Gloria L. Frontini
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Gloria L. Frontini has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Fernando Otero
Department of Mathematics, College of Engineering, Universidad Nacional de Mar del Plata, Mar del Plata, Argentina
2 shared publications - Guillermo Enrique Eliçabe
Department of Chemical Engineering, Instituto de Investigación en Ciencia y Tecnología de Materiales (INTEMA), Facultad de Ingeniería, Universidad Nacional de Mar del Plata / CONICET, J. B. Justo 4302, 7600 Mar del Plata, Argentina
2 shared publications Bianca Bietti Managó
Univ Nac Mar Del Plata, Dto Matemat, Fac Ingn, RA-7600 Mar Del Plata, Argentina
1 shared publicationElena M. Fernández Berdaguer
Instituto de Cálculo FCEyN, Fac. Ingeniería, Univ. Nac, de Buenos Aires
1 shared publicationFernando Otero
Universidad Nacional de Mar del Plata
1 shared publicationGuillermo E. Eliçabe
Institute of Material Science and Technology (INTEMA), National University of Mar del Plata, Mar del Plata, Argentina
1 shared publication
Latest Publications
- Open Access
- 26 June 2024
- Published by EdiUNS - Editorial de la Universidad Nacional del Sur in Latin American Applied Research - An international journal
- Vol. 54 (3) , 375-382
AN INFORMATION-THEORETIC FILTER SINGLE-STEP SEQUENTIAL MONTE CARLO METHOD IN PRACTICE. AN EXPERIMENTAL CASE STUDY FOR THE PARTICLE SIZE DISTRIBUTION ESTIMATION
In this article, we implement an extended version of a Monte Carlo methodology making use of a Sampling/Mapping/Filtering (SMF) strategy, to estimate the Particle Size Distribution (PSD) of a particle system. The methodological difference is shown by the use of a filter, based on information theory, which computes a cut-off level using an optimization scheme following the principle of relevant information (PRI). The practical application of the full strategy considers the fusion between scanning electron microscope (SEM) data and static light scattering (SLS) measurements. The two models are utilized, assuming spherical particles represented as hard spheres: the so-called local monodisperse approximation (LMA) and the Vrij’s finite mixtures model (VFMM). We analyze the resulting estimates for different configurations of both prior information and SLS models, where final results are compared to those obtained in previous studies for a polymeric particle system embedded in a solid polymer matrix.
- 26 June 2024
- Published by EdiUNS - Editorial de la Universidad Nacional del Sur in Latin American Applied Research - An international journal
- Vol. 54 (3) , 375-382
Open AccessAN INFORMATION-THEORETIC FILTER SINGLE-STEP SEQUENTIAL MONTE CARLO METHOD IN PRACTICE. AN EXPERIMENTAL CASE STUDY FOR THE PARTICLE SIZE DISTRIBUTION ESTIMATION
In this article, we implement an extended version of a Monte Carlo methodology making use of a Sampling/Mapping/Filtering (SMF) strategy, to estimate the Particle Size Distribution (PSD) of a particle system. The methodological difference is shown by the use of a filter, based on information theory, which computes a cut-off level using an optimization scheme following the principle of relevant information (PRI). The practical application of the full strategy considers the fusion between scanning electron microscope (SEM) data and static light scattering (SLS) measurements. The two models are utilized, assuming spherical particles represented as hard spheres: the so-called local monodisperse approximation (LMA) and the Vrij’s finite mixtures model (VFMM). We analyze the resulting estimates for different configurations of both prior information and SLS models, where final results are compared to those obtained in previous studies for a polymeric particle system embedded in a solid polymer matrix.
