Jun Hee Choi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jun Hee Choi has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Gyu-Tae Kim
School of Electrical Engineering, Korea University, Seoul, Republic of Korea
2 shared publications Chan Wook Baik
Frontier Research Laboratory, Samsung Advanced Institute of Technology, PO Box 111, Suwon 440-600, Korea
1 shared publicationDo-Hyun Kim
School of Electrical Engineering, Korea University , Seoul 02841, South Korea
1 shared publication- Do-Hyun Kim
School of Electrical Engineering, Korea University, Seoul, Republic of Korea
1 shared publication - Gyu-Chul Yi
Seoul National University
1 shared publication H.-K. Jang
Korea University School of Electrical Engineering Seoul 136-701, South Korea
1 shared publication
Latest Publications
- 9 October 2017
- Published by AIP Publishing in Applied Physics Letters
- Vol. 111 (15)
Induction heating effect on the performance of flexible MoS2 field-effect transistors
We investigated the induction heating effect on device characteristics of flexible molybdenum disulfide (MoS2) field-effect transistors (FETs). A polyimide film was employed as a flexible substrate, and poly(3,4-ethylenedioxythiophene):polystyrene sulfonate was coated on the flexible substrate as a bottom gate. After the annealing process on the flexible MoS2 FETs by induction heating, the field effect mobility was enhanced from 2.13 to 5.58 cm2/V·s with the slight increase of the on-off ratio from 5.17 × 102 to 1.98 × 103. Moreover, the low field mobility was almost unchanged from 7.75 to 7.33 cm2/V·s, indicating that the induction heating mainly contributed to the enhancement of the device performances by contact improvement between electrodes and MoS2. With the simple model of the diode and resistor connected in series, it was confirmed that the Schottky diode disappeared with contact enhancement. Our findings can contribute to the contact improvement with minimum damage when low dimensional nanomaterials are used as channel materials on flexible substrates.
- 9 October 2017
- Published by AIP Publishing in Applied Physics Letters
- Vol. 111 (15)
Induction heating effect on the performance of flexible MoS2 field-effect transistors
We investigated the induction heating effect on device characteristics of flexible molybdenum disulfide (MoS2) field-effect transistors (FETs). A polyimide film was employed as a flexible substrate, and poly(3,4-ethylenedioxythiophene):polystyrene sulfonate was coated on the flexible substrate as a bottom gate. After the annealing process on the flexible MoS2 FETs by induction heating, the field effect mobility was enhanced from 2.13 to 5.58 cm2/V·s with the slight increase of the on-off ratio from 5.17 × 102 to 1.98 × 103. Moreover, the low field mobility was almost unchanged from 7.75 to 7.33 cm2/V·s, indicating that the induction heating mainly contributed to the enhancement of the device performances by contact improvement between electrodes and MoS2. With the simple model of the diode and resistor connected in series, it was confirmed that the Schottky diode disappeared with contact enhancement. Our findings can contribute to the contact improvement with minimum damage when low dimensional nanomaterials are used as channel materials on flexible substrates.
- 31 October 2016
- Published by AIP Publishing in Applied Physics Letters
- Vol. 109 (18) , 183102
Ambipolar behavior in MoS2 field effect transistors by using catalytic oxidation
Modulation of electrical properties in MoS2 flakes is an attractive issue from the point of view of device applications. In this work, we demonstrate that an ambipolar behavior in MoS2 field effect transistors (FETs) can be easily obtained by heating MoS2 flakes under air atmosphere in the presence of cobalt oxide catalyst (MoS2 + O2 → MoOx + SOx). The catalytic oxidation of MoS2 flakes between source-drain electrodes resulted in lots of MoOx nanoparticles (NPs) on MoS2 flakes with thickness reduction from 64 nm to 17 nm. Consequently, N-type behavior of MoS2 FETs was converted into ambipolar transport characteristics by MoOx NPs which inject hole carriers to MoS2 flakes.
- 31 October 2016
- Published by AIP Publishing in Applied Physics Letters
- Vol. 109 (18) , 183102
Ambipolar behavior in MoS2 field effect transistors by using catalytic oxidation
Modulation of electrical properties in MoS2 flakes is an attractive issue from the point of view of device applications. In this work, we demonstrate that an ambipolar behavior in MoS2 field effect transistors (FETs) can be easily obtained by heating MoS2 flakes under air atmosphere in the presence of cobalt oxide catalyst (MoS2 + O2 → MoOx + SOx). The catalytic oxidation of MoS2 flakes between source-drain electrodes resulted in lots of MoOx nanoparticles (NPs) on MoS2 flakes with thickness reduction from 64 nm to 17 nm. Consequently, N-type behavior of MoS2 FETs was converted into ambipolar transport characteristics by MoOx NPs which inject hole carriers to MoS2 flakes.
- 10 June 2010
- Published by IOP Publishing in Nanotechnology
- Vol. 21 (26) , 265603
ZnO nanostructures with controlled morphologies on a glass substrate
We report morphology-controlled selective growth of ZnO nanostructures on glass substrates by using catalyst-free metal-organic chemical vapor deposition. For the morphology-controlled selective growth, a microheating method using a series of microheaters was developed, which provided well-controlled local heating based on the microheater geometry and spatial arrangement. ZnO nanostructure morphology depended on the local growth temperature, so various nanostructure morphologies were obtained selectively at specific positions on glass substrates by using local microheating. The monolithic integration of nanostructures with different morphologies will have great potential for applications in multifunctional devices.
- 10 June 2010
- Published by IOP Publishing in Nanotechnology
- Vol. 21 (26) , 265603
ZnO nanostructures with controlled morphologies on a glass substrate
We report morphology-controlled selective growth of ZnO nanostructures on glass substrates by using catalyst-free metal-organic chemical vapor deposition. For the morphology-controlled selective growth, a microheating method using a series of microheaters was developed, which provided well-controlled local heating based on the microheater geometry and spatial arrangement. ZnO nanostructure morphology depended on the local growth temperature, so various nanostructure morphologies were obtained selectively at specific positions on glass substrates by using local microheating. The monolithic integration of nanostructures with different morphologies will have great potential for applications in multifunctional devices.