Amalio Garrido Escudero
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Amalio Garrido Escudero has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Alfonso Pérez-Garrido
Cátedra de Ingeniería y Toxicología Ambiental, Universidad Cátolica San Antonio, Guadalupe, Murcia, Spain
5 shared publications - Aliuska Morales Helguera
Center of Chemical Bioactives, University of Las Villas, Santa Clara 54838, Cuba
4 shared publications - Maria Natalia Dias Soeiro Cordeiro
University of Porto
4 shared publications Adela Abellán Guillén
1 shared publication- Ana Balea
Department of Chemical Engineering and Materials, Universidad Complutense de Madrid, Av. Complutense s/n, 28040 Madrid, Spain
1 shared publication - Angeles Blanco
Department of Chemical Engineering and Materials, University Complutense of Madrid, Madrid, Spain
1 shared publication
Latest Publications
- Open Access
Modelling the Mineralization of Formaldehyde by Treatment with Nitric Acid
Formaldehyde is a recalcitrant pollutant, which is difficult to remove from wastewater using conventional and advanced treatments. The objective of this research was to remove the organic matter from formaldehyde from an industrial wastewater, achieving its total mineralization and allowing the reuse of the water. The treatment was based on the reaction of formaldehyde with nitric acid, which was first studied and modelled with synthetic waters. Results show that it was possible to almost completely mineralize the formaldehyde (>95% TOC removal) at the best conditions studied (1.72 M of nitric acid and 85 °C of temperature). The addition of NaNO2 accelerated this reaction; however, after 2 h of reaction time, its effect was negligible at the maximum concentration of HNO3 studied. The results obtained with industrial wastewater fit well with the model. It is concluded that formaldehyde in actual wastewaters can be successfully removed through direct mineralization with nitric acid, under selected conditions.
Open AccessModelling the Mineralization of Formaldehyde by Treatment with Nitric Acid
Formaldehyde is a recalcitrant pollutant, which is difficult to remove from wastewater using conventional and advanced treatments. The objective of this research was to remove the organic matter from formaldehyde from an industrial wastewater, achieving its total mineralization and allowing the reuse of the water. The treatment was based on the reaction of formaldehyde with nitric acid, which was first studied and modelled with synthetic waters. Results show that it was possible to almost completely mineralize the formaldehyde (>95% TOC removal) at the best conditions studied (1.72 M of nitric acid and 85 °C of temperature). The addition of NaNO2 accelerated this reaction; however, after 2 h of reaction time, its effect was negligible at the maximum concentration of HNO3 studied. The results obtained with industrial wastewater fit well with the model. It is concluded that formaldehyde in actual wastewaters can be successfully removed through direct mineralization with nitric acid, under selected conditions.
- 6 November 2015
- Published by American Chemical Society (ACS) in Journal of Chemical Education
- Vol. 93 (1) , 103-110
Chemistry and Explosives: An Approach to the Topic through an Artistic and Historical Contribution Made by a Spanish Global Explosives Supplier
- 6 November 2015
- Published by American Chemical Society (ACS) in Journal of Chemical Education
- Vol. 93 (1) , 103-110
Chemistry and Explosives: An Approach to the Topic through an Artistic and Historical Contribution Made by a Spanish Global Explosives Supplier
- 31 July 2013
- Published by American Chemical Society (ACS) in Journal of Chemical Education
- Vol. 90 (9) , 1196-1199
Using a Hands-On Method To Help Students Learn Inorganic Chemistry Nomenclature via Assembly of Two-Dimensional Shapes
- 31 July 2013
- Published by American Chemical Society (ACS) in Journal of Chemical Education
- Vol. 90 (9) , 1196-1199
Using a Hands-On Method To Help Students Learn Inorganic Chemistry Nomenclature via Assembly of Two-Dimensional Shapes
- 17 September 2011
- Published by American Chemical Society (ACS) in Journal of Chemical Information and Modeling
- Vol. 51 (10) , 2746-2759
Two New Parameters Based on Distances in a Receiver Operating Characteristic Chart for the Selection of Classification Models
There are several indices that provide an indication of different types on the performance of QSAR classification models, being the area under a Receiver Operating Characteristic (ROC) curve still the most powerful test to overall assess such performance. All ROC related parameters can be calculated for both the training and test sets, but, nevertheless, neither of them constitutes an absolute indicator of the classification performance by themselves. Moreover, one of the biggest drawbacks is the computing time needed to obtain the area under the ROC curve, which naturally slows down any calculation algorithm. The present study proposes two new parameters based on distances in a ROC curve for the selection of classification models with an appropriate balance in both training and test sets, namely the following: the ROC graph Euclidean distance (ROCED) and the ROC graph Euclidean distance corrected with Fitness Function (FIT(λ)) (ROCFIT). The behavior of these indices was observed through the study on the mutagenicity for four genotoxicity end points of a number of nonaromatic halogenated derivatives. It was found that the ROCED parameter gets a better balance between sensitivity and specificity for both the training and prediction sets than other indices such as the Matthews correlation coefficient, the Wilk’s lambda, or parameters like the area under the ROC curve. However, when the ROCED parameter was used, the follow-on linear discriminant models showed the lower statistical significance. But the other parameter, ROCFIT, maintains the ROCED capabilities while improving the significance of the models due to the inclusion of FIT(λ).
