Yoo-Lim Cheon
Research Subjects
Yoo-Lim Cheon has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
- Moses Chung
Pohang University of Science and Technology
6 shared publications - Dong-O Jeon
IRIS Institute for Basic Science 34000 Daejeon Republic of Korea
3 shared publications Seok-Ho Moon
Intense Beam and Accelerator Laboratory, Department of Physics, Ulsan National Institute of Science and Technology, Ulsan 44919, Republic of Korea
2 shared publicationsAlex Taylor
Facility for Rare Isotope Beams
1 shared publicationAndrei Ganshyn
Facility for Rare Isotope Beams
1 shared publicationC.K. Sung
Department of Physics, Ulsan National Institute of Science and Technology, Ulsan 44919, Korea
1 shared publication
Latest Publications
- Open Access
- 10 March 2026
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 29 (3)
Improved high-gradient performance for medium-velocity superconducting half-wave resonators: Surface preparation and trapped flux mitigation
A development effort to improve the performance of superconducting radio-frequency half-wave resonators (SRF HWRs) is underway at the Facility for Rare Isotope Beams (FRIB), where 220 such resonators are in operation. Our goal was to achieve an intrinsic quality factor ( Q 0 ) of ≥ 2 × 10 10 at an accelerating gradient ( E acc ) of 12 MV / m . FRIB production resonators were prepared with buffered chemical polishing. First trials of electropolishing (EP) and post-EP low-temperature baking of FRIB HWRs allowed us to reach higher gradient (15 MV/m, limited by quench) with a higher quality factor at high gradient, but Q 0 was still below our goal. Trapped magnetic flux during the Dewar test was found to be a source of Q 0 reduction. Three strategies were used to reduce the trapped flux: (i) adding a local magnetic shield (LMGS) to supplement the “global” magnetic shield around the Dewar for reduction of the ambient magnetic field; (ii) performing a “uniform cooldown” (UC) to reduce the thermoelectric currents; and (iii) using a compensation coil to further reduce the ambient field with active field cancellation (AFC). The LMGS improved the Q 0 , but not enough to reach our goal. With UC and AFC, we exceeded our goal, reaching Q 0 = 2.8 × 10 10 at E acc = 12 MV / m .
- 10 March 2026
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 29 (3)
Open AccessImproved high-gradient performance for medium-velocity superconducting half-wave resonators: Surface preparation and trapped flux mitigation
A development effort to improve the performance of superconducting radio-frequency half-wave resonators (SRF HWRs) is underway at the Facility for Rare Isotope Beams (FRIB), where 220 such resonators are in operation. Our goal was to achieve an intrinsic quality factor ( Q 0 ) of ≥ 2 × 10 10 at an accelerating gradient ( E acc ) of 12 MV / m . FRIB production resonators were prepared with buffered chemical polishing. First trials of electropolishing (EP) and post-EP low-temperature baking of FRIB HWRs allowed us to reach higher gradient (15 MV/m, limited by quench) with a higher quality factor at high gradient, but Q 0 was still below our goal. Trapped magnetic flux during the Dewar test was found to be a source of Q 0 reduction. Three strategies were used to reduce the trapped flux: (i) adding a local magnetic shield (LMGS) to supplement the “global” magnetic shield around the Dewar for reduction of the ambient magnetic field; (ii) performing a “uniform cooldown” (UC) to reduce the thermoelectric currents; and (iii) using a compensation coil to further reduce the ambient field with active field cancellation (AFC). The LMGS improved the Q 0 , but not enough to reach our goal. With UC and AFC, we exceeded our goal, reaching Q 0 = 2.8 × 10 10 at E acc = 12 MV / m .
