SIShuichi Ichikawa

Shuichi Ichikawa

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Shuichi Ichikawa has a total of 31 co-authors. Here are the top co-authors by number of shared publications:

  • Naoki Fujieda

    Department of Electrical and Electronic Information Engineering, Toyohashi University of Technology, Toyohashi, Aichi, Japan

    3 shared publications
  • Hiroyuki Sumino

    Department of Clinical Laboratory Medicine, Gunma University Graduate School of Medicine, Showamachi, Maebashi, Gunma 371-8511, Japan

    2 shared publications
  • Hisao Kumakura

    Department of Cardiovascular Medicine, Cardiovascular Hospital of Central Japan (Kitakanto Cardiovascular Hospital)

    2 shared publications
  • Yoshiaki Takayama

    Department of Cardiology, Cardiovascular Hospital of Central Japan (Kitakanto Cardiovascular Hospital), Gunma, Japan

    2 shared publications
  • Hiroshi Yamamoto

    Department of Knowledge-Based Information Engineering, Toyohashi University of Technology, 1-1 Hibarigaoka, Tempaku, Toyohashi 441-8580 Japan

    1 shared publication
  • Hisashi Hata

    Department of Knowledge-Based Information Engineering, Toyohashi University of Technology, 1-1 Hibarigaoka, Tempaku, Toyohashi 441-8580 Japan

    1 shared publication

Latest Publications

  • Open Access

    Performance Enhancement of the LFSR-Based Unpredictable Random Number Generator in Rocket Core

    by Takayoshi Shikano, Shuichi Ichikawa

    Masaoka et al. introduced an unpredictable random number generator (URNG) using a linear feedback shift register (LFSR) embedded within the CPU. Subsequent work by Kamogari and Ichikawa elucidated the LFSR requirements and the minimal essential period to pass the Diehard test. In this study we investigate a Rocket Core with a built-in LFSR, which was designed according to the results of preceding studies. By sampling the lower 32 bits of the 128-bit LFSR, a random number sequence was generated at a rate of 49.4 Mbit/s on a 50-MHz Rocket Core. The derived random sequence passed both the Diehard and NIST tests. Furthermore, we propose to replace an LFSR with a Leap-ahead LFSR, which applies its characteristic polynomial 32 times in a cycle. This improvement results in a significantly greater generation rate of 451 Mbit/s, while maintaining compliance with the Diehard and the NIST tests. The resource overhead of this URNG is negligible compared to the logic scale of the base system (LiteX/Rocket). Considering its low cost, high generation rate, high randomness quality, and ease of use, the proposed design is regarded to be a promising RNG support solution for a wide range of processors.

  • Open Access

    Design and Implementation of an On-Line Quality Control System for Latch-Based True Random Number Generator

    by Naoki Fujieda, Shuichi Ichikawa, Ryusei Oya, Hitomi Kishibe

    This paper presents a design and an implementation of an on-line quality control method for a TRNG (True Random Number Generator) on an FPGA. It is based on a TRNG with RS latches and a temporal XOR corrector, which can make a trade-off between throughput and randomness quality by changing the number of accumulations by XOR. The goal of our method is to increase the throughput within the range of keeping the quality of output random numbers. In order to detect a sign of the loss of quality from the TRNG in parallel with random number generation, our method distinguishes random bitstrings to be tested from those to be output. The test bitstring is generated with the fewer number of accumulations than that of the output bitstring. The number of accumulations will be increased if the test bitstring fails in the randomness test. We designed and evaluated a prototype of on-line quality control system, using a Zynq-7000 FPGA SoC. The results indicate that the TRNG with the proposed method achieved 1.91-2.63 Mbits/s of throughput with 16 latches, following the change of the quality of output random numbers. The total number of logic elements in the prototype system with 16 latches was comparable to an existing system with 256 latches, without quality control capabilities.

  • Open Access

    Message from the Organizers

    by Jacir L. Bordim, Shûichi Ichikawa, Satoshi Fujita

    Presents the introductory welcome message from the conference proceedings. May include the conference officers' congratulations to all involved with the conference event and publication of the proceedings record.

  • A true random number generator that utilizes thermal noise in a programmable system‐on‐chip (PSoC)

    by Shunsuke Matsuoka, Shuichi Ichikawa, Naoki Fujieda

    Summary: This study presents four designs for a true random number generator (TRNG) for Cypress programmable system‐on‐chip (SoC) (PSoC) devices, whose entropy source is the thermal noise of resistors. The first design includes a ΔΣ analog‐to‐digital converter (ADC) with two external resistors of 6 MΩ, where the resolution was set to 16 bits. The second, third, and fourth designs adopt the internal resistors of a programmable gain amplifier (PGA) as a noise source. The second design adopts a single‐stage PGA (gain 50) with a ΔΣ ADC, while the third design adopts a two‐stage PGA (gain 50 × 50) with a ΔΣ ADC. The fourth design adopts a trans‐impedance amplifier (TIA) with a ΔΣ ADC. All four designs have passed the National Institute of Standards and Technology (NIST) test suite.


