Kensuke Yamauchi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Kensuke Yamauchi has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
Tetsu Takahashi
9 shared publicationsIkuya Miyamoto
4 shared publicationsKatsuyuki Funaki
Department of Oral and Maxillofacial Surgery Division of Oral and Maxillofacial Reconstructive Surgery Kyushu Dental College Kitakyushu Japan
4 shared publicationsShinnosuke Nogami
3 shared publicationsYoshihiro Yamashita
3 shared publicationsT. Takahashi
2 shared publications
Latest Publications
- 1 May 2012
- Published by Wolters Kluwer Health in Journal of Craniofacial Surgery
- Vol. 23 (3) , 658-660
Pivot Technique Combined With Mandibular Backward Distraction Osteogenesis for the Patient With High Risk for Relapse
Severe skeletal relapse is one of the most difficult problems after mandibular advancement, and the management to overcome such problems tends to require more compromised methods and longer treatment period. We described that mandibular backward distraction osteogenesis with maxillomandibular fixation at an appropriate occlusion. Furthermore, to avoid inappropriate distraction vector, the distal plates of the distraction device were fixed with 1 screw to work as a pivot after the manipulation of the condyle to the glenoid fossa at the end of distraction activation. This technique was applied to 3 female patients with mandibular deficiency. The intraoral distractors were set on the lateral surface of the mandibular body; the fixation of the distal plate was fixed with 1 monocortical screw to make the proximal segment including the condyle manipulating at the end of the distraction phase by releasing the maxillomandibular fixation. The distraction rate was 1 mm/d, and the latency period was 7 days. The follow-up period after mandibular backward distraction osteogenesis ranged from 26 to 56 months. No specific complication, such as broken device, severe infection, or bony nonunion, occurred. Postoperative relapse was not observed during the follow-up period. This technique might become 1 choice to apply for mandibular deficiency in a patient with high risk for relapse.
- 1 May 2012
- Published by Wolters Kluwer Health in Journal of Craniofacial Surgery
- Vol. 23 (3) , 658-660
Pivot Technique Combined With Mandibular Backward Distraction Osteogenesis for the Patient With High Risk for Relapse
Severe skeletal relapse is one of the most difficult problems after mandibular advancement, and the management to overcome such problems tends to require more compromised methods and longer treatment period. We described that mandibular backward distraction osteogenesis with maxillomandibular fixation at an appropriate occlusion. Furthermore, to avoid inappropriate distraction vector, the distal plates of the distraction device were fixed with 1 screw to work as a pivot after the manipulation of the condyle to the glenoid fossa at the end of distraction activation. This technique was applied to 3 female patients with mandibular deficiency. The intraoral distractors were set on the lateral surface of the mandibular body; the fixation of the distal plate was fixed with 1 monocortical screw to make the proximal segment including the condyle manipulating at the end of the distraction phase by releasing the maxillomandibular fixation. The distraction rate was 1 mm/d, and the latency period was 7 days. The follow-up period after mandibular backward distraction osteogenesis ranged from 26 to 56 months. No specific complication, such as broken device, severe infection, or bony nonunion, occurred. Postoperative relapse was not observed during the follow-up period. This technique might become 1 choice to apply for mandibular deficiency in a patient with high risk for relapse.
- 1 February 2012
- Published by Elsevier in Journal of Oral and Maxillofacial Surgery
- Vol. 70 (2) , 401-406
Risk Factors for Neurosensory Disturbance After Bilateral Sagittal Split Osteotomy Based on Position of Mandibular Canal and Morphology of Mandibular Angle
- 1 February 2012
- Published by Elsevier in Journal of Oral and Maxillofacial Surgery
- Vol. 70 (2) , 401-406
Risk Factors for Neurosensory Disturbance After Bilateral Sagittal Split Osteotomy Based on Position of Mandibular Canal and Morphology of Mandibular Angle
- 26 January 2012
- Published by Wiley in Clinical Oral Implants Research
- Vol. 24 (5) , 563-568
Horizontal alveolar distraction osteogenesis for dental implant: long‐term results
Objectives: The aim of the present study was to present the results of patients followed for at least 3 years who underwent horizontal distraction osteogenesis DO and a final implant prosthesis.Material and Methods: A total of 13 sites in 12 patients (three men, nine women; mean age 45.4 years, range 21–63 years) who presented with severe horizontal atrophy of a partially edentulous maxilla or mandible were treated using horizontal DO. The horizontal distraction device was set on the transport bone which was osteotomized as bone splitting method and fixed to the segment using microscrews.Results: The median of latency period was 9 days (range: 7–17); the median of amount of device activation was 5.6 mm (range: 4.4–9.6); the median of distraction period was 14 days (range: 8–24); and the median of consolidation period, from the end of activation until implant placement, was 13 weeks (range: 11–20). The median of actual gain in bone width at the end of the consolidation period was 3.6 mm (range: 1.1–5.6). A total of 35 implants were inserted in the augmented area with primary implant stability. The median of follow‐up from the start of prosthetic loading was 5.4 years. Consequently, the implant survival and success rates were 100% and 94.2%, respectively.Conclusion: This article reports the long‐term results of horizontal alveolar DO using a mesh device for patients with an atrophic alveolar region. Our results confirm that this technique is a predictable and effective regenerative procedure for implant preprosthetic treatment in patients with severe horizontal atrophy of the alveolar ridge.