- Open Access
- 8 November 2022
- Published by Brazilian Society for Computational and Applied Mathematics (SBMAC) in Trends in Computational and Applied Mathematics
- Vol. 23 (4) , 749-767
A Novel In Silico Monte Carlo Approach to Optimize a PSD Estimation Problem. Generation of Data Fusion Experiment Rules
This article analyzes the performance of combining information from Scanning Electron Microscopy (SEM) micrographs with Static Light Scattering (SLS) measurements for retrieving the so-called Particle Size Distribution (PSD) in terms of experimental features. The corresponding data fusion is implemented using a novel Monte Carlo-based method consisting in a SMF (Sampling-Mapping-Filtering) approach. This approach provides an important reference to assess the strategy of the experiment for this specific problem by means of solving an inverse problem. Furthermore, low levels of volume fraction and a PSD represented by log-normal distributions are considered in order to reduce processing and model errors due to ill-posedness. The prior statistics corresponding to the SEM micrographs have been achieved by means of the Jackknife procedure used as a resampling technique. The likelihood term considers iid normal measurements generated from the Local Monodisperse Approximation (LMA) and also makes use of the same model as forward linear model, in an inversion case known as inverse crime. However, it has been proved that the LMA performs well in practice for low fraction volume systems as considered here. The PSD retrieval is measured in terms of improvement in precision with respect to one of the log-normal parameters in SEM micrographs, i.e., the desirability. Estimates are expressed as a function of a typical system parameter such as polydispersity, as well as experimental variables, i.e., number of particles per micrograph (PPM) and noise level $\varepsilon$ in the SLS measurements. These estimations are then analyzed by means of the Box-Behnken (BB) design and the response surface methodology (RSM) in order to generate a surrogate model from which rules for the optimization of the experiment are made when desirability is maximized. Finally, a Rule-Based System (RBS) is proposed for future use.- 8 November 2022
- Published by Brazilian Society for Computational and Applied Mathematics (SBMAC) in Trends in Computational and Applied Mathematics
- Vol. 23 (4) , 749-767
Open AccessA Novel In Silico Monte Carlo Approach to Optimize a PSD Estimation Problem. Generation of Data Fusion Experiment Rules
This article analyzes the performance of combining information from Scanning Electron Microscopy (SEM) micrographs with Static Light Scattering (SLS) measurements for retrieving the so-called Particle Size Distribution (PSD) in terms of experimental features. The corresponding data fusion is implemented using a novel Monte Carlo-based method consisting in a SMF (Sampling-Mapping-Filtering) approach. This approach provides an important reference to assess the strategy of the experiment for this specific problem by means of solving an inverse problem. Furthermore, low levels of volume fraction and a PSD represented by log-normal distributions are considered in order to reduce processing and model errors due to ill-posedness. The prior statistics corresponding to the SEM micrographs have been achieved by means of the Jackknife procedure used as a resampling technique. The likelihood term considers iid normal measurements generated from the Local Monodisperse Approximation (LMA) and also makes use of the same model as forward linear model, in an inversion case known as inverse crime. However, it has been proved that the LMA performs well in practice for low fraction volume systems as considered here. The PSD retrieval is measured in terms of improvement in precision with respect to one of the log-normal parameters in SEM micrographs, i.e., the desirability. Estimates are expressed as a function of a typical system parameter such as polydispersity, as well as experimental variables, i.e., number of particles per micrograph (PPM) and noise level $\varepsilon$ in the SLS measurements. These estimations are then analyzed by means of the Box-Behnken (BB) design and the response surface methodology (RSM) in order to generate a surrogate model from which rules for the optimization of the experiment are made when desirability is maximized. Finally, a Rule-Based System (RBS) is proposed for future use. - 1 February 2016
- Published by Elsevier in Ultrasonics
- Vol. 65, 315-328
Layered material characterization using ultrasonic transmission. An inverse estimation methodology
- 1 February 2016
- Published by Elsevier in Ultrasonics
- Vol. 65, 315-328
Layered material characterization using ultrasonic transmission. An inverse estimation methodology
- 1 January 2008
- Published by Taylor & Francis in Inverse Problems in Science and Engineering
- Vol. 16 (8) , 995-1004
Estimation of size distribution in concentrated particle systems from light scattering measurements
We consider the estimation of the particle size distribution (PSD) of concentrated particle systems with low contrast between particles and solvent from light scattering (LS) measurements. We follow Pedersen's monodisperse approximation, in which an effective particle volume fraction is used to take into account interference between particles. This parameter must be determined simultaneously with the PSD to characterize the system. To solve the inverse problem, we first assumed that the PSD is described by a log-normal function. We applied the Levenberg–Marquardt algorithm for the non-linear parameter estimation. We also approached the free-form case following a scheme by which Tikhonov's regularization method is used to estimate the PSD, simultaneously with a non-linear least-squares optimization used to estimate the effective parameter. The solutions obtained from the analysis of simulated measurements showed that a priori knowledge of the distribution form improves the quality of the estimation, but the problem can be solved properly when actual PSD form is not known.
