Jonathan Pinder
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jonathan Pinder has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- April Cridland Mathad
Department of Physics, Faculty of Science and Engineering, Swansea University, Swansea, UK
6 shared publications - José Verdú
Department of Physics and Astronomy, University of Sussex, Sussex BN1 9QH, United Kingdom
6 shared publications - John Henry Lacy
Department of Physics Williams College 01267 Williamstown MA USA
4 shared publications - A. J. Uribe Jimenez
TRIUMF, Vancouver, British Columbia, Canada.
3 shared publications Alberto Uribe
Geonium Chip Group, School of Mathematical and Physical Sciences, University of Sussex, Falmer, U.K.
2 shared publicationsRyan Willetts
Geonium Chip Group, School of Mathematical and Physical Sciences, University of Sussex, Falmer, U.K.
2 shared publications
Latest Publications
- Open Access
- 1 August 2022
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 93 (8) , 083202
High frequency properties of a planar ion trap fabricated on a chip
We report on the measurement of the high frequency properties of a planar Penning ion trap fabricated on a chip. Two types of chips have been measured: the first manufactured by photolithographic metal deposition on a p-doped silicon substrate and the second made with printed circuit board technology on an alumina substrate. The input capacitances and the admittances between the different trap’s electrodes play a critical role in the electronic detection of the trapped particles. The measured input capacitances of the photolithographic chip amount to 65−76 pF, while the values for the printed circuit board chips are in the range of 3−5 pF. The latter are small enough for detecting non-destructively a single trapped electron or ion with a specifically tuned LC resonator. We have also measured a mutual capacitance of ∼85 fF between two of the trap’s electrodes in the printed circuit board chip. This enables the detection of single, or very few, trapped particles in a broader range of charge-to-mass ratios with a simple resistor on the chip. We provide analytic calculations of the capacitances and discuss their origin and possible further reduction.
- 1 August 2022
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 93 (8) , 083202
Open AccessHigh frequency properties of a planar ion trap fabricated on a chip
We report on the measurement of the high frequency properties of a planar Penning ion trap fabricated on a chip. Two types of chips have been measured: the first manufactured by photolithographic metal deposition on a p-doped silicon substrate and the second made with printed circuit board technology on an alumina substrate. The input capacitances and the admittances between the different trap’s electrodes play a critical role in the electronic detection of the trapped particles. The measured input capacitances of the photolithographic chip amount to 65−76 pF, while the values for the printed circuit board chips are in the range of 3−5 pF. The latter are small enough for detecting non-destructively a single trapped electron or ion with a specifically tuned LC resonator. We have also measured a mutual capacitance of ∼85 fF between two of the trap’s electrodes in the printed circuit board chip. This enables the detection of single, or very few, trapped particles in a broader range of charge-to-mass ratios with a simple resistor on the chip. We provide analytic calculations of the capacitances and discuss their origin and possible further reduction.
- 27 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 32 (7) , 1-11
Flux Pumping of Multiple Double-Loop Superconducting Structures for a Planar Magnetic Field Source
We discuss how flux pumping can be applied to multiple inductively coupled superconducting circuits, and describe its importance to the operation of a novel, planar magnetic field source for quantum technology applications. Specifically, we discuss how applying a transformer-rectifier flux pumping technique to several double-loop superconducting structures simultaneously allows for the effect of cross-talk — the inevitable coupling between neighbouring superconducting loops — to be accounted for. Using both a theoretical model and an experimental verification, we introduce a method of calibrating a flux-pumped magnetic field source such that any desired magnetic field distribution within the critical current limits of the used materials can be obtained.
- 27 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 32 (7) , 1-11
Flux Pumping of Multiple Double-Loop Superconducting Structures for a Planar Magnetic Field Source
We discuss how flux pumping can be applied to multiple inductively coupled superconducting circuits, and describe its importance to the operation of a novel, planar magnetic field source for quantum technology applications. Specifically, we discuss how applying a transformer-rectifier flux pumping technique to several double-loop superconducting structures simultaneously allows for the effect of cross-talk — the inevitable coupling between neighbouring superconducting loops — to be accounted for. Using both a theoretical model and an experimental verification, we introduce a method of calibrating a flux-pumped magnetic field source such that any desired magnetic field distribution within the critical current limits of the used materials can be obtained.
- 12 October 2020
- Published by AIP Publishing in Applied Physics Letters
- Vol. 117 (15)
Coherent coupling of a trapped electron to a distant superconducting microwave cavity
We theoretically investigate the coupling of a single electron in a planar Penning trap with a remote superconducting microwave (MW) cavity. Coupling frequencies around Ω=2π·1 MHz can be reached with resonators with a loaded quality factor of Q=105, allowing for the strong coupling regime. The electron and the cavity form a system of two coupled quantum harmonic oscillators. This is a hybrid and linear microwave quantum network. We show that the coherent interaction can be sustained over distances of a few mm up to several cm. Similar to classical linear MW circuits, the coherent quantum exchange of photons is ruled by the impedances of the electron and the cavity. As one concrete application, we discuss the entanglement of the cyclotron motions of two electrons located in two separate traps.
