Savio L Y Woo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Savio L Y Woo has a total of 84 co-authors. Here are the top co-authors by number of shared publications:
Rui Liang
Musculoskeletal Research Center, Department of Bioengineering, Swanson School of Engineering, University of Pittsburgh, Pittsburgh, PA 15219, USA
9 shared publicationsMatthew B. Fisher
<!--1--> Department of Bioengineering, Musculoskeletal Research Center, Swanson School of Engineering University of Pittsburgh 405 Center for Bioengineering, 300 Technology Drive 15219 Pittsburgh PA USA
7 shared publicationsKwang E. Kim
Musculoskeletal Research Center, Department of Bioengineering, Swanson School of Engineering, University of Pittsburgh, Pittsburgh, PA 15219, USA
5 shared publicationsSteven D. Abramowitch
Musculoskeletal Research Center, Department of Bioengineering, University of Pittsburgh, 405 Center for Bioengineering, 300 Technology Drive, Pittsburgh, Pennsylvania 15219
4 shared publicationsFengyan Jia
Musculoskeletal Research Center, Department of Bioengineering, University of Pittsburgh, 405 Center for Bioengineering, 300 Technology Drive, Pittsburgh, Pennsylvania 15219
3 shared publicationsHo‐Joong Jung
<!--1--> Department of Bioengineering, Musculoskeletal Research Center, Swanson School of Engineering University of Pittsburgh 405 Center for Bioengineering, 300 Technology Drive 15219 Pittsburgh PA USA
3 shared publications
Latest Publications
- 18 September 2020
- Published by Elsevier in Journal of Biomechanics
- Vol. 110, 109911
In Memoriam of Yuan-Cheng "Bert" Fung
- 18 September 2020
- Published by Elsevier in Journal of Biomechanics
- Vol. 110, 109911
In Memoriam of Yuan-Cheng "Bert" Fung
- 11 July 2019
- Published by ASME International in Journal of Biomechanical Engineering
- Vol. 141 (9)
A Tribute to Our Centenarian Yuan-Cheng Fung: Father of Modern Biomechanics
- 11 July 2019
- Published by ASME International in Journal of Biomechanical Engineering
- Vol. 141 (9)
A Tribute to Our Centenarian Yuan-Cheng Fung: Father of Modern Biomechanics
- 27 May 2017
- Published by Springer Nature
- p. 185-196
The Use of a Large Animal Model and Robotic Technology to Validate New Biotherapies for ACL Healing
- 27 May 2017
- Published by Springer Nature
- p. 185-196
The Use of a Large Animal Model and Robotic Technology to Validate New Biotherapies for ACL Healing
- Open Access
- 1 July 2015
- Published by Elsevier in Journal of Orthopaedic Translation
- Vol. 3 (3) , 114-122
Positive effects of an extracellular matrix hydrogel on rat anterior cruciate ligament fibroblast proliferation and collagen mRNA expression
- 1 July 2015
- Published by Elsevier in Journal of Orthopaedic Translation
- Vol. 3 (3) , 114-122
Open AccessPositive effects of an extracellular matrix hydrogel on rat anterior cruciate ligament fibroblast proliferation and collagen mRNA expression
- 10 June 2015
- Published by Springer Nature
- p. 3203-3216
Orthopedic Research in the Year 2025
- 10 June 2015
- Published by Springer Nature
- p. 21-31
Measuring In Vivo Joint Motion and Ligament Function: New Developments
- 10 June 2015
- Published by Springer Nature
- p. 21-31
Measuring In Vivo Joint Motion and Ligament Function: New Developments
- 11 October 2014
- Published by Springer Nature
- p. 1-12
Measuring In Vivo Joint Motion and Ligament Function: New Developments
- 11 October 2014
- Published by Springer Nature
- p. 1-12
Measuring In Vivo Joint Motion and Ligament Function: New Developments
- 8 August 2014
- Published by Springer Nature
- p. 1-16
Orthopedic Research in the Year 2025
- 8 January 2014
- Published by SAGE Publications in The American Journal of Sports Medicine
- Vol. 42 (3) , 723-730
Biomechanical Evaluation of the Quadriceps Tendon Autograft for Anterior Cruciate Ligament Reconstruction