- 26 January 2012
- Published by Wiley in Clinical Oral Implants Research
- Vol. 24 (5) , 563-568
Horizontal alveolar distraction osteogenesis for dental implant: long‐term results
Objectives: The aim of the present study was to present the results of patients followed for at least 3 years who underwent horizontal distraction osteogenesis DO and a final implant prosthesis.Material and Methods: A total of 13 sites in 12 patients (three men, nine women; mean age 45.4 years, range 21–63 years) who presented with severe horizontal atrophy of a partially edentulous maxilla or mandible were treated using horizontal DO. The horizontal distraction device was set on the transport bone which was osteotomized as bone splitting method and fixed to the segment using microscrews.Results: The median of latency period was 9 days (range: 7–17); the median of amount of device activation was 5.6 mm (range: 4.4–9.6); the median of distraction period was 14 days (range: 8–24); and the median of consolidation period, from the end of activation until implant placement, was 13 weeks (range: 11–20). The median of actual gain in bone width at the end of the consolidation period was 3.6 mm (range: 1.1–5.6). A total of 35 implants were inserted in the augmented area with primary implant stability. The median of follow‐up from the start of prosthetic loading was 5.4 years. Consequently, the implant survival and success rates were 100% and 94.2%, respectively.Conclusion: This article reports the long‐term results of horizontal alveolar DO using a mesh device for patients with an atrophic alveolar region. Our results confirm that this technique is a predictable and effective regenerative procedure for implant preprosthetic treatment in patients with severe horizontal atrophy of the alveolar ridge.
- 1 December 2009
- Published by Elsevier in Oral Surgery Oral Medicine Oral Pathology Oral Radiology and Endodontology
- Vol. 108 (6) , 861-866
Implant placement for periosteal expansion osteogenesis using β-tricalcium phosphate block: An experimental study in dogs
- 1 December 2009
- Published by Elsevier in Oral Surgery Oral Medicine Oral Pathology Oral Radiology and Endodontology
- Vol. 108 (6) , 861-866
Implant placement for periosteal expansion osteogenesis using β-tricalcium phosphate block: An experimental study in dogs
- 1 June 2008
- Published by Wiley in Journal of Periodontology
- Vol. 79 (6) , 999-1005
Periosteal Expansion Osteogenesis Using Highly Purified Beta‐Tricalcium Phosphate Blocks: A Pilot Study in Dogs
Background: In highly atrophic edentulous jaws, the augmentation of the alveolar process is standard treatment for dental implantation because of the lack of alveolar bone height and width. Our aim was to examine periosteal expansion osteogenesis in a dog model, based on the concept of distraction osteogenesis, using a highly purified beta‐tricalcium phosphate (β‐TCP) block instead of an original bone segment.Methods: Three beagle dogs weighing 10 to 12 kg were used. The β‐TCP block was placed at the lateral surface of the mandibular bone. Two titanium screws were inserted from the lingual aspect to push the block to the buccal side. After a latency period of 8 days, during which primary wound healing occurred, the lingual screws were advanced by ∼0.5 mm/day for 8 days. Specimens were taken 8 weeks after lingual screw adjustments ceased and were analyzed by hematoxylin and eosin, tartrate‐resistant acid phosphatase (TRAP), and Villanueva bone staining.Results: The alveolar form at the experimental region was changed dramatically following lateral expansion with the β‐TCP block. Newly formed bone was observed in the gap between the bone and the β‐TCP block, as well as on the lateral surface of the block. Moreover, the replacement of large parts of β‐TCP with newly formed bone was observed in the β‐TCP block area. However, newly formed bone was not observed over the upper parts of the block, and multinucleated TRAP‐positive cells were attached to the β‐TCP in the periphery of this area.Conclusion: The highly purified β‐TCP block worked as an activator for the soft tissue, including the periosteum, as well as a space maker to induce an osteoblastic response in the periosteum.
