Judit Farrando-Pérez
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Judit Farrando-Pérez has a total of 75 co-authors. Here are the top co-authors by number of shared publications:
- Joaquin Silvestre Albero
Laboratorio de Materiales Avanzados, Departamento de Química Inorgánica, Universidad de Alicante, 03690 Alicante, Spain
6 shared publications C. Cuadrado-Collados
4 shared publications- Manuel Martínez-Escandell
Laboratorio de Materiales Avanzados, Departamento de Química Inorgánica-Instituto Universitario de Materiales, Universidad de Alicante, E-03690 San Vicente del Raspeig, Spain
3 shared publications A. Arenillas
1 shared publicationA. D. Ebner
University of South Carolina, Columbia, USA
1 shared publicationA. Dailly
General Motors, Warren, USA
1 shared publication
Latest Publications
- Open Access
- 8 October 2024
- Published by Springer Nature in Nature Communications
- Vol. 15 (1) , 1-8
Tuneable mesoporous silica material for hydrogen storage application via nano-confined clathrate hydrate construction
Safe storage and utilisation of hydrogen is an ongoing area of research, showing potential to enable hydrogen becoming an effective fuel, substituting current carbon-based sources. Hydrogen storage is associated with a high energy cost due to its low density and boiling point, which drives a high price. Clathrates (gas hydrates) are water-based (ice-like) structures incorporating small non-polar compounds such as H2 in cages formed by hydrogen bonded water molecules. Since only water is required to construct the cages, clathrates have been identified as a potential solution for safe storage of hydrogen. In bulk, pure hydrogen clathrate (H2O-H2) only forms in harsh conditions, but confined in nanospaces the properties of water are altered and hydrogen storage at mild pressure and temperature could become possible. Here, specifically a hydrophobic mesoporous silica is proposed as a host material, providing a suitable nano-confinement for ice-like clathrate hydrate. The hybrid silica material shows an important decrease of the pressure required for clathrate formation (approx. 20%) compared to the pure H2O-H2 system. In-situ inelastic neutron scattering (INS) and neutron diffraction (ND) provided unique insights into the interaction of hydrogen with the complex surface of the hybrid material and demonstrated the stability of nano-confined hydrogen clathrate hydrate.
- 8 October 2024
- Published by Springer Nature in Nature Communications
- Vol. 15 (1) , 1-8
Open AccessTuneable mesoporous silica material for hydrogen storage application via nano-confined clathrate hydrate construction
Safe storage and utilisation of hydrogen is an ongoing area of research, showing potential to enable hydrogen becoming an effective fuel, substituting current carbon-based sources. Hydrogen storage is associated with a high energy cost due to its low density and boiling point, which drives a high price. Clathrates (gas hydrates) are water-based (ice-like) structures incorporating small non-polar compounds such as H2 in cages formed by hydrogen bonded water molecules. Since only water is required to construct the cages, clathrates have been identified as a potential solution for safe storage of hydrogen. In bulk, pure hydrogen clathrate (H2O-H2) only forms in harsh conditions, but confined in nanospaces the properties of water are altered and hydrogen storage at mild pressure and temperature could become possible. Here, specifically a hydrophobic mesoporous silica is proposed as a host material, providing a suitable nano-confinement for ice-like clathrate hydrate. The hybrid silica material shows an important decrease of the pressure required for clathrate formation (approx. 20%) compared to the pure H2O-H2 system. In-situ inelastic neutron scattering (INS) and neutron diffraction (ND) provided unique insights into the interaction of hydrogen with the complex surface of the hybrid material and demonstrated the stability of nano-confined hydrogen clathrate hydrate.
- Open Access
- 21 June 2023
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 48 (93) , 36474-36484
Improved thermal management in HKUST-1 composites upon graphite flakes incorporation: Hydrogen adsorption properties
- 21 June 2023
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 48 (93) , 36474-36484
Open AccessImproved thermal management in HKUST-1 composites upon graphite flakes incorporation: Hydrogen adsorption properties
- Open Access
- 1 January 2022
- Published by Elsevier in SSRN Electronic Journal
Carbon-Based Monoliths with Improved Thermal and Mechanical Properties for Methane Storage
A series of activated carbon materials have been prepared from petroleum residue using KOH as activating agent. The gravimetric adsorption capacity for methane of the synthesized samples increases with the activation degree, albeit at a lower packing density of the carbon material. These results anticipate an optimum pitch/KOH ratio (1:3) to achieve an upper limit in the volumetric storage capacity. Activated carbon powders have been conformed into monoliths using a small amount of a binder (5 wt.%), either carboxymethyl cellulose or polyvinyl alcohol, with proper mechanical properties. Incorporation of graphite or graphene in the initial formulation does not alter and/or modify significantly the textural properties of the original activated carbon. However, once conformed into monoliths, the presence of graphite or graphene allows to improve i) the packing density of the monoliths (up to 0.52 g/cm3), ii) their mechanical properties (compressive strength ≈ 12.3 MPa) and iii) their thermal conductivity (up to 0.49 W/mK) without compromising the methane storage capacity (ca. 100 V/V).
