Kyoungmi Lee
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Kyoungmi Lee has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Joo Wan Cha
National Institute of Meteorological Sciences (NIMS), Korea Meteorological Administration (KMA), Seogwipo, Republic of Korea
3 shared publications Bu-Yo Kim
1 shared publication- Bu-Yo Kim
National Institute of Meteorological Sciences (NIMS), Korea Meteorological Administration (KMA), Seogwipo, Republic of Korea
1 shared publication - Chang Hoon Jung
Department of Health Management Kyungin Women's University Incheon Republic of Korea
1 shared publication - Changbeom Cho1 shared publication
ChunHo Cho
National Institute of Meteorological Research, Korea Meteorological Administration, Seoul, Korea
1 shared publication
Latest Publications
- Open Access
- 31 December 2024
- Published by The Korean Environmental Sciences Society in Journal of Environmental Science International
- Vol. 33 (12) , 957-975
Development of Korea’s First Large Scale Advanced Cloud Physics Experimental Chamber (I): Design of the Cloud Physics Experimental Chamber System and Detailed Structural Analysis of the Cloud Chamber
- 31 December 2024
- Published by The Korean Environmental Sciences Society in Journal of Environmental Science International
- Vol. 33 (12) , 957-975
Open AccessDevelopment of Korea’s First Large Scale Advanced Cloud Physics Experimental Chamber (I): Design of the Cloud Physics Experimental Chamber System and Detailed Structural Analysis of the Cloud Chamber
- Open Access
- 6 July 2023
- Published by Copernicus GmbH
Introduction to the First Large-Scale Cloud Physics Experimental Chamber in Korea: Design, Construction, and Initial Experiments
The National Institute of Meteorological Sciences has recently constructed a Korea Cloud Physics Experimental Chamber (K-CPEC) to investigate the fundamental processes of cloud formation and implement a rainfall enhancement. The K-CPEC is capable of adiabatic expansion and covers temperatures ranging from –70℃ to 60℃, pressures from 1,013 hPa to 30 hPa, and relative humidity from 10% to 95%. It consists of an inner and outer chamber, with the outer chamber (5m x 5m) controlling pressure and the inner chamber (3m x 3m) controlling temperature to minimize heat loss during experiments. Notably, the inner chamber is constructed using dual materials of copper and stainless steel, a first in the world, which increases thermal efficiency with copper and ensures structural safety of the inner chamber with stainless steel. The K-CPEC is equipped with various observation equipment, such as pressure, temperature, and humidity sensors, an optical particle counter, a cloud condensation nuclei counter, an ice nuclei counter, and a cloud particles imager. Through temperature and pressure control, the K-CPEC can replicate cloud formation processes, and the observation equipment can measure characteristics of aerosol, cloud particles, and ice crystals. Performance testing has confirmed that the K-CPEC is a valuable facility for activating various types of aerosol particles and verifying cloud particle and ice crystal formation processes. Research using a cloud chamber is a research method introduced for the first time in Korea, and the cloud generation experimental procedure and observation method have not yet been systematized. Therefore, it is necessary to ensure reproducibility and reliability by performing repeated experiments according to experimental analysis procedures developed in the future. Through this, it will be possible to lay the foundation for various studies using cloud chambers and increase their usability. This research has been supported by the "Research on Weather Modification and Cloud Physics"(KMA2018-00224) project of NIMS/KMA.
- 6 July 2023
- Published by Copernicus GmbH
Open AccessIntroduction to the First Large-Scale Cloud Physics Experimental Chamber in Korea: Design, Construction, and Initial Experiments
The National Institute of Meteorological Sciences has recently constructed a Korea Cloud Physics Experimental Chamber (K-CPEC) to investigate the fundamental processes of cloud formation and implement a rainfall enhancement. The K-CPEC is capable of adiabatic expansion and covers temperatures ranging from –70℃ to 60℃, pressures from 1,013 hPa to 30 hPa, and relative humidity from 10% to 95%. It consists of an inner and outer chamber, with the outer chamber (5m x 5m) controlling pressure and the inner chamber (3m x 3m) controlling temperature to minimize heat loss during experiments. Notably, the inner chamber is constructed using dual materials of copper and stainless steel, a first in the world, which increases thermal efficiency with copper and ensures structural safety of the inner chamber with stainless steel. The K-CPEC is equipped with various observation equipment, such as pressure, temperature, and humidity sensors, an optical particle counter, a cloud condensation nuclei counter, an ice nuclei counter, and a cloud particles imager. Through temperature and pressure control, the K-CPEC can replicate cloud formation processes, and the observation equipment can measure characteristics of aerosol, cloud particles, and ice crystals. Performance testing has confirmed that the K-CPEC is a valuable facility for activating various types of aerosol particles and verifying cloud particle and ice crystal formation processes. Research using a cloud chamber is a research method introduced for the first time in Korea, and the cloud generation experimental procedure and observation method have not yet been systematized. Therefore, it is necessary to ensure reproducibility and reliability by performing repeated experiments according to experimental analysis procedures developed in the future. Through this, it will be possible to lay the foundation for various studies using cloud chambers and increase their usability. This research has been supported by the "Research on Weather Modification and Cloud Physics"(KMA2018-00224) project of NIMS/KMA.
