Xiaodong Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Xiaodong Wang has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
Guiyun Yi
5 shared publicationsJuanmei Zhou
5 shared publicationsBin Yang
4 shared publicationsYan Wang
4 shared publicationsYaping Zhang
3 shared publications- Guang Sun
School of Chemistry and Chemical Engineering, Henan Polytechnic University, Jiaozuo 454000, China
2 shared publications
Latest Publications
- 18 March 2026
- Published by Trans Tech Publications, Ltd. in Journal of Nano Research
- Vol. 91, 51-65
Preparation of Co3O4/In2O3 Nanobundles and Their High Formaldehyde-Sensitive Properties
Formaldehyde is an indoor pollutant that poses a risk to human health, and prolonged exposure may lead to various diseases. Therefore, highly sensitive and selective detection technologies are needed to accurately monitor formaldehyde concentrations. In 2 O 3 is a commonly-used semiconductor material in gas sensing. However, the gas sensing performance of pure In 2 O 3 sensors falls far from expectation and the construction of heterojunctions is an effective strategy to resolve such issue. In this study, indium oxide-based composites (Co 3 O 4 /In 2 O 3 ) with a typical p-n heterojunction were synthesized via a simple template-free hydrothermal method for high-performance formaldehyde sensing. XRD, SEM, TEM, and XPS confirmed the p-n heterojunction formation and its positive impact on enhancing surface reactivity. Gas-sensing tests demonstrated that the 3 wt% Co 3 O 4 /In 2 O 3 sensor exhibited optimal performance. The 3 wt% Co 3 O 4 /In 2 O 3 sensor exhibited a response value of 11.1 to 100 ppm formaldehyde at 300°C that was threefold higher than that of pure In 2 O 3 (3.77); its recovery time was 41 seconds quicker than that of In 2 O 3 (73 s vs. 114 s). The sensor also showed excellent selectivity, reproducibility, and stability. This research presents a scalable, heterojunction-driven design concept for the next generation of gas sensors.
- 18 March 2026
- Published by Trans Tech Publications, Ltd. in Journal of Nano Research
- Vol. 91, 51-65
Preparation of Co3O4/In2O3 Nanobundles and Their High Formaldehyde-Sensitive Properties
Formaldehyde is an indoor pollutant that poses a risk to human health, and prolonged exposure may lead to various diseases. Therefore, highly sensitive and selective detection technologies are needed to accurately monitor formaldehyde concentrations. In 2 O 3 is a commonly-used semiconductor material in gas sensing. However, the gas sensing performance of pure In 2 O 3 sensors falls far from expectation and the construction of heterojunctions is an effective strategy to resolve such issue. In this study, indium oxide-based composites (Co 3 O 4 /In 2 O 3 ) with a typical p-n heterojunction were synthesized via a simple template-free hydrothermal method for high-performance formaldehyde sensing. XRD, SEM, TEM, and XPS confirmed the p-n heterojunction formation and its positive impact on enhancing surface reactivity. Gas-sensing tests demonstrated that the 3 wt% Co 3 O 4 /In 2 O 3 sensor exhibited optimal performance. The 3 wt% Co 3 O 4 /In 2 O 3 sensor exhibited a response value of 11.1 to 100 ppm formaldehyde at 300°C that was threefold higher than that of pure In 2 O 3 (3.77); its recovery time was 41 seconds quicker than that of In 2 O 3 (73 s vs. 114 s). The sensor also showed excellent selectivity, reproducibility, and stability. This research presents a scalable, heterojunction-driven design concept for the next generation of gas sensors.
- 9 January 2025
- Published by Elsevier in Materials Today Communications
- Vol. 42
Highly open skeleton In2O3/ZnO as a high-performance formaldehyde sensing material for gas sensors
- 9 January 2025
- Published by Elsevier in Materials Today Communications
- Vol. 42
Highly open skeleton In2O3/ZnO as a high-performance formaldehyde sensing material for gas sensors
- 17 July 2024
- Published by Springer Nature in Journal of Porous Materials
- Vol. 31 (6) , 2091-2100
Preparation of Pt-modified In2O3 nanobundles with enhanced formaldehyde gas sensing performance
- 17 July 2024
- Published by Springer Nature in Journal of Porous Materials
- Vol. 31 (6) , 2091-2100
Preparation of Pt-modified In2O3 nanobundles with enhanced formaldehyde gas sensing performance
- 16 November 2023
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 47 (48) , 22226-22234
Construction of ZnCo 2 O 4 decorated ZnO heterostructure materials for sensing triethylamine with dramatically enhanced performance
In this paper, a sensor based on a novel ZnCo 2 O 4 /ZnO nanosheet-like p–n heterostructure was designed using a one-step hydrothermal method and utilized to dramatically improve the sensitivity toward triethylamine (TEA) gas.
- 16 November 2023
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 47 (48) , 22226-22234
Construction of ZnCo 2 O 4 decorated ZnO heterostructure materials for sensing triethylamine with dramatically enhanced performance
In this paper, a sensor based on a novel ZnCo 2 O 4 /ZnO nanosheet-like p–n heterostructure was designed using a one-step hydrothermal method and utilized to dramatically improve the sensitivity toward triethylamine (TEA) gas.