- 1 January 2008
- Published by Taylor & Francis in Inverse Problems in Science and Engineering
- Vol. 16 (8) , 995-1004
Estimation of size distribution in concentrated particle systems from light scattering measurements
We consider the estimation of the particle size distribution (PSD) of concentrated particle systems with low contrast between particles and solvent from light scattering (LS) measurements. We follow Pedersen's monodisperse approximation, in which an effective particle volume fraction is used to take into account interference between particles. This parameter must be determined simultaneously with the PSD to characterize the system. To solve the inverse problem, we first assumed that the PSD is described by a log-normal function. We applied the Levenberg–Marquardt algorithm for the non-linear parameter estimation. We also approached the free-form case following a scheme by which Tikhonov's regularization method is used to estimate the PSD, simultaneously with a non-linear least-squares optimization used to estimate the effective parameter. The solutions obtained from the analysis of simulated measurements showed that a priori knowledge of the distribution form improves the quality of the estimation, but the problem can be solved properly when actual PSD form is not known.
- 22 December 2006
- Published by Taylor & Francis in Inverse Problems in Science and Engineering
- Vol. 15 (2) , 123-135
Analysis of the solution of the elastic light scattering inverse problem for polymeric emulsions
We consider the problem of inversion of elastic light scattering (ELS) measurements from polymeric emulsions, to obtain its particle size distribution (PSD) and its refractive index. The mathematical formulation results in a nonlinear inverse problem. A Fredholm integral equation of the first kind appears with an unknown parameter in its kernel. We discuss the existence, uniqueness, and stability of the generalized solutions of the problem when it is stated as a minimization problem with a least square functional. First, we assume that the PSD is known, and for this case we prove that the solution exists and is unique as long as the relation between the measurements and the parameter is by an injective function. Then, we use this result to state sufficient conditions for the complete problem. The analysis of existence and uniqueness of the solution for the problem in hand is supported by numerical simulation. The Phillips–Tikhonov regularization method is proposed to stabilize the problem when noisy-data is available.
- 22 December 2006
- Published by Taylor & Francis in Inverse Problems in Science and Engineering
- Vol. 15 (2) , 123-135
Analysis of the solution of the elastic light scattering inverse problem for polymeric emulsions
We consider the problem of inversion of elastic light scattering (ELS) measurements from polymeric emulsions, to obtain its particle size distribution (PSD) and its refractive index. The mathematical formulation results in a nonlinear inverse problem. A Fredholm integral equation of the first kind appears with an unknown parameter in its kernel. We discuss the existence, uniqueness, and stability of the generalized solutions of the problem when it is stated as a minimization problem with a least square functional. First, we assume that the PSD is known, and for this case we prove that the solution exists and is unique as long as the relation between the measurements and the parameter is by an injective function. Then, we use this result to state sufficient conditions for the complete problem. The analysis of existence and uniqueness of the solution for the problem in hand is supported by numerical simulation. The Phillips–Tikhonov regularization method is proposed to stabilize the problem when noisy-data is available.
- 20 December 2006
- Published by Wiley in Particle & Particle Systems Characterization
- Vol. 23 (5) , 374-380
Particle Size Distribution Retrieval from Elastic Light Scattering Measurements by a Modified Regularization Method
- 20 December 2006
- Published by Wiley in Particle & Particle Systems Characterization
- Vol. 23 (5) , 374-380
Particle Size Distribution Retrieval from Elastic Light Scattering Measurements by a Modified Regularization Method