Background: Recently, many surgeons have chosen the quadriceps tendon (QT) as an autograft for anterior cruciate ligament (ACL) reconstruction. However, there have not been biomechanical studies that quantitatively evaluated knee function after reconstruction using a QT autograft. Purpose: To measure the 6 degrees of freedom knee kinematics and in situ graft forces after reconstruction with a QT autograft compared with a quadrupled semitendinosus and gracilis (QSTG) tendon autograft. Study Design: Controlled laboratory study. Methods: Ten human cadaveric knees (age, 54-64 years) were tested in 3 conditions: (1) intact, (2) ACL deficient, and (3) after ACL reconstruction using a QT or QSTG autograft. With use of a robotic/universal force-moment sensor testing system, knee kinematics and in situ forces in the ACL and autografts were obtained at 5 knee flexion angles under externally applied loads: (1) 134-N anterior tibial load, (2) 134-N anterior tibial load with 200-N axial compression, and (3) 10-N·m valgus and 5-N·m internal tibial torque. Results: Under the anterior tibial load, both autografts restored anterior tibial translation to within 2.5 mm of the intact knee and in situ forces to within 20 N of the intact ACL at 15°, 30°, and 60°. Adding compression did not change these findings. With the combined rotatory load, the anterior tibial translation and graft in situ forces were again not significantly different from the intact ACL. There were no significant differences between the grafts under any experimental condition. Conclusion: Reconstruction of the ACL with a QT autograft restored knee function to similar levels as that reconstructed with a QSTG autograft under loads simulating clinical examinations. Clinical Relevance: The positive biomechanical results of this cadaveric study lend support to the use of a QT autograft for ACL reconstruction, as it could restore knee function immediately after surgery under applied loads that mimic clinical examinations.
- 8 January 2014
- Published by SAGE Publications in The American Journal of Sports Medicine
- Vol. 42 (3) , 723-730
Biomechanical Evaluation of the Quadriceps Tendon Autograft for Anterior Cruciate Ligament Reconstruction
Background: Recently, many surgeons have chosen the quadriceps tendon (QT) as an autograft for anterior cruciate ligament (ACL) reconstruction. However, there have not been biomechanical studies that quantitatively evaluated knee function after reconstruction using a QT autograft. Purpose: To measure the 6 degrees of freedom knee kinematics and in situ graft forces after reconstruction with a QT autograft compared with a quadrupled semitendinosus and gracilis (QSTG) tendon autograft. Study Design: Controlled laboratory study. Methods: Ten human cadaveric knees (age, 54-64 years) were tested in 3 conditions: (1) intact, (2) ACL deficient, and (3) after ACL reconstruction using a QT or QSTG autograft. With use of a robotic/universal force-moment sensor testing system, knee kinematics and in situ forces in the ACL and autografts were obtained at 5 knee flexion angles under externally applied loads: (1) 134-N anterior tibial load, (2) 134-N anterior tibial load with 200-N axial compression, and (3) 10-N·m valgus and 5-N·m internal tibial torque. Results: Under the anterior tibial load, both autografts restored anterior tibial translation to within 2.5 mm of the intact knee and in situ forces to within 20 N of the intact ACL at 15°, 30°, and 60°. Adding compression did not change these findings. With the combined rotatory load, the anterior tibial translation and graft in situ forces were again not significantly different from the intact ACL. There were no significant differences between the grafts under any experimental condition. Conclusion: Reconstruction of the ACL with a QT autograft restored knee function to similar levels as that reconstructed with a QSTG autograft under loads simulating clinical examinations. Clinical Relevance: The positive biomechanical results of this cadaveric study lend support to the use of a QT autograft for ACL reconstruction, as it could restore knee function immediately after surgery under applied loads that mimic clinical examinations.
- 25 November 2013
- Published by Elsevier in Journal of Biomechanics
- Vol. 47 (2) , 592-595
Tensile properties of the medial patellofemoral ligament: The effect of specimen orientation
- 25 November 2013
- Published by Elsevier in Journal of Biomechanics
- Vol. 47 (2) , 592-595
Tensile properties of the medial patellofemoral ligament: The effect of specimen orientation