Sana Ben Mariem
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Sana Ben Mariem has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Anis Younes
Institut Terre et Environnement de Strasbourg, Université de Strasbourg, CNRS, ENGEES, UMR 7063, 67084 Strasbourg, France
3 shared publications - Issam Daghari
INAT Tunisia
3 shared publications - Jiří Šimůnek
Department of Environmental Sciences University of California Riverside Riverside California USA
3 shared publications - Sabri Kanzari
National Research Institute of Rural Engineering, Water and Forestry, University of Carthage, Ariana 2080, Tunisia
3 shared publications - Khouloud Ben Ali
National Institute of Rural Engineering, Waters, and Forestry, University of Carthage, Ariana 2080, Tunisia
2 shared publications - Samir Ghannem
University of Carthage, Faculty of Sciences of Bizerte, Laboratory of Environment Biomonitoring, Coastal Ecology and Ecotoxicology Unit, Zarzouna, 7021, Tunisia
2 shared publications
Latest Publications
- Open Access
Modeling Irrigation of Tomatoes with Saline Water in Semi-Arid Conditions Using Hydrus-1D
In arid and semi-arid regions like Tunisia, irrigation water is typically saline, posing a risk of soil and crop salinization and yield reduction. This research aims to study the combined effects of soil matric and osmotic potential stresses on tomato root water uptake. Plants were grown in pot and field experiments in loamy-clay soils and were irrigated with three different irrigation water qualities: 0, 3.5, and 7 dS/m. The Hydrus-1D model was used to simulate the combined dynamics of subsurface soil water and salts. Successful calibration and validation of the model against measured water and salt profiles enabled the examination of the combined effects of osmotic and matric potential stresses on root water uptake. Relative yields, indirectly estimated from actual and potential transpiration, indicated that the multiplicative stress response model effectively simulated the measured yields and the impact of saline water irrigation on crop yields. The experimental and modeling results provide information to aid in determining the salinity levels conducive to optimal crop growth. The findings indicate that the selected salinity levels affect tomato growth to varying degrees. Specifically, the salinity levels conducive to optimal tomato growth were between 0 and 3.5 dS/m, with a significant growth reduction above this salinity level. The gradual salinization of the root zone further evidenced this effect. The scenario considering a temperature increase of 2 °C had no significant impact on crop yields in the pot and field experiments.
Open AccessModeling Irrigation of Tomatoes with Saline Water in Semi-Arid Conditions Using Hydrus-1D
In arid and semi-arid regions like Tunisia, irrigation water is typically saline, posing a risk of soil and crop salinization and yield reduction. This research aims to study the combined effects of soil matric and osmotic potential stresses on tomato root water uptake. Plants were grown in pot and field experiments in loamy-clay soils and were irrigated with three different irrigation water qualities: 0, 3.5, and 7 dS/m. The Hydrus-1D model was used to simulate the combined dynamics of subsurface soil water and salts. Successful calibration and validation of the model against measured water and salt profiles enabled the examination of the combined effects of osmotic and matric potential stresses on root water uptake. Relative yields, indirectly estimated from actual and potential transpiration, indicated that the multiplicative stress response model effectively simulated the measured yields and the impact of saline water irrigation on crop yields. The experimental and modeling results provide information to aid in determining the salinity levels conducive to optimal crop growth. The findings indicate that the selected salinity levels affect tomato growth to varying degrees. Specifically, the salinity levels conducive to optimal tomato growth were between 0 and 3.5 dS/m, with a significant growth reduction above this salinity level. The gradual salinization of the root zone further evidenced this effect. The scenario considering a temperature increase of 2 °C had no significant impact on crop yields in the pot and field experiments.
- Open Access
- 6 May 2024
- Published by MDPI AG in Preprints.org
Modeling Saline Water Supply for Irrigation of Tomatoes in Semi-Arid Conditions Using Hydrus-1D
In arid and semi-arid regions like Tunisia, irrigation water is typically saline, posing a soil and crop salinization risk and yield reduction. This research aims to study the combined effects of soil matric and osmotic potential stresses on tomato root water uptake. Plants were grown in pot and field experiments in loamy-clay soils and were irrigated with three different irrigation water qualities: 0, 3.5, and 7 dS/m. The Hydrus-1D model was used to simulate the combined dynamics of subsurface soil water and salts. Successful calibration and validation of the model against measured water and salt profiles enabled the examination of the combined effects of osmotic and matric potential stresses on root water uptake. Relative yields, indirectly estimated from actual and potential transpiration, indicated that the multiplicative stress response model effectively simulated measured yields and the impact of saline water irrigation on crop yields. The gradual salinization of the root zone further evidenced this effect. The scenario considering a temperature increase of 2°C had no significant impact on crop yields in the pot and field experiments.
