Bahruddin Saad

The construction and electrochemical response characteristics of poly(vinyl chloride) (PVC) membrane electrodes for tetracaine hydrochloride (TCH) are described. The sensing membranes incorporating ion-association complexes of tetracaine cation with phosphotungstic acid (PTA) or phosphomolybdic acid (PMA) or Sodium tetraphenyl borate (NaTPB) as electroactive materials and di-n-butyl phthalate (DBPH) or tri-n-butyl phosphate (TBP) as a plasticizer in PVC matrixes were evaluated. The results obtained show the electrodes based on PTA or PMA as electroactive compounds and DBPH as plasticizer with a fast, stable and near-Nernstian response over a wide concentration range (1 × 10⁻⁵–5 × 10⁻² M), with cationic slopes of 55.02 and 52.05 mV decade⁻¹ over a pH range of (2.5–6.5). The electrodes show good discrimination of tetracaine from several inorganic cations and sugars. The electrodes were successfully applied for the determination of tetracaine in pharmaceutical formulations.

A novel microextraction method based on vortex‐ and CO₂‐assisted liquid–liquid microextraction with salt addition for the isolation of furanic compounds (5‐hydroxymethyl‐2‐furaldehyde, 5‐methyl‐2‐furaldehyde, 2‐furaldehyde, 3‐furaldehyde, 2‐furoic and 3‐furoic acids) was developed. Purging the sample with CO₂ was applied after vortexing to enhance the phase separation and mass transfer of the analytes. The optimum extraction conditions were: extraction solvent (volume), propyl acetate (125 μL); sample pH, 2.4; vortexing time, 45 s; salt concentration, 25% w/v and purging time, 5 min. The analytes were separated using an ODS Hypersil C₁₈ column (250×4.6 mm i.d, 5 μm) under gradient flow. The proposed method showed good linearities (r² >0.999), low detection limits (0.08–1.9 μg/L) and good recoveries (80.7–122%). The validated method was successfully applied for the determination of the furanic compounds in concentrated juice (mango, date, orange, pomegranate, roselle, mangosteen and soursop) and dried fruit (prune, date and apricot paste) samples.

The aim of the current study was to develop a simple, precise, and accurate capillary zone electrophoresis method for the determination of zolpidem tartrate in tablet dosage form. Separation was conducted in normal polarity mode at 25°C, 22 kV, using hydrodynamic injection for 10 s. Separation was achieved using a background electrolyte of 20 mM disodium hydrogen phosphate adjusted with phosphoric acid (85%), pH at 5.50, and detection at 254 nm. Using the above optimized conditions, complete determination took place in less than 3 min using amiloride HCl as the internal standard. The method was linear over the range of 3–1000 μg mL⁻¹ with a correlation coefficient of 0.9999. Forced degradation studies were conducted by introducing a sample of zolpidem tartrate standard and pharmaceutical sample solutions to different forced degradation conditions, being neutral (water), basic (0.1 M NaOH), acidic (0.1 M HCl), oxidative (10% H₂O₂), temperature (60°C in oven for 3 days), and photolytic (exposure to UV light at 254 nm for 2 h). Degradation products resulting from the stress studies did not interfere with the detection of zolpidem tartrate and the assay can be considered stability-indicating.