YUYoshiaki Uesu

Yoshiaki Uesu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yoshiaki Uesu has a total of 52 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Optical second-harmonic generation microscopy as a tool for ferroelastic domain wall exploration

    by Hiroko Yokota, Yoshiaki Uesu

    Domain walls (DWs) of four typical ferroelastics, CaTiO3 (CTO), LaAlO3 (LAO), Pb3(PO4)2 (PPO), and BiVO4 (BVO), were observed by the second harmonic generation (SHG) microscopy, and the results were compared. The DWs of the examined ferroelastics are all polar. This fact does not depend on whether the crystal is an insulator (CTO, LAO, and PPO) or a semiconductor (BVO), on whether it has ferroelectric instability (CTO) or not (LAO, PPO, and BVO), or on the DW state, namely, whether the DW is crystallographically prominent or non-prominent. The symmetry of these DWs was determined from the SHG anisotropy, and it was clarified that they are a subgroup of the high temperature phase. In the cases of CTO and PPO, stress was applied to move the DW, and its polarity and symmetry were examined. The main characteristics did not change even when stress was applied. In all samples, uniform SHG was observed for each DW. This indicates that the DWs of the examined ferroelastics seem to be in a ferroelectric single domain state.


  • Domain wall generated polarity in ferroelastics: Results from resonance piezoelectric spectroscopy, piezoelectric force microscopy, and optical second harmonic generation measurements in LaAlO3 with twin and tweed microstructures

    by Hiroko Yokota, C. R. S. Haines, Suguru Matsumoto, Nozomo Hasegawa, Michael A. Carpenter, Yooun Heo, Alexe Marin, E. K. H. Salje, Yoshiaki Uesu

    Ferroelastic LaAlO3 (space group R3¯c) exists with two different microstructures: twins and tweed. Both microstructures contain electrical dipole moments. Polarity inside ferroelastic twin walls has been shown using two complementary experimental techniques and identical samples. PFM reveals a weak piezoelectric effect at the loci of the domain walls. In tweed samples, the PFM signal is finite but variable in the entire sample. PFM shows that same characteristic tweed microstructure as observed optically. The piezoelectric effect is of a similar magnitude inside twin walls and, space averaged, in the tweed microstructure (and approximately one order of magnitude smaller than in c-oriented PbTiO3 single crystals). Resonance piezoelectric spectroscopy proves that domain walls vibrate under the application of an external driving electric field. The resonance frequency is very close to stress induced vibrations. This is evidence for weak but finite coupling between the local dipole moments in the domain walls and the external electric field. The same coupling and the piezoelectric response are much stronger in the tweed sample. Symmetry breaking by dipolar vectors in a LaAlO3 sample with tweed has been confirmed by the observation of optical second harmonic signals. The noncentrosymmetric point group is identified as 3m in agreement with earlier work on twinned LaAlO3 but in contradiction with predictions of Landau-Ginzburg theory of simple ferroelastic wall structures.


  • Open Access

    Direct evidence of polar ferroelastic domain boundaries in semiconductor BiVO4

    by H. Yokota, N. Hasegawa, M. Glazer, E. K. H. Salje, Y. Uesu

    Ferroelastic domain boundaries in semiconductor bismuth vanadate, BiVO4, are examined using second harmonic generation microscopy. Although the bulk is centrosymmetric, domain boundaries produce homogeneous second harmonic (SH) signals. The polarization dependences of SH intensities exhibit strong anisotropy compatible with the polar symmetry m. The present results are compared with the experimental results of other ferroelastics we have observed so far. Unlike other ferroelastic materials, the directions of the SH maxima are in the same direction for all domain boundaries.


  • Symmetry and three-dimensional anisotropy of polar domain boundaries observed in ferroelastic LaAlO3 in the complete absence of ferroelectric instability

    by H. Yokota, S. Matsumoto, E. K. H. Salje, Y. Uesu

    The domain boundaries of ferroelastic LaAlO3 (LAO) are examined using a nonlinear optical second harmonic generation (SHG) microscope. Although bulk crystalline LAO possesses centro-symmetry and is inherently non-SH active, our three-dimensional observations reveal that the domain boundaries of LAO exhibit SH activity with almost the same magnitude within a boundary. The polarization dependence of the SH intensities shows strong anisotropy, which is explained by the polar trigonal point group, 3m. The polar direction is found to be along the [111]pc axis and inclined from the domain boundary plane. It implies that the biquadratic coupling scheme of two order parameters could be the main origin of the emergence of polar nature at the domain boundary. Our experimental results together with those of CaTiO3 suggest that the polar nature of the domain boundary in ferroelastic materials may be a ubiquitous phenomenon.