- 19 May 2023
- Published by Springer Nature in Journal of Porous Materials
- Vol. 30 (6) , 1925-1936
Preparation of porous Co3O4-ZnO nanosheet composites and study of their gas-sensitive properties
- 19 May 2023
- Published by Springer Nature in Journal of Porous Materials
- Vol. 30 (6) , 1925-1936
Preparation of porous Co3O4-ZnO nanosheet composites and study of their gas-sensitive properties
- 24 June 2021
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 21 (7) , 4201-4206
A Novel Technique for Large-Scale Fabrication of 3D Colloidal Crystals: Suspending Self-Assembly in Water Medium (SSAM)
- 24 June 2021
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 21 (7) , 4201-4206
A Novel Technique for Large-Scale Fabrication of 3D Colloidal Crystals: Suspending Self-Assembly in Water Medium (SSAM)
- Open Access
- 11 November 2019
- Published by MDPI AG in Nanomaterials
- Vol. 9 (11) , 1599
Hydrothermal Synthesis of Co3O4/ZnO Hybrid Nanoparticles for Triethylamine Detection
Development of high performances gas sensors to monitor and detect the volatile organic compound triethylamine is of paramount importance for health and environmental protection. The Co3O4-ZnO nanoparticles composite was successfully synthesized by the one-step hydrothermal route and annealing process in this work. The gas sensitivity test results show that the composite exhibits excellent triethylamine-sensing performance at a cobalt content of 1 at%, indicating potential application for triethylamine detection. The sensor based on the Co3O4-ZnO composite had higher sensitivity to triethylamine, better selectivity, and faster response recovery rate compared with pure ZnO sensor. Combined with the structural characteristics of the characterized Co3O4-ZnO nanocomposite, the optimized triethylamine sensing performances can be ascribed to the p-n heterojunction effect between Co3O4 and ZnO, as well as the catalytic and high oxygen adsorption properties of Co3O4.
- 11 November 2019
- Published by MDPI AG in Nanomaterials
- Vol. 9 (11) , 1599
Open AccessHydrothermal Synthesis of Co3O4/ZnO Hybrid Nanoparticles for Triethylamine Detection
Development of high performances gas sensors to monitor and detect the volatile organic compound triethylamine is of paramount importance for health and environmental protection. The Co3O4-ZnO nanoparticles composite was successfully synthesized by the one-step hydrothermal route and annealing process in this work. The gas sensitivity test results show that the composite exhibits excellent triethylamine-sensing performance at a cobalt content of 1 at%, indicating potential application for triethylamine detection. The sensor based on the Co3O4-ZnO composite had higher sensitivity to triethylamine, better selectivity, and faster response recovery rate compared with pure ZnO sensor. Combined with the structural characteristics of the characterized Co3O4-ZnO nanocomposite, the optimized triethylamine sensing performances can be ascribed to the p-n heterojunction effect between Co3O4 and ZnO, as well as the catalytic and high oxygen adsorption properties of Co3O4.
- Open Access
- 1 January 2017
- Published by Wiley in Journal of Nanomaterials
- Vol. 2017, 1-10
One-Step Synthesis of Hierarchical Micro-Mesoporous SiO2/Reduced Graphene Oxide Nanocomposites for Adsorption of Aqueous Cr(VI)
A novel micro-mesostructured SiO2/reduced graphene oxide (RGO) nanocomposite was successfully synthesized by means of simple one-step hydrothermal method under acidic conditions using tetraethoxysilane (TEOS) and graphene oxide (GO) as the raw material. The nanocomposites were characterized by TEM, XRD, FT-IR, TG-DSC, and N2 adsorption-desorption. The results showed that GO was partially reduced to RGO without adding any reducing agent and SiO2 nanoparticles (ca. 10 nm) were uniformly anchored on the surface of RGO. The optimized composite contained 75 wt.% SiO2 and possessed hierarchical micro-mesoporous structure with surface area of 676 m2/g. The adsorption performance of synthesized SiO2/RGO samples was investigated by removal efficiency of Cr(VI) ions in wastewater. The Cr(VI) adsorption reached equilibrium in 30 min and 98.8% Cr(VI) adsorption efficiency was achieved at pH = 2 at 35°C. Stability tests showed that SiO2 nanoparticles effectively prevented RGO from the restacking. The mechanisms of composite formation and for Cr(VI) adsorption were suggested.
- 1 January 2017
- Published by Wiley in Journal of Nanomaterials
- Vol. 2017, 1-10
Open AccessOne-Step Synthesis of Hierarchical Micro-Mesoporous SiO2/Reduced Graphene Oxide Nanocomposites for Adsorption of Aqueous Cr(VI)
A novel micro-mesostructured SiO2/reduced graphene oxide (RGO) nanocomposite was successfully synthesized by means of simple one-step hydrothermal method under acidic conditions using tetraethoxysilane (TEOS) and graphene oxide (GO) as the raw material. The nanocomposites were characterized by TEM, XRD, FT-IR, TG-DSC, and N2 adsorption-desorption. The results showed that GO was partially reduced to RGO without adding any reducing agent and SiO2 nanoparticles (ca. 10 nm) were uniformly anchored on the surface of RGO. The optimized composite contained 75 wt.% SiO2 and possessed hierarchical micro-mesoporous structure with surface area of 676 m2/g. The adsorption performance of synthesized SiO2/RGO samples was investigated by removal efficiency of Cr(VI) ions in wastewater. The Cr(VI) adsorption reached equilibrium in 30 min and 98.8% Cr(VI) adsorption efficiency was achieved at pH = 2 at 35°C. Stability tests showed that SiO2 nanoparticles effectively prevented RGO from the restacking. The mechanisms of composite formation and for Cr(VI) adsorption were suggested.