Kun He
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Kun He has a total of 74 co-authors. Here are the top co-authors by number of shared publications:
Xiewen Hu
14 shared publications- Xiewen Hu
Faculty of Geosciences and Environment Engineering, Southwest Jiaotong University, Chengdu 610031, China
13 shared publications - Bo Liu
Railway Engineering Research Institute, China Academy of Railway Science Corporation Limited, Beijing 100081, China
8 shared publications Gang Luo
8 shared publicationsBo Liu
6 shared publicationsChuanjie Xi
Faculty of Geosciences and Engineering, Southwest Jiaotong University, Chengdu, China
5 shared publications
Latest Publications
- 29 September 2026
- Published by Springer Nature in Journal of Mountain Science
- Vol. 23 (9) , 4500-4523
Debris flow susceptibility assessment based on Choquet fuzzy integral with small sample size: A case study of Shimian County, Ya’an City
- 29 September 2026
- Published by Springer Nature in Journal of Mountain Science
- Vol. 23 (9) , 4500-4523
Debris flow susceptibility assessment based on Choquet fuzzy integral with small sample size: A case study of Shimian County, Ya’an City
- 5 August 2026
- Published by Wiley in Earth Surface Processes and Landforms
- Vol. 51 (8) , e70380
Early post‐fire debris‐flow initiation following the March 2024 Yajiang Fire, Sichuan, China
Burned slopes, with reduced vegetation cover, enhanced soil water repellency and decreased infiltration capacity, are highly susceptible to post‐fire debris flows and can pose immediate threats to infrastructure and communities in steep mountain regions. However, the initiation mechanisms of the first set of debris flows after a fire remain poorly understood, hindering effective hazard management. Following the 15 March 2024 Yajiang Fire in Sichuan, China, which burned approximately 278.8 km 2 , 506 post‐fire debris‐flow events occurred during the same year and caused severe damage. Within this broader context, this study focuses on the early post‐fire stage and uses the Baima catchment as a detailed study site to investigate how ash‐rich hillslope sediment was redistributed, stored in channels and subsequently involved in debris‐flow initiation. By combining rainfall and wind records, soil water repellency tests, repeated measurements of ash thickness on hillslopes, surveys of dry‐ravel storage within channels, unmanned aerial vehicle (UAV) mapping, repeated field investigations and sediment analyses, we show that wind and gravity rapidly transferred ash from slopes to channels. Within 11 days after the fire, approximately 93.8% of the ash in the Baima catchment had accumulated in channels as dry‐ravel deposits, which became the dominant source material for the earliest debris flows. Field evidence indicates that these early debris flows were initiated when rainfall mixed with channel‐stored dry‐ravel deposits to form a high‐viscosity, ‘concrete‐like’ mixture, which was then driven downslope by continued inflow and gravity. At the regional scale, early post‐fire debris flows were concentrated in small, steep catchments, most of them smaller than 1 km 2 . In the Baima catchment, about 86.6% of the solid material in the debris flow was derived from loose ash‐rich sediment. Coarse particles were preferentially deposited at catchment outlets as a granular phase, whereas finer ash‐rich material extended farther downstream as a muddy phase. These findings provide direct field evidence for the initiation of early post‐fire debris flows in the Hengduan Mountains, showing that rapid hillslope‐to‐channel sediment transfer can preload small, steep burned catchments and strongly influence their earliest debris‐flow response. This study therefore provides a process‐based basis for early hazard recognition and emergency response to post‐fire debris‐flow hazards in the Hengduan Mountains and other similar steep mountain regions.