- 6 May 2024
- Published by MDPI AG in Preprints.org
Open AccessModeling Saline Water Supply for Irrigation of Tomatoes in Semi-Arid Conditions Using Hydrus-1D
In arid and semi-arid regions like Tunisia, irrigation water is typically saline, posing a soil and crop salinization risk and yield reduction. This research aims to study the combined effects of soil matric and osmotic potential stresses on tomato root water uptake. Plants were grown in pot and field experiments in loamy-clay soils and were irrigated with three different irrigation water qualities: 0, 3.5, and 7 dS/m. The Hydrus-1D model was used to simulate the combined dynamics of subsurface soil water and salts. Successful calibration and validation of the model against measured water and salt profiles enabled the examination of the combined effects of osmotic and matric potential stresses on root water uptake. Relative yields, indirectly estimated from actual and potential transpiration, indicated that the multiplicative stress response model effectively simulated measured yields and the impact of saline water irrigation on crop yields. The gradual salinization of the root zone further evidenced this effect. The scenario considering a temperature increase of 2°C had no significant impact on crop yields in the pot and field experiments.
- Open Access
Simulation of Water and Salt Dynamics in the Soil Profile in the Semi-Arid Region of Tunisia—Evaluation of the Irrigation Method for a Tomato Crop
In Tunisia, water used for irrigation is often saline, increasing the risk of salinization for soils and crops. In this study, an experiment was conducted on a tomato crop cultivated on a silty-clay soil irrigated with three different water qualities: 0, 3.5, and 7 dS·m−1. Experimental data were then used to calibrate and validate the Hydrus-1D model, which simulates water flow and salt transfer in soils. The successfully-calibrated and validated model was then used to study the combined effects of the soil osmotic and soil matrix potentials on root water uptake. The values of the root mean square error (RMSE), the coefficient of determination (CD), the modeling efficiency (EF), and the coefficient of residual mass (CRM) were close to their optimal values for both soil water content and soil electrical conductivity profiles, indicating the reliability of the model to reproduce water and salt dynamics. Relative yields (Yr), indirectly estimated using actual and potential root water uptake (transpiration), indicated that the multiplicative stress response model (using the S-shape model) satisfactorily simulates measured yields and reproduces the effects of irrigation with saline waters on crop yields. An alternative scenario using a reduction of water requirements by 50% was investigated to assess an irrigation method with considerable water savings. As the results show that relative yields, Yr, were only slightly reduced, the crop water requirements estimated by CROPWAT 8.0 must have been overestimated. The variation of the soil salinity in the root zone highlighted a high salinization risk in the short-term when water of 7 dS·m−1 is used for irrigation.
Open AccessSimulation of Water and Salt Dynamics in the Soil Profile in the Semi-Arid Region of Tunisia—Evaluation of the Irrigation Method for a Tomato Crop
In Tunisia, water used for irrigation is often saline, increasing the risk of salinization for soils and crops. In this study, an experiment was conducted on a tomato crop cultivated on a silty-clay soil irrigated with three different water qualities: 0, 3.5, and 7 dS·m−1. Experimental data were then used to calibrate and validate the Hydrus-1D model, which simulates water flow and salt transfer in soils. The successfully-calibrated and validated model was then used to study the combined effects of the soil osmotic and soil matrix potentials on root water uptake. The values of the root mean square error (RMSE), the coefficient of determination (CD), the modeling efficiency (EF), and the coefficient of residual mass (CRM) were close to their optimal values for both soil water content and soil electrical conductivity profiles, indicating the reliability of the model to reproduce water and salt dynamics. Relative yields (Yr), indirectly estimated using actual and potential root water uptake (transpiration), indicated that the multiplicative stress response model (using the S-shape model) satisfactorily simulates measured yields and reproduces the effects of irrigation with saline waters on crop yields. An alternative scenario using a reduction of water requirements by 50% was investigated to assess an irrigation method with considerable water savings. As the results show that relative yields, Yr, were only slightly reduced, the crop water requirements estimated by CROPWAT 8.0 must have been overestimated. The variation of the soil salinity in the root zone highlighted a high salinization risk in the short-term when water of 7 dS·m−1 is used for irrigation.