Andres Camilo Jimenez
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Andres Camilo Jimenez has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Vicente García-Díaz
University of Oviedo, Oviedo, Spain
6 shared publications - John Petearson Anzola
Fundación Universitaria los Libertadores
4 shared publications - Sandro Javier Bolaños Castro
District University “Francisco José de Caldas
3 shared publications John Anzola
Department of Electronic Engineering, Fundación Universitaria Los Libertadores, Carrera 16 No. 63 A - 68, Bogotá, Colombia
2 shared publicationsJohn Petearson Anzola
Department of Electronic Engineering, Los Libertadores Foundation University Bogotá, Colombia
2 shared publicationsAlexander Jimenez-Triana
Department of Electronic Engineering, Fundación Universitaria Los Libertadores, Carrera 16 No. 63 A - 68, Bogotá, Colombia
1 shared publication
Latest Publications
- Open Access
- 26 November 2020
- Published by SAGE Publications in Journal of Ambient Intelligence and Smart Environments
- Vol. 12 (6) , 547-548
Decentralized navigation model for multiagent cooperative robotic systems
On November 20, 2018 at 11 am, Andrés Camilo Jiménez Alvarez defended his Ph.D. thesis entitled Decentralized navigation model for multiagent cooperative robotic systems at the Distrital University Francisco José de Caldas. Andrés Camilo Jiménez Alvarez presented his dissertation in a public open event held in the “Wise Caldas Auditory”, and was able to expose and defend all his research, it was approved by the committee. The thesis was supervised by his advisors, Vicente García-Díaz and Sandro Javier Bolaños, together with the thesis committee, Rubén Gonzáles Crespo, Oscar Fernando Avilés and Roberto Ferro Escobar. All the cited people were present at the event.
- 26 November 2020
- Published by SAGE Publications in Journal of Ambient Intelligence and Smart Environments
- Vol. 12 (6) , 547-548
Open AccessDecentralized navigation model for multiagent cooperative robotic systems
On November 20, 2018 at 11 am, Andrés Camilo Jiménez Alvarez defended his Ph.D. thesis entitled Decentralized navigation model for multiagent cooperative robotic systems at the Distrital University Francisco José de Caldas. Andrés Camilo Jiménez Alvarez presented his dissertation in a public open event held in the “Wise Caldas Auditory”, and was able to expose and defend all his research, it was approved by the committee. The thesis was supervised by his advisors, Vicente García-Díaz and Sandro Javier Bolaños, together with the thesis committee, Rubén Gonzáles Crespo, Oscar Fernando Avilés and Roberto Ferro Escobar. All the cited people were present at the event.
- 1 October 2018
- Published by Elsevier in Computers and Electrical Engineering
- Vol. 71, 533-545
A vision-based measurement model for instruments without internet connectivity
- 1 October 2018
- Published by Elsevier in Computers and Electrical Engineering
- Vol. 71, 533-545
A vision-based measurement model for instruments without internet connectivity
- Open Access
- 13 August 2018
- Published by Universidad Distrital Francisco Jose de Caldas in Visión electrónica
- Vol. 1 (2) , 254-260
Leach performance analysis varying the percentage of cluster head
The LEACH protocol is a “standard” protocol used in the analysis and simulation of wireless sensor networks. This article analyzes the effect of varying parameter values in the LEACH protocol. In particular, the case of varying cluster head node assignments to , , and of the total nodes of the network. Specifically, it shows the energy effect of this variation and the corresponding data traffic analysis, showing simulation results that illustrate the behavior resulting from this variation by using an approach of time-division multiplexing on the clusters.
- 13 August 2018
- Published by Universidad Distrital Francisco Jose de Caldas in Visión electrónica
- Vol. 1 (2) , 254-260
Open AccessLeach performance analysis varying the percentage of cluster head
The LEACH protocol is a “standard” protocol used in the analysis and simulation of wireless sensor networks. This article analyzes the effect of varying parameter values in the LEACH protocol. In particular, the case of varying cluster head node assignments to , , and of the total nodes of the network. Specifically, it shows the energy effect of this variation and the corresponding data traffic analysis, showing simulation results that illustrate the behavior resulting from this variation by using an approach of time-division multiplexing on the clusters.