  • An Analysis of DCM-Based True Random Number Generator

    by Naoki Fujieda, Masaaki Takeda, Shuichi Ichikawa

    A TRNG (True Random Number Generator) using DCM blocks of a Xilinx FPGA has advantages of minimal usage of logic elements and tunability of clock frequencies to search for better randomness. Its operating principle is Beat Frequency Detection, which uses the LSBs of a counter that counts the number of successive logic-ones captured by a D flip-flop. In this paper, we evaluate the DCM-based TRNG with 100 frequency pairs. The findings of this work include that (1) only 12 frequency pairs passed the diehard statistical tests when three LSBs were extracted as directed in the previous work, (2) the value of the counter exhibits biphasic histograms, (3) small counter values show less uncertainty, and (4) the number of frequency pairs that passed the tests was doubled to 24 by extracting only one LSB from small counter values, with a 16.9% reduction in the generation rate.


  • An FPGA implementation of hard‐wired sequence control system based on PLC software

    by Shuichi Ichikawa, Masanori Akinaka, Hisashi Hata, Ryo Ikeda, Hiroshi Yamamoto

    Although a programmable logic controller (PLC) has been widely adopted for the sequence control of industrial machinery, its performance does not always satisfy the recent requirements in large and highly responsive systems. With the state‐of‐the‐art field programmable gate array (FPGA) technology, it is possible to implement a control program with hard‐wired logic for higher response and reduced implementation cost/space. This approach is also worthwhile for transmigration of legacy PLC software into forthcoming FPGA‐based control hardware. This study presents a systematic method to implement a hard‐wired sequence control from PLC software. PLC instructions are converted into VHDL codes, and then implemented as logic circuit with various peripheral functions. Productive PLC programs were examined with Mitsubishi Electric FX2N PLC and Altera Stratix II FPGA, and were shown to fit into a common FPGA chip. A straightforward Sequential design was estimated to be 184 times faster than PLC, while a performance‐oriented Flat design was estimated to be 44 times faster than Sequential design (i.e., 8050 times faster than PLC). A practical perfect layer winder system was actually built and successfully operated with our FPGA control board, whose logic design was implemented with our tools. © 2011 Institute of Electrical Engineers of Japan. Published by John Wiley & Sons, Inc.


  • Effects of spironolactone on cardiac sympathetic nerve activity and left ventricular remodelling after reperfusion therapy in patients with first ST-segment elevation myocardial infarction

    by Shu Kasama, Takuji Toyama, Hiroyuki Sumino, Hisao Kumakura, Yoshiaki Takayama, Kazutomo Minami, Shuichi Ichikawa, Naoya Matsumoto, Yuichi Sato, Masahiko Kurabayashi

    Objective To evaluate the effects of spironolactone on cardiac sympathetic nerve activity (CSNA) and left ventricular (LV) remodelling in patients with ST-segment elevation myocardial infarction (STEMI). Design Single-centre, prospective, randomised evaluation study. Setting Patients with a first STEMI and single-vessel disease undergoing primary coronary angioplasty. Patients Sixty patients randomly assigned to two groups before angioplasty. Interventions Patients were randomly assigned to receive or not the spironolactone before primary coronary angioplasty. Main outcome The extent score (ES) was determined by use of 99mTc-pyrophosphate scintigraphy to evaluate the area of initial myocardial damage 3–5 days after primary angioplasty. The LV end-diastolic volume (LVEDV), LV end-systolic volume (LVESV) and LV ejection fraction were determined by echocardiography, and plasma procollagen type III aminoterminal peptide (PIIINP) was measured before and 3 weeks after treatments. The delayed heart/mediastinum count (H/M) ratio, delayed total defect score (TDS) and washout rate (WR) were determined from 123I-meta-iodobenzylguanidine scintigraphy after 3 weeks. Results After primary angioplasty, age, gender, risk factors, culprit coronary artery, peak serum creatine kinase concentration, recanalisation time and ES were similar in the two groups. However, in the spironolactone group, the TDS and WR were significantly lower (TDS: mean (SD) 22.5 (8.0) vs 29.5 (10.1), pConclusion Administration of spironolactone improves CSNA and prevents LV remodelling in patients with a first STEMI.


  • Open Access

    Acute Myocardial Infarction Due to Vasospasm in a 13-Year-Old Boy

    by Tsutomu Hosoi, Yukio Koyama, Shouichi Tange, Hiroyuki Sumino, Yasushi Kawai, Hisao Kumakura, Yoshiaki Takayama, Shuichi Ichikawa, Susumu Imai, Tadashi Suzuki

    We describe an unusual case of acute myocardial infarction due to vasospasm in a 13-year-old boy. He was admitted to our hospital with severe congestive heart failure and shock. He had experienced a feeling of chest oppression with dyspnea while running, which grew worse. He then lost consciousness and was brought by ambulance to our intensive care unit. He had had similar but milder episodes of chest oppression months earlier. The family history revealed that his father had died suddenly from hypertrophic cardiomyopathy and that his grandmother also had hypertrophic cardiomyopathy. On admission, the patient was bathed in a cold sweat, his pulse was weak, and his blood pressure was too low to measure. Coarse crackling and wheezing were audible in both lung fields. Administration of catecholamine and intra-aortic balloon pumping failed to stabilize the hemodynamic variables, but percutaneous cardiopulmonary support proved to be lifesaving. Coronary arteriography performed during his convalescence showed no evidence of atherosclerosis. The acetylcholine provocation test ultimately revealed a diagnosis of acute myocardial infarction due to vasospasm. (Jpn Circ J 1997; 61: 536 - 542)