Pablo López-Porfiri
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Pablo López-Porfiri has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
- Maria Gonzalez-Miquel
Dpto. Ingeniería Química Industrial y del Medio Ambiente, ETSI Industriales, Universidad Politécnica de Madrid, C/José Gutiérrez Abascal 2, 28006 Madrid, Spain
4 shared publications - Patricia Gorgojo
Department of Chemical Engineering, Faculty of Science and Engineering, The University of Manchester, Manchester, UK
4 shared publications Juan C. de la Fuente
3 shared publications- Maria Perez-Page
Department of Chemical Engineering, The University of Manchester, Manchester M13 9PL, UK
3 shared publications Arturo Bejarano
2 shared publications- Benjamin S. Moore
Department of Chemical Engineering, The University of Manchester, Manchester M13 9PL, UK
2 shared publications
Latest Publications
- Open Access
- 28 January 2026
- Published by Elsevier in Chemical Engineering Journal
- Vol. 530
Membrane pervaporation to enhance triacetin production: reaction experiments, simulation and techno-economic analysis of the intensified process
- 28 January 2026
- Published by Elsevier in Chemical Engineering Journal
- Vol. 530
Open AccessMembrane pervaporation to enhance triacetin production: reaction experiments, simulation and techno-economic analysis of the intensified process
- Open Access
- 19 May 2025
- Published by Elsevier in Journal of Membrane Science
- Vol. 732
GO as gutter layer in superglassy thin film composite membranes for enhanced gas separation
- 19 May 2025
- Published by Elsevier in Journal of Membrane Science
- Vol. 732
Open AccessGO as gutter layer in superglassy thin film composite membranes for enhanced gas separation
- Open Access
- 25 March 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 13 (18) , 13518-13531
The hydrophilic nature trade-off of supported ionic liquid membranes on CO 2 /CH 4 separation performance
The influence of water content in biogas upgrading on selectivity/stability was assessed through capillary pressure, transport kinetics, and phase equilibria.
- 25 March 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 13 (18) , 13518-13531
Open AccessThe hydrophilic nature trade-off of supported ionic liquid membranes on CO 2 /CH 4 separation performance
The influence of water content in biogas upgrading on selectivity/stability was assessed through capillary pressure, transport kinetics, and phase equilibria.
- 8 February 2025
- Published by Elsevier in Chemical Engineering Journal
- Vol. 507
Implications of non-ideal gas dispersion for underground hydrogen storage
- 8 February 2025
- Published by Elsevier in Chemical Engineering Journal
- Vol. 507
Implications of non-ideal gas dispersion for underground hydrogen storage
- Open Access
- 20 February 2024
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 12 (9) , 3766-3779
Extraction of 5-Hydroxymethylfurfural and Furfural in Aqueous Biphasic Systems: A COSMO-RS Guided Approach to Greener Solvent Selection
5-Hydroxymethylfurfural (HMF) and furfural (Fur) are promising biobased platform chemicals, derived from the dehydration of carbohydrate feedstocks, normally conducted in an aqueous phase. Plagued by side-reactions in such phase, such as the rehydration to levulinic acid (LA) and formic acid (FA) or self-condensation to humins, HMF and Fur necessitates diversification from monophasic aqueous reaction systems toward biphasic systems to mitigate undesired side-reactions. Here, a methodology based on the COnductor-like Screening MOdel for Real Solvents (COSMO-RS) method was used to screen solvent candidates based on the predicted partition coefficients (Ki). Hansen solubility parameters in conjunction with excess thermodynamic quantities determined by COSMO-RS were employed to assess solvent compatibility. Experimental validation of the COSMO-RS values highlighted only minor deviations from the predictions with root-mean-square-error (RMSE) values of HMF and Fur at 0.76 and 5.32, respectively, at 298 K. The combined effort suggested cyclohexanone, isophorone, and methyl isobutyl ketone (MIBK) as the best candidates. Finally, extraction solvent reuse demonstrated cyclohexanone suitability for HMF extraction with KHMF of 3.66 and MIBK for Fur with KFur 7.80 with consistent partitioning across four total runs. Both solvents are classified as recommended by the CHEM21 solvent selection guide, hence adding to the sustainability of the process.