- 5 August 2026
- Published by Wiley in Earth Surface Processes and Landforms
- Vol. 51 (8) , e70380
Early post‐fire debris‐flow initiation following the March 2024 Yajiang Fire, Sichuan, China
Burned slopes, with reduced vegetation cover, enhanced soil water repellency and decreased infiltration capacity, are highly susceptible to post‐fire debris flows and can pose immediate threats to infrastructure and communities in steep mountain regions. However, the initiation mechanisms of the first set of debris flows after a fire remain poorly understood, hindering effective hazard management. Following the 15 March 2024 Yajiang Fire in Sichuan, China, which burned approximately 278.8 km 2 , 506 post‐fire debris‐flow events occurred during the same year and caused severe damage. Within this broader context, this study focuses on the early post‐fire stage and uses the Baima catchment as a detailed study site to investigate how ash‐rich hillslope sediment was redistributed, stored in channels and subsequently involved in debris‐flow initiation. By combining rainfall and wind records, soil water repellency tests, repeated measurements of ash thickness on hillslopes, surveys of dry‐ravel storage within channels, unmanned aerial vehicle (UAV) mapping, repeated field investigations and sediment analyses, we show that wind and gravity rapidly transferred ash from slopes to channels. Within 11 days after the fire, approximately 93.8% of the ash in the Baima catchment had accumulated in channels as dry‐ravel deposits, which became the dominant source material for the earliest debris flows. Field evidence indicates that these early debris flows were initiated when rainfall mixed with channel‐stored dry‐ravel deposits to form a high‐viscosity, ‘concrete‐like’ mixture, which was then driven downslope by continued inflow and gravity. At the regional scale, early post‐fire debris flows were concentrated in small, steep catchments, most of them smaller than 1 km 2 . In the Baima catchment, about 86.6% of the solid material in the debris flow was derived from loose ash‐rich sediment. Coarse particles were preferentially deposited at catchment outlets as a granular phase, whereas finer ash‐rich material extended farther downstream as a muddy phase. These findings provide direct field evidence for the initiation of early post‐fire debris flows in the Hengduan Mountains, showing that rapid hillslope‐to‐channel sediment transfer can preload small, steep burned catchments and strongly influence their earliest debris‐flow response. This study therefore provides a process‐based basis for early hazard recognition and emergency response to post‐fire debris‐flow hazards in the Hengduan Mountains and other similar steep mountain regions.
- Open Access
- 1 December 2025
- Published by KEAI Publishing in Underground Space
- Vol. 25, 33-53
Integrated geophysical and computational modeling of hydromechanical mechanisms of underground debris flows in mining region
- 1 December 2025
- Published by KEAI Publishing in Underground Space
- Vol. 25, 33-53
Open AccessIntegrated geophysical and computational modeling of hydromechanical mechanisms of underground debris flows in mining region
- Open Access
- 30 October 2025
- Published by Copernicus GmbH in Natural Hazards and Earth System Sciences
- Vol. 25 (11) , 4247-4262
Kinetic characteristics investigation of the Yingxingping rockslide based on discrete element method combined with discrete fracture network
The development of rock fractures on the mountain ridge in meizoseismal area may lead to fatal rockslides. This study focused on a catastrophic post-earthquake rockslide case in Wenchuan, Southwestern China. On-site investigation and aerial photography were used to ascertained the basic characteristics and determine three regions: the source area, transitional area, and depositional area. A three-dimensional discrete element method (DEM) with the discrete fracture network (DFN) was employed to assess the dynamic process of the rockslide. The sliding mass disintegrated quickly into smaller blocks, with those in the front-edge reaching the bottom of the slope earlier and experiencing higher acceleration. The maximum velocity and displacement of the sliding blocks were found to be 56.75 m s−1 and 508.61 m, respectively, lasting for approximately 104.45 s. The effects of fractures density and friction angle on the kinetic characteristics of rockslide were analysed, and the check dam was utilized to prevent the rockslide deposit in the debris flow gully. This study provides referenced information for assessing the kinetic process and preventing post-earthquake rockslides in meizoseismal areas.
- 30 October 2025
- Published by Copernicus GmbH in Natural Hazards and Earth System Sciences
- Vol. 25 (11) , 4247-4262
Open AccessKinetic characteristics investigation of the Yingxingping rockslide based on discrete element method combined with discrete fracture network
The development of rock fractures on the mountain ridge in meizoseismal area may lead to fatal rockslides. This study focused on a catastrophic post-earthquake rockslide case in Wenchuan, Southwestern China. On-site investigation and aerial photography were used to ascertained the basic characteristics and determine three regions: the source area, transitional area, and depositional area. A three-dimensional discrete element method (DEM) with the discrete fracture network (DFN) was employed to assess the dynamic process of the rockslide. The sliding mass disintegrated quickly into smaller blocks, with those in the front-edge reaching the bottom of the slope earlier and experiencing higher acceleration. The maximum velocity and displacement of the sliding blocks were found to be 56.75 m s−1 and 508.61 m, respectively, lasting for approximately 104.45 s. The effects of fractures density and friction angle on the kinetic characteristics of rockslide were analysed, and the check dam was utilized to prevent the rockslide deposit in the debris flow gully. This study provides referenced information for assessing the kinetic process and preventing post-earthquake rockslides in meizoseismal areas.
