Holly Leopardi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Holly Leopardi has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
- Tara Michele Fortier
National Institute of Standards and Technology 325 Broadway 80305 Boulder Colorado USA
4 shared publications - Scott A. Diddams
University of Colorado
3 shared publications - John Kitching
National Institute of Standards and Technology
2 shared publications - Kenji Numata
NASA Goddard Space Flight Center
2 shared publications - Kohei Yamamoto
University of Maryland, Baltimore County
2 shared publications - Matthew T. Hummon
National Institute of Standards and Technology
2 shared publications
Latest Publications
- 9 June 2026
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 25 (6)
Searching systematically for coupling of laser and phase-modulation noise in heterodyne interferometry
- 9 June 2026
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 25 (6)
Searching systematically for coupling of laser and phase-modulation noise in heterodyne interferometry
- 15 May 2026
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 25 (5)
Alternative approach to time-delay interferometry with an optical frequency comb
- 15 May 2026
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 25 (5)
Alternative approach to time-delay interferometry with an optical frequency comb
- Open Access
- 1 October 2024
- Published by AIP Publishing in APL Photonics
- Vol. 9 (10)
Classical and quantum frequency combs for satellite-based clock synchronization
The next generation of space-based networks for communications, sensing, and navigation will contain optical clocks embedded within satellites. To fully realize the capabilities of such clocks, high-precision clock synchronization across the networks will be necessary. Current experiments have shown the potential for classical frequency combs to synchronize remote optical clocks over free space. However, these classical combs are restricted in precision to the standard quantum limit. Quantum frequency combs, however, which exhibit quantum properties such as squeezing and entanglement, provide pathways for going beyond the standard quantum limit. Here, we present our perspective on the prospects for practical clock synchronization in space using both classical and quantum frequency combs. We detail the current outcomes achievable with a classical frequency comb approach to synchronization, before quantifying the potential outcomes offered by quantum frequency combs. Challenges to be overcome in deploying frequency combs in space are presented, and the implications of almost-perfect synchronization for future space-based applications and experiments are discussed.
- 1 October 2024
- Published by AIP Publishing in APL Photonics
- Vol. 9 (10)
Open AccessClassical and quantum frequency combs for satellite-based clock synchronization
The next generation of space-based networks for communications, sensing, and navigation will contain optical clocks embedded within satellites. To fully realize the capabilities of such clocks, high-precision clock synchronization across the networks will be necessary. Current experiments have shown the potential for classical frequency combs to synchronize remote optical clocks over free space. However, these classical combs are restricted in precision to the standard quantum limit. Quantum frequency combs, however, which exhibit quantum properties such as squeezing and entanglement, provide pathways for going beyond the standard quantum limit. Here, we present our perspective on the prospects for practical clock synchronization in space using both classical and quantum frequency combs. We detail the current outcomes achievable with a classical frequency comb approach to synchronization, before quantifying the potential outcomes offered by quantum frequency combs. Challenges to be overcome in deploying frequency combs in space are presented, and the implications of almost-perfect synchronization for future space-based applications and experiments are discussed.
- 1 January 2022
- Published by Optica Publishing Group
- Vol. 31, STh5N.2
An Er/Yb:glass laser-based optical frequency comb for precision metrology
We characterize an Er/Yb:glass laser frequency comb for precision metrology of atomic clocks and demonstrate a fractional frequency instability −18 at 1-s averaging and a 10 GHz phase noise < −110 dBc/Hz at a 1 Hz offset.
- 1 January 2022
- Published by Optica Publishing Group
- Vol. 31, STh5N.2
An Er/Yb:glass laser-based optical frequency comb for precision metrology
We characterize an Er/Yb:glass laser frequency comb for precision metrology of atomic clocks and demonstrate a fractional frequency instability −18 at 1-s averaging and a 10 GHz phase noise < −110 dBc/Hz at a 1 Hz offset.
- Open Access
- 15 September 2021
- Published by Optica Publishing Group in Optics Letters
- Vol. 46 (18) , 4702-4705
High-performance, compact optical standard
We describe a high-performance, compact optical frequency standard based on a microfabricated Rb vapor cell and a low-noise, external cavity diode laser operating on the Rb two-photon transition at 778 nm. The optical standard achieves an instability of 1.8 × 10 − 13 τ − 1 / 2 for times less than 100 s and a flicker noise floor of 1 × 10 − 14 out to 6000 s. At long integration times, the instability is limited by variations in optical probe power and the ac Stark shift. The retrace was measured to 5.7 × 10 − 13 after 30 h of dormancy. Such a simple, yet high-performance optical standard could be suitable as an accurate realization of the meter or, if coupled with an optical frequency comb, as a compact atomic clock comparable to a hydrogen maser.