- Open Access
- 10 June 2022
- Published by MDPI AG in Remote Sensing
- Vol. 14 (12) , 2795
Theoretical Calculations of Directional Scattering Intensities of Small Nonspherical Ice Crystals: Implications for Forward Scattering Probes
In situ aircraft measurements of the sizes and concentrations of liquid cloud droplets and ice crystals with maximum dimensions (Dmax) less than ~50 μm have been measured mainly using forward scattering probes over the past half century. The operating principle of forward scattering probes is that the measured intensity of light scattered by a cloud particle at specific forward scattering angles can be related to the size of that particle assuming the shape and thermodynamic phase of the target are known. Current forward-scattering probes assume spherical liquid cloud droplets and use the Lorenz–Mie theory to convert the scattered light to particle size. Uncertainties in sizing ice crystals using forward scattering probes are unavoidable since the single-scattering properties of ice crystals differ from those of spherical liquid cloud droplets and because their shapes can vary. In this study, directional scattering intensities of four different aspect ratios (ARs = 0.25, 0.50, 1.00, and 2.00) of hexagonal ice crystals with random orientations and of spherical liquid cloud droplets were calculated using the discrete dipole approximation (i.e., ADDA) and Lorenz–Mie code, respectively, to quantify the errors in sizing small ice crystals and cloud droplets using current forward scattering probes and to determine the ranges of optimal scattering angles that would be used in future forward scattering probes. The calculations showed that current forward scattering probes have average 5.0% and 17.4% errors in sizing liquid cloud droplets in the forward (4–12°) and backward (168–176°) direction, respectively. For measurements of hexagonal ice crystals, average sizing errors were 42.1% (23.9%) in the forward (backward) direction and depended on the ARs of hexagonal ice crystals, which are larger than those for liquid cloud droplets. A newly developed size conversion table based on the calculated single-scattering properties of hexagonal ice crystals using the ADDA reduced the sizing errors for the hexagonal ice crystals down to 14.2% (21.9%) in the forward (backward) direction. This study is a purely theoretical examination of the operating principle of forward scattering probes and there are several limitations, such as assumed hexagonal ice crystals with smooth surfaces and random orientations.
- 10 June 2022
- Published by MDPI AG in Remote Sensing
- Vol. 14 (12) , 2795
Open AccessTheoretical Calculations of Directional Scattering Intensities of Small Nonspherical Ice Crystals: Implications for Forward Scattering Probes
In situ aircraft measurements of the sizes and concentrations of liquid cloud droplets and ice crystals with maximum dimensions (Dmax) less than ~50 μm have been measured mainly using forward scattering probes over the past half century. The operating principle of forward scattering probes is that the measured intensity of light scattered by a cloud particle at specific forward scattering angles can be related to the size of that particle assuming the shape and thermodynamic phase of the target are known. Current forward-scattering probes assume spherical liquid cloud droplets and use the Lorenz–Mie theory to convert the scattered light to particle size. Uncertainties in sizing ice crystals using forward scattering probes are unavoidable since the single-scattering properties of ice crystals differ from those of spherical liquid cloud droplets and because their shapes can vary. In this study, directional scattering intensities of four different aspect ratios (ARs = 0.25, 0.50, 1.00, and 2.00) of hexagonal ice crystals with random orientations and of spherical liquid cloud droplets were calculated using the discrete dipole approximation (i.e., ADDA) and Lorenz–Mie code, respectively, to quantify the errors in sizing small ice crystals and cloud droplets using current forward scattering probes and to determine the ranges of optimal scattering angles that would be used in future forward scattering probes. The calculations showed that current forward scattering probes have average 5.0% and 17.4% errors in sizing liquid cloud droplets in the forward (4–12°) and backward (168–176°) direction, respectively. For measurements of hexagonal ice crystals, average sizing errors were 42.1% (23.9%) in the forward (backward) direction and depended on the ARs of hexagonal ice crystals, which are larger than those for liquid cloud droplets. A newly developed size conversion table based on the calculated single-scattering properties of hexagonal ice crystals using the ADDA reduced the sizing errors for the hexagonal ice crystals down to 14.2% (21.9%) in the forward (backward) direction. This study is a purely theoretical examination of the operating principle of forward scattering probes and there are several limitations, such as assumed hexagonal ice crystals with smooth surfaces and random orientations.
- 1 May 2013
- Published by Springer Nature in Asia-Pacific Journal of Atmospheric Sciences
- Vol. 49 (3) , 313-323
Analysis of changes in extreme temperatures using quantile regression
- 1 May 2013
- Published by Springer Nature in Asia-Pacific Journal of Atmospheric Sciences
- Vol. 49 (3) , 313-323
Analysis of changes in extreme temperatures using quantile regression