KOKim Olesen

Kim Olesen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Kim Olesen has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Efficient Beam Characterization for Reconfigurable Intelligent Surfaces

    by Yifa Li, Fengchun Zhang, Kim Olesen, Zhinong Ying, Gert Frølund Pedersen, Hao Sun, Wei Fan

    Reconfigurable Intelligent Surface (RIS) is an attractive solution in 6G wireless networks due to its versatile beam control capabilities. Characterization of RIS beam patterns, particularly their main beams, is essential during the design, optimization, and deployment stages. Conventionally, RIS beam patterns are measured sequentially in the far-field anechoic chambers, therefore the measurements are both time-consuming and costly. To address this, we propose an efficient RIS main beam characterization method by extracting signal responses from individual RIS elements in the all-on mode, and simultaneously reconstructing all possible RIS main beams based on these measured element responses and the phase configurations required for beamforming. We validated the method through RIS beam pattern measurements with a 2-bit $10\times 10$ RIS at 3.5 GHz, showing that the reconstructed main beams closely match those obtained from conventional measurements.


  • Multiple-Frequency-Band Channel Characterization for In-Vehicle Wireless Networks

    by Mengting Li, Yifa Li, Qiyu Zeng, Kim Olesen, Fengchun Zhang, Wei Fan

    In-vehicle wireless networks are crucial for advancing smart transportation systems and enhancing interaction among vehicles and their occupants. However, there are limited studies in the current state of the art that investigate the in-vehicle channel characteristics in multiple frequency bands. In this paper, we present measurement campaigns conducted in a van and a car across below 7 GHz, millimeter-wave (mmWave), and sub-Terahertz (Sub-THz) bands. These campaigns aim to compare the channel characteristics for in-vehicle scenarios across various frequency bands. Channel impulse responses (CIRs) were measured at various locations distributed across the engine bay of both the van and car. The CIR results reveal a high similarity in the delay properties between frequency bands below 7 GHz and mmWave bands for the measurements in the engine bay. Sparse channels can be observed at Sub-THz bands in the engine bay scenarios. Channel spatial profiles in the passenger cabin of both the van and car are obtained by the directional scan sounding scheme for three bands. We compare the power angle delay profiles (PADPs) measured at different frequency bands in two line of sight (LOS) scenarios and one non-LOS (NLOS) scenario. Some major multipath components (MPCs) can be identified in all frequency bands and their trajectories are traced based on the geometry of the vehicles. The angular spread of arrival is also calculated for three scenarios. The analysis of channel characteristics in this paper can enhance our understanding of in-vehicle channels and foster the evolution of in-vehicle wireless networks.


  • Experimental Over-the-Air Diagnosis of 1-Bit RIS Based on Complex Signal Measurements

    by Yifa Li, Fengchun Zhang, Kim Olesen, Zhinong Ying, Wei Fan

    The reconfigurable intelligent surface (RIS), is regarded as a promising technology for enhancing wireless system performance. The RIS design typically comprises a substantial number of cost-effective RIS elements. RIS diagnosis, which aims at identifying faulty RIS elements, is essential to ensure the RIS functions as intended. In this letter, a low-cost, robust, fast, yet highly effective over-the-air (OTA) diagnosis method based on complex signal measurements is proposed to detect the faulty phase shifters in passive 1-bit RISs. This method only requires a phase inversion operation (i.e., $0^{o}$ and $180^{o}$ phase states) for each RIS element. The algorithm is experimentally validated using a commercial RIS operating at 3.5 GHz in a mid-field anechoic measurement setup, (i.e., with a measurement distance much smaller than the Fraunhofer far-field distance of the RIS) demonstrating its effectiveness and robustness in practical setups.