- 15 September 2021
- Published by Optica Publishing Group in Optics Letters
- Vol. 46 (18) , 4702-4705
Open AccessHigh-performance, compact optical standard
We describe a high-performance, compact optical frequency standard based on a microfabricated Rb vapor cell and a low-noise, external cavity diode laser operating on the Rb two-photon transition at 778 nm. The optical standard achieves an instability of 1.8 × 10 − 13 τ − 1 / 2 for times less than 100 s and a flicker noise floor of 1 × 10 − 14 out to 6000 s. At long integration times, the instability is limited by variations in optical probe power and the ac Stark shift. The retrace was measured to 5.7 × 10 − 13 after 30 h of dormancy. Such a simple, yet high-performance optical standard could be suitable as an accurate realization of the meter or, if coupled with an optical frequency comb, as a compact atomic clock comparable to a hydrogen maser.
- 22 May 2020
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 368 (6493) , 889-892
Coherent optical clock down-conversion for microwave frequencies with 10 −18 instability
Good timing for microwave technology: Timing standards around the world define the second using atomic clocks, specifically the microwave frequencies emitted from trapped atoms. Optical clocks, which are based on optical transitions of atoms, operate at much higher frequency and have been shown to exhibit better stability. Nakamura et al. demonstrate a framework that carries the improved stability of the optical domain over to microwaves (see the Perspective by Curtis). In addition to contributing to the eventual redefinition of the second based on optical clocks, this work will also lead to improvements in microwave-based technologies such as astronomical imaging and geodesy through very long baseline interferometry, radar, communications, and navigation systems. Science , this issue p. 889 ; see also p. 825
- 22 May 2020
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 368 (6493) , 889-892
Coherent optical clock down-conversion for microwave frequencies with 10 −18 instability
Good timing for microwave technology: Timing standards around the world define the second using atomic clocks, specifically the microwave frequencies emitted from trapped atoms. Optical clocks, which are based on optical transitions of atoms, operate at much higher frequency and have been shown to exhibit better stability. Nakamura et al. demonstrate a framework that carries the improved stability of the optical domain over to microwaves (see the Perspective by Curtis). In addition to contributing to the eventual redefinition of the second based on optical clocks, this work will also lead to improvements in microwave-based technologies such as astronomical imaging and geodesy through very long baseline interferometry, radar, communications, and navigation systems. Science , this issue p. 889 ; see also p. 825
- Open Access
- 17 June 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (13) , 14513-14524
Microresonator Brillouin laser stabilization using a microfabricated rubidium cell
We frequency stabilize the output of a miniature stimulated Brillouin scattering (SBS) laser to rubidium atoms in a microfabricated cell to realize a laser system with frequency stability at the 10−11 level over seven decades in averaging time. In addition, our system has the advantages of robustness, low cost and the potential for integration that would lead to still further miniaturization. The SBS laser operating at 1560 nm exhibits a spectral linewidth of 820 Hz, but its frequency drifts over a few MHz on the 1 hour timescale. By locking the second harmonic of the SBS laser to the Rb reference, we reduce this drift by a factor of 103 to the level of a few kHz over the course of an hour. For our combined SBS and Rb laser system, we measure a frequency noise of 4 × 104 Hz2/Hz at 10 Hz offset frequency which rapidly rolls off to a level of 0.2 Hz2/Hz at 100 kHz offset. The corresponding Allan deviation is ≤2 × 10−11 for averaging times spanning 10−4 to 103 s. By optically dividing the signal of the laser down to microwave frequencies, we generate an RF signal at 2 GHz with phase noise at the level of −76 dBc/Hz and −140 dBc/Hz at offset frequencies of 10 Hz and 10 kHz, respectively.
- 17 June 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (13) , 14513-14524
Open AccessMicroresonator Brillouin laser stabilization using a microfabricated rubidium cell
We frequency stabilize the output of a miniature stimulated Brillouin scattering (SBS) laser to rubidium atoms in a microfabricated cell to realize a laser system with frequency stability at the 10−11 level over seven decades in averaging time. In addition, our system has the advantages of robustness, low cost and the potential for integration that would lead to still further miniaturization. The SBS laser operating at 1560 nm exhibits a spectral linewidth of 820 Hz, but its frequency drifts over a few MHz on the 1 hour timescale. By locking the second harmonic of the SBS laser to the Rb reference, we reduce this drift by a factor of 103 to the level of a few kHz over the course of an hour. For our combined SBS and Rb laser system, we measure a frequency noise of 4 × 104 Hz2/Hz at 10 Hz offset frequency which rapidly rolls off to a level of 0.2 Hz2/Hz at 100 kHz offset. The corresponding Allan deviation is ≤2 × 10−11 for averaging times spanning 10−4 to 103 s. By optically dividing the signal of the laser down to microwave frequencies, we generate an RF signal at 2 GHz with phase noise at the level of −76 dBc/Hz and −140 dBc/Hz at offset frequencies of 10 Hz and 10 kHz, respectively.