- Open Access
- 23 April 2025
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 57 (9)
Design and beam dynamics of a 400 kW D + linear accelerator to generate fusion-like neutrons for breeding blanket tests in Korea
- 23 April 2025
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 57 (9)
Open AccessDesign and beam dynamics of a 400 kW D + linear accelerator to generate fusion-like neutrons for breeding blanket tests in Korea
- 12 June 2023
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 83 (8) , 620-633
Overview of fusion-like neutron sources based on high-intensity linear accelerators
- 12 June 2023
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 83 (8) , 620-633
Overview of fusion-like neutron sources based on high-intensity linear accelerators
- Open Access
- 10 June 2022
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 25 (6) , 064002
Effects of beam spinning on the fourth-order particle resonance of 3D bunched beams in high-intensity linear accelerators
The aim of this study is to make the parameter space of zero-current phase advance greater than 90° available to the high-intensity linear accelerator (linac) design and operation, which has been excluded to avoid the envelope instabilities and particle resonances. The earlier study of Cheon et al. [ Nucl. Instrum. Methods Phys. Res., Sect. A 1013, 165647 (2021)] reported that the spinning of ion beams can mitigate the fourth-order particle resonance and the associated envelope instability in high-intensity linacs. In the present work, we further investigate the effects of beam spinning on the fourth-order particle resonance in the case of 3D bunched beams with fast acceleration. We also explore the space-charge-driven resonance in the longitudinal plane and confirm that the fourth-order particle resonance can be manifested when the longitudinal zero-current phase advance is larger than 90° and the depressed phase advance is less than 90°, similar to the transverse case. The beam spinning effects are examined in both transverse and longitudinal planes during beam acceleration through periodic solenoid and quadrupole-doublet focusing channels.- 10 June 2022
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 25 (6) , 064002
Open AccessEffects of beam spinning on the fourth-order particle resonance of 3D bunched beams in high-intensity linear accelerators
The aim of this study is to make the parameter space of zero-current phase advance greater than 90° available to the high-intensity linear accelerator (linac) design and operation, which has been excluded to avoid the envelope instabilities and particle resonances. The earlier study of Cheon et al. [ Nucl. Instrum. Methods Phys. Res., Sect. A 1013, 165647 (2021)] reported that the spinning of ion beams can mitigate the fourth-order particle resonance and the associated envelope instability in high-intensity linacs. In the present work, we further investigate the effects of beam spinning on the fourth-order particle resonance in the case of 3D bunched beams with fast acceleration. We also explore the space-charge-driven resonance in the longitudinal plane and confirm that the fourth-order particle resonance can be manifested when the longitudinal zero-current phase advance is larger than 90° and the depressed phase advance is less than 90°, similar to the transverse case. The beam spinning effects are examined in both transverse and longitudinal planes during beam acceleration through periodic solenoid and quadrupole-doublet focusing channels. - 1 June 2020
- Published by AIP Publishing in Physics of Plasmas
- Vol. 27 (6) , 063105
Analysis on the stop band of fourth-order resonance in high-intensity linear accelerators
The earlier study of [Jeon et al., Phys. Rev. Spec. Top.--Accel. Beams 12, 054204 (2009)] discovered fourth-order particle resonance in linear accelerators (linacs) for any non-KV distributions (such as Gaussian and waterbag) and found that this particle resonance was predominantly manifested over the envelope instability. Several experiments have since been performed and demonstrated that fourth-order resonance indeed occurred for . Nonetheless, the lower bound of the particle resonance stop band and detailed parametric studies (e.g., scanning with various beam currents and zero-current phase advances σ0) on the emittance growth from the fourth-order resonance have been somewhat limited. This paper presents analytical and numerical investigations to observe the fourth-order resonance under several focusing field types (e.g., solenoid and quadrupole) with a wide range of parameters. From these studies, the general stop band for the fourth-order particle resonance is established to be and . Self-consistent multi-particle simulations using TraceWin and PARMILA codes are performed with initially well-matched Gaussian beams to observe the emittance growth originating from the fourth-order particle resonance. It is found that the emittance growth rate varies depending on σ0 and tune depression (or equivalently beam current). It transpires that the region in which the envelope instability develops is consistent with the envelope instability stop band. The fourth-order particle resonance stop band is wider than the envelope instability stop band, and the envelope instability is induced following fourth-order particle resonance only within the envelope instability stop band in the tune-depression space.- 1 June 2020
