Tattiana Enrich-Essvein
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Tattiana Enrich-Essvein has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Alejandro B. Rodríguez Navarro
Departamento de Mineralogía y Petrología, Universidad de Granada, Granada, Spain
2 shared publications Alejandro B. Rodríguez-Navarro
Department of Mineralogy and Petrology, Faculty of Sciences, University of Granada, Spain
2 shared publications- Carolina Cifuentes-Jiménez
Universidad de Granada, España
2 shared publications - Cristiane Meira Assunção
Department of Pediatric Dentistry, School of Dentistry Federal University of Minas Gerais (UFMG) Belo Horizonte Brazil
2 shared publications - María Victoria Bolaños-Carmona
Universidad de Granada, España
2 shared publications Nicole Marchioro dos Santos
Dr. Santos is a PhD student, Department of Surgery and Orthopedics, School of Dentistry, Federal University of Rio Grande do Sul, Porto Alegre, Rio Grande do Sul, Brazil
2 shared publications
Latest Publications
- Open Access
- 25 March 2026
- Published by Elsevier in Poultry Science
- Vol. 105 (6) , 106859
Variation in cranial and caudal keel bone composition and its association with keel damage severity in laying hens
- 25 March 2026
- Published by Elsevier in Poultry Science
- Vol. 105 (6) , 106859
Open AccessVariation in cranial and caudal keel bone composition and its association with keel damage severity in laying hens
- Open Access
- 1 January 2026
- Published by FapUNIFESP (SciELO) in Journal of Applied Oral Science
- Vol. 34, e20250848
Polyphenol-functionalized silver nanoparticles promote differential remineralization and reinforcement of demineralized dentin
Silver nanoparticles (AgNPs) have gained relevance in restorative dentistry due to their antimicrobial and remineralizing properties. However, the role of AgNPs functionalized with different polyphenols in dentin remineralization remains insufficiently understood. Objectives This study aimed to synthesize and characterize AgNPs functionalized with crosslinking polyphenols extracted from grape seed extract (GSE) and green tea leaves (GT), and to evaluate their biocompatibility and their effects on the mechanical and physicochemical properties of demineralized dentin. Methodology AgNPs were characterized by TEM, XRD, TGA, and zeta potential analysis to determine particle morphology, crystalline structure, chemical composition, and surface charge. Biocompatibility was assessed using fibroblast cytotoxicity assays. In total, 40 human mid-coronal dentin specimens were randomly assigned to four groups (n=10): Control- (sound dentin), Control+ (pH-cycled dentin without treatment), AgGSE (pH-cycled + AgGSE, 1 min), and AgGT (pH-cycled + AgGT, 1 min). Treated dentin was analyzed by ATR-FTIR, XRD, TGA, and three-point bending tests. Results Both AgNPs were successfully synthesized and exhibited high biocompatibility. AgGSE demonstrated greater dentin matrix interaction, resulting in significantly higher flexural strength (p≤0.001). In contrast, AgGT induced pronounced remineralization with increased PO4/Amide I ratio (p=0.003) and CO3/PO4 ratios (p=0.007 by TGA; p=0.03 by ATR-FTIR), consistent with carbonated apatite deposition. Conclusions Green-synthesized AgNPs functionalized with GT or GSE promoted reinforcement and remineralization of demineralized dentin through distinct mechanisms of action. These findings highlight their potential as biocompatible agents for dental therapies.
- 1 January 2026
- Published by FapUNIFESP (SciELO) in Journal of Applied Oral Science
- Vol. 34, e20250848
Open AccessPolyphenol-functionalized silver nanoparticles promote differential remineralization and reinforcement of demineralized dentin
Silver nanoparticles (AgNPs) have gained relevance in restorative dentistry due to their antimicrobial and remineralizing properties. However, the role of AgNPs functionalized with different polyphenols in dentin remineralization remains insufficiently understood. Objectives This study aimed to synthesize and characterize AgNPs functionalized with crosslinking polyphenols extracted from grape seed extract (GSE) and green tea leaves (GT), and to evaluate their biocompatibility and their effects on the mechanical and physicochemical properties of demineralized dentin. Methodology AgNPs were characterized by TEM, XRD, TGA, and zeta potential analysis to determine particle morphology, crystalline structure, chemical composition, and surface charge. Biocompatibility was assessed using fibroblast cytotoxicity assays. In total, 40 human mid-coronal dentin specimens were randomly assigned to four groups (n=10): Control- (sound dentin), Control+ (pH-cycled dentin without treatment), AgGSE (pH-cycled + AgGSE, 1 min), and AgGT (pH-cycled + AgGT, 1 min). Treated dentin was analyzed by ATR-FTIR, XRD, TGA, and three-point bending tests. Results Both AgNPs were successfully synthesized and exhibited high biocompatibility. AgGSE demonstrated greater dentin matrix interaction, resulting in significantly higher flexural strength (p≤0.001). In contrast, AgGT induced pronounced remineralization with increased PO4/Amide I ratio (p=0.003) and CO3/PO4 ratios (p=0.007 by TGA; p=0.03 by ATR-FTIR), consistent with carbonated apatite deposition. Conclusions Green-synthesized AgNPs functionalized with GT or GSE promoted reinforcement and remineralization of demineralized dentin through distinct mechanisms of action. These findings highlight their potential as biocompatible agents for dental therapies.
