Selvam Ragupathy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Selvam Ragupathy has a total of 57 co-authors. Here are the top co-authors by number of shared publications:
B. Srividhya
Department of Chemistry K.S. Rangasamy College of Technology (autonomous) Tiruchengode Tamil Nadu 637 215 India
4 shared publicationsD. Senthil Kumar
Department of Physics Vel Tech Rangarajan Dr. Sagunthala R&D Institute of Science and Technology Chennai Tamil Nadu 600 062 India
4 shared publicationsL. Guganathan
4 shared publicationsT. Sathya
Arunai Engineering College
3 shared publications- Arumugam Priyadharsan
Department of Conservative Dentistry and Endodontics, Saveetha Dental College and Hospitals, Saveetha Institute of Medical and Technical Sciences (SIMATS), Chennai, India
2 shared publications K. Sathishkumar
2 shared publications
Latest Publications
- 18 August 2025
- Published by Wiley in ChemistrySelect
- Vol. 10 (32)
Preparation and Characterization of an Activated Carbon‐Derived from Almond Shell for the Removal of Rhodamine B Dye: Kinetics, Isotherm, and Thermodynamics Analysis
Since organic pollutants from wastewater have grown more hazardous to the environment in recent years, decontaminating wastewater before disposing of it is crucial. Here, the purpose is to prepare activated carbon (AC) from almond shells (AS) using KOH activation with an impregnation ratio of 1:4 (AS:KOH). ASs and ASAC (almond shell activated carbon) have been characterized using a variety of analytical techniques, including FTIR, XRD, Raman, BET, and SEM with EDS mapping analysis. The prepared ASAC exhibited a specific surface area of 1082 m 2 g −1 . Optimized conditions of the study include an adsorbent dosage of 0.30 g/L, pH of 3, and initial dye concentration of 100–180 mg/L with a contact time of 70 min, wherein batch adsorption study showed high removal efficiency. It demonstrated a remarkable rhodamine B (RhB) removal capacity of 191.331 mgg −1 in aqueous solution. Equilibrium adsorption data were tested using Langmuir, Freundlich, Temkin, and Dubinin–Radushkevich (D–R) isothermal models by nonlinear regression. The adsorption fit the Langmuir isotherm model well, and pseudo‐second‐order kinetics. The adsorption was exothermic and spontaneous, according to thermodynamic studies. Additionally, the ASAC's reusability showed that it can be used for up to five cycles without its removal efficiency, highlighting its potential for sustainable and cost‐effective water treatment.
- 18 August 2025
- Published by Wiley in ChemistrySelect
- Vol. 10 (32)
Preparation and Characterization of an Activated Carbon‐Derived from Almond Shell for the Removal of Rhodamine B Dye: Kinetics, Isotherm, and Thermodynamics Analysis
Since organic pollutants from wastewater have grown more hazardous to the environment in recent years, decontaminating wastewater before disposing of it is crucial. Here, the purpose is to prepare activated carbon (AC) from almond shells (AS) using KOH activation with an impregnation ratio of 1:4 (AS:KOH). ASs and ASAC (almond shell activated carbon) have been characterized using a variety of analytical techniques, including FTIR, XRD, Raman, BET, and SEM with EDS mapping analysis. The prepared ASAC exhibited a specific surface area of 1082 m 2 g −1 . Optimized conditions of the study include an adsorbent dosage of 0.30 g/L, pH of 3, and initial dye concentration of 100–180 mg/L with a contact time of 70 min, wherein batch adsorption study showed high removal efficiency. It demonstrated a remarkable rhodamine B (RhB) removal capacity of 191.331 mgg −1 in aqueous solution. Equilibrium adsorption data were tested using Langmuir, Freundlich, Temkin, and Dubinin–Radushkevich (D–R) isothermal models by nonlinear regression. The adsorption fit the Langmuir isotherm model well, and pseudo‐second‐order kinetics. The adsorption was exothermic and spontaneous, according to thermodynamic studies. Additionally, the ASAC's reusability showed that it can be used for up to five cycles without its removal efficiency, highlighting its potential for sustainable and cost‐effective water treatment.
- 24 May 2025
- Published by Wiley in Luminescence
- Vol. 40 (5) , e70200
Facile Synthesis of Tin‐Doped Copper Oxide Loaded on Almond Shell Activated Carbon Composite for the Photodegradation of Organic Pollutants Under Sunlight
With a wide range of development opportunities, photocatalytic technology provides a potent solution to today's energy and environmental issues. In this study, a tin‐doped copper oxide nanoparticle loaded on almond shell activated carbon (Sn: CuO/ASAC) were prepared and thoroughly examined and described using UV‐DRS, XRD, BET, FT‐IR, SEM with EDS, and XPS. Band gap energy was decreased and visible absorbance was increased as a result of Sn‐doping and ASAC loading. Therefore, by altering batch experimental conditions such starting pH and the quantity of Sn‐doped CuO loaded on ASAC composite, all the product samples were employed for MB dye degradation from aqueous solution under sunlight. The obtained results revealed that >99.37% MB removal over composite sample was achieved within 90 min by using 1.2 g L −1 adsorbent dosage, 40‐mg/L MB at weakly alkaline pH values. The kinetics study accurately describes the MB degradation rates, revealing a high rate constant of 0.052 min −1 for the composite samples as compared to other samples. The photocatalytic mechanism of the composite was studied by radical scavenging tests of the Sn: CuO/ASAC. These findings suggested that the ASAC composite loaded with Sn‐doped CuO could be considered as a dye wastewater treatment technique.
