Lukas C. Buelens
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Lukas C. Buelens has a total of 55 co-authors. Here are the top co-authors by number of shared publications:
- Hilde Poelman
Laboratory for Chemical Technology, Ghent University, Technologiepark 125, B-9052 Ghent, Belgium
11 shared publications - Vladimir V. Galvita
Laboratory for Chemical Technology, Ghent University, Technologiepark 125, B-9052 Ghent, Belgium
10 shared publications - Kevin Marcel Van Geem
Laboratory for Chemical Technology Ghent University Ghent Belgium
6 shared publications - Guy B. Marin
Laboratory for Chemical Technology, Ghent University, Technologiepark 121, 9052 Zwijnaarde, Belgium
5 shared publications Vladimir V. Galvita
5 shared publications- Georgios Bellos
Dow Benelux BV, Herbert H. Dowweg, NM Hoek
3 shared publications
Latest Publications
- 7 July 2026
- Published by Elsevier in Chemical Engineering Science
- Vol. 337
Multi-objective optimization of magnetic ON-OFF mode in magnetically fluidized beds
- 7 July 2026
- Published by Elsevier in Chemical Engineering Science
- Vol. 337
Multi-objective optimization of magnetic ON-OFF mode in magnetically fluidized beds
- Open Access
- 18 March 2026
- Published by Elsevier in SSRN Electronic Journal
Process Analysis of Sustainable Methanol Production Using Super-Dry Reforming: Techno-Economic, Lifecycle, And Exergy Analysis
To reduce the carbon footprint of methanol production, this study assesses integrating a super-dry reforming (SDR) section into a conventional steam methane reforming (SMR)-based natural gas (NG) methanol plant. Both the conventional SMR and the integrated SMR-SDR configurations are modelled in Aspen Plus and evaluated by techno-economic analysis, sensitivity analysis, cradle-to-gate life-cycle assessment and exergy analysis. Optimising the syngas composition to the isothermal methanol synthesis loop increases the single-pass carbon-to-methanol conversion from 21.8% to 53.7%. It almost eliminates water co-production (−99.7%), enabling lower recycle and purification duties and 18% lower NG, 15% lower CO2 and 15% lower process-water feeds. Feedstock efficiency rises from 40% to 50%. The cradle-to-gate global warming potential decreases by about 19%, from 0.99 to 0.80 kg CO2-eq kg−1 MeOH, while rational exergy efficiency increases from 56% to 59%. These improvements are offset by ~26% higher CAPEX and ~7% higher OPEX, resulting in a higher levelized cost of methanol (LCOM, 604 vs 581 €/t). However, both values fall within recent European methanol price ranges. Sensitivity analysis indicates that the NG price (22-58 € MWh-1) and CAPEX (-30%/+50%) are the dominant drivers of the LCOM. The SMR-SDR configuration becomes economically competitive (LCOMSMR-SDR < LCOMconv) only at NG prices > 54.7 € MWh-1 (69% above the base case). Decreased CO2 emissions and lower CO2 feedstock demand provide additional opportunities under high ETS and CO2 feedstock prices. Still, within the investigated ranges, CO2-related cost variations alone do not overturn the economic preference for the conventional route.
- 18 March 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessProcess Analysis of Sustainable Methanol Production Using Super-Dry Reforming: Techno-Economic, Lifecycle, And Exergy Analysis
To reduce the carbon footprint of methanol production, this study assesses integrating a super-dry reforming (SDR) section into a conventional steam methane reforming (SMR)-based natural gas (NG) methanol plant. Both the conventional SMR and the integrated SMR-SDR configurations are modelled in Aspen Plus and evaluated by techno-economic analysis, sensitivity analysis, cradle-to-gate life-cycle assessment and exergy analysis. Optimising the syngas composition to the isothermal methanol synthesis loop increases the single-pass carbon-to-methanol conversion from 21.8% to 53.7%. It almost eliminates water co-production (−99.7%), enabling lower recycle and purification duties and 18% lower NG, 15% lower CO2 and 15% lower process-water feeds. Feedstock efficiency rises from 40% to 50%. The cradle-to-gate global warming potential decreases by about 19%, from 0.99 to 0.80 kg CO2-eq kg−1 MeOH, while rational exergy efficiency increases from 56% to 59%. These improvements are offset by ~26% higher CAPEX and ~7% higher OPEX, resulting in a higher levelized cost of methanol (LCOM, 604 vs 581 €/t). However, both values fall within recent European methanol price ranges. Sensitivity analysis indicates that the NG price (22-58 € MWh-1) and CAPEX (-30%/+50%) are the dominant drivers of the LCOM. The SMR-SDR configuration becomes economically competitive (LCOMSMR-SDR < LCOMconv) only at NG prices > 54.7 € MWh-1 (69% above the base case). Decreased CO2 emissions and lower CO2 feedstock demand provide additional opportunities under high ETS and CO2 feedstock prices. Still, within the investigated ranges, CO2-related cost variations alone do not overturn the economic preference for the conventional route.
