Yong Bao

Yong Bao

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Yong Bao has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Ultrasonic forward modeling of industrial oil–water two-phase flow

    by Yanwei Li, Yong Bao, Chao Tan, Feng Dong

  • Low-Frequency Acoustic Temperature Monitoring for Coal Powder Storage in Reverberant and Noisy Environment

    by Jingyu Gao, Yong Bao, Feng Dong, Chao Tan

    Stored pulverized coal is prone to oxidation, leading to internal temperature rise and increased risks of spontaneous combustion. Therefore, accurate monitoring of the internal temperature is of critical importance. Acoustic thermometry is regarded as a promising technique for tracking internal temperature changes within stored pulverized coal, owing to its high penetration ability, non-invasive nature, rapid response and low equipment cost. Nonetheless, the effectiveness of its penetration hinges on employing low-frequency sound waves, which may suffer from measurement inaccuracy due to reverberation interference and ambient noise, especially for temperature monitoring in enclosed spaces. To address this issue, this study developed a deep learning dereverberation and parameter extraction algorithm using CNN-Transformer. Experimental results demonstrate that the method effectively suppresses reverberation in enclosed spaces and enables high-precision recovery of temperature-related acoustic parameters. These improvements are expected to support subsequent acoustic tomography, in which accurate parameter estimation is essential for reconstructing the temperature distribution of stored pulverized coal.

  • Similarity-Based AIC Time-of-Flight Estimation Algorithm for Ultrasonic Flowmeters

    by Yong Bao, Liangjie Wang, Feng Dong, Kai Zuo, Chao Tan

    Due to the advantages of non-invasive, no pressure drop, bi-direction measurement and not affected by the liquid conductivity, ultrasonic transient-time flowmeter has been widely used in industrial process. The measurement quality of the ultrasonic flowmeter largely depends on the time-of-flight (TOF) estimation accuracy. However, for the flow rate monitoring in down-hole pipelines of oil production well, the conventional TOF estimation algorithm may lack the noise robustness against waveform distortion, spike noise and interference, and the temporal resolution for flowrate changes of small-diameter pipe. In this paper, a similarity based Akaike Information Criterion (SAIC) TOF estimation algorithm is proposed. The proposed method uses a similarity-based function to improve the accuracy and noise robustness and uses the sub-sample TOF corrections to improve temporal resolution. Numerical simulations and experimental studies have been conducted to validate the performance of the proposed method. Results show that the proposed SAIC method significantly reduced the TOF estimation standard deviation from 106.1 ns to 1.24 ns, and the corresponding flow rate achieved a good accuracy with averaged relative errors of 1.31% and averaged repeatability errors of 0.59%, which make it well suited for industrial applications. The code of the proposed method is open-source, and can be accessed via the MATLAB file exchange(https://ww2.mathworks.cn/matlabcentral/fileexchange/ 169821-similarity-based-aic-time-of-flight-estimation-algorithm).


  • Wideband Ultrasound Tomography System for Real-Time Monitoring of Multiphase Flow

    by Chao Tan, Qingze Li, Yong Bao, Feng Dong

    Due to the advantages of radiation-free, low equipment cost and high sensitivity to the gas-liquid interface, ultrasonic tomography (UT) has been considered an effective sensing technique for multiphase flow monitoring in industrial process. In this paper, an advanced wideband ultrasonic tomography (WBUT) system based on industrial compact peripheral component interconnect (CPCI) bus is designed for real-time monitoring of the multiphase flow in industrial process. The novel features of the WBUT system include: (1) High intensity wideband ultrasonic excitation and data acquisition; (2) Real-time on-board signal processing and ultrasonic parameter extraction; (3) High speed ultrasonic data processing, storage, and communication; (4) Improved image quality with higher spatial resolution and noise robustness using the wideband tomographic reconstruction; (5) Particle size awareness using the ultrasonic spectrum measurements. The performance of the proposed WBUT system was validated by experimental studies. The results demonstrated that the WBUT system fully leverages multi-frequency data to distinguish 3-4 randomly distributed small inclusions with a spatial resolution of 5 mm, maintains high reconstruction quality under low signal-to-noise ratio (SNR) or missing data conditions, and differentiate in particle size between two liquid-solid samples of identical concentration. These attributes are invaluable for monitoring the industrial process multiphase flow in a comprehensive way.


  • Size, Distribution, and Acoustic Impedance Quantization of Bubbles and Droplets Using Ultrasonic Complex Sound Pressure

    by Sheng Tian, Chao Tan, Zhixing Zhang, Yong Bao, Feng Dong

    Oil-gas-water three-phase medium is frequently encountered in various industrial processes. A comprehensive understanding of the discrete phase is of great importance for the industrial process safety assurance and economic benefits of production. Concerns about the discrete phase in the three-phase medium not only refer to the spatial resolution but also acoustically distinguish the gas bubble and oil droplet. We present a novel ultrasonic measurement technique for the three-phase medium using the ultrasonic phased array (UPA) sensor and complex sound pressure measurement to accomplish this goal. The proposed method can provide accurate size and location measurements to resolve the bubble and droplet spatially, and accurate acoustic impedance measurements to distinguish the bubble and droplet in oil-gas-water three-phase medium. Briefly, we develop a forward scattering complex sound pressure peak (FSCSPP) method to quantitatively characterize the size and distribution of the bubble and droplet, a sound transmission degree (STD) method to calculate these discrete phases’ acoustic impedance values, and a sound transmission threshold (STT) parameter to distinguish the bubble and droplet. The simulation and experimental results show that the above method is highly accurate and sensitive in spatially resolving and acoustically distinguishing the bubble and droplet in the oil-gas-water three-phase medium.