- Open Access
Decentralized Online Simultaneous Localization and Mapping for Multi-Agent Systems
Planning tasks performed by a robotic agent require previous access to a map of the environment and the position where the agent is located. This creates a problem when the agent is placed in a new environment. To solve it, the RA must execute the task known as Simultaneous Location and Mapping (SLAM) which locates the agent in the new environment while generating the map at the same time, geometrically or topologically. One of the big problems in SLAM is the amount of memory required for the RA to store the details of the environment map. In addition, environment data capture needs a robust processing unit to handle data representation, which in turn is reflected in a bigger RA unit with higher energy use and production costs. This article presents a design for a system capable of a decentralized implementation of SLAM that is based on the use of a system comprised of wireless agents capable of storing and distributing the map as it is being generated by the RA. The proposed system was validated in an environment with a surface area of 25 m , in which it was capable of generating the topological map online, and without relying on external units connected to the system.Open AccessDecentralized Online Simultaneous Localization and Mapping for Multi-Agent Systems
Planning tasks performed by a robotic agent require previous access to a map of the environment and the position where the agent is located. This creates a problem when the agent is placed in a new environment. To solve it, the RA must execute the task known as Simultaneous Location and Mapping (SLAM) which locates the agent in the new environment while generating the map at the same time, geometrically or topologically. One of the big problems in SLAM is the amount of memory required for the RA to store the details of the environment map. In addition, environment data capture needs a robust processing unit to handle data representation, which in turn is reflected in a bigger RA unit with higher energy use and production costs. This article presents a design for a system capable of a decentralized implementation of SLAM that is based on the use of a system comprised of wireless agents capable of storing and distributing the map as it is being generated by the RA. The proposed system was validated in an environment with a surface area of 25 m , in which it was capable of generating the topological map online, and without relying on external units connected to the system. - Open Access
A Decentralized Framework for Multi-Agent Robotic Systems
Over the past few years, decentralization of multi-agent robotic systems has become an important research area. These systems do not depend on a central control unit, which enables the control and assignment of distributed, asynchronous and robust tasks. However, in some cases, the network communication process between robotic agents is overlooked, and this creates a dependency for each agent to maintain a permanent link with nearby units to be able to fulfill its goals. This article describes a communication framework, where each agent in the system can leave the network or accept new connections, sending its information based on the transfer history of all nodes in the network. To this end, each agent needs to comply with four processes to participate in the system, plus a fifth process for data transfer to the nearest nodes that is based on Received Signal Strength Indicator (RSSI) and data history. To validate this framework, we use differential robotic agents and a monitoring agent to generate a topological map of an environment with the presence of obstacles.
Open AccessA Decentralized Framework for Multi-Agent Robotic Systems
Over the past few years, decentralization of multi-agent robotic systems has become an important research area. These systems do not depend on a central control unit, which enables the control and assignment of distributed, asynchronous and robust tasks. However, in some cases, the network communication process between robotic agents is overlooked, and this creates a dependency for each agent to maintain a permanent link with nearby units to be able to fulfill its goals. This article describes a communication framework, where each agent in the system can leave the network or accept new connections, sending its information based on the transfer history of all nodes in the network. To this end, each agent needs to comply with four processes to participate in the system, plus a fifth process for data transfer to the nearest nodes that is based on Received Signal Strength Indicator (RSSI) and data history. To validate this framework, we use differential robotic agents and a monitoring agent to generate a topological map of an environment with the presence of obstacles.
- 1 September 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 216-221
Autonomous multi-agent system for on-line topological mapping and location using wireless sensor network
In planning tasks a Robotic Agent (RA) must know a priori the environment map where it is located, which is a problem if the same RA faces a different environment. To overcome this problem, the RA must perform the task of Simultaneous Localization and Mapping (SLAM), to locate the agent in the environment while simultaneously generate the geometric or topological map. This article presents the design of a decentralized online system for SLAM by an autonomous RA, responsible for placing wireless sensor nodes based on its Received Signal Strength Indication (RSSI) and programming them with the estimated position by processing the RA odometry, creating a Multi-Agent System (MAS) by the construction of a Wireless Sensor Network (WSN). The validation of this system is driven in a non-uniform two-dimensional environment with respect to RA, showing the generation of an online topological map with an error of 8%, without the dependence of a central unit.
- 1 September 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 216-221
Autonomous multi-agent system for on-line topological mapping and location using wireless sensor network
In planning tasks a Robotic Agent (RA) must know a priori the environment map where it is located, which is a problem if the same RA faces a different environment. To overcome this problem, the RA must perform the task of Simultaneous Localization and Mapping (SLAM), to locate the agent in the environment while simultaneously generate the geometric or topological map. This article presents the design of a decentralized online system for SLAM by an autonomous RA, responsible for placing wireless sensor nodes based on its Received Signal Strength Indication (RSSI) and programming them with the estimated position by processing the RA odometry, creating a Multi-Agent System (MAS) by the construction of a Wireless Sensor Network (WSN). The validation of this system is driven in a non-uniform two-dimensional environment with respect to RA, showing the generation of an online topological map with an error of 8%, without the dependence of a central unit.