- Open Access
- 11 March 2026
- Published by Elsevier in SSRN Electronic Journal
Process analysis of sustainable methanol production using super-dry reforming: techno-economic, life-cycle, and exergy analysis
To reduce the carbon footprint of methanol production, this study assesses integrating a super-dry reforming (SDR) section into a conventional steam methane reforming (SMR)-based natural gas (NG) methanol plant. Both the conventional SMR and the integrated SMR-SDR configurations are modelled in Aspen Plus and evaluated by techno-economic analysis, sensitivity analysis, cradle-to-gate life-cycle assessment and exergy analysis. Optimising the syngas composition to the isothermal methanol synthesis loop increases the single-pass carbon-to-methanol conversion from 21.8% to 53.7%. It almost eliminates water co-production (−99.7%), enabling lower recycle and purification duties and 18% lower NG, 15% lower CO2 and 15% lower process-water feeds. Feedstock efficiency rises from 40% to 50%. The cradle-to-gate global warming potential decreases by about 19%, from 0.99 to 0.80 kg CO2-eq kg−1 MeOH, while rational exergy efficiency increases from 56% to 59%. These improvements are offset by ~26% higher CAPEX and ~7% higher OPEX, resulting in a higher levelized cost of methanol (LCOM, 604 vs 581 €/t). However, both values fall within recent European methanol price ranges. Sensitivity analysis indicates that the NG price (22-58 € MWh-1) and CAPEX (-30%/+50%) are the dominant drivers of the LCOM. The SMR-SDR configuration becomes economically competitive (LCOMSMR-SDR < LCOMconv) only at NG prices > 54.7 € MWh-1 (69% above the base case). Decreased CO2 emissions and lower CO2 feedstock demand provide additional opportunities under high ETS and CO2 feedstock prices. Still, within the investigated ranges, CO2-related cost variations alone do not overturn the economic preference for the conventional route.
- 11 March 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessProcess analysis of sustainable methanol production using super-dry reforming: techno-economic, life-cycle, and exergy analysis
To reduce the carbon footprint of methanol production, this study assesses integrating a super-dry reforming (SDR) section into a conventional steam methane reforming (SMR)-based natural gas (NG) methanol plant. Both the conventional SMR and the integrated SMR-SDR configurations are modelled in Aspen Plus and evaluated by techno-economic analysis, sensitivity analysis, cradle-to-gate life-cycle assessment and exergy analysis. Optimising the syngas composition to the isothermal methanol synthesis loop increases the single-pass carbon-to-methanol conversion from 21.8% to 53.7%. It almost eliminates water co-production (−99.7%), enabling lower recycle and purification duties and 18% lower NG, 15% lower CO2 and 15% lower process-water feeds. Feedstock efficiency rises from 40% to 50%. The cradle-to-gate global warming potential decreases by about 19%, from 0.99 to 0.80 kg CO2-eq kg−1 MeOH, while rational exergy efficiency increases from 56% to 59%. These improvements are offset by ~26% higher CAPEX and ~7% higher OPEX, resulting in a higher levelized cost of methanol (LCOM, 604 vs 581 €/t). However, both values fall within recent European methanol price ranges. Sensitivity analysis indicates that the NG price (22-58 € MWh-1) and CAPEX (-30%/+50%) are the dominant drivers of the LCOM. The SMR-SDR configuration becomes economically competitive (LCOMSMR-SDR < LCOMconv) only at NG prices > 54.7 € MWh-1 (69% above the base case). Decreased CO2 emissions and lower CO2 feedstock demand provide additional opportunities under high ETS and CO2 feedstock prices. Still, within the investigated ranges, CO2-related cost variations alone do not overturn the economic preference for the conventional route.
