Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Dmitry Vladimirovich Balandin has a total of 35 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Modeling of Controlled Omnidirectional Motion of a Spherical Robot with Electromagnetic Drive

    by Dmitry V. Balandin, Alexander M. Tuzikov, Ruslan S. Biryukov

    This paper extends the modeling and control of a spherical robot with electromagnetic drive (SRED) from planar to fully three-dimensional motion on uneven surfaces. The robot consists of two concentric spherical shells: an outer shell carrying permanent magnets (PMs) and an inner shell with solenoid-type electromagnets (EMs); rolling is produced by the controlled electromagnetic interaction between the two magnet arrays. To enable omnidirectional rolling, the magnet placement is generalized to vertex-transitive polyhedra with cubic or icosahedral symmetry, which preserves the scalarity of the inertia tensors and allows the existing optimal control framework to be applied without modification. Within this class, \(M=60\) PMs on a rhombicosidodecahedron and \(S=24\) EMs on a truncated octahedron are selected; numerical evaluation over \(10^{4}\) relative orientations confirms that a nonzero torque can be generated about an arbitrary axis. The drive model is reformulated as a three-dimensional torque map matrix, and coil currents and terminal voltages are recovered from a reference torque via the generalized-\(H_{2}\) optimal controller, a Tikhonov-regularized pseudoinverse, and Kirchhoff’s circuit equations with back-EMF terms. Simulations of straight-line rolling, lateral-offset correction, and three-dimensional path tracking on a Gaussian bell-shaped surface confirm convergence of the tracking error to zero, with currents and voltages within the range of standard low-voltage motor drivers.

  • Worst-Case Impact Problems for Mechanical Systems with Distributed Parameters

    by Polina P. Tkachenko, Dmitry V. Balandin, Tatiana V. Ryabikova, Alexander K. Lyubimov

  • The Worst-Case Disturbances Acting on Multi-mass Mechanical Systems

    by Polina Tkachenko, Dmitry Balandin, Tatiana Ryabikova


  • Optimal Control of the Movement of a Spherical Robot on Uneven Surfaces

    by D. V. Balandin, R. S. Biryukov, A. M. Tuzikov

    We consider a mathematical model of the continuous movement of a spherical robot over an arbitrary uneven surface, as well as a reduced model that excludes slipping and twisting. State-feedback control laws are synthesized to ensure that the robot moves along a given trajectory. The effectiveness of the proposed control laws is demonstrated by computer simulation results. A possible implementation of an electromagnetic drive for generating the robot’s motion is discussed.


  • Open Access

    The problems of the worst-case disturbances acting on multi-mass elastic system

    by Polina P. Tkachenko, Dmitry V. Balandin, Tatiana V. Ryabikova, Рябикова Татьяна Владимировна

    An analytical framework for synthesizing worst-case external disturbances for linear dynamical systems described by ordinary differential equations is presented in the paper. The study is conducted for three classical functional spaces $L_2, L_{\infty}, L_1$ over a fixed time interval, which corresponds to identifying disturbances with bounded energy, bounded amplitude, and bounded impulse, respectively. Linear elastic mechanical systems are chosen as a illustrative object of analysis, thus providing an intuitive interpretation of the results. A unified performance metric is introduced for quantitative assessment of solutions. This metrics is the ratio of a system's target output (e.g., maximum deviation) to the $L_p$-norm of the disturbance (i.e. the normalized system response). Explicit analytical expressions for the worst-case disturbances and their corresponding performance indices are derived. The interrelations between the indices obtained for different disturbance classes are examined. Numerical simulation results are provided for single- and multiple-degree-of-freedom systems, represented as chains of point masses interconnected by elastic and damping elements, and connected to a movable base.


  • Open Access

    Optimal control of coupled buildings under seismic excitation

    by Polina Tkachenko, Dmitry Balandin

    The article explores the concept of managing coupled buildings under seismic excitation. Connecting two closely spaced structures enables the redistribution of energy and reduction of structural responses. To minimize the resulting damage, the use of smart control is proposed. Smart control operates using feedback, allowing the system to adapt in real-time. To solve the problem of finding an optimal control, the paper suggests considering it within the framework of multicriteria optimization problems, with the criteria being the maximum deformation of each building described using the generalized H 2 -norm. The article presents a method for solving multicriteria problems using linear matrix inequalities (LMIs) and Hermeyer convolution. Detailed examples are provided for a system of two coupled buildings. The results of computing the optimal smart control for systems of varying dimensions, as well as the outcomes of modeling using real earthquake data, are presented MATLAB software, utilizing the SDPT3 and YALMIP libraries, is employed for performing the calculations and visualizing the results.

  • Path Tracking Control of a Spherical Robot with Pendulum-Like Driver

    by Dmitry V. Balandin, Ruslan S. Biryukov, Alexander M. Tuzikov


  • Open Access

    Математическая модель и комбинированный квазиоптимальный алгоритм процесса переработки сахарной свеклы

    by Дмитрий Владимирович Баландин, Олег Анатольевич Кузенков, Альберт Исмаилович Эгамов, Арина Олеговна Гертель

