Nicolas Preux

The innovative Green Ceramic Hybrid Machining (GCHM) process sequentially combines milling with a cutting tool (GCM, Green Ceramic Machining) and laser beam machining (GCLBM) of a ceramic material (black Y-TZP in this study) at the green stage mainly to increase productivity, avoid taper angle limitations of laser beam machining, and obtain micro-features. The study focuses on the reliability and the repeatability of the properties of sintered parts obtained by three manufacturing processes (GCM, GCLBM, GCHM) to assess the performance of hybridisation. It turns out that GCHM is a compromise of both milling and laser beam processes; it increases the repeatability of the surface quality and it slightly reduces (less than 7%) the flexural strength by comparison to milling for a similar reliability. The study also highlights that the surface quality of GCLBM processed parts relies on of the surface generated by the previous operation. Milling that surface at the previous step is therefore recommended, corresponding to the sequence adopted by GCHM.

Manufacturing of advanced ceramic parts exhibiting complex geometries is laborious and expensive. Traditionally, the machining is carried out on a so-called ‘green ceramic’: a compact composed of ceramic powder held with the help of a binder. This difficulty is due not only to the composition of the material, but also to the lack of methods that determine optimal machining parameters. The goal of this paper is to apply the method based on ductile material behavior to determine a feed rate working range to ensure a machining quality. Indeed, a previous study demonstrated the limits of this method in determining cutting speed. In this case, two material removal mechanisms are observed: a mechanism dominated by pulling of the material and a proper machining mechanism. This demonstrates that the specific cutting energy is a reliable indicator for machining quality assessment. In the studied case, the recommended machining parameters to ensure quality machining of Y-TZP green ceramic with a 3 mm diameter cylindrical tool are: a cutting speed of 250 m/min, a feed per tooth of 0.037 mm/tooth, an axial depth of cut of 0.7 mm, and a radial depth of cut of 3 mm.

The demand for inert bioceramics is always increasing in the dental field. Yttrium oxide tetragonal zirconia polycrystals (Y-TZP) are oxide ceramics which are currently used because of their interesting mechanical properties due to a toughening transformation. Industrially speaking, machining of the ceramic before sintering (green body) is very common because it allows a better productivity and it reduces crack probability during the sintering process. The goal of this paper is to determine the behavior of green ceramic during the machining operation. This study is carried out on several blanks with different binder percentages. The specific cutting energy (SCE) and the surface quality (R_a and R_z) are determined for several cutting speeds. The SCE follows a logarithmic evolution when the cutting speed increases. Despite this increase, the R_a are relatively stable whatever the cutting speed and the binder percentage. At a low cutting speed, a higher R_z value is observed caused by pullout of material. The increase of cutting speed allows to stabilize the R_z value whatever the binder percentage. This study shows that the green ceramic has a pseudo-plastic behavior whose machinability depends mainly on the interaction between the material and the cutting edge of the tool, so unlike pre-sintered ceramic or metallic part cutting speed has a low influence on the quality of the machined part.