Bal Govind
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Bal Govind has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
Ashish Kumar
7 shared publicationsSahiba Bano
CSIR-National Physical Laboratory, Dr. K.S. Krishnan Marg, New Delhi110012, India
5 shared publicationsAman Bhardwaj
Department of Chemistry, Hindu College, University of Delhi, Delhi110007, India
3 shared publicationsGunjan Sharma
2 shared publicationsPurnima Bharti
2 shared publicationsRoop Chandra
2 shared publications
Latest Publications
- Open Access
- 24 October 2026
- Published by Elsevier in SSRN Electronic Journal
Enhancement in Magnetization with Mn-Substitution at Co-Site in Fe2CoSb Full-Heusler Contrary to Slater-Pauling Rule
- Tuning of magnetic moments in Heusler alloys is enabled through the manipulation of valence electron count (VEC) via elemental substitution. Here, we successfully fabricated Co-substituted Fe2MnSb full-Heusler alloy through solid-state reaction. Structural analyses of reacted samples are performed through Rietveld refinement of obtained X-Ray Diffraction (XRD) data. The refinement results revealed the hexagonal structure (Space Group- P 63/mmc) of all the samples with the evolution of cubic phase. Saturated magnetization values, measured using the vibrating sample magnetometer (VSM) technique, are obtained to be 2.82 μB/f.u., 4.11 μB/f.u., 4.22 μB/f.u. at 15K temperature for Fe2Mn0.25Co0.75Sb, Fe2Mn0.5Co0.5Sb, and Fe2Mn0.75Co0.25Sb compositions, respectively. Bifurcation between ZFC and FC curves measured from 5K to 300K is found to be small, which in turn supports the phase purity of the ferromagnetic ground state. Magnetic moments of the prepared samples are increasing with decreasing VEC, which is contrary to the Slater-Pauling rule.
- 24 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessEnhancement in Magnetization with Mn-Substitution at Co-Site in Fe2CoSb Full-Heusler Contrary to Slater-Pauling Rule
- Tuning of magnetic moments in Heusler alloys is enabled through the manipulation of valence electron count (VEC) via elemental substitution. Here, we successfully fabricated Co-substituted Fe2MnSb full-Heusler alloy through solid-state reaction. Structural analyses of reacted samples are performed through Rietveld refinement of obtained X-Ray Diffraction (XRD) data. The refinement results revealed the hexagonal structure (Space Group- P 63/mmc) of all the samples with the evolution of cubic phase. Saturated magnetization values, measured using the vibrating sample magnetometer (VSM) technique, are obtained to be 2.82 μB/f.u., 4.11 μB/f.u., 4.22 μB/f.u. at 15K temperature for Fe2Mn0.25Co0.75Sb, Fe2Mn0.5Co0.5Sb, and Fe2Mn0.75Co0.25Sb compositions, respectively. Bifurcation between ZFC and FC curves measured from 5K to 300K is found to be small, which in turn supports the phase purity of the ferromagnetic ground state. Magnetic moments of the prepared samples are increasing with decreasing VEC, which is contrary to the Slater-Pauling rule.
