András Szenes
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
András Szenes has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Attila Bonyár
Department of Electronics Technology Faculty of Electrical Engineering and Informatics Budapest University of Technology and Economics Egry József street 18 H-1111 Budapest Hungary
2 shared publications - Dávid Vass
Department for Quantum Optics, University of Szeged, 6720 Szeged, Hungary
2 shared publications - Emese Tóth
Department for Quantum Optics, University of Szeged, 6720 Szeged, Hungary
2 shared publications - Gábor Galbács
Department of Molecular and Analytical Chemistry, University of Szeged, Dóm sq. 7-8, Szeged, 6720, Hungary
2 shared publications - István Papp
Wigner Research Centre for Physics, 1121 Budapest, Hungary
2 shared publications - István Rigó
HUN-REN Wigner Research Centre for Physics, Konkoly-Thege Miklós út 29-33, 1121 Budapest, Hungary
2 shared publications
Latest Publications
- Open Access
With Nanoplasmonics towards Fusion
A status report is presented about the Nanoplasmonic Laser Induced Fusion Experiment (NAPLIFE). The goal is to investigate and verify plasmonically enhanced phenomena on the surfaces of nanoantennas embedded in a polymer target at laser intensities up to a few times W/cm and pulse durations of 40–120 fs. The first results on enhanced crater formation for Au-doped polymer targets are shown, and SERS signals typical for and bound vibrations are cited. Trials to detect ratio by means of LIBS measurments are reported. Plasmonics has the potential to work at these intensities, enhancing the energy and deuterium production, due to thus far unknown mechanisms.Open AccessWith Nanoplasmonics towards Fusion
A status report is presented about the Nanoplasmonic Laser Induced Fusion Experiment (NAPLIFE). The goal is to investigate and verify plasmonically enhanced phenomena on the surfaces of nanoantennas embedded in a polymer target at laser intensities up to a few times W/cm and pulse durations of 40–120 fs. The first results on enhanced crater formation for Au-doped polymer targets are shown, and SERS signals typical for and bound vibrations are cited. Trials to detect ratio by means of LIBS measurments are reported. Plasmonics has the potential to work at these intensities, enhancing the energy and deuterium production, due to thus far unknown mechanisms. - Open Access
- 5 November 2022
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 23 (21) , 13575
The Effect of Femtosecond Laser Irradiation and Plasmon Field on the Degree of Conversion of a UDMA-TEGDMA Copolymer Nanocomposite Doped with Gold Nanorods
In this work, the effects of femtosecond laser irradiation and doping with plasmonic gold nanorods on the degree of conversion (DC) of a urethane dimethacrylate (UDMA)–triethylene glycol dimethacrylate (TEGDMA) nanocomposite were investigated. The UDMA-TEGDMA photopolymer was prepared in a 3:1 weight ratio and doped with dodecanethiol- (DDT) capped gold nanorods of 25 × 75 or 25 × 85 nm nominal diameter and length. It was found that the presence of the gold nanorods alone (without direct plasmonic excitation) can increase the DC of the photopolymer by 6–15%. This increase was found to be similar to what could be achieved with a control heat treatment of 30 min at 180 °C. It was also shown that femtosecond laser impulses (795 nm, 5 mJ pulse energy, 50 fs pulse length, 2.83 Jcm−2 fluence), applied after the photopolymerization under a standard dental curing lamp, can cause a 2–7% increase in the DC of undoped samples, even after thermal pre-treatment. The best DC values (12–15% increase) were obtained with combined nanorod doping and subsequent laser irradiation close to the plasmon resonance peak of the nanorods (760–800 nm), which proves that the excited plasmon field can directly facilitate double bond breakage (without thermoplasmonic effects due to the short pulse length) and increase the crosslink density independently from the initial photopolymerization process.
- 5 November 2022
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 23 (21) , 13575
Open AccessThe Effect of Femtosecond Laser Irradiation and Plasmon Field on the Degree of Conversion of a UDMA-TEGDMA Copolymer Nanocomposite Doped with Gold Nanorods
In this work, the effects of femtosecond laser irradiation and doping with plasmonic gold nanorods on the degree of conversion (DC) of a urethane dimethacrylate (UDMA)–triethylene glycol dimethacrylate (TEGDMA) nanocomposite were investigated. The UDMA-TEGDMA photopolymer was prepared in a 3:1 weight ratio and doped with dodecanethiol- (DDT) capped gold nanorods of 25 × 75 or 25 × 85 nm nominal diameter and length. It was found that the presence of the gold nanorods alone (without direct plasmonic excitation) can increase the DC of the photopolymer by 6–15%. This increase was found to be similar to what could be achieved with a control heat treatment of 30 min at 180 °C. It was also shown that femtosecond laser impulses (795 nm, 5 mJ pulse energy, 50 fs pulse length, 2.83 Jcm−2 fluence), applied after the photopolymerization under a standard dental curing lamp, can cause a 2–7% increase in the DC of undoped samples, even after thermal pre-treatment. The best DC values (12–15% increase) were obtained with combined nanorod doping and subsequent laser irradiation close to the plasmon resonance peak of the nanorods (760–800 nm), which proves that the excited plasmon field can directly facilitate double bond breakage (without thermoplasmonic effects due to the short pulse length) and increase the crosslink density independently from the initial photopolymerization process.
- Open Access
Plasmonic Structure Integrated Single-Photon Detector Configurations to Improve Absorptance and Polarization Contrast
Configurations capable of maximizing both the absorption component of system detection efficiency and the achievable polarization contrast were determined for 1550 nm polarized light illumination of different plasmonic structure integrated superconducting nanowire single-photon detectors (SNSPDs) consisting of p = 264 nm and P = 792 nm periodic niobium nitride (NbN) patterns on silica substrate. Global effective NbN absorptance maxima appear in case of p/s-polarized light illumination in S/P-orientation (γ = 90°/0° azimuthal angle) and the highest polarization contrast is attained in S-orientation of all devices. Common nanophotonical origin of absorptance enhancement is collective resonance on nanocavity gratings with different profiles, which is promoted by coupling between localized modes in quarter-wavelength metal-insulator-metal nanocavities and laterally synchronized Brewster-Zenneck-type surface waves in integrated SNSPDs possessing a three-quarter-wavelength-scaled periodicity. The spectral sensitivity and dispersion characteristics reveal that device design specific optimal configurations exist.
Open AccessPlasmonic Structure Integrated Single-Photon Detector Configurations to Improve Absorptance and Polarization Contrast
Configurations capable of maximizing both the absorption component of system detection efficiency and the achievable polarization contrast were determined for 1550 nm polarized light illumination of different plasmonic structure integrated superconducting nanowire single-photon detectors (SNSPDs) consisting of p = 264 nm and P = 792 nm periodic niobium nitride (NbN) patterns on silica substrate. Global effective NbN absorptance maxima appear in case of p/s-polarized light illumination in S/P-orientation (γ = 90°/0° azimuthal angle) and the highest polarization contrast is attained in S-orientation of all devices. Common nanophotonical origin of absorptance enhancement is collective resonance on nanocavity gratings with different profiles, which is promoted by coupling between localized modes in quarter-wavelength metal-insulator-metal nanocavities and laterally synchronized Brewster-Zenneck-type surface waves in integrated SNSPDs possessing a three-quarter-wavelength-scaled periodicity. The spectral sensitivity and dispersion characteristics reveal that device design specific optimal configurations exist.