- 20 February 2024
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 12 (9) , 3766-3779
Open AccessExtraction of 5-Hydroxymethylfurfural and Furfural in Aqueous Biphasic Systems: A COSMO-RS Guided Approach to Greener Solvent Selection
5-Hydroxymethylfurfural (HMF) and furfural (Fur) are promising biobased platform chemicals, derived from the dehydration of carbohydrate feedstocks, normally conducted in an aqueous phase. Plagued by side-reactions in such phase, such as the rehydration to levulinic acid (LA) and formic acid (FA) or self-condensation to humins, HMF and Fur necessitates diversification from monophasic aqueous reaction systems toward biphasic systems to mitigate undesired side-reactions. Here, a methodology based on the COnductor-like Screening MOdel for Real Solvents (COSMO-RS) method was used to screen solvent candidates based on the predicted partition coefficients (Ki). Hansen solubility parameters in conjunction with excess thermodynamic quantities determined by COSMO-RS were employed to assess solvent compatibility. Experimental validation of the COSMO-RS values highlighted only minor deviations from the predictions with root-mean-square-error (RMSE) values of HMF and Fur at 0.76 and 5.32, respectively, at 298 K. The combined effort suggested cyclohexanone, isophorone, and methyl isobutyl ketone (MIBK) as the best candidates. Finally, extraction solvent reuse demonstrated cyclohexanone suitability for HMF extraction with KHMF of 3.66 and MIBK for Fur with KFur 7.80 with consistent partitioning across four total runs. Both solvents are classified as recommended by the CHEM21 solvent selection guide, hence adding to the sustainability of the process.
- Open Access
- 3 March 2023
- Published by Springer Nature in npj Clean Water
- Vol. 6 (1) , 1-9
Towards the technological maturity of membrane distillation: the MD module performance curve
Membrane distillation (MD) is constantly acknowledged in the research literature as a promising technology for the future of desalination, with an increasing number of studies reported year after year. However, real MD applications still lag behind with only a few pilot-plant tests worldwide. The lack of technology transfer from academia to industry is caused by important gaps between its fundamental basis and the process design. Herein, we explore critical disconnections by conducting coupled mass and heat transfer modeling and MD simulations; we use well-known MD mass and heat transfer equations to model and simulate flux over a typical MD membrane for different geometries, areas, and operational conditions in direct contact configuration. From the analysis of the results, we propose research guidelines and process development strategies, and construct an MD module performance curve. From this graph, permeate flow rate, thermal energy consumption and outlet temperatures can be determined for given feed inlet conditions (temperature and concentration). Comprehensive tools such as this MD module curve and good communication between membrane developers and process engineers are required to accelerate the process of bringing the MD technology from a still-emerging status to a maturity level.
- 3 March 2023
- Published by Springer Nature in npj Clean Water
- Vol. 6 (1) , 1-9
Open AccessTowards the technological maturity of membrane distillation: the MD module performance curve
Membrane distillation (MD) is constantly acknowledged in the research literature as a promising technology for the future of desalination, with an increasing number of studies reported year after year. However, real MD applications still lag behind with only a few pilot-plant tests worldwide. The lack of technology transfer from academia to industry is caused by important gaps between its fundamental basis and the process design. Herein, we explore critical disconnections by conducting coupled mass and heat transfer modeling and MD simulations; we use well-known MD mass and heat transfer equations to model and simulate flux over a typical MD membrane for different geometries, areas, and operational conditions in direct contact configuration. From the analysis of the results, we propose research guidelines and process development strategies, and construct an MD module performance curve. From this graph, permeate flow rate, thermal energy consumption and outlet temperatures can be determined for given feed inlet conditions (temperature and concentration). Comprehensive tools such as this MD module curve and good communication between membrane developers and process engineers are required to accelerate the process of bringing the MD technology from a still-emerging status to a maturity level.
- 22 May 2020
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 8 (24) , 8958-8969
Green Solvent Selection Guide for Biobased Organic Acid Recovery
- 22 May 2020
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 8 (24) , 8958-8969
Green Solvent Selection Guide for Biobased Organic Acid Recovery
- 1 December 2017
- Published by Elsevier in The Journal of Chemical Thermodynamics
- Vol. 115, 269-275
High-pressure (vapor + liquid) equilibria for binary systems containing carbon dioxide and key apple odorants, hexanal and ethyl-2-methylbutyrate
- 1 December 2017
- Published by Elsevier in The Journal of Chemical Thermodynamics
- Vol. 115, 269-275
High-pressure (vapor + liquid) equilibria for binary systems containing carbon dioxide and key apple odorants, hexanal and ethyl-2-methylbutyrate
- 11 October 2016
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 61 (12) , 4245-4251
Excess Molar Enthalpies of Deep Eutectic Solvents (DESs) Composed of Quaternary Ammonium Salts and Glycerol or Ethylene Glycol
- 11 October 2016
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 61 (12) , 4245-4251
Excess Molar Enthalpies of Deep Eutectic Solvents (DESs) Composed of Quaternary Ammonium Salts and Glycerol or Ethylene Glycol