- 24 May 2025
- Published by Wiley in Luminescence
- Vol. 40 (5) , e70200
Facile Synthesis of Tin‐Doped Copper Oxide Loaded on Almond Shell Activated Carbon Composite for the Photodegradation of Organic Pollutants Under Sunlight
With a wide range of development opportunities, photocatalytic technology provides a potent solution to today's energy and environmental issues. In this study, a tin‐doped copper oxide nanoparticle loaded on almond shell activated carbon (Sn: CuO/ASAC) were prepared and thoroughly examined and described using UV‐DRS, XRD, BET, FT‐IR, SEM with EDS, and XPS. Band gap energy was decreased and visible absorbance was increased as a result of Sn‐doping and ASAC loading. Therefore, by altering batch experimental conditions such starting pH and the quantity of Sn‐doped CuO loaded on ASAC composite, all the product samples were employed for MB dye degradation from aqueous solution under sunlight. The obtained results revealed that >99.37% MB removal over composite sample was achieved within 90 min by using 1.2 g L −1 adsorbent dosage, 40‐mg/L MB at weakly alkaline pH values. The kinetics study accurately describes the MB degradation rates, revealing a high rate constant of 0.052 min −1 for the composite samples as compared to other samples. The photocatalytic mechanism of the composite was studied by radical scavenging tests of the Sn: CuO/ASAC. These findings suggested that the ASAC composite loaded with Sn‐doped CuO could be considered as a dye wastewater treatment technique.
- Top Cited Papers
- 16 January 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (10) , 13345-13354
High adsorption capacities of rhodamine B dye by activated carbon synthesized from cotton stalks agricultural waste by chemical activation
- 16 January 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (10) , 13345-13354
Top Cited PapersHigh adsorption capacities of rhodamine B dye by activated carbon synthesized from cotton stalks agricultural waste by chemical activation
- 26 March 2024
- Published by Springer Nature in Ionics
- Vol. 30 (5) , 2915-2926
Critical assessment of a Ce-doped SnO2 loaded on PPSAC composite photocatalyst on improved photocatalytic activity under visible light
- 26 March 2024
- Published by Springer Nature in Ionics
- Vol. 30 (5) , 2915-2926
Critical assessment of a Ce-doped SnO2 loaded on PPSAC composite photocatalyst on improved photocatalytic activity under visible light
- 18 December 2023
- Published by Springer Nature in Ionics
- Vol. 30 (2) , 1167-1176
Efficient photocatalytic degradation of rhodamine B using Ag-doped TiO2-loaded groundnut shell activated carbon under solar light
- 18 December 2023
- Published by Springer Nature in Ionics
- Vol. 30 (2) , 1167-1176
Efficient photocatalytic degradation of rhodamine B using Ag-doped TiO2-loaded groundnut shell activated carbon under solar light
- 16 April 2023
- Published by Elsevier in Chemosphere
- Vol. 330, 138708
Effect of metal doping and non-metal loading on light energy driven degradation of organic dye using ZnO nanocatalysts
- 16 April 2023
- Published by Elsevier in Chemosphere
- Vol. 330, 138708
Effect of metal doping and non-metal loading on light energy driven degradation of organic dye using ZnO nanocatalysts
- 23 May 2022
- Published by Elsevier in Environmental Research
- Vol. 212 (Pt D) , 113497
Adsorption of brilliant green dye onto activated carbon prepared from cashew nut shell by KOH activation: Studies on equilibrium isotherm
- 23 May 2022
- Published by Elsevier in Environmental Research
- Vol. 212 (Pt D) , 113497
Adsorption of brilliant green dye onto activated carbon prepared from cashew nut shell by KOH activation: Studies on equilibrium isotherm
- 4 May 2022
- Published by Elsevier in Chemosphere
- Vol. 302, 134844
Enhanced photocatalytic degradation of organic pollutants by Ag–TiO2 loaded cassava stem activated carbon under sunlight irradiation
- 4 May 2022
- Published by Elsevier in Chemosphere
- Vol. 302, 134844
Enhanced photocatalytic degradation of organic pollutants by Ag–TiO2 loaded cassava stem activated carbon under sunlight irradiation
- 9 February 2022
- Published by Elsevier in Environmental Research
- Vol. 210, 112833
Effect of doping and loading Parameters on photocatalytic degradation of brilliant green using Sn doped ZnO loaded CSAC
- 9 February 2022
- Published by Elsevier in Environmental Research
- Vol. 210, 112833
Effect of doping and loading Parameters on photocatalytic degradation of brilliant green using Sn doped ZnO loaded CSAC