  • Open Access

    Polar nature of stress-induced twin walls in ferroelastic CaTiO3

    by H. Yokota, S. Niki, R. Haumont, P. Hicher, Y. Uesu

    A compressive uniaxial mechanical stress is applied on ferroelastic CaTiO3 (CTO), and a change in the domain structure is observed under a polarization microscope and a second harmonic generation (SHG) microscope. New twin walls (TWs) appear perpendicular to the original TWs under stress. The SHG microscope observations and analyses confirm that this type of stress-induced TWs is polar, similar to the original TWs, and is crystallographically prominent with monoclinic symmetry m. A quantitative estimation of this stress-induced effect reveals that CTO is hard ferroelastic in the sense that the TW movement requires a large stress. A possible application of this phenomenon is discussed.


  • Direct evidence of polar nature of ferroelastic twin boundaries inCaTiO3obtained by second harmonic generation microscope

    by H. Yokota, H. Usami, R. Haumont, P. Hicher, J. Kaneshiro, E. K. H. Salje, Y. Uesu

    The polar nature of twin boundaries (TBs) of inherently nonpolar ferroelastic ${\mathrm{CaTiO}}_{3}$ is examined by the confocal second harmonic generation (SHG) microscope. Three-dimensional SHG images of samples with the pseudocubic (110) and (1-11) planes confirm that both crystallographically prominent TB ($W$ plane) and nonprominent TB (${W}^{$'${}}$ plane) are SHG active and consequently polar. The directions of the electric polarization ${P}_{S}$ are determined from the anisotropy of SHG intensities. In the ${W}^{$'${}}$ plane, the SHG polar diagrams are well fitted using the point-group symmetry 2, which reveals that the ${P}_{S}$ directions parallel to the twofold axis do not lie in the ${W}^{$'${}}$ plane but are tilted from it. In the $W$ plane, the ${P}_{S}$ direction lies in the mirror plane of the point-group symmetry $m$.


  • Open Access

    Ferroelectricity and Ferromagnetism of BaTiO3/BaFeO3Superlattice Thin Films

    by Ryosuke Fukatani, Hiroko Yokota, Shingo Ogura, Yoshiaki Uesu, Ausrine Bartasyte, Mamoru Fukunaga, Yukio Noda

    Ferroelectric BaTiO3 and antiferromagnetic BaFeO3 are deposited alternatively by a pulsed laser deposition method with the aim of fabricating room-temperature multiferroic materials. X-ray diffraction (XRD) analysis reveals that the superlattice structure is fabricated with a designed periodicity and thin film quality is improved by increasing BaFeO3 layers. Ferroelectricity and ferromagnetic properties are examined by the double-wave method (DWM) of D–E hysteresis loops, an XRD dilatometry, and a superconducting quantum interference device magnetometer. Our superlattice thin film shows multiferroicity, i.e., the coexistence of ferroelectricity and ferromagnetism, at room temperature.


  • Open Access

    Optical Second Harmonic Generation Microscopy as a Tool of Material Diagnosis

    by Hiroko Yokota, Junichi Kaneshiro, Yoshiaki Uesu

    The second harmonic generation microscope (SHGM) constructs images of intensity distributions of SH waves produced by the interaction of fundamental waves with a polar material. We have developed this nonlinear optical microscope in order to make possible nondestructive, three-dimensional (3D) observations of various kinds of inorganic and organic materials. The SHGM can disclose also inverted domain structures of antiparallel spontaneous polarizations using the interference with the reference SH waves. The observation principle and several applications to structural characterizations of LiNbO3 and LiTaO3 quasi-phase matching devices, domain structure analyses of a relaxor/ferroelectric solid solution Pb(Zn1/3Nb2/3)O3-9%PbTiO3 at the morphotropic phase boundary, development of order parameter in a quantum paraelectric relaxor Li-doped KTaO3, and antiphase polar domain structures of muscle fibers and myofibrils are surveyed by stressing the high effectiveness of the SHGM as a tool of material diagnosis.


  • SHG microscopic observation of Pb(Zn1/3Nb2/3)O3–9%PbTiO3single crystal

    by Junichi Kaneshiro, Yoshiaki Uesu

    Non-destructive and contactless observations of the domain structures in a single crystal of solid solution Pb(Zn1/3Nb2/3)O3–9%PbTiO3 (PZN–9PT) was performed using the scanning second-harmonic generation (SHG) microscopy with the spatial resolution of optical wavelength scale. A novel method of the 2D mapping of SHG polarization dependence (Pol-D) is proposed. The result indicates that the Pol-Ds correspond well to the observed SHG images of domain structures. The directions of ferroelectric spontaneous polarizations are quantitatively analysed by comparing SHG images and the Pol-Ds. It is confirmed that PZN-9PT has the monoclinic symmetry at room temperature.