Brahim Messnaoui
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Brahim Messnaoui has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Abderrahim Dinane
Equipe de Thermodynamique et Energétique, Centre de Recherches en Energie, Département de Physique, Faculté de Sciences de Rabat, Université Mohammed V, Rabat 10090, Morocco
4 shared publications A. Samaouali
Equipe de Thermodynamique et Energétique, Centre de Recherches en Energie, Département de Physique, Faculté de Sciences, Université Mohammed V, Agdal, Rabat, Morocco
3 shared publicationsS. El Hantati
Equipe de Thermodynamique et Energétique, Centre de Recherches en Energie, Département de Physique, Faculté de Sciences, Université Mohammed V, Agdal, Rabat, Morocco
3 shared publicationsW. El Fadel
Equipe de Thermodynamique et Energétique, Centre de Recherches en Energie, Département de Physique, Faculté de Sciences, Université Mohammed V, Agdal, Rabat, Morocco
3 shared publicationsZ. Nour
Equipe de Thermodynamique et Energétique, Centre de Recherches en Energie, Département de Physique, Faculté de Sciences, Université Mohammed V, Agdal, Rabat, Morocco
3 shared publicationsA. Dinane
Equipe de Thermodynamique et Energétique, Centre de Recherches en Energie, Département de Physique, Faculté de Sciences, Université Mohammed V, Agdal, Rabat, Morocco
2 shared publications
Latest Publications
- Open Access
- 10 July 2025
- Published by Center of Biomass and Renewable Energy Scientia Academy in International Journal of Renewable Energy Development
- Vol. 14 (5) , 914-926
Advanced one-dimensional heterogeneous model for high temperature water gas shift membrane reactors
To predict the behavior of small-scale WGS membrane reactors, a new model based on the 1D heterogeneous approach was developed. Unlike most studies, which rely on 1D pseudo-homogeneous models—typically limited to reactors filled with small catalyst particles which are prone to misestimating catalytic effectiveness when larger catalyst grains are used in which mass transfer resistance is usually considered only within the dense membrane layer which a valid assumption only when this layer is thick, the proposed model adapts to a wide range of catalyst sizes and geometries and also accounts for resistance in the porous stainless steel support of the membrane. This makes it suitable when the dense layer is thin.Comparison with experimental data under various conditions validated the model’s ability to predict the behavior of reactors packed with large catalyst particles (Vgrain ≈ 169 mm³). Therefore, the developed 1D heterogeneous model accurately predicts membrane reactor behavior without resorting to more complex 2D models. Simulations highlighted the significant influence of particle geometry on the catalyst effectiveness factor throughout the reactor, while its impact on carbon monoxide conversion, hydrogen partial pressure, and the temperature profile is especially pronounced near the reactor inlet. Additionally, results showed that sweep gas use accelerates the reaction and aids hydrogen permeation. Finally, CO conversion in the membrane reactor reached 1.3 times that of a conventional fixed-bed reactor.
- 10 July 2025
- Published by Center of Biomass and Renewable Energy Scientia Academy in International Journal of Renewable Energy Development
- Vol. 14 (5) , 914-926
Open AccessAdvanced one-dimensional heterogeneous model for high temperature water gas shift membrane reactors
To predict the behavior of small-scale WGS membrane reactors, a new model based on the 1D heterogeneous approach was developed. Unlike most studies, which rely on 1D pseudo-homogeneous models—typically limited to reactors filled with small catalyst particles which are prone to misestimating catalytic effectiveness when larger catalyst grains are used in which mass transfer resistance is usually considered only within the dense membrane layer which a valid assumption only when this layer is thick, the proposed model adapts to a wide range of catalyst sizes and geometries and also accounts for resistance in the porous stainless steel support of the membrane. This makes it suitable when the dense layer is thin.Comparison with experimental data under various conditions validated the model’s ability to predict the behavior of reactors packed with large catalyst particles (Vgrain ≈ 169 mm³). Therefore, the developed 1D heterogeneous model accurately predicts membrane reactor behavior without resorting to more complex 2D models. Simulations highlighted the significant influence of particle geometry on the catalyst effectiveness factor throughout the reactor, while its impact on carbon monoxide conversion, hydrogen partial pressure, and the temperature profile is especially pronounced near the reactor inlet. Additionally, results showed that sweep gas use accelerates the reaction and aids hydrogen permeation. Finally, CO conversion in the membrane reactor reached 1.3 times that of a conventional fixed-bed reactor.