- 12 October 2020
- Published by AIP Publishing in Applied Physics Letters
- Vol. 117 (15)
Coherent coupling of a trapped electron to a distant superconducting microwave cavity
We theoretically investigate the coupling of a single electron in a planar Penning trap with a remote superconducting microwave (MW) cavity. Coupling frequencies around Ω=2π·1 MHz can be reached with resonators with a loaded quality factor of Q=105, allowing for the strong coupling regime. The electron and the cavity form a system of two coupled quantum harmonic oscillators. This is a hybrid and linear microwave quantum network. We show that the coherent interaction can be sustained over distances of a few mm up to several cm. Similar to classical linear MW circuits, the coherent quantum exchange of photons is ruled by the impedances of the electron and the cavity. As one concrete application, we discuss the entanglement of the cyclotron motions of two electrons located in two separate traps.
- 1 October 2020
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 91 (10) , 103201
Planar, strong magnetic field source for a chip ion trap
We present a planar, scalable magnetic field source, originally conceived for a chip ion trap. It consists of two symmetric sections, each with several independent currents arranged in coplanar, concentric rectangular loops. The currents allow for tuning the strength of the field and its lowest-order derivatives at one discretional position along the source’s vertical symmetry axis, a few mm above its surface. We describe the construction and calibration of the device and the cryogenic setup. The two most important current configurations for a Penning ion trap, the homogeneous field and the magnetic bottle, are investigated experimentally. Homogeneous fields around 0.5 T are routinely reached. We discuss the maximum attainable field, and we briefly describe ongoing further developments aiming at homogeneous fields well above 1 T.
- 1 October 2020
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 91 (10) , 103201
Planar, strong magnetic field source for a chip ion trap
We present a planar, scalable magnetic field source, originally conceived for a chip ion trap. It consists of two symmetric sections, each with several independent currents arranged in coplanar, concentric rectangular loops. The currents allow for tuning the strength of the field and its lowest-order derivatives at one discretional position along the source’s vertical symmetry axis, a few mm above its surface. We describe the construction and calibration of the device and the cryogenic setup. The two most important current configurations for a Penning ion trap, the homogeneous field and the magnetic bottle, are investigated experimentally. Homogeneous fields around 0.5 T are routinely reached. We discuss the maximum attainable field, and we briefly describe ongoing further developments aiming at homogeneous fields well above 1 T.
- 24 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 30 (8) , 1-12
Superconducting Flux Pump for a Planar Magnetic Field Source
We describe a novel use for superconducting flux pumping, namely a method for magnetizing a planar magnetic field source. The method is useful for many applications, but we illustrate it with the planar Penning trap with applications in quantum technology. A flux pumping mechanism and associated mathematical model are described. The method allows for complete control of the induced persistent current in a double-loop superconducting structure, whereby the final current is a known function of the applied flux and the loop geometry. We have tested our flux pumping technique and found excellent agreement with the theory.
- 24 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 30 (8) , 1-12
Superconducting Flux Pump for a Planar Magnetic Field Source
We describe a novel use for superconducting flux pumping, namely a method for magnetizing a planar magnetic field source. The method is useful for many applications, but we illustrate it with the planar Penning trap with applications in quantum technology. A flux pumping mechanism and associated mathematical model are described. The method allows for complete control of the induced persistent current in a double-loop superconducting structure, whereby the final current is a known function of the applied flux and the loop geometry. We have tested our flux pumping technique and found excellent agreement with the theory.
- Open Access
Single Microwave Photon Detection with a Trapped Electron
We investigate theoretically the use of an electron in a Penning trap as a detector of single microwave photons. At the University of Sussex we are developing a chip Penning trap technology, designed to be integrated within quantum circuits. Microwave photons are guided into the trap and interact with the electron’s quantum cyclotron motion. This is an electric dipole transition, where the near field of the microwave radiation induces quantum jumps of the cyclotron harmonic oscillator. The quantum jumps can be monitored using the continuous Stern-Gerlach effect, providing the quantum non demolition signal of the microwave quanta. We calculate the quantum efficiency of photon detection and discuss the main features and technical challenges for the trapped electron as a quantum microwave sensor.
Open AccessSingle Microwave Photon Detection with a Trapped Electron
We investigate theoretically the use of an electron in a Penning trap as a detector of single microwave photons. At the University of Sussex we are developing a chip Penning trap technology, designed to be integrated within quantum circuits. Microwave photons are guided into the trap and interact with the electron’s quantum cyclotron motion. This is an electric dipole transition, where the near field of the microwave radiation induces quantum jumps of the cyclotron harmonic oscillator. The quantum jumps can be monitored using the continuous Stern-Gerlach effect, providing the quantum non demolition signal of the microwave quanta. We calculate the quantum efficiency of photon detection and discuss the main features and technical challenges for the trapped electron as a quantum microwave sensor.
- 1 December 2013
- Published by Elsevier in International Journal of Mass Spectrometry
- Vol. 356, 49-59
A planar Penning trap with tunable dimensionality of the trapping potential
- 1 December 2013
- Published by Elsevier in International Journal of Mass Spectrometry
- Vol. 356, 49-59
A planar Penning trap with tunable dimensionality of the trapping potential