Tatsushi Saito
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Tatsushi Saito has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
Atsutomo Nakamura
Department of Materials Physics Nagoya University Nagoya Japan
1 shared publication- Atsutomo Nakamura
Department of Mechanical Science and Bioengineering The University of Osaka Toyonaka Japan
1 shared publication Katsuyuki Matsunaga
Department of Materials Physics Nagoya University Nagoya Japan
1 shared publication- Katsuyuki Matsunaga
Nagoya University
1 shared publication Tatsuya Yokoi
Department of Materials Physics Nagoya University Nagoya Japan
1 shared publication- Tatsuya Yokoi
Department of Materials Physics, Nagoya University, Nagoya 464-8603, Japan
1 shared publication
Latest Publications
- Open Access
- 18 October 2021
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 11 (54) , 34004-34014
First-principles based theoretical calculations of atomic structures of hydroxyapatite surfaces and their charge states in contact with aqueous solutions
Surface charge states of biomaterials are often important for the adsorption of cells, proteins, and foreign ions on their surfaces, which should be clarified at the atomic and electronic levels. First-principles calculations were performed to reveal thermodynamically stable surface atomic structures and their charge states in hydroxyapatite (HAp). Effects of aqueous environments on the surface stability were considered using an implicit solvation model. It was found that in an air atmosphere, stoichiometric {0001} and P-rich {100} surfaces are energetically favorable, whereas in an aqueous solution, a Ca-rich {100} surface is the most stable. This difference suggests that preferential surface structures strongly depend on chemical environments with and without aqueous solutions. Their surface potentials at zero charge were calculated to obtain the isoelectric points (pHPZC). pHPZC values for the {0001} surface and the Ca-rich {100} surface were obtained to be 4.8 and 8.7, respectively. This indicates that in an aqueous solution at neutral pH, the {0001} and Ca-rich {100} surfaces are negatively and positively charged, respectively. This trend agrees with experimental data from chromatography and zeta potential measurements. Our methodology based on first-principles calculations enables determining macroscopic charge states of HAp surfaces from atomic and electronic levels.
- 18 October 2021
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 11 (54) , 34004-34014
Open AccessFirst-principles based theoretical calculations of atomic structures of hydroxyapatite surfaces and their charge states in contact with aqueous solutions
Surface charge states of biomaterials are often important for the adsorption of cells, proteins, and foreign ions on their surfaces, which should be clarified at the atomic and electronic levels. First-principles calculations were performed to reveal thermodynamically stable surface atomic structures and their charge states in hydroxyapatite (HAp). Effects of aqueous environments on the surface stability were considered using an implicit solvation model. It was found that in an air atmosphere, stoichiometric {0001} and P-rich {100} surfaces are energetically favorable, whereas in an aqueous solution, a Ca-rich {100} surface is the most stable. This difference suggests that preferential surface structures strongly depend on chemical environments with and without aqueous solutions. Their surface potentials at zero charge were calculated to obtain the isoelectric points (pHPZC). pHPZC values for the {0001} surface and the Ca-rich {100} surface were obtained to be 4.8 and 8.7, respectively. This indicates that in an aqueous solution at neutral pH, the {0001} and Ca-rich {100} surfaces are negatively and positively charged, respectively. This trend agrees with experimental data from chromatography and zeta potential measurements. Our methodology based on first-principles calculations enables determining macroscopic charge states of HAp surfaces from atomic and electronic levels.
- 22 May 2020
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 103 (9) , 5354-5364
Formation energies and site preference of substitutional divalent cations in carbonated apatite
First‐principles calculations were performed to examine defect formation energies and site preference of substitutional divalent cations M 2+ (M = Mg, Cu, Zn, Cd, Sr, Pb, and Ba) in hydroxyapatite (HAp, Ca 10 (PO 4 ) 6 (OH) 2 ) and carbonated apatite (CAp). All inequivalent substitutional sites of and M 2+ were investigated to determine their most preferential sites. For all M 2+ studied, their defect formation energies for the most stable substitutional sites were lower in CAp than in hydroxyapatite (HAp), demonstrating that M 2+ are preferentially substituted into CAp over HAp. For Ca sites in CAp, correlations between the defect formation energies and Ca‐O bond lengths showed that bigger and smaller M 2+ than Ca 2+ are preferentially substituted for Ca sites with longer and shorter bond lengths than those in HAp, respectively. In addition, Ca sites with lower coordination numbers than 6 are preferentially substituted by Zn 2+ and Cu 2+ that originally tend to form 4‐ or 5‐fold coordination in their phosphate crystals. substitution is therefore likely to effectively stabilize substitutional foreign ions by modifying bond lengths and coordination numbers of Ca sites from those in pure HAp. These effects may play an important role in enhancing the M 2+ solubility into CAp.
- 22 May 2020
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 103 (9) , 5354-5364
Formation energies and site preference of substitutional divalent cations in carbonated apatite
First‐principles calculations were performed to examine defect formation energies and site preference of substitutional divalent cations M 2+ (M = Mg, Cu, Zn, Cd, Sr, Pb, and Ba) in hydroxyapatite (HAp, Ca 10 (PO 4 ) 6 (OH) 2 ) and carbonated apatite (CAp). All inequivalent substitutional sites of and M 2+ were investigated to determine their most preferential sites. For all M 2+ studied, their defect formation energies for the most stable substitutional sites were lower in CAp than in hydroxyapatite (HAp), demonstrating that M 2+ are preferentially substituted into CAp over HAp. For Ca sites in CAp, correlations between the defect formation energies and Ca‐O bond lengths showed that bigger and smaller M 2+ than Ca 2+ are preferentially substituted for Ca sites with longer and shorter bond lengths than those in HAp, respectively. In addition, Ca sites with lower coordination numbers than 6 are preferentially substituted by Zn 2+ and Cu 2+ that originally tend to form 4‐ or 5‐fold coordination in their phosphate crystals. substitution is therefore likely to effectively stabilize substitutional foreign ions by modifying bond lengths and coordination numbers of Ca sites from those in pure HAp. These effects may play an important role in enhancing the M 2+ solubility into CAp.