Andrew W. Tricker
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Andrew W. Tricker has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Carsten Sievers
Georgia Institute of Technology
4 shared publications - Adam Zev Weber
Lawrence Berkeley National Laboratory
2 shared publications Erin V. Phillips
School of Chemistry and Biochemistry, Georgia Institute of Technology, Atlanta, Georgia 30332, United States
2 shared publicationsNemanja Danilovic
Energy Storage and Distributed Resources Division, Lawrence Berkeley National Laboratory, Berkeley, USA
2 shared publications- Xiong Peng
Energy Storage and Distributed Resources Division Lawrence Berkeley National Laboratory Berkeley CA 94720 USA
2 shared publications - Andreas Sebastian Bommarius
School of Chemical & Biomolecular Engineering, Georgia Institute of Technology, 950 Atlantic Drive, Atlanta, Georgia 30332-2000, United States
1 shared publication
Latest Publications
- Open Access
- 5 August 2024
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 12 (33) , 12306-12312
Mechanocatalytic Hydrogenolysis of the Lignin Model Dimer Benzyl Phenyl Ether over Supported Palladium Catalysts
This work demonstrates the mechanocatalytic hydrogenolysis of the ether bond in the lignin model compound benzyl phenyl ether (BPE) and hardwood lignin isolated by hydrolysis with supercritical water. Pd catalysts with 4 wt % loading on Al2O3 and SiO2 supports achieve 100% conversion of BPE with a toluene production rate of (2.6-2.9) × 10-5 mol·min-1. The formation of palladium hydrides under H2 gas flow contributes to an increase in the turnover frequency by a factor of up to 300 compared to Ni on silica-alumina. While a near-quantitative toluene yield is obtained, some of the phenolic products remain adsorbed on the catalyst.
- 5 August 2024
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 12 (33) , 12306-12312
Open AccessMechanocatalytic Hydrogenolysis of the Lignin Model Dimer Benzyl Phenyl Ether over Supported Palladium Catalysts
This work demonstrates the mechanocatalytic hydrogenolysis of the ether bond in the lignin model compound benzyl phenyl ether (BPE) and hardwood lignin isolated by hydrolysis with supercritical water. Pd catalysts with 4 wt % loading on Al2O3 and SiO2 supports achieve 100% conversion of BPE with a toluene production rate of (2.6-2.9) × 10-5 mol·min-1. The formation of palladium hydrides under H2 gas flow contributes to an increase in the turnover frequency by a factor of up to 300 compared to Ni on silica-alumina. While a near-quantitative toluene yield is obtained, some of the phenolic products remain adsorbed on the catalyst.
- Open Access
- 31 July 2023
- Published by Springer Nature in Nature Communications
- Vol. 14 (1) , 1-11
Ionomer-free and recyclable porous-transport electrode for high-performing proton-exchange-membrane water electrolysis
Clean hydrogen production requires large-scale deployment of water-electrolysis technologies, particularly proton-exchange-membrane water electrolyzers (PEMWEs). However, as iridium-based electrocatalysts remain the only practical option for PEMWEs, their low abundance will become a bottleneck for a sustainable hydrogen economy. Herein, we propose high-performing and durable ionomer-free porous transport electrodes (PTEs) with facile recycling features enabling Ir thrifting and reclamation. The ionomer-free porous transport electrodes offer a practical pathway to investigate the role of ionomer in the catalyst layer and, from microelectrