapy can improve muscle balance and gait. Previous studies showed the importance of gait analysis as part of multidisciplinary tools for effective rehabilitation treatment. However, the high cost and the infrastructure required for the implementation of commercial gait analysis systems as well as the time-consuming preparation procedures, limit the access to this service. A low cost, non-restrictive, portable and of simple operation and installation system was developed based on Kinect v2 sensor. This study aims to validate it for capturing and analysing gait parameters in children with cerebral palsy. Several gait parameters from eleven CP patients with different levels of disability classified as a function of the Gross Motor Function Classification System (GMFCS) from II to III were recorded while they walked on a flat surface. The Kinect-based gait analysis system was compared with video-recording that yielded the same results. These results show the potential of Kinect to analyse gait in frail patient populations unobtrusively and with very low cost. More importantly, regarding to spatial parameters, the Kinect system was useful even for the worst case of GMFCS III that show a large gait variability with abnormal patterns.
- 1 July 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2018 40th Annual International Conference of the IEEE Engineering in Medicine and Biology Society (EMBC)
- Vol. 2018, 1472-1475
Elbow Joint Angle Estimation with Surface Electromyography Using Autoregressive Models
This paper presents a method to estimate the elbow joint angle from surface electromyography (sEMG) measurements of biceps, triceps and brachioradialis. This estimation is of major importance for the design of human robot interfaces based on sEMG. It is also relevant to model the muscular system and to design biomimetic mechanisms. However, the processing and interpretation of electromyographic signals is challenging due to nonlinearities, unmodeled muscle dynamics, noise and interferences. In order to determine an estimation model and a calibration procedure for the model parameters, a set of experiments were carried out with six subjects. The experiments consisted of series of continuous (cyclical) and discrete elbow flexo-extensions with three different loads (i.e. 0 kg, 1.5kg and 3 kg). The sEMG data from the biceps brachii, triceps brachii and brachioradialis and the joint angle were recorded. Four different modeling techniques were evaluated: State Space (SS), Autoregressive with Exogenous Input (ARX), Autoregressive Moving-Average with Exogenous Input (ARMAX), Autoregressive Integrated Moving-Average with Exogenous Input (ARIMAX). After the model was selected, a second experiment was performed in order to validate the estimation procedure. The results show a procedure to estimate the EMG-to-angle relation with high correlation and low mean-square-root errors with respect to the measured angle data.
- 1 July 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2018 40th Annual International Conference of the IEEE Engineering in Medicine and Biology Society (EMBC)
- Vol. 2018, 1472-1475
Elbow Joint Angle Estimation with Surface Electromyography Using Autoregressive Models
This paper presents a method to estimate the elbow joint angle from surface electromyography (sEMG) measurements of biceps, triceps and brachioradialis. This estimation is of major importance for the design of human robot interfaces based on sEMG. It is also relevant to model the muscular system and to design biomimetic mechanisms. However, the processing and interpretation of electromyographic signals is challenging due to nonlinearities, unmodeled muscle dynamics, noise and interferences. In order to determine an estimation model and a calibration procedure for the model parameters, a set of experiments were carried out with six subjects. The experiments consisted of series of continuous (cyclical) and discrete elbow flexo-extensions with three different loads (i.e. 0 kg, 1.5kg and 3 kg). The sEMG data from the biceps brachii, triceps brachii and brachioradialis and the joint angle were recorded. Four different modeling techniques were evaluated: State Space (SS), Autoregressive with Exogenous Input (ARX), Autoregressive Moving-Average with Exogenous Input (ARMAX), Autoregressive Integrated Moving-Average with Exogenous Input (ARIMAX). After the model was selected, a second experiment was performed in order to validate the estimation procedure. The results show a procedure to estimate the EMG-to-angle relation with high correlation and low mean-square-root errors with respect to the measured angle data.