- Published by AIP Publishing in Physics of Plasmas
- Vol. 27 (6) , 063105
Analysis on the stop band of fourth-order resonance in high-intensity linear accelerators
The earlier study of [Jeon et al., Phys. Rev. Spec. Top.--Accel. Beams 12, 054204 (2009)] discovered fourth-order particle resonance in linear accelerators (linacs) for any non-KV distributions (such as Gaussian and waterbag) and found that this particle resonance was predominantly manifested over the envelope instability. Several experiments have since been performed and demonstrated that fourth-order resonance indeed occurred for . Nonetheless, the lower bound of the particle resonance stop band and detailed parametric studies (e.g., scanning with various beam currents and zero-current phase advances σ0) on the emittance growth from the fourth-order resonance have been somewhat limited. This paper presents analytical and numerical investigations to observe the fourth-order resonance under several focusing field types (e.g., solenoid and quadrupole) with a wide range of parameters. From these studies, the general stop band for the fourth-order particle resonance is established to be and . Self-consistent multi-particle simulations using TraceWin and PARMILA codes are performed with initially well-matched Gaussian beams to observe the emittance growth originating from the fourth-order particle resonance. It is found that the emittance growth rate varies depending on σ0 and tune depression (or equivalently beam current). It transpires that the region in which the envelope instability develops is consistent with the envelope instability stop band. The fourth-order particle resonance stop band is wider than the envelope instability stop band, and the envelope instability is induced following fourth-order particle resonance only within the envelope instability stop band in the tune-depression space.- 1 April 2019
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 14 (04) , P04007
Design study of Beam Loss Monitoring system for the Rare Isotope Science Project in Korea
A new heavy ion accelerator facility called RAON is being constructed in Daejeon, Korea to produce rare isotope beams of various energies for the Rare Isotope Science Project (RISP). This facility is designed to use both the In-flight Fragmentation (IF) and Isotope Separation On-Line (ISOL) systems to provide a wide range of rare isotope beams to be utilized in many fundamental physics experiments and in various applications. The RAON can use both stable heavy ion beams and rare isotope beams with energies up to a few hundreds of MeV/u with 400 kW of beam power. One of the greatest challenges in operating such a high beam power facility (~400 kW) is to accurately monitor the beam loss and trigger the Machine Protection System (MPS) reasonably quickly. In this paper, we report the conceptual design of the RAON beam loss monitoring system. Monte Carlo simulations using the MCNPX code were performed to understand beam loss-induced neutron and gamma radiation. The types of detectors were determined based on radiation simulations while considering the sensitivities of the detectors and response time requirements.
- 1 April 2019
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 14 (04) , P04007
Design study of Beam Loss Monitoring system for the Rare Isotope Science Project in Korea
A new heavy ion accelerator facility called RAON is being constructed in Daejeon, Korea to produce rare isotope beams of various energies for the Rare Isotope Science Project (RISP). This facility is designed to use both the In-flight Fragmentation (IF) and Isotope Separation On-Line (ISOL) systems to provide a wide range of rare isotope beams to be utilized in many fundamental physics experiments and in various applications. The RAON can use both stable heavy ion beams and rare isotope beams with energies up to a few hundreds of MeV/u with 400 kW of beam power. One of the greatest challenges in operating such a high beam power facility (~400 kW) is to accurately monitor the beam loss and trigger the Machine Protection System (MPS) reasonably quickly. In this paper, we report the conceptual design of the RAON beam loss monitoring system. Monte Carlo simulations using the MCNPX code were performed to understand beam loss-induced neutron and gamma radiation. The types of detectors were determined based on radiation simulations while considering the sensitivities of the detectors and response time requirements.