- 1 January 2022
- Published by Elsevier in SSRN Electronic Journal
Open AccessCarbon-Based Monoliths with Improved Thermal and Mechanical Properties for Methane Storage
A series of activated carbon materials have been prepared from petroleum residue using KOH as activating agent. The gravimetric adsorption capacity for methane of the synthesized samples increases with the activation degree, albeit at a lower packing density of the carbon material. These results anticipate an optimum pitch/KOH ratio (1:3) to achieve an upper limit in the volumetric storage capacity. Activated carbon powders have been conformed into monoliths using a small amount of a binder (5 wt.%), either carboxymethyl cellulose or polyvinyl alcohol, with proper mechanical properties. Incorporation of graphite or graphene in the initial formulation does not alter and/or modify significantly the textural properties of the original activated carbon. However, once conformed into monoliths, the presence of graphite or graphene allows to improve i) the packing density of the monoliths (up to 0.52 g/cm3), ii) their mechanical properties (compressive strength ≈ 12.3 MPa) and iii) their thermal conductivity (up to 0.49 W/mK) without compromising the methane storage capacity (ca. 100 V/V).
- 1 December 2020
- Published by Elsevier in Chemical Engineering Journal
- Vol. 402
Well-defined meso/macroporous materials as a host structure for methane hydrate formation: Organic versus carbon xerogels
- 1 December 2020
- Published by Elsevier in Chemical Engineering Journal
- Vol. 402
Well-defined meso/macroporous materials as a host structure for methane hydrate formation: Organic versus carbon xerogels
- Open Access
- 11 September 2020
- Published by Springer Nature in Adsorption
- Vol. 26 (8) , 1253-1266
A reference high-pressure CH4 adsorption isotherm for zeolite Y: results of an interlaboratory study
This paper reports the results of an international interlaboratory study led by the National Institute of Standards and Technology (NIST) on the measurement of high-pressure surface excess methane adsorption isotherms on NIST Reference Material RM 8850 (Zeolite Y), at 25 °C up to 7.5 MPa. Twenty laboratories participated in the study and contributed over one-hundred adsorption isotherms of methane on Zeolite Y. From these data, an empirical reference equation was determined, along with a 95% uncertainty interval (Uk=2). By requiring participants to replicate a high-pressure reference isotherm for carbon dioxide adsorption on NIST Reference Material RM 8852 (ZSM-5), this interlaboratory study also demonstrated the usefulness of reference isotherms in evaluating the performance of high-pressure adsorption experiments.
- 11 September 2020
- Published by Springer Nature in Adsorption
- Vol. 26 (8) , 1253-1266
Open AccessA reference high-pressure CH4 adsorption isotherm for zeolite Y: results of an interlaboratory study
This paper reports the results of an international interlaboratory study led by the National Institute of Standards and Technology (NIST) on the measurement of high-pressure surface excess methane adsorption isotherms on NIST Reference Material RM 8850 (Zeolite Y), at 25 °C up to 7.5 MPa. Twenty laboratories participated in the study and contributed over one-hundred adsorption isotherms of methane on Zeolite Y. From these data, an empirical reference equation was determined, along with a 95% uncertainty interval (Uk=2). By requiring participants to replicate a high-pressure reference isotherm for carbon dioxide adsorption on NIST Reference Material RM 8852 (ZSM-5), this interlaboratory study also demonstrated the usefulness of reference isotherms in evaluating the performance of high-pressure adsorption experiments.
- Open Access
- 12 June 2020
- Published by MDPI AG in Nanomaterials
- Vol. 10 (6) , 1156
Surface Interactions and Mechanisms Study on the Removal of Iodide from Water by Use of Natural Zeolite-Based Silver Nanocomposites
In this work a natural zeolite was modified with silver following two different methods to derive Ag2O and Ag0 nanocomposites. The materials were fully characterized and the results showed that both materials were decorated with nanoparticles of size of 5–25 nm. The natural and modified zeolites were used for the removal of iodide from aqueous solutions of initial concentration of 30–1400 ppm. Natural zeolite showed no affinity for iodide while silver forms were very efficient reaching a capacity of up to 132 mg/g. Post-adsorption characterizations showed that AgI was formed on the surface of the modified zeolites and the amount of iodide removed was higher than expected based on the silver content. A combination of experimental data and characterizations indicate that the excess iodide is most probably related to negatively charged AgI colloids and Ag-I complexes forming in the solution as well as on the surface of the modified zeolites.
- 12 June 2020
- Published by MDPI AG in Nanomaterials
- Vol. 10 (6) , 1156
Open AccessSurface Interactions and Mechanisms Study on the Removal of Iodide from Water by Use of Natural Zeolite-Based Silver Nanocomposites
In this work a natural zeolite was modified with silver following two different methods to derive Ag2O and Ag0 nanocomposites. The materials were fully characterized and the results showed that both materials were decorated with nanoparticles of size of 5–25 nm. The natural and modified zeolites were used for the removal of iodide from aqueous solutions of initial concentration of 30–1400 ppm. Natural zeolite showed no affinity for iodide while silver forms were very efficient reaching a capacity of up to 132 mg/g. Post-adsorption characterizations showed that AgI was formed on the surface of the modified zeolites and the amount of iodide removed was higher than expected based on the silver content. A combination of experimental data and characterizations indicate that the excess iodide is most probably related to negatively charged AgI colloids and Ag-I complexes forming in the solution as well as on the surface of the modified zeolites.
- 5 September 2018
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 122 (38) , 22008-22017
Direct Measurement of Microporosity and Molecular Accessibility in Stöber Spheres by Adsorption Isotherms
- 5 September 2018
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 122 (38) , 22008-22017
Direct Measurement of Microporosity and Molecular Accessibility in Stöber Spheres by Adsorption Isotherms