- Open Access
- 17 July 2017
- Published by Association for Computing Machinery (ACM)
- p. 1-7
WSN analysis in grid topology for potato crops for IoT
Due to the development of Internet of Things (IoT) and extensive use of Wireless Sensor Networks (WSN) in precision agriculture, we take potato crops as a study domain for sensors and their behavior on their deployment in a particular area. We study how application responsiveness is determined by performance metrics in wireless communications. We also describe how data collected by the sensors aids in finding solutions to the cropfis domain problems through data aggregation over time. The aim of this work is to analyze traffic behavior of a grid-topology wireless sensor network, chosen based on the distance between rows and potato plants within a hectare, by analyzing the performance of a service request from an IoT application.
- 17 July 2017
- Published by Association for Computing Machinery (ACM)
- p. 1-7
Open AccessWSN analysis in grid topology for potato crops for IoT
Due to the development of Internet of Things (IoT) and extensive use of Wireless Sensor Networks (WSN) in precision agriculture, we take potato crops as a study domain for sensors and their behavior on their deployment in a particular area. We study how application responsiveness is determined by performance metrics in wireless communications. We also describe how data collected by the sensors aids in finding solutions to the cropfis domain problems through data aggregation over time. The aim of this work is to analyze traffic behavior of a grid-topology wireless sensor network, chosen based on the distance between rows and potato plants within a hectare, by analyzing the performance of a service request from an IoT application.
- Open Access
- 17 July 2017
- Published by Association for Computing Machinery (ACM)
- p. 1-6
Design of a System for Vehicle Traffic Estimation for Applications on IoT
The analysis of traffic jams has become an interesting topic for smart cities. This analysis allows to perform studies for the reduction of environmental contamination, fuel consumption and the driving time. In this article, a wireless autonomous system to estimate the vehicle traffic, oriented to be used in the Internet of Things (IoT) applications is presented. In order to perform the estimation of the speed and orientation of the moving vehicles, the optical flow technique is used through the method of Gunnar Farneback, applying segmentation by morphology to avoid false information captured in situations where the optical flow may not detect the movement. To process and monitor the information in real time, the data is sent to the cloud using Flask framework, making it available for multiple users. The system is designed and verified through a Raspberrypi 2 development card, with a wi-fi module compatible with Ad-Hoc networks
- 17 July 2017
- Published by Association for Computing Machinery (ACM)
- p. 1-6
Open AccessDesign of a System for Vehicle Traffic Estimation for Applications on IoT
The analysis of traffic jams has become an interesting topic for smart cities. This analysis allows to perform studies for the reduction of environmental contamination, fuel consumption and the driving time. In this article, a wireless autonomous system to estimate the vehicle traffic, oriented to be used in the Internet of Things (IoT) applications is presented. In order to perform the estimation of the speed and orientation of the moving vehicles, the optical flow technique is used through the method of Gunnar Farneback, applying segmentation by morphology to avoid false information captured in situations where the optical flow may not detect the movement. To process and monitor the information in real time, the data is sent to the cloud using Flask framework, making it available for multiple users. The system is designed and verified through a Raspberrypi 2 development card, with a wi-fi module compatible with Ad-Hoc networks
- Open Access
- 29 July 2016
- Published by International Association of Online Engineering (IAOE) in International Journal of Online and Biomedical Engineering (iJOE)
- Vol. 12 (7) , 66
Methodology Design of Computational Experiments Founded on Design-based Science Case Study: Motion Models
In this article are compared random waypoint motion models and Manhattan against a model of semicircular motion, analyzing the total distance traveled, the average total energy of robots’ agents and convergence time at 80% of exploration of the navigation area using as design methodology, design-based science. Agent's robots involved in the experiment show no cognitive and cooperative parameter, therefore, the results obtained in this article will allow extracting temporal and energy characteristics that allows exploring as much area in the shortest possible time, in order to get heuristics for future work in SLAM tasks
- 29 July 2016
- Published by International Association of Online Engineering (IAOE) in International Journal of Online and Biomedical Engineering (iJOE)
- Vol. 12 (7) , 66
Open AccessMethodology Design of Computational Experiments Founded on Design-based Science Case Study: Motion Models
In this article are compared random waypoint motion models and Manhattan against a model of semicircular motion, analyzing the total distance traveled, the average total energy of robots’ agents and convergence time at 80% of exploration of the navigation area using as design methodology, design-based science. Agent's robots involved in the experiment show no cognitive and cooperative parameter, therefore, the results obtained in this article will allow extracting temporal and energy characteristics that allows exploring as much area in the shortest possible time, in order to get heuristics for future work in SLAM tasks