- 1 September 2021
- Published by Elsevier in Dental Materials
- Vol. 37 (9) , 1437-1445
Proanthocyanidin-functionalized hydroxyapatite nanoparticles as dentin biomodifier
- 1 September 2021
- Published by Elsevier in Dental Materials
- Vol. 37 (9) , 1437-1445
Proanthocyanidin-functionalized hydroxyapatite nanoparticles as dentin biomodifier
- 27 May 2020
- Published by Springer Nature in Clinical Oral Investigations
- Vol. 25 (3) , 841-849
Influence of de-remineralization process on chemical, microstructural, and mechanical properties of human and bovine dentin
Objectives This study compared the chemical composition, microstructural, and mechanical properties of human and bovine dentin subjected to a demineralization/remineralization process. Materials and methods Human and bovine incisors were sectioned to obtain 120 coronal dentin beams (6 × 1 × 1 mm3) that were randomly allocated into 4 subgroups (n = 15) according to the time of treatment (sound, pH-cycling for 3, 7, and 14 days). Three-point bending mechanical test, attenuated total reflectance–Fourier transform infrared (ATR-FTIR), thermogravimetric (TG), and X-ray diffraction (XRD) techniques were employed to characterize the dentin samples. Results Regarding chemical composition at the molecular level, bovine sound dentin showed significantly lower values in organic and inorganic content (collagen cross-linking, CO3/amide I, and CO3/PO4; p = 0.002, p = 0.026, and p = 0.002, respectively) compared to humans. Employing XRD analyses, a higher mineral crystallinity in human dentin than in bovines at 7 and 14 days (p = 0.003 and p = 0.009, respectively) was observed. At the end of the pH-cycling, CI (ATR-FTIR) and CO3/PO4 ratios (ATR-FTIR) increased, while CO3/amide I (ATR-FTIR), PO4/amide I (ATR-FTIR), and %mineral (TG) ratios decreased. The extension by compression values increased over exposure time with significant differences between dentin types (p < 0.001, in all cases), reaching higher values in bovine dentin. However, flexural strength (MPa) did not show differences between groups. We also observed the correlation between compositional variables (i.e., PO4/amide I, CI, and %mineral) and the extension by compression. Conclusions Human and bovine dentin are different in terms of microstructure, chemical composition, mechanical strength, and in their response to the demineralization/remineralization process by pH-cycling. Clinical relevance These dissimilarities may constitute a potential limitation when replacing human teeth with bovines in in vitro studies.