  • Open Access

    Fast Dual-LiDAR Reconstruction for Dynamic Wind Field Retrieval

    by Yong Bao, Chao Tan, Jiabin Jia

    With the advantages of high accuracy, high spatial resolution, and long measurement range, LiDAR is considered as the most suitable measurement technique to deliver quantitative imaging of wind fields. However, for complex wind fields, such as monitoring wind turbine wakes where both the temporal resolution and reconstruction speed are of great significance, the conventional LiDAR system lacks the temporal resolution to capture the fast changes of wind turbine wake fields. In this paper, a novel dynamic wind retrieval method is developed to improve temporal resolution using the unsynchronised dual-LiDAR scanning scheme. By exploiting the temporal redundancy information of the LiDAR Line-of-Sight (LoS) data in successive frames, a reduced number of LiDAR scanning points is required for the 2D horizontal wind field retrieval with the help of unsynchronised dual-LiDAR wind scanning scheme, low-rank data up-sampling and a divergence-free regularised wind retrieval algorithm. Numerical simulation is performed to validate the proposed method. Results show that the temporal resolution of LiDAR wind retrieval can be improved by a factor of 2 to 8 and provide acceptable results with good spatial resolution.


  • Spatially Driven Chemical Species Tomography With Size-Adaptive Hybrid Meshing Scheme

    by Rui Zhang, Jingjing Si, Godwin Enemali, Yong Bao, Chang Liu

    This paper develops a size-adaptive hybrid meshing scheme for Chemical Species Tomography (CST) that is driven by the customized spatial resolution of the sensing region. Traditionally, the entire sensing region in CST is uniformly discretized with the empirically determined density of the meshes. Such a discretization results in a) waste of computational efforts on the less spatially resolved location; and b) much severer rank deficiency. To solve the above-mentioned issues, we introduce, for the first time, a size-adaptive hybrid meshing scheme for CST. Driven by the spatial resolution, dense meshes are deployed in the region of interest (RoI) to detail the target flow field while sparse ones are deployed out of the RoI to fully consider the physically existing laser absorption. The proposed scheme is numerically validated using a CST sensor with 128 laser beams. The visual and quantitative metric comparisons show that the proposed hybrid-size meshing scheme outperforms the traditionally uniform-size meshing scheme, giving 35% lower image error and 38% less significant dislocation at a typical 35 dB signal-to-noise ratio in the RoI. The proposed hybrid-size meshing scheme significantly facilitates the reconstruction of the industrial combustion processes where the combustion zone is bypassed by cooling flows. In these scenarios, the proposed scheme can adapt a finer resolution to detail the combustion zone, while maintaining the integrity of the physical model by less resolved reconstruction of the bypass flows.


  • Oil–Water Two-Phase Flow Volume Fraction Measurement Based on Nonlinear Ultrasound Technique

    by Yong Bao, Chao Tan, Feng Dong

    Ultrasonic techniques have been widely used to determine the volume fractions of liquid components in oil–water two-phase flow. The two major ultrasonic interactions amenable to volume fraction estimation are the sound speed and attenuation. Instead of using these two linear ultrasound parameters, this study explores the use of ultrasound nonlinear parameter to measure the volume fraction of oil–water two-phase flow. Based on the theoretical modeling of ultrasound nonlinear propagation and nonlinearity measurement principle using finite amplitude insertion substitution (FAIS), we established a relationship between volume fraction and the amplitude of the second harmonic components in the received ultrasound waveform. With the use of high-intensity ultrasonic excitation, two-end calibration, and second harmonic amplitude extraction, the volume fraction of water can be calculated. The performance of the proposed method is validated by the numerical simulations and experimental studies in a lab-scale flow loop. Good qualitative agreement between the model and results shows that the nonlinear ultrasonic measurement technique has good quantitative accuracy and high measurement sensitivity, which make it well suited for industrial applications.


  • Ultrasound Phase Array Tomography for Biphasic Medium Distribution Imaging Using Synthetic Aperture Beam Scanning

    by Hao Liu, Chao Tan, Zhanpeng Li, Yong Bao, Feng Dong

    Industrial Ultrasonic Tomography (UT) possesses unique advantages in visualizing multiphase medium and has received broad attention in the past decades. Facing small bubble distribution imaging, the current independent-transducer-based UT faces bottleneck problems of limited projection number and large projection diameter. To image the cross-sectional bubble distribution, an original concept of Ultrasonic Phase Array Tomography (UPAT) is proposed by introducing the ultrasound phase array (UPA) transducers and novel designed sensing strategy into UT. The UPAT emits a wide and directional acoustic beam towards the receivers, on which each element forms a narrow projection to detect small bubbles on its path. Hence, the UPAT forms a novel sensing strategy with shifting and multi-angled acoustic beam scanning of whole cross-section, as well as the precise measurement on high amount of narrow projections. To mathematically model the UPAT, the acoustic field distribution and beam steering algorithm are designed for beam scanning with shifted apertures, while the forward/inverse solutions are proposed for tomographic imaging. In numerical simulations, the 8-transducer UPAT is with much lower imaging error than the state-of-art 32-transducer transmissive/reflective UT with relative error reduced by 65.66% in average. In lab-scale experiments, the reconstructed bubble size, shape and distribution are with good accuracy, boundary preservation and image purity.