    В статье представлена математическая модель переработки сахарной свеклы. Рассматривается набор партий сырья, которые отличается друг от друга исходным химическим составом и скоростью его изменения в течение хранения. Отличительная особенность исследования состоит в учете эффекта дозревания сырья на начальной стадии хранения. Основная оптимизационная задача исследования состоит в том, чтобы построить такую последовательность переработки имеющихся партий сырья, при которой выход сахара будет максимальным. Точное решение поставленной задачи возможно на основе хорошо известной в дискретной оптимизации задачи о назначениях. Однако невозможность априорного знания об изменении всех характеристик сырья во время хранения требует разработки эвристических алгоритмов, не использующих исчерпывающую информацию о составе сырья. В настоящей статье предложены два новых эвристических алгоритма переработки, которые являются комбинациями уже известных эвристических алгоритмов — «жадного» и «бережливого». Такая комбинация обусловлена эффектом дозаривания сырья и состоит в поочередном применении «жадного» и «бережливого» алгоритмов на разных стадиях хранения — в период дозаривания и в последующее время, когда происходит увядание свеклы, сопровождающееся снижением сахаристости. В ходе проведенного исследования решена задача оценки возможных потерь при реализации эвристических квазиоптимальных алгоритмов переработки сахарной свеклы по отношению к теоретически рассчитанному максимально возможному выходу сахара. Оценка предлагаемых алгоритмов проводилась с учетом данных Сергачского сахарного завода. В результате проведенного исследования было установлено, что квазиоптимальным алгоритмом независимо от продолжительности стадии дозаривания является бережливый/ жадный алгоритм. Именно этот алгоритм рекомендуется использовать на практике при наличии процесса дозаривания.


  • Comparison of Heuristic Strategies for Sugar Beet Processing Schedules

    by Dmitry V. Balandin, Albert I. Egamov, Oleg A. Kuzenkov

    The article considers heuristic strategies of processing batches of sugar beet taking into account their uneven degradation. The processing sequence affects the amount of output of sugar. The purpose is to maximize the sugar yield. The optimization problem is closely related to the well-known assignment problem of discrete optimization. Various heuristic strategies have been proposed to achieve the stated purpose. To evaluate the capabilities of different strategies, a numerical experiment was carried out. For known sets of initial sugar content and batch degradation parameters at each processing stage, the value of the objective function for each of the proposed strategies is calculated. After 50 such experiments, the average relative losses were calculated and tables of relative losses were built. The results obtained allow us to evaluate which strategy is preferable for this acceptable set of parameters, and which ones are not profitable to use exclusively. The results were analyzed and recommendations for practical implementation were drawn up.


  • Open Access

    Educational and Research Project in the System of Formation of Digital Culture Competencies

    by Dmitry Vladimirovich Balandin, Oleg Anatolyevich Kuzenkov, Albert Ismailovich Egamov, Arina Olegovna Gertel

    Обсуждается связь масштабной национальной программы «Цифровая экономика Российской Федерации» и модернизации подготовки специалистов в области ИТ. Наиболее перспективным для образовательного процесса, с точки зрения исследователей, является проектный подход. Он активно внедряется в обучение различных образовательных учреждений для подготовки бакалавров и магистров в области информационных технологий. Исследуется применение таких проектов как приоритетных в Нижегородском государственном университете им. Н. И. Лобачевского. В статье в качестве показательного приводится учебно-исследовательский проект о нахождении оптимального плана переработки сахарной свеклы. Этот проект имеет следующие плюсы: мощная теоретическая основа, тесная связь учебного материала с действительностью, интуитивно понятные алгоритмы, связанные с численным решением задачи. Описывается ход реализации этой работы. Для проверки готовности студента к экспериментальной части авторами проекта подготовлена теоретическая часть. Всего авторами подготовлено 4 этапа прохождения данного проекта. Проверяется в том числе умение находить на практике квазиоптимальные решения оптимизационной задачи. На выходе обязательно представление графиков целевых функций для различных планов переработки партий свеклы, полученных вследствие работы программы, написанной на популярном алгоритмическом языке Python. Это необходимо для умения наглядного представления и сравнения результатов, полученных при применении различных тактик и планов переработки, и последующего выбора лучшего варианта. При всем этом у студентов появляется опыт слияния в данном образовательном процессе науки и IT-индустрии, без которого невозможно в современном мире быть конкурентоспособным выпускником. Использование проектного подхода является высокоэффективным средством формирования компетенций цифровой культуры и модернизации учебного процесса подготовки специалистов в области информационных технологий. The dependence of the large-scale national program "Digital Economy of the Russian Federation" and modernization of training of IT specialists is discussed. The most promising approach for the educational process from the point of view of researchers is the project approach. It is actively being implemented in the training of various educational institutions for the preparation of bachelors and masters in the field of information technology. The application of such projects as priority ones at the Lobachevsky Nizhny Novgorod State University is being investigated. The article provides an educational and research project on finding the optimal schedule for sugar beet processing as an indicative one. This project has the following advantages: a powerful theoretical basis, a close connection of the educational material with reality, intuitive algorithms related to the numerical solution of the problem. The progress of this work is described. To check the student's readiness for the experimental part, the authors of the project have prepared a theoretical part. In total, the authors have prepared 4 stages of this project. The ability to find quasi-optimal solutions to an optimization problem in practice is tested, among other things. At the output, it is mandatory to present graphs of objective functions for various plans for processing batches of beets obtained as a result of the operation of a program written in the popular algorithmic Python language. This is necessary for the ability to visualize and compare the results obtained by applying various tactics and processing plans, and then choose the best one. At the same time, students have the experience of merging science and the IT industry in this educational process, without which it is impossible to be a competitive graduate in the modern world. The use of the project approach is a highly effective means of forming digital culture competencies and modernizing the educational process of training specialists in the field of information technology.