Hans Brouwer

In the pre-reduction cyclone of the HIsarna process, both thermal decomposition and gas reduction of the injected iron ores occur simultaneously at gas temperatures of 1723–1773 K. In this study, the kinetics of the thermal decomposition of three iron ores (namely OreA, OreB and OreC) for HIsarna ironmaking were analysed as an isolated process with a symmetrical thermogravimetric analyser (TGA) under an inert atmosphere. Using various methods, the chemical and mineralogical composition, particle size distribution, morphology and phase distribution of the ores were analysed. The ores differ in their mineralogy and morphology, where OreA only contains hematite as iron-bearing phase and OreB and OreC include goethite and hematite. To obtain the kinetic parameters in non-isothermal conditions, the Coats–Redfern Integral Method was applied for heating rates of 1, 2 and 5 K/min and a maximum temperature of 1773 K. The TGA results indicate that goethite and hematite decomposition occur as a two-stage process in an inert atmosphere of Ar. The proposed reaction mechanism for the first stage of goethite decomposition is chemical reaction with an activation energy ranging from 46.55 to 60.38 kJ/mol for OreB and from 69.90 to 134.47 kJ/mol for OreC. The proposed reaction mechanism for the second stage of goethite decomposition is diffusion, showing an activation energy ranging between 24.43 and 44.76 kJ/mol for OreB and between 3.32 and 23.29 kJ/mol for OreC. In terms of hematite decomposition, only the first stage was analysed. The proposed reaction mechanism is chemical reaction control. OreA shows an activation energy of 545.47 to 670.50 kJ/mol, OreB one of 587.68 to 831.54 kJ/mol and OreC one of 424.31 to 592.32 kJ/mol.

Since the oxidation reactions in the process of steel production occur in harsh conditions (i.e., high temperatures and gas atmospheres), it is practically impossible to observe in situ the compositional changes in the steel and the formed oxide scale. Hence, a coupled thermodynamic-kinetic numerical model is developed that predicts the formation of oxide phases and the composition profile of the steel alloy’s constituents in a short time due to external oxidation. The model is applied to high-temperature oxidation of Fe–Mn alloys under different conditions. Oxidizing experiments executed with a thermogravimetric analyzer (TGA) on Fe–Mn alloys with different Mn contents (below 10 wt %) are used to determine kinetic parameters that serve as an input for the model. The mass gain data as a function of time show both linear and parabolic regimes. The results of the numerical simulations are presented. The effect of different parameters, such as temperature, Mn content of the alloy, oxygen partial pressure, and oxidizing gas flow rate on the alloy composition and oxide phases formed, is determined. It is shown that increasing the temperature and decreasing the oxygen partial pressure both lead to a thicker depleted area.

Pulsed laser beam welding was used successfully to join the oxide dispersion-strengthened (ODS) Eurofer steel. The joining was conducted with a laser power of 2500 W and a pulsed duration of 4 ms. With the filler material being used, a minor material loss and microvoids were observed in the joint. The microstructure of the fusion zone consists of dual phase elongated structures. The heat-affected zone has a width of around 0.06 mm with finer grains. The transmission electron microscopy observation reveals that nanoprecipitates are finely distributed in the fusion zone. The tensile strength, yield strength and elongation of the joint are slightly inferior to the base material. The fractography results reveal a typical ductile fracture. The experimental results indicate a reasonable joint from the perspective of both the microstructure and mechanical behaviour.