- 17 September 2011
- Published by American Chemical Society (ACS) in Journal of Chemical Information and Modeling
- Vol. 51 (10) , 2746-2759
Two New Parameters Based on Distances in a Receiver Operating Characteristic Chart for the Selection of Classification Models
There are several indices that provide an indication of different types on the performance of QSAR classification models, being the area under a Receiver Operating Characteristic (ROC) curve still the most powerful test to overall assess such performance. All ROC related parameters can be calculated for both the training and test sets, but, nevertheless, neither of them constitutes an absolute indicator of the classification performance by themselves. Moreover, one of the biggest drawbacks is the computing time needed to obtain the area under the ROC curve, which naturally slows down any calculation algorithm. The present study proposes two new parameters based on distances in a ROC curve for the selection of classification models with an appropriate balance in both training and test sets, namely the following: the ROC graph Euclidean distance (ROCED) and the ROC graph Euclidean distance corrected with Fitness Function (FIT(λ)) (ROCFIT). The behavior of these indices was observed through the study on the mutagenicity for four genotoxicity end points of a number of nonaromatic halogenated derivatives. It was found that the ROCED parameter gets a better balance between sensitivity and specificity for both the training and prediction sets than other indices such as the Matthews correlation coefficient, the Wilk’s lambda, or parameters like the area under the ROC curve. However, when the ROCED parameter was used, the follow-on linear discriminant models showed the lower statistical significance. But the other parameter, ROCFIT, maintains the ROCED capabilities while improving the significance of the models due to the inclusion of FIT(λ).
- 1 January 2010
- Published by Elsevier in Toxicology
- Vol. 268 (1-2) , 64-77
A topological substructural molecular design approach for predicting mutagenesis end-points of , -unsaturated carbonyl compounds- 1 January 2010
- Published by Elsevier in Toxicology
- Vol. 268 (1-2) , 64-77
A topological substructural molecular design approach for predicting mutagenesis end-points of , -unsaturated carbonyl compounds- 1 December 2009
- Published by Elsevier in Journal of Pharmaceutical Sciences
- Vol. 98 (12) , 4557-4576
QSPR modelling with the topological substructural molecular design approach: β-cyclodextrin complexation
- 1 December 2009
- Published by Elsevier in Journal of Pharmaceutical Sciences
- Vol. 98 (12) , 4557-4576
QSPR modelling with the topological substructural molecular design approach: β-cyclodextrin complexation
- 1 January 2009
- Published by Elsevier in Bioorganic & Medicinal Chemistry
- Vol. 17 (2) , 896-904
Convenient QSAR model for predicting the complexation of structurally diverse compounds with β-cyclodextrins
- 1 January 2009
- Published by Elsevier in Bioorganic & Medicinal Chemistry
- Vol. 17 (2) , 896-904
Convenient QSAR model for predicting the complexation of structurally diverse compounds with β-cyclodextrins
- 1 May 2008
- Published by Elsevier in Bioorganic & Medicinal Chemistry
- Vol. 16 (10) , 5720-5732
Halogenated derivatives QSAR model using spectral moments to predict haloacetic acids (HAA) mutagenicity
- 1 May 2008
- Published by Elsevier in Bioorganic & Medicinal Chemistry
- Vol. 16 (10) , 5720-5732
Halogenated derivatives QSAR model using spectral moments to predict haloacetic acids (HAA) mutagenicity
- 1 April 2003
- Published by Taylor & Francis in Communications in Soil Science and Plant Analysis
- Vol. 34 (7-8) , 957-971
Bioremediation of Sewage Sludge by Composting
Sewage sludge used as soil organic amendment can positively affect soil physical, chemical, and biological properties. This organic material may be a solution for improving the low organic matter content of Mediterranean soils. However, the addition of sewage sludge to soils have not always shown positive effects, probably due to the particular characteristics of the residues concerned: high heavy metal or phytotoxic substance content, excess of labile organic matter, pathogenic microorganisms, etc. Composting process can be a useful tool to eliminate some of these problems. In the present work, a sewage sludge mixed with wood shaving as bulking agent has been composted. During this process, a decrease of organic matter fractions due to organic matter mineralization was observed. Fresh sewage sludge contained high numbers of pathogen microorganisms but when this material was submitted to composting process microorganisms decreased to suitable level. Organic compounds such as pesticide residues can also be...
- 1 April 2003
- Published by Taylor & Francis in Communications in Soil Science and Plant Analysis
- Vol. 34 (7-8) , 957-971
Bioremediation of Sewage Sludge by Composting
Sewage sludge used as soil organic amendment can positively affect soil physical, chemical, and biological properties. This organic material may be a solution for improving the low organic matter content of Mediterranean soils. However, the addition of sewage sludge to soils have not always shown positive effects, probably due to the particular characteristics of the residues concerned: high heavy metal or phytotoxic substance content, excess of labile organic matter, pathogenic microorganisms, etc. Composting process can be a useful tool to eliminate some of these problems. In the present work, a sewage sludge mixed with wood shaving as bulking agent has been composted. During this process, a decrease of organic matter fractions due to organic matter mineralization was observed. Fresh sewage sludge contained high numbers of pathogen microorganisms but when this material was submitted to composting process microorganisms decreased to suitable level. Organic compounds such as pesticide residues can also be...
- 1 January 1986
- Published by Elsevier in Analytica Chimica Acta
- Vol. 184, 227-234
Determination of iodate and periodate at the microgram level by a kinetic method
- 1 January 1986
- Published by Elsevier in Analytica Chimica Acta
- Vol. 184, 227-234
Determination of iodate and periodate at the microgram level by a kinetic method