- 6 February 2026
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 16 (4) , 3999-4016
Breaking the Code of Active Sites in CO 2 -Assisted Propane Dehydrogenation over Mg(Fe,Al)O x
- 6 February 2026
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 16 (4) , 3999-4016
Breaking the Code of Active Sites in CO 2 -Assisted Propane Dehydrogenation over Mg(Fe,Al)O x
- Open Access
- 28 January 2026
- Published by Elsevier in Chemical Engineering Journal
- Vol. 530
Experimental magnetic field-driven segregation mechanisms in Geldart D magnetically fluidized beds: From uniform to gradient fields
- 28 January 2026
- Published by Elsevier in Chemical Engineering Journal
- Vol. 530
Open AccessExperimental magnetic field-driven segregation mechanisms in Geldart D magnetically fluidized beds: From uniform to gradient fields
- 4 November 2025
- Published by Wiley in Advanced Sustainable Systems
- Vol. 9 (12)
Techno‐Economic Assessment of Chemical Looping Partial Oxidation of Mixed Polyolefin Post‐Consumer Plastic Waste
The global push for climate neutrality and circularity has intensified interest in converting plastic waste into valuable chemical feedstocks. This study examines the techno‐economic feasibility of producing syngas from post‐consumer plastic waste (PCPW) via chemical looping partial oxidation (CLPO) and compares it to more established syngas production techniques, namely dry reforming of methane (DRM) and gasification of PCPW. Process simulations are conducted in Aspen Plus, targeting a syngas stoichiometric number (SN) of 2.0, which is ideal for downstream Fischer–Tropsch synthesis. The CLPO process, conceptualized in a dual fluidized bed reactor setup, is modeled using literature data and compared to DRM and gasification in terms of capital and operational expenditures (CAPEX and OPEX). A detailed separation train is designed to meet severe syngas purity requirements, accounting for typical impurities present in process feedstocks. Results show that, although CLPO offers flexibility and avoids direct air separation, it suffers from high CAPEX and OPEX, leading to a significantly higher levelized cost of syngas (LCOS) of 616 € t −1 , compared to 503 and 494 € t −1 for the DRM and gasification benchmarks, respectively. Sensitivity analyses highlight syngas selling price and reactor CAPEX as key economic drivers.
- 4 November 2025
- Published by Wiley in Advanced Sustainable Systems
- Vol. 9 (12)
Techno‐Economic Assessment of Chemical Looping Partial Oxidation of Mixed Polyolefin Post‐Consumer Plastic Waste
The global push for climate neutrality and circularity has intensified interest in converting plastic waste into valuable chemical feedstocks. This study examines the techno‐economic feasibility of producing syngas from post‐consumer plastic waste (PCPW) via chemical looping partial oxidation (CLPO) and compares it to more established syngas production techniques, namely dry reforming of methane (DRM) and gasification of PCPW. Process simulations are conducted in Aspen Plus, targeting a syngas stoichiometric number (SN) of 2.0, which is ideal for downstream Fischer–Tropsch synthesis. The CLPO process, conceptualized in a dual fluidized bed reactor setup, is modeled using literature data and compared to DRM and gasification in terms of capital and operational expenditures (CAPEX and OPEX). A detailed separation train is designed to meet severe syngas purity requirements, accounting for typical impurities present in process feedstocks. Results show that, although CLPO offers flexibility and avoids direct air separation, it suffers from high CAPEX and OPEX, leading to a significantly higher levelized cost of syngas (LCOS) of 616 € t −1 , compared to 503 and 494 € t −1 for the DRM and gasification benchmarks, respectively. Sensitivity analyses highlight syngas selling price and reactor CAPEX as key economic drivers.
- 29 May 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 64 (23) , 11380-11396
Nanoscale Interactions in a Multifunctional Ni–Fe–Ca–Mg–Al–O Chemical Looping Material
- 29 May 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 64 (23) , 11380-11396
Nanoscale Interactions in a Multifunctional Ni–Fe–Ca–Mg–Al–O Chemical Looping Material
- 19 March 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 64 (13) , 6878-6896
Methane Pyrolysis over Ordered Mesoporous Carbons and Carbon Blacks: Catalyst Design and Impact of Carbon Deposition
- 19 March 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 64 (13) , 6878-6896
Methane Pyrolysis over Ordered Mesoporous Carbons and Carbon Blacks: Catalyst Design and Impact of Carbon Deposition