  • Design and Validation of a Multilink Phase- Compensated Long-Range Ultrawideband VNA-Based Channel Sounder

    by Yejian Lyu, Allan Wainaina Mbugua, Zhiqiang Yuan, Kim Olesen, Wei Fan

    This article presents a novel and cost-effective vector network analyzer (VNA)-based phase-compensated channel sounder operating in the frequency range of 10–50 GHz using radio-over-fiber (RoF) techniques, which can support multilink/channel long-range phase-coherent measurements. The optical cable enables long-range channel measurements with a dynamic range of 115.7 dB at 30 GHz (for the back-to-back connection). The phase compensation scheme is utilized for stabilizing the inherent phase variations introduced by the optical fiber of the channel sounder to enable its application in multichannel/antenna measurements. A novel optical delay line and combiner scheme is proposed and implemented to separate the signals, thereby saving the port resource on the VNA for multilink/channel measurements. The proposed channel sounder is validated in back-to-back measurements under two optical cable conditions, i.e., with the presence of thermal changes and mechanical stress. The phase change could be maintained within 3° at 10–30 GHz and 7° in 30–50 GHz compared to the over 80° phase variation introduced by the cable effects at 10–50 GHz, demonstrating the robustness and effectiveness of the developed channel sounder in practice. With the proposed optical delay line and combiner scheme, multiple channels can be measured simultaneously with minimal VNA ports, significantly reducing the measurement cost and time for multilink channel measurements. Two multilink indoor channel measurements are conducted and analyzed using a virtual uniform rectangular array (URA) at 28-GHz bands. The results demonstrate the capability of the proposed channel sounder to perform high-fidelity long-range ultrawideband multilink channel measurements.


  • Design and Validation of the Phase-Compensated Long-Range Sub-THz VNA-Based Channel Sounder

    by Yejian Lyu, Allan Wainaina Mbugua, Kim Olesen, Pekka Kyosti, Wei Fan

    This paper presents the first vector network analyzer (VNA)-based sub-Terahertz (sub-THz) phase-compensated channel sounder at 220 330 GHz using radio-over-fiber (RoF) techniques that could enable long-range phase-coherent measurements. The optical cable solution enables long-range channel measurements at sub-THz bands, since it can effectively minimize the cable loss. This paper also proposes a novel phase compensation scheme to stabilize the phase variations introduced by optical fiber of the channel sounder to enable its application in multi-channel/antenna measurements. This proposed channel sounder is validated in back-to-back measurements under two optical cable conditions, i.e., with presence of thermal changes and mechanical stress. The phase variation introduced by the cable effects in the system is shown to be over 400_ in 220-330 GHz, compared to 15_ at 220-288 GHz and 37_ in 288-330 GHz after compensation, respectively, demonstrating the robustness and effectiveness of the developed channel sounder in practice. The developed system, which has a dynamic range of 106:7 dB, can support measurement range up to 300m (limited by the optical cable length in our system and subject to over-the-air signal transmission loss in practical environment).


  • Open Access

    UWB Wind Turbine Blade Deflection Sensing for Wind Energy Cost Reduction

    by Shuai Zhang, Tobias Lindstrøm Jensen, Ondrej Franek, Patrick C. F. Eggers, Kim Olesen, Claus Byskov, Gert Frølund Pedersen

    A new application of utilizing ultra-wideband (UWB) technology to sense wind turbine blade deflections is introduced in this paper for wind energy cost reduction. The lower UWB band of 3.1–5.3 GHz is applied. On each blade, there will be one UWB blade deflection sensing system, which consists of two UWB antennas at the blade root and one UWB antenna at the blade tip. The detailed topology and challenges of this deflection sensing system are addressed. Due to the complexity of the problem, this paper will first realize the on-blade UWB radio link in the simplest case, where the tip antenna is situated outside (and on the surface of) a blade tip. To investigate this case, full-blade time-domain measurements are designed and conducted under different deflections. The detailed measurement setups and results are provided. If the root and tip antenna locations are properly selected, the first pulse is always of sufficient quality for accurate estimations under different deflections. The measured results reveal that the blade tip-root distance and blade deflection can be accurately estimated in the complicated and lossy wireless channels around a wind turbine blade. Some future research topics on this application are listed finally.