- 28 March 2025
- Published by Elsevier in Solid State Communications
- Vol. 401
Investigation of magnetic properties of disordered Co1.75Ni0.25MnSi full-Heusler alloy
- 28 March 2025
- Published by Elsevier in Solid State Communications
- Vol. 401
Investigation of magnetic properties of disordered Co1.75Ni0.25MnSi full-Heusler alloy
- 26 October 2022
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 5 (11) , 14127-14135
Enhanced Thermoelectric Performance of NixBi0.5Sb1.5Te3via In Situ Formation of NiTe2 Channels
- 26 October 2022
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 5 (11) , 14127-14135
Enhanced Thermoelectric Performance of NixBi0.5Sb1.5Te3via In Situ Formation of NiTe2 Channels
- 28 July 2022
- Published by Springer Nature
- p. 157-165
Errors in Measurement of Magnetic Field and Magnetic Moment with its Associated Uncertainty
- 28 July 2022
- Published by Springer Nature
- p. 157-165
Errors in Measurement of Magnetic Field and Magnetic Moment with its Associated Uncertainty
- 1 June 2022
- Published by Springer Nature in Applied Physics A
- Vol. 128 (6) , 1-10
Substitution of excess Mn at Ni and Sn site in full-Heusler Mn2.4Ni0.8Sn0.8 alloy
- 1 June 2022
- Published by Springer Nature in Applied Physics A
- Vol. 128 (6) , 1-10
Substitution of excess Mn at Ni and Sn site in full-Heusler Mn2.4Ni0.8Sn0.8 alloy
- 7 November 2021
- Published by Springer Nature in Journal of Superconductivity and Novel Magnetism
- Vol. 35 (2) , 445-453
Disorder Induced Magnetic Behavior of Non-Stoichiometric Co0.75Mn0.5Fe0.75Si Full-Heusler Alloy
- 7 November 2021
- Published by Springer Nature in Journal of Superconductivity and Novel Magnetism
- Vol. 35 (2) , 445-453
Disorder Induced Magnetic Behavior of Non-Stoichiometric Co0.75Mn0.5Fe0.75Si Full-Heusler Alloy
- 1 January 2021
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 517, 167375
Electronic structure and magnetic properties of a full-Heusler Mn2NiSb: Cu2MnAl type structure
- 1 January 2021
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 517, 167375
Electronic structure and magnetic properties of a full-Heusler Mn2NiSb: Cu2MnAl type structure
- 20 May 2020
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 5 (21) , 11895-11900
Structural and Magnetic Properties of Ni1+xMnSb Bulk Heusler Composite Materials
Variation in structural and magnetic properties with changing valence electron count (VEC) has been studied well in the family of Heusler compounds, while such changes in VEC resulting in half-Heusler (HH) and full-Heusler (FH) composites have not been reported to observe their effect on the magnetic properties. Herein, we have synthesized the composite of HH and FH phases in Ni1+xMnSb (x = 0.0, 0.3, and 0.6) via changing VEC from 22 to 28 in order to investigate the structural and magnetic properties. Interestingly, a transition from half-metallic ferromagnetic to normal ferromagnetic was revealed in Ni1+xMnSb (x = 0.0, 0.3, and 0.6) materials with increasing VEC. The structural investigations of these materials were performed using a X-ray diffraction technique and analyzed by Rietveld Refinement software for all the samples. Rietveld analysis reveals the presence of a significant amount of the NiSb paramagnetic impurity phase in the HH NiMnSb system while in the case of Ni1+xMnSb (x = 0.3 and 0.6), no such impurity phase was observed. Only FH and HH phases in Ni1+xMnSb (x = 0.3 and 0.6) samples were noticed. The magnetic measurement performed on samples employing a vibrating sample magnetometer reveals the ferromagnetic ordering in all samples. A weak hysteresis loop with saturated magnetic moments ∼2.99 and 2.98 μB at room temperature was observed for NiMnSb and Ni1.3MnSb, respectively, while a strong hysteresis loop with lower magnetic moment of 0.88 μB was observed in the Ni1.6MnSb composite. Furthermore, the observed magnetic moments for the composite Ni1.3MnSb have been explained on the basis of the Slater–Pauling rule in relation to VEC.