- 13 September 2025
- Published by Springer Nature in Landslides
- Vol. 23 (1) , 129-141
Variability of post-fire debris flow initiation mechanisms across different lithological zones in the Hengduan Mountains, China
- 13 September 2025
- Published by Springer Nature in Landslides
- Vol. 23 (1) , 129-141
Variability of post-fire debris flow initiation mechanisms across different lithological zones in the Hengduan Mountains, China
- 6 August 2025
- Published by Springer Nature in Journal of Mountain Science
- Vol. 22 (8) , 2765-2792
Unveiling dominant factors for gully distribution in wildfire-affected areas using explainable AI: A case study of Xiangjiao catchment, Southwest China
- 6 August 2025
- Published by Springer Nature in Journal of Mountain Science
- Vol. 22 (8) , 2765-2792
Unveiling dominant factors for gully distribution in wildfire-affected areas using explainable AI: A case study of Xiangjiao catchment, Southwest China
- 25 June 2025
- Published by Springer Nature in Landslides
- Vol. 22 (11) , 3641-3656
Spatiotemporal distribution characteristics of post-fire debris flows during the first rainy season following Yajiang Fire, Sichuan, China
- 25 June 2025
- Published by Springer Nature in Landslides
- Vol. 22 (11) , 3641-3656
Spatiotemporal distribution characteristics of post-fire debris flows during the first rainy season following Yajiang Fire, Sichuan, China
- 11 March 2025
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Earth Surface
- Vol. 130 (3)
Post‐Wildfire Soil Properties Changes: Insights Into Hillslope Erosion After the March 2024 Yajiang Fire
Soil property changes influence material transport from hillslopes to channels after the wildfire and may indirectly trigger debris flow initiation. This study investigates post‐fire soil property evolution and its role in hillslope erosion following the 15 March 2024 Yajiang Fire, integrating field measurements with laboratory simulations to quantify temperature‐ and duration‐dependent soil changes and their controls. Results demonstrate that wildfire‐driven soil organic matter alteration is governed predominantly by peak heating temperature and not exposure duration. Post‐fire soil profiles are stratified into three thermal impact zones: (a) a high‐temperature zone (>600°C), characterized by complete organic matter combustion; (b) a water‐repellent (WR) zone (100–600°C), subdivided into a highly WR layer, an aggregate stability (AS)‐enhancement layer, and a low WR layer; and (c) an unaffected zone (<100°C). The high‐temperature zone and highly WR layer, mobilized by wind and gravity, accumulate in channels as dry ravel deposits, forming the primary source of immediate post‐fire debris flows. The AS‐enhancement layer, exhibiting improved aggregate stability, temporarily mitigates raindrop splash and interrill erosion of underlying soils prior to the first post‐fire rainfall event. However, this layer delays but does not prevent deeper soil mobilization during subsequent intense runoff. These findings clarify temperature thresholds controlling post‐fire soil zonation, highlight mechanisms linking soil property changes to debris flow initiation, and provide valuable data on post‐fire hillslope erosion processes.
- 11 March 2025
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Earth Surface
- Vol. 130 (3)
Post‐Wildfire Soil Properties Changes: Insights Into Hillslope Erosion After the March 2024 Yajiang Fire
Soil property changes influence material transport from hillslopes to channels after the wildfire and may indirectly trigger debris flow initiation. This study investigates post‐fire soil property evolution and its role in hillslope erosion following the 15 March 2024 Yajiang Fire, integrating field measurements with laboratory simulations to quantify temperature‐ and duration‐dependent soil changes and their controls. Results demonstrate that wildfire‐driven soil organic matter alteration is governed predominantly by peak heating temperature and not exposure duration. Post‐fire soil profiles are stratified into three thermal impact zones: (a) a high‐temperature zone (>600°C), characterized by complete organic matter combustion; (b) a water‐repellent (WR) zone (100–600°C), subdivided into a highly WR layer, an aggregate stability (AS)‐enhancement layer, and a low WR layer; and (c) an unaffected zone (<100°C). The high‐temperature zone and highly WR layer, mobilized by wind and gravity, accumulate in channels as dry ravel deposits, forming the primary source of immediate post‐fire debris flows. The AS‐enhancement layer, exhibiting improved aggregate stability, temporarily mitigates raindrop splash and interrill erosion of underlying soils prior to the first post‐fire rainfall event. However, this layer delays but does not prevent deeper soil mobilization during subsequent intense runoff. These findings clarify temperature thresholds controlling post‐fire soil zonation, highlight mechanisms linking soil property changes to debris flow initiation, and provide valuable data on post‐fire hillslope erosion processes.
- 18 September 2024
- Published by Springer Nature in Landslides
- Vol. 21 (12) , 3179-3189
Preliminary analysis of the wildfire on March 15, 2024, and the following post-fire debris flows in Yajiang County, Sichuan, China
- 18 September 2024
- Published by Springer Nature in Landslides
- Vol. 21 (12) , 3179-3189
Preliminary analysis of the wildfire on March 15, 2024, and the following post-fire debris flows in Yajiang County, Sichuan, China