Adriana S. Oliveira
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Adriana S. Oliveira has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Jose Alberto Baeza
Departamento de Ingeniería Química, Universidad Autónoma de Madrid, C/Francisco Tomás y Valiente 7, 28049 Madrid, Spain
6 shared publications - Luisa Calvo
Departamento de Ingeniería Química, Universidad Autónoma de Madrid, C/Francisco Tomás y Valiente 7, 28049 Madrid, Spain
5 shared publications M.A. Gilarranz
3 shared publicationsB. Saenz de Miera
2 shared publications- Carine Tondo Alves
Universidade Federal do Recôncavo da Bahia
2 shared publications E.A. Torres
2 shared publications
Latest Publications
- Open Access
- 9 February 2023
- Published by Elsevier in Chemical Engineering Journal
- Vol. 460
Aqueous phase reforming of starch wastewater over Pt and Pt-based bimetallic catalysts for green hydrogen production
- 9 February 2023
- Published by Elsevier in Chemical Engineering Journal
- Vol. 460
Open AccessAqueous phase reforming of starch wastewater over Pt and Pt-based bimetallic catalysts for green hydrogen production
- Open Access
- 16 October 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (20) , 10424
Toward Sustainability of the Aqueous Phase Reforming of Wastewater: Heat Recovery and Integration
Aqueous-phase reforming has been revealed as a novel, interesting and efficient process for the treatment of wastewater containing organic pollutants. However, due to the relatively severe operating conditions (above 15 bar and 200 °C), this process could become economically competitive if any solution for energy or material valorization is implemented. Most research has been devoted to direct the process to H2 production as an alternative to reach economic sustainability, but the results obtained were not competitive in the current market of hydrogen and syngas. In this work, a preliminary simulation study (using Aspen HYSYS software) of the process heat balance in different conditions was implemented to induce a heat integration that would allow the auto-sustainability of the process, even generating in some cases an excess of energy that could constitute an opportunity for a positive economic balance. The results showed that this approach would only be possible by maximizing the methane production to the detriment of hydrogen production.
- 16 October 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (20) , 10424
Open AccessToward Sustainability of the Aqueous Phase Reforming of Wastewater: Heat Recovery and Integration
Aqueous-phase reforming has been revealed as a novel, interesting and efficient process for the treatment of wastewater containing organic pollutants. However, due to the relatively severe operating conditions (above 15 bar and 200 °C), this process could become economically competitive if any solution for energy or material valorization is implemented. Most research has been devoted to direct the process to H2 production as an alternative to reach economic sustainability, but the results obtained were not competitive in the current market of hydrogen and syngas. In this work, a preliminary simulation study (using Aspen HYSYS software) of the process heat balance in different conditions was implemented to induce a heat integration that would allow the auto-sustainability of the process, even generating in some cases an excess of energy that could constitute an opportunity for a positive economic balance. The results showed that this approach would only be possible by maximizing the methane production to the detriment of hydrogen production.
- 1 October 2020
- Published by Elsevier in Journal of Water Process Engineering
- Vol. 37
Sewage treatment using Aqueous Phase Reforming for reuse purpose
- 1 October 2020
- Published by Elsevier in Journal of Water Process Engineering
- Vol. 37
Sewage treatment using Aqueous Phase Reforming for reuse purpose
- 1 April 2020
- Published by Elsevier in Renewable Energy
- Vol. 148, 889-896
Effect of basicity in the aqueous phase reforming of brewery wastewater for H2 production
- 1 April 2020
- Published by Elsevier in Renewable Energy
- Vol. 148, 889-896
Effect of basicity in the aqueous phase reforming of brewery wastewater for H2 production
- 1 May 2019
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 245, 367-375
Production of hydrogen from brewery wastewater by aqueous phase reforming with Pt/C catalysts
- 1 May 2019
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 245, 367-375
Production of hydrogen from brewery wastewater by aqueous phase reforming with Pt/C catalysts
- Open Access
- 12 September 2018
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Water Research & Technology
- Vol. 4 (12) , 1979-1987
Exploration of the treatment of fish-canning industry effluents by aqueous-phase reforming using Pt/C catalysts
In the current work, an exploratory study on the application of catalytic aqueous phase reforming (APR) to the treatment of fish-canning wastewater was performed for the first time. Pt/C (3%, w) catalysts were supported on different commercial carbon supports (two activated carbons and a carbon black) and tested in the APR of tuna-cooking wastewater. The effect of the supports and the reaction systems (batch vs. semi-continuous) on the performance of the catalysts was tested. The stability of the catalysts upon 3 successive reuse cycles was checked. TOC and COD removal ranged within 45–60%, which was ascribed to adsorption on the supports, hydrothermal carbonization and APR. The percentage of valuable gases (H2 and alkanes) reached up to 18% of the gas production showing the potential of APR for the valorization and treatment of wastewater. The production of gases is affected by the high chloride, acetate and phosphate concentrations, which may provoke catalyst deactivation. The use of a catalyst with a basic support significantly increased the production of gases and the H2 percentage in the gas fraction. Gas production was higher in semi-continuous compared to batch operation, maybe because the withdrawn gas displaces the reaction towards the products. The percentage of alkanes in the gas phase decreased upon successive catalyst reuse cycles at the expense of H2, which is probably due to sintering of Pt nanoparticles with the corresponding decrease of the number of low-coordinated Pt sites promoting methanation reactions.
- 12 September 2018
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Water Research & Technology
- Vol. 4 (12) , 1979-1987
Open AccessExploration of the treatment of fish-canning industry effluents by aqueous-phase reforming using Pt/C catalysts
In the current work, an exploratory study on the application of catalytic aqueous phase reforming (APR) to the treatment of fish-canning wastewater was performed for the first time. Pt/C (3%, w) catalysts were supported on different commercial carbon supports (two activated carbons and a carbon black) and tested in the APR of tuna-cooking wastewater. The effect of the supports and the reaction systems (batch vs. semi-continuous) on the performance of the catalysts was tested. The stability of the catalysts upon 3 successive reuse cycles was checked. TOC and COD removal ranged within 45–60%, which was ascribed to adsorption on the supports, hydrothermal carbonization and APR. The percentage of valuable gases (H2 and alkanes) reached up to 18% of the gas production showing the potential of APR for the valorization and treatment of wastewater. The production of gases is affected by the high chloride, acetate and phosphate concentrations, which may provoke catalyst deactivation. The use of a catalyst with a basic support significantly increased the production of gases and the H2 percentage in the gas fraction. Gas production was higher in semi-continuous compared to batch operation, maybe because the withdrawn gas displaces the reaction towards the products. The percentage of alkanes in the gas phase decreased upon successive catalyst reuse cycles at the expense of H2, which is probably due to sintering of Pt nanoparticles with the corresponding decrease of the number of low-coordinated Pt sites promoting methanation reactions.
- Open Access
- 1 February 2013
- Published by Elsevier in Fuel Processing Technology
- Vol. 106, 102-107
Transesterification of waste frying oil using a zinc aluminate catalyst
- 1 February 2013
- Published by Elsevier in Fuel Processing Technology
- Vol. 106, 102-107
Open AccessTransesterification of waste frying oil using a zinc aluminate catalyst
- Open Access
- 1 January 2012
- Published by Elsevier in Procedia Engineering
- Vol. 42, 1928-1945
Transesterification of Waste Frying Oils Using ZnAl2O4 as Heterogeneous Catalyst
- 1 January 2012
- Published by Elsevier in Procedia Engineering
- Vol. 42, 1928-1945
Open AccessTransesterification of Waste Frying Oils Using ZnAl2O4 as Heterogeneous Catalyst