- 20 May 2020
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 5 (21) , 11895-11900
Structural and Magnetic Properties of Ni1+xMnSb Bulk Heusler Composite Materials
Variation in structural and magnetic properties with changing valence electron count (VEC) has been studied well in the family of Heusler compounds, while such changes in VEC resulting in half-Heusler (HH) and full-Heusler (FH) composites have not been reported to observe their effect on the magnetic properties. Herein, we have synthesized the composite of HH and FH phases in Ni1+xMnSb (x = 0.0, 0.3, and 0.6) via changing VEC from 22 to 28 in order to investigate the structural and magnetic properties. Interestingly, a transition from half-metallic ferromagnetic to normal ferromagnetic was revealed in Ni1+xMnSb (x = 0.0, 0.3, and 0.6) materials with increasing VEC. The structural investigations of these materials were performed using a X-ray diffraction technique and analyzed by Rietveld Refinement software for all the samples. Rietveld analysis reveals the presence of a significant amount of the NiSb paramagnetic impurity phase in the HH NiMnSb system while in the case of Ni1+xMnSb (x = 0.3 and 0.6), no such impurity phase was observed. Only FH and HH phases in Ni1+xMnSb (x = 0.3 and 0.6) samples were noticed. The magnetic measurement performed on samples employing a vibrating sample magnetometer reveals the ferromagnetic ordering in all samples. A weak hysteresis loop with saturated magnetic moments ∼2.99 and 2.98 μB at room temperature was observed for NiMnSb and Ni1.3MnSb, respectively, while a strong hysteresis loop with lower magnetic moment of 0.88 μB was observed in the Ni1.6MnSb composite. Furthermore, the observed magnetic moments for the composite Ni1.3MnSb have been explained on the basis of the Slater–Pauling rule in relation to VEC.
- 1 May 2014
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 790-791, 503-508
Mechanical Behavior of Novel Suction Cast Ti-Cu-Fe-Co-Ni High Entropy Alloys
The present investigation reports mechanical properties of novel multicomponent TixCuyFe20Co20Ni20 high entropy alloys (HEAs) with different alloy chemistry (x/y = 1/3, 3/7, 3/5, 9/11, 1, 11/9 and 3/2). The alloy cylinders were prepared by vacuum arc melting-cum-suction casting route. The detailed electron microscopic observations reveal the presence of three different solid solution phases; FCC (a1) phase, FCC (a2) phase and BCC (b) phase for all the investigated alloys, whereas ultrafine eutectic between FCC (a1) phase, and Ti2 (Co, Ni) - type Laves phase has been observed for the HEAs with x/y = 9/11, 1, 11/9 and 3/2. Room temperature compression test of the suction cast cylinders with aspect ratio of 2/1 has been conducted to obtain mechanical properties of the HEAs. The optimum combination of strength (~ 1.88 GPa) and plasticity (~ 21 %) is obtained for x/y = 9/11; indicating simultaneous improvement of strength as well as plasticity of the novel HEAs. Fractographic analysis of the fractured surfaces reveals mixed mode of fracture for x/y = 1/3, 3/7 and 3/5, ductile mode for x/y = 9/11 and 1, whereas brittle mode of fracture for x/y = 11/9 and 3/2.
- 1 May 2014
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 790-791, 503-508
Mechanical Behavior of Novel Suction Cast Ti-Cu-Fe-Co-Ni High Entropy Alloys
The present investigation reports mechanical properties of novel multicomponent TixCuyFe20Co20Ni20 high entropy alloys (HEAs) with different alloy chemistry (x/y = 1/3, 3/7, 3/5, 9/11, 1, 11/9 and 3/2). The alloy cylinders were prepared by vacuum arc melting-cum-suction casting route. The detailed electron microscopic observations reveal the presence of three different solid solution phases; FCC (a1) phase, FCC (a2) phase and BCC (b) phase for all the investigated alloys, whereas ultrafine eutectic between FCC (a1) phase, and Ti2 (Co, Ni) - type Laves phase has been observed for the HEAs with x/y = 9/11, 1, 11/9 and 3/2. Room temperature compression test of the suction cast cylinders with aspect ratio of 2/1 has been conducted to obtain mechanical properties of the HEAs. The optimum combination of strength (~ 1.88 GPa) and plasticity (~ 21 %) is obtained for x/y = 9/11; indicating simultaneous improvement of strength as well as plasticity of the novel HEAs. Fractographic analysis of the fractured surfaces reveals mixed mode of fracture for x/y = 1/3, 3/7 and 3/5, ductile mode for x/y = 9/11 and 1, whereas brittle mode of fracture for x/y = 11/9 and 3/2.