Md. Rakibul Hasan

Nano size Copper (Cu) incorporated TiO₂ nanotubes was successfully synthesized via the anodic oxidation technique in ethylene glycol (EG) containing 0.5 wt % NH₄F and 1.6 wt % KOH for the photocatalytic degradation of Simazine (2-chloro-4, 6-diethylamino-1,3,5-triazine) under Ultraviolet (UV) illumination. In the present study, the influence of different loading Cu concentrations on the formation of Cu-TiO₂ nanotubes film towards the photocatalytic degradation of Simazine is reported. Based on our study, it was found that the optimum Cu loading concentration was about 0.45 wt % on TiO₂ nanotubes film for approximately 64% photocatalytic degradation of Simazine after 4 h under UV illumination. This finding was mainly attributed to the uniform surface covering of the Cu loaded TiO₂NTs which acted as electron traps, preventing the recombination of electron hole pairs, eventually leading to higher photocatalytic activity of our photocatalyst in degrading the targeted organic pollutant, Simazine. Moreover, an increased kinetic rate of the degradation to 0.0135 h⁻¹ was observed in the presence of Cu in TiO₂NTs.

A phenolic biosensor based on a zirconium oxide/polyethylene glycol/tyrosinase composite film for the detection of phenolic compounds has been explored. The formation of the composite film was expected via electrostatic interaction between hexacetyltrimethylammonium bromide (CTAB), polyethylene glycol (PEG), and zirconium oxide nanoparticles casted on screen printed carbon electrode (SPCE). Herein, the electrode was treated by casting hexacetyltrimethylammonium bromide on SPCE to promote a positively charged surface. Later, zirconium oxide was mixed with polyethylene glycol and the mixture was dropped cast onto the positively charged SPCE/CTAB. Tyrosinase was further immobilized onto the modified SPCE. Characterization of the prepared nanocomposite film and the modified SPCE surface was investigated by scanning electron microscopy (SEM), Electrochemical Impedance Spectroscopy (EIS), and Cyclic voltamogram (CV). The developed biosensor exhibits rapid response for less than 10 s. Two linear calibration curves towards phenol in the concentrations ranges of 0.075–10 µM and 10–55 µM with the detection limit of 0.034 µM were obtained. The biosensor shows high sensitivity and good storage stability for at least 30 days.

Highly efficient photoelectrocatalytic reduction of CO ₂ into methanol and formic acid at Cu doped RGO–TiO ₂ photoelectrode.

Ga doping in RGO–TiO ₂ nanocomposite photoelectrode shows enhanced photocurrent density (4.6 mA cm ⁻² ) in CO ₂ photoelectrocatalysis.