Lílian Moreira Barros
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Lílian Moreira Barros has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Andréa Mittelmann
Embrapa Dairy Cattle Juiz de Fora Minas Gerais Brazil
1 shared publication - Antonio Costa de Oliveira
Plant Genomics and Breeding Center, Department of Plant Sciences, Faculty of Agronomy “Eliseu Maciel”, Federal University of Pelotas, Capão do Leão 96160-000, RS, Brazil
1 shared publication - Bianca Camargo Aranha
Crop Protection Federal University of Pelotas Pelotas RS Brazil
1 shared publication - Bruno Lemos Batista
Centro de Ciências Naturais e Humanas, Universidade Federal do ABC, Santo André 09280-560, SP, Brazil
1 shared publication - Camila Pegoraro
Plant Genomics and Breeding Center, Department of Plant Sciences, Faculty of Agronomy “Eliseu Maciel”, Federal University of Pelotas, Capão do Leão 96160-000, RS, Brazil
1 shared publication - Carlos Busanello
Universidade Federal de Pelotas
1 shared publication
Latest Publications
- Open Access
- 25 March 2022
- Published by Universidad Nacional de Colombia in Acta Agronomica
- Vol. 70 (3)
Sowing rate and its effects on forage yield of tetraploid ryegrass
There is a shortage of information about the ryegrass crop (Lolium multiflorum Lam.), especially regarding the suitable sowing rate. Thus, the present work aimed to determine the most adequate sowing rate for tetraploid ryegrass cultivars. A tetraploid ryegrass population was sown at different densities: 150, 300, 600, 900, 1200, 1500, 1800 seeds/m². The number of plants per m², percentage of soil cover, leaf yield and green and dry forage yield were evaluated. The experimental design was randomized blocks with three replications. To observe the behavior of the pasture at different densities for each cut, regression analysis was performed, through which it was possible to verify that the sowing rate has greater influence on the initial cut of the crop. In all the variables analyzed by regression, only the second cut presented a linear trend favorable to the increase in density. In the other cuts, an increase was observed, both in the height of plants and in the yield variables, up to the density of 1500 seeds/m², with a subsequent fall to the highest density, indicating that higher densities may be detrimental to pasture yield. Therefore the density of 1500 seeds/m² is the most suitable for tetraploid ryegrass cultivars.
- 25 March 2022
- Published by Universidad Nacional de Colombia in Acta Agronomica
- Vol. 70 (3)
Open AccessSowing rate and its effects on forage yield of tetraploid ryegrass
There is a shortage of information about the ryegrass crop (Lolium multiflorum Lam.), especially regarding the suitable sowing rate. Thus, the present work aimed to determine the most adequate sowing rate for tetraploid ryegrass cultivars. A tetraploid ryegrass population was sown at different densities: 150, 300, 600, 900, 1200, 1500, 1800 seeds/m². The number of plants per m², percentage of soil cover, leaf yield and green and dry forage yield were evaluated. The experimental design was randomized blocks with three replications. To observe the behavior of the pasture at different densities for each cut, regression analysis was performed, through which it was possible to verify that the sowing rate has greater influence on the initial cut of the crop. In all the variables analyzed by regression, only the second cut presented a linear trend favorable to the increase in density. In the other cuts, an increase was observed, both in the height of plants and in the yield variables, up to the density of 1500 seeds/m², with a subsequent fall to the highest density, indicating that higher densities may be detrimental to pasture yield. Therefore the density of 1500 seeds/m² is the most suitable for tetraploid ryegrass cultivars.
- 14 June 2020
- Published by Springer Nature in Biological Trace Element Research
- Vol. 199 (3) , 1194-1206
Mineral and Fatty Acid Content Variation in White Oat Genotypes Grown in Brazil
A healthy diet is directly associated with a nutrient-rich and toxic contaminant poor intake. A diet poor in diversity can lead to micronutrient deficiency. The intake of functional foods can provide benefits in the prevention and treatment of diseases. Oats are a functional food; are a source of soluble fiber, lipids, proteins, vitamins, minerals, and polyphenols; and are low in carbohydrate content. Thus, in this study, we characterize mineral accumulation, fatty acid composition, and the absence of contaminants in oat genotypes to evaluate the potential of this cereal as food to minimize the effects of micronutrient deficiency. Most of the oat genotypes showed higher mineral levels than other cereals such as wheat, rice, and maize. FAEM 5 Chiarasul, Barbarasul, UPFA Ouro, URS Altiva, URS Brava, and URS Taura showed higher iron concentration while URS Brava showed the highest zinc concentration. The oat genotypes did not show significant arsenic, strontium, and cadmium accumulation. Considering the accumulation of trace elements in the grain, little genetic diversity among the analyzed oat accessions was detected, dividing into two groups. Regarding fatty acid composition, IPR Afrodite, FAEM 4 Carlasul, FAEM 5 Chiarasul, URS Taura, Barbarasul, and URS 21 showed higher essential fatty acid concentrations. These genotypes can be used in crosses with URS Brava, which displayed a higher Fe and Zn accumulation and is genetically distant from the other cultivars. Oat is a functional food showing ability for the accumulation of minerals and also essential fatty acids.
- 14 June 2020
- Published by Springer Nature in Biological Trace Element Research
- Vol. 199 (3) , 1194-1206
Mineral and Fatty Acid Content Variation in White Oat Genotypes Grown in Brazil
A healthy diet is directly associated with a nutrient-rich and toxic contaminant poor intake. A diet poor in diversity can lead to micronutrient deficiency. The intake of functional foods can provide benefits in the prevention and treatment of diseases. Oats are a functional food; are a source of soluble fiber, lipids, proteins, vitamins, minerals, and polyphenols; and are low in carbohydrate content. Thus, in this study, we characterize mineral accumulation, fatty acid composition, and the absence of contaminants in oat genotypes to evaluate the potential of this cereal as food to minimize the effects of micronutrient deficiency. Most of the oat genotypes showed higher mineral levels than other cereals such as wheat, rice, and maize. FAEM 5 Chiarasul, Barbarasul, UPFA Ouro, URS Altiva, URS Brava, and URS Taura showed higher iron concentration while URS Brava showed the highest zinc concentration. The oat genotypes did not show significant arsenic, strontium, and cadmium accumulation. Considering the accumulation of trace elements in the grain, little genetic diversity among the analyzed oat accessions was detected, dividing into two groups. Regarding fatty acid composition, IPR Afrodite, FAEM 4 Carlasul, FAEM 5 Chiarasul, URS Taura, Barbarasul, and URS 21 showed higher essential fatty acid concentrations. These genotypes can be used in crosses with URS Brava, which displayed a higher Fe and Zn accumulation and is genetically distant from the other cultivars. Oat is a functional food showing ability for the accumulation of minerals and also essential fatty acids.