- 1 June 2008
- Published by Wiley in Journal of Periodontology
- Vol. 79 (6) , 999-1005
Periosteal Expansion Osteogenesis Using Highly Purified Beta‐Tricalcium Phosphate Blocks: A Pilot Study in Dogs
Background: In highly atrophic edentulous jaws, the augmentation of the alveolar process is standard treatment for dental implantation because of the lack of alveolar bone height and width. Our aim was to examine periosteal expansion osteogenesis in a dog model, based on the concept of distraction osteogenesis, using a highly purified beta‐tricalcium phosphate (β‐TCP) block instead of an original bone segment.Methods: Three beagle dogs weighing 10 to 12 kg were used. The β‐TCP block was placed at the lateral surface of the mandibular bone. Two titanium screws were inserted from the lingual aspect to push the block to the buccal side. After a latency period of 8 days, during which primary wound healing occurred, the lingual screws were advanced by ∼0.5 mm/day for 8 days. Specimens were taken 8 weeks after lingual screw adjustments ceased and were analyzed by hematoxylin and eosin, tartrate‐resistant acid phosphatase (TRAP), and Villanueva bone staining.Results: The alveolar form at the experimental region was changed dramatically following lateral expansion with the β‐TCP block. Newly formed bone was observed in the gap between the bone and the β‐TCP block, as well as on the lateral surface of the block. Moreover, the replacement of large parts of β‐TCP with newly formed bone was observed in the β‐TCP block area. However, newly formed bone was not observed over the upper parts of the block, and multinucleated TRAP‐positive cells were attached to the β‐TCP in the periphery of this area.Conclusion: The highly purified β‐TCP block worked as an activator for the soft tissue, including the periosteum, as well as a space maker to induce an osteoblastic response in the periosteum.
- 1 December 2007
- Published by Elsevier in Oral Surgery Oral Medicine Oral Pathology Oral Radiology and Endodontology
- Vol. 104 (6) , 747-751
Condylar luxation following bilateral intraoral vertical ramus osteotomy
- 1 December 2007
- Published by Elsevier in Oral Surgery Oral Medicine Oral Pathology Oral Radiology and Endodontology
- Vol. 104 (6) , 747-751
Condylar luxation following bilateral intraoral vertical ramus osteotomy
- 1 September 2007
- Published by Elsevier in Journal of Oral and Maxillofacial Surgery
- Vol. 65 (9) , 1859-1861
Biodegradable Screw Fixation in Maxillofacial Distraction Osteogenesis
- 1 September 2007
- Published by Elsevier in Journal of Oral and Maxillofacial Surgery
- Vol. 65 (9) , 1859-1861
Biodegradable Screw Fixation in Maxillofacial Distraction Osteogenesis
- 1 August 2006
- Published by Wolters Kluwer Health in Plastic and Reconstructive Surgery
- Vol. 118 (2) , 39e-45e
Maxillary Distraction Osteogenesis Combined with Mandibular Osteotomy to Correct Asymmetry of the Maxillomandibular Complex
- 1 August 2006
- Published by Wolters Kluwer Health in Plastic and Reconstructive Surgery
- Vol. 118 (2) , 39e-45e
Maxillary Distraction Osteogenesis Combined with Mandibular Osteotomy to Correct Asymmetry of the Maxillomandibular Complex
- 1 June 2006
- Published by Elsevier in International Journal of Oral and Maxillofacial Surgery
- Vol. 35 (6) , 493-498
Maxillary distraction osteogenesis using Le Fort I osteotomy without intraoperative down-fracture
- 1 June 2006
- Published by Elsevier in International Journal of Oral and Maxillofacial Surgery
- Vol. 35 (6) , 493-498
Maxillary distraction osteogenesis using Le Fort I osteotomy without intraoperative down-fracture