Charles J. Gatt
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Charles J. Gatt has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Michael G. Dunn
Department of Orthopaedic Surgery, Rutgers Biomedical and Health Sciences-Robert Wood Johnson Medical School , New Brunswick, New Jersey
2 shared publications - Eleni Panas-Perez
Orthopaedic Research Laboratory, Department of Orthopaedic Surgery, University of Medicine and Dentistry of New Jersey, Robert Wood Johnson Medical School, New Brunswick, NJ 08903, USA
1 shared publication - Joachim Kohn
New Jersey Center for Biomaterials, Rutgers University, 145 Bevier Road, Piscataway, NJ 08854, USA
1 shared publication - Michael Jaffe
Department of Biomedical Engineering, New Jersey Institute of Technology, Newark, NJ 07102, USA.
1 shared publication - N. Sanjeeva Murthy
New Jersey Center for Biomaterials, Rutgers University, Piscataway, New Jersey
1 shared publication - Nick Tovar
Biomaterials and Regenerative Biology Division, NYU College of Dentistry, New York, NY, USA
1 shared publication
Latest Publications
- 10 October 2012
- Published by Springer Nature in Journal of Materials Science: Materials in Medicine
- Vol. 24 (1) , 257-265
Development of a silk and collagen fiber scaffold for anterior cruciate ligament reconstruction
The objective of this study was to determine a silk-collagen fiber ratio for an anterior cruciate ligament (ACL) reconstruction composite scaffold device. Composite fiber scaffolds with silk volumes ≥14 % and collagen volume <86 % demonstrated comparable or greater initial ultimate tensile stress relative to the human ACL. Silk scaffolds implanted subcutaneously and intraarticularly in rabbits demonstrated an 84 and 92 % reduction in strength with a 26 and 22 % reduction in volume after 8 weeks, respectively. The mechanical degradation findings of this preliminary study suggest that a composite scaffold with an initial UTS value of at least 129 MPa, or roughly a 48:52 silk to collagen volume ratio meets the minimal mechanical requirements necessary to proceed to a functional ACL reconstruction study in vivo.
- 10 October 2012
- Published by Springer Nature in Journal of Materials Science: Materials in Medicine
- Vol. 24 (1) , 257-265
Development of a silk and collagen fiber scaffold for anterior cruciate ligament reconstruction
The objective of this study was to determine a silk-collagen fiber ratio for an anterior cruciate ligament (ACL) reconstruction composite scaffold device. Composite fiber scaffolds with silk volumes ≥14 % and collagen volume <86 % demonstrated comparable or greater initial ultimate tensile stress relative to the human ACL. Silk scaffolds implanted subcutaneously and intraarticularly in rabbits demonstrated an 84 and 92 % reduction in strength with a 26 and 22 % reduction in volume after 8 weeks, respectively. The mechanical degradation findings of this preliminary study suggest that a composite scaffold with an initial UTS value of at least 129 MPa, or roughly a 48:52 silk to collagen volume ratio meets the minimal mechanical requirements necessary to proceed to a functional ACL reconstruction study in vivo.
- 20 July 2009
- Published by Wiley in Journal of Biomedical Materials Research Part A
- Vol. 93A (2) , 738-747
A comparison of degradable synthetic polymer fibers for anterior cruciate ligament reconstruction
We compared mechanical properties, degradation rates, and cellular compatibilities of two synthetic polymer fibers potentially useful as ACL reconstruction scaffolds: poly(desaminotyrosyl‐tyrosine dodecyl dodecanedioate)(12,10), p(DTD DD) and poly(L‐lactic acid), PLLA. The yield stress of ethylene oxide (ETO) sterilized wet fibers was 150 ± 22 MPa and 87 ± 12 MPa for p(DTD DD) and PLLA, respectively, with moduli of 1.7 ± 0.1 MPa and 4.4 ± 0.43 MPa. Strength and molecular weight retention were determined after incubation under physiological conditions at varying times. After 64 weeks strength decreased to 20 and 37% of the initial sterile fiber values and MW decreased to 41% and 36% of the initial values for p(DTD DD) and PLLA, respectively. ETO sterilization had no significant effect on mechanical properties. Differences in mechanical behavior may be due to the semicrystalline nature of PLLA and the small degree of crystallinity induced by mesogenic ordering in p(DTD DD) suggested by DSC analysis. Fibroblast growth was similar on 50‐fiber scaffolds of both polymers through 16 days in vitro. These data suggest that p(DTD DD) fibers, with higher strength, lower stiffness, favorable degradation rate and cellular compatibility, may be a superior alternative to PLLA fibers for development of ACL reconstruction scaffolds. © 2009 Wiley Periodicals, Inc. J Biomed Mater Res, 2010
- 20 July 2009
- Published by Wiley in Journal of Biomedical Materials Research Part A
- Vol. 93A (2) , 738-747
A comparison of degradable synthetic polymer fibers for anterior cruciate ligament reconstruction
We compared mechanical properties, degradation rates, and cellular compatibilities of two synthetic polymer fibers potentially useful as ACL reconstruction scaffolds: poly(desaminotyrosyl‐tyrosine dodecyl dodecanedioate)(12,10), p(DTD DD) and poly(L‐lactic acid), PLLA. The yield stress of ethylene oxide (ETO) sterilized wet fibers was 150 ± 22 MPa and 87 ± 12 MPa for p(DTD DD) and PLLA, respectively, with moduli of 1.7 ± 0.1 MPa and 4.4 ± 0.43 MPa. Strength and molecular weight retention were determined after incubation under physiological conditions at varying times. After 64 weeks strength decreased to 20 and 37% of the initial sterile fiber values and MW decreased to 41% and 36% of the initial values for p(DTD DD) and PLLA, respectively. ETO sterilization had no significant effect on mechanical properties. Differences in mechanical behavior may be due to the semicrystalline nature of PLLA and the small degree of crystallinity induced by mesogenic ordering in p(DTD DD) suggested by DSC analysis. Fibroblast growth was similar on 50‐fiber scaffolds of both polymers through 16 days in vitro. These data suggest that p(DTD DD) fibers, with higher strength, lower stiffness, favorable degradation rate and cellular compatibility, may be a superior alternative to PLLA fibers for development of ACL reconstruction scaffolds. © 2009 Wiley Periodicals, Inc. J Biomed Mater Res, 2010