Rebecca Brown
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Rebecca Brown has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
Robert Content
Australian Astronomical Observatory (Australia)
2 shared publicationsRoss Zhelem
Australian Astronomical Observatory (Australia)
2 shared publicationsAdeline Wang
The Univ. of Sydney (Australia)
1 shared publication- Andrew M. Hopkins
Macquarie University
1 shared publication - Craig Glennie
Department of Civil and Environmental Engineering, University of Houston, Houston, TX, USA
1 shared publication - David M. Brown
Australian Astronomical Observatory (Australia)
1 shared publication
Latest Publications
- Open Access
- 22 February 2020
- Published by MDPI AG in Remote Sensing
- Vol. 12 (4) , 722
Evaluation of SPL100 Single Photon Lidar Data
Geiger-mode and single photon lidar sensors have recently emerged on the commercial market, advertising greater collection efficiency than the traditional linear mode lidar (LML) systems. Non-linear photon detection is a new technology for the geospatial community, and its performance characteristics for surveying and mapping are not yet well understood. Therefore, the geospatial quality of the data produced by one of these new sensors, the Leica SPL100, is examined by comparing the achieved lidar point cloud accuracy, precision, digital elevation model (DEM) generation, canopy penetration, and multiple return generation to a LML point cloud. We find the SPL100 has a lower ranging precision than linear mode lidar and that the precision is more negatively affected by surface properties such as low intensity and high incidence angle. The accuracy of the SPL100 point cloud, however, was found to be comparable to LML for smooth horizontal surfaces. A 1 m resolution SPL100 DEM was also comparable to a corresponding LML DEM, but the SPL100 was observed to have a reduced ability to resolve multiple returns through vegetation when compared to a LML sensor. In its current state, the SPL100 is likely best suited for applications in which the need for collection efficiency outweighs the need for maximum precision and canopy penetration and modeling.
- 22 February 2020
- Published by MDPI AG in Remote Sensing
- Vol. 12 (4) , 722
Open AccessEvaluation of SPL100 Single Photon Lidar Data
Geiger-mode and single photon lidar sensors have recently emerged on the commercial market, advertising greater collection efficiency than the traditional linear mode lidar (LML) systems. Non-linear photon detection is a new technology for the geospatial community, and its performance characteristics for surveying and mapping are not yet well understood. Therefore, the geospatial quality of the data produced by one of these new sensors, the Leica SPL100, is examined by comparing the achieved lidar point cloud accuracy, precision, digital elevation model (DEM) generation, canopy penetration, and multiple return generation to a LML point cloud. We find the SPL100 has a lower ranging precision than linear mode lidar and that the precision is more negatively affected by surface properties such as low intensity and high incidence angle. The accuracy of the SPL100 point cloud, however, was found to be comparable to LML for smooth horizontal surfaces. A 1 m resolution SPL100 DEM was also comparable to a corresponding LML DEM, but the SPL100 was observed to have a reduced ability to resolve multiple returns through vegetation when compared to a LML sensor. In its current state, the SPL100 is likely best suited for applications in which the need for collection efficiency outweighs the need for maximum precision and canopy penetration and modeling.
- 6 July 2018
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10702, 53
Hector: a modular integral field spectrograph instrument for the Anglo-Australian Telescope
Based on the success of the SAMI integral field spectrograph (IFS) instrument on the Anglo-Australian Telescope (AAT) the capacity for large IFS nearby galaxy surveys on the AAT is being substantially expanded with a new instrument called Hector. The high filling-fraction imaging fibre bundles ‘hexabundles’ of the type used on SAMI, are being enlarged to cover up to 30-arcsec diameter. The aim is to reach two effective radii on most galaxies, where the galaxy rotation curve flattens and >75% of the specific angular momentum of disk galaxies is accounted for. Driven by the key science case, Hector will have a 1.3A spectral resolution, enabling high-order stellar kinematics to be measured on a larger fraction of galaxies than with any other IFS instrument. Hector will be on sky in 2019. The first module of Hector, Hector-I, will have 21 hexabundles and >42 sky fibres to observe 20 galaxies and a calibration star simultaneously. It consists of new blue and red-arm spectrographs that have been designed at the Australian Astronomical Observatory (AAO; now called AAO-Macquarie), coupled to the new hexabundles and robotic positioner from AAO-USydney (formerly the Sydney Astrophotonics Instrumentation Laboratory, SAIL) at Sydney University. A novel robotic positioning concept will compensate for varying telecentricity over the 2-degree-field of the AAT to recoup the 20% loss in light at the edge of the field. Hector-I will survey 15,000 galaxies. Additional modules in the future would result in 30,000 galaxies. Hector will take integral field spectroscopy on galaxies with z<0.15 in the 4MOST WAVES-North and WAVES-South∗ regions. The WAVES data, which will come later, will give the environment metrics neces- sary to relate how local and global environments influence galaxy growth through gas accretion, star formation and spins measured with Hector. The WALLABY ASKAP† survey will trace HI gas across the Hector fields, which in combination with Hector will give a complete view of gas accretion and star formation.
- 6 July 2018
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10702, 53
Hector: a modular integral field spectrograph instrument for the Anglo-Australian Telescope
Based on the success of the SAMI integral field spectrograph (IFS) instrument on the Anglo-Australian Telescope (AAT) the capacity for large IFS nearby galaxy surveys on the AAT is being substantially expanded with a new instrument called Hector. The high filling-fraction imaging fibre bundles ‘hexabundles’ of the type used on SAMI, are being enlarged to cover up to 30-arcsec diameter. The aim is to reach two effective radii on most galaxies, where the galaxy rotation curve flattens and >75% of the specific angular momentum of disk galaxies is accounted for. Driven by the key science case, Hector will have a 1.3A spectral resolution, enabling high-order stellar kinematics to be measured on a larger fraction of galaxies than with any other IFS instrument. Hector will be on sky in 2019. The first module of Hector, Hector-I, will have 21 hexabundles and >42 sky fibres to observe 20 galaxies and a calibration star simultaneously. It consists of new blue and red-arm spectrographs that have been designed at the Australian Astronomical Observatory (AAO; now called AAO-Macquarie), coupled to the new hexabundles and robotic positioner from AAO-USydney (formerly the Sydney Astrophotonics Instrumentation Laboratory, SAIL) at Sydney University. A novel robotic positioning concept will compensate for varying telecentricity over the 2-degree-field of the AAT to recoup the 20% loss in light at the edge of the field. Hector-I will survey 15,000 galaxies. Additional modules in the future would result in 30,000 galaxies. Hector will take integral field spectroscopy on galaxies with z<0.15 in the 4MOST WAVES-North and WAVES-South∗ regions. The WAVES data, which will come later, will give the environment metrics neces- sary to relate how local and global environments influence galaxy growth through gas accretion, star formation and spins measured with Hector. The WALLABY ASKAP† survey will trace HI gas across the Hector fields, which in combination with Hector will give a complete view of gas accretion and star formation.
- 22 July 2016
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9912, 99121W-99121W-20
TAIPAN instrument fibre positioner and Starbug robots: engineering overview
- 22 July 2016
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9912, 99121W-99121W-20
TAIPAN instrument fibre positioner and Starbug robots: engineering overview