- 27 May 2020
- Published by Springer Nature in Clinical Oral Investigations
- Vol. 25 (3) , 841-849
Influence of de-remineralization process on chemical, microstructural, and mechanical properties of human and bovine dentin
Objectives This study compared the chemical composition, microstructural, and mechanical properties of human and bovine dentin subjected to a demineralization/remineralization process. Materials and methods Human and bovine incisors were sectioned to obtain 120 coronal dentin beams (6 × 1 × 1 mm3) that were randomly allocated into 4 subgroups (n = 15) according to the time of treatment (sound, pH-cycling for 3, 7, and 14 days). Three-point bending mechanical test, attenuated total reflectance–Fourier transform infrared (ATR-FTIR), thermogravimetric (TG), and X-ray diffraction (XRD) techniques were employed to characterize the dentin samples. Results Regarding chemical composition at the molecular level, bovine sound dentin showed significantly lower values in organic and inorganic content (collagen cross-linking, CO3/amide I, and CO3/PO4; p = 0.002, p = 0.026, and p = 0.002, respectively) compared to humans. Employing XRD analyses, a higher mineral crystallinity in human dentin than in bovines at 7 and 14 days (p = 0.003 and p = 0.009, respectively) was observed. At the end of the pH-cycling, CI (ATR-FTIR) and CO3/PO4 ratios (ATR-FTIR) increased, while CO3/amide I (ATR-FTIR), PO4/amide I (ATR-FTIR), and %mineral (TG) ratios decreased. The extension by compression values increased over exposure time with significant differences between dentin types (p < 0.001, in all cases), reaching higher values in bovine dentin. However, flexural strength (MPa) did not show differences between groups. We also observed the correlation between compositional variables (i.e., PO4/amide I, CI, and %mineral) and the extension by compression. Conclusions Human and bovine dentin are different in terms of microstructure, chemical composition, mechanical strength, and in their response to the demineralization/remineralization process by pH-cycling. Clinical relevance These dissimilarities may constitute a potential limitation when replacing human teeth with bovines in in vitro studies.
- 1 January 2020
- Vol. 42 (1) , 47-52
Microshear Bond Strength of Adhesive Systems on Eroded Primary Enamel and Dentin
Purpose: Erosive tooth wear often leads to surface loss requiring restoration of primary teeth with adhesive materials. The purpose o f this study was to evaluate the microshear bond strength (mu SBS) of different adhesive systems to sound and eroded primary enamel and dentin surfaces. Methods: Half of the samples underwent erosion (immersion in Coca-Cola for one minute five times over five days) and abrasion cycles (brushing with an electric toothbrush, fluoride toothpaste slurry. for one minute at 250 g load). Samples were divided into adhesive groups (N equals 12): Adper Single Bond 2 (etch-and-rinse); Single Bond Universal (self-etch); Optibond FL (etch-and-rinse with fluoride); and Bond-Force (self-etch with fluoride). Resin composite was bonded on sample surfaces and subjected to mu SBS test. Data were analyzed by two-way analysis of variance, Tukey test, and chi-square test (P= 0.0.5) on mu SBS test. The failure mode evaluation showed significant differences between sound and eroded dentin (P=0.003) but no difference among the adhesives (P=0.177). Conclusions: Microshear bond strength in primary enamel and dentin was not affected by erosion/abrasion or type of adhesive system.
- 1 January 2020
- Vol. 42 (1) , 47-52
Microshear Bond Strength of Adhesive Systems on Eroded Primary Enamel and Dentin
Purpose: Erosive tooth wear often leads to surface loss requiring restoration of primary teeth with adhesive materials. The purpose o f this study was to evaluate the microshear bond strength (mu SBS) of different adhesive systems to sound and eroded primary enamel and dentin surfaces. Methods: Half of the samples underwent erosion (immersion in Coca-Cola for one minute five times over five days) and abrasion cycles (brushing with an electric toothbrush, fluoride toothpaste slurry. for one minute at 250 g load). Samples were divided into adhesive groups (N equals 12): Adper Single Bond 2 (etch-and-rinse); Single Bond Universal (self-etch); Optibond FL (etch-and-rinse with fluoride); and Bond-Force (self-etch with fluoride). Resin composite was bonded on sample surfaces and subjected to mu SBS test. Data were analyzed by two-way analysis of variance, Tukey test, and chi-square test (P= 0.0.5) on mu SBS test. The failure mode evaluation showed significant differences between sound and eroded dentin (P=0.003) but no difference among the adhesives (P=0.177). Conclusions: Microshear bond strength in primary enamel and dentin was not affected by erosion/abrasion or type of adhesive system.
- Open Access
- 18 January 2018
- Published by FapUNIFESP (SciELO) in Journal of Applied Oral Science
- Vol. 26, e20170053
Effect of erosive challenges on deciduous teeth undergoing restorative procedures with different adhesive protocols - an in vitro study
Keywords: Deciduous tooth; Erosive tooth wear; Adhesive; Tooth erosion; Tooth wear
- 18 January 2018
- Published by FapUNIFESP (SciELO) in Journal of Applied Oral Science
- Vol. 26, e20170053
Open AccessEffect of erosive challenges on deciduous teeth undergoing restorative procedures with different adhesive protocols - an in vitro study
Keywords: Deciduous tooth; Erosive tooth wear; Adhesive; Tooth erosion; Tooth wear