- 12 June 2024
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 69 (7) , 2429-2441
Thermodynamic Properties of NaCl-HCl(aq) and HCl-NaCl-KCl(aq) at a Temperature of 298.15 K
- 12 June 2024
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 69 (7) , 2429-2441
Thermodynamic Properties of NaCl-HCl(aq) and HCl-NaCl-KCl(aq) at a Temperature of 298.15 K
- 29 December 2023
- Published by Springer Nature in Journal of Solution Chemistry
- Vol. 53 (6) , 790-814
Thermodynamic Behavior of the System Water/d-Sucrose/NH4H2PO4 at 298.15 K, and Salting-Out of NH4H2PO4 on d-Sucrose Solutions
- 29 December 2023
- Published by Springer Nature in Journal of Solution Chemistry
- Vol. 53 (6) , 790-814
Thermodynamic Behavior of the System Water/d-Sucrose/NH4H2PO4 at 298.15 K, and Salting-Out of NH4H2PO4 on d-Sucrose Solutions
- 20 October 2023
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 62 (43) , 17986-17996
Experimental Determination of Osmotic Coefficient and Salt Solubility of System NH4NO3–NH4H2PO4–H2O and Their Correlation and Prediction with the Pitzer–Simonson–Clegg Model
- 20 October 2023
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 62 (43) , 17986-17996
Experimental Determination of Osmotic Coefficient and Salt Solubility of System NH4NO3–NH4H2PO4–H2O and Their Correlation and Prediction with the Pitzer–Simonson–Clegg Model
- 20 June 2023
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 68 (11) , 2842-2855
Thermodynamics of K2HPO4/d-Sucrose/Water System at 298.15 K: Experiment and Modeling
- 20 June 2023
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 68 (11) , 2842-2855
Thermodynamics of K2HPO4/d-Sucrose/Water System at 298.15 K: Experiment and Modeling
- Open Access
- 4 May 2023
- Published by Springer Nature in Research Square
Thermodynamic behavior of the system water/D-Sucrose/ NH4H2PO4 at 298.15 K, and salting-out of NH4H2PO4 on D-Sucrose Solutions
The hygrometric method is used to determine new thermodynamic data on water activity and saturated aqueous solution of the water/D-Sucrose/ Ammonium Dihydrogen Phosphate (ADP) system in a wide range of NH4H2PO4 molality, ranging from 0.1 to 3 mol.kg− 1, and for various D-Sucrose contents from 0. to 4 mol.kg− 1. Powder X-ray diffraction (XRD) and attenuated total reflection Fourier-transform infrared (ATR-FTIR) spectroscopy were used to characterize the solid state. The Pitzer Simonson-Clegg model (PSC) is used to fit the experimental data of osmotic coefficient obtained from water activities data. The predicted saturated aqueous solutions, with the PSC model, are in good agreement with experimental data. For the concentration inferior to 1 mol.kg− 1, the negative deviation from ideality was shown with increasing the ADP concentrations. The estimated values of the activity coefficient of D-Sucrose, activity coefficient of ADP, and the Gibbs energy of transfer of ADP from water to mixture (water /D-Sucrose) show that both ADP and D-Sucrose exert significant salting-out effects on the aqueous solution.
- 4 May 2023
- Published by Springer Nature in Research Square
Open AccessThermodynamic behavior of the system water/D-Sucrose/ NH4H2PO4 at 298.15 K, and salting-out of NH4H2PO4 on D-Sucrose Solutions
The hygrometric method is used to determine new thermodynamic data on water activity and saturated aqueous solution of the water/D-Sucrose/ Ammonium Dihydrogen Phosphate (ADP) system in a wide range of NH4H2PO4 molality, ranging from 0.1 to 3 mol.kg− 1, and for various D-Sucrose contents from 0. to 4 mol.kg− 1. Powder X-ray diffraction (XRD) and attenuated total reflection Fourier-transform infrared (ATR-FTIR) spectroscopy were used to characterize the solid state. The Pitzer Simonson-Clegg model (PSC) is used to fit the experimental data of osmotic coefficient obtained from water activities data. The predicted saturated aqueous solutions, with the PSC model, are in good agreement with experimental data. For the concentration inferior to 1 mol.kg− 1, the negative deviation from ideality was shown with increasing the ADP concentrations. The estimated values of the activity coefficient of D-Sucrose, activity coefficient of ADP, and the Gibbs energy of transfer of ADP from water to mixture (water /D-Sucrose) show that both ADP and D-Sucrose exert significant salting-out effects on the aqueous solution.
- 10 June 2020
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 65 (7) , 3536-3545
Use of the Hygrometric Method for Determination of Water Activity of an Aqueous Hydrochloric Acid System at 298.15 K
- 10 June 2020
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 65 (7) , 3536-3545
Use of the Hygrometric Method for Determination of Water Activity of an Aqueous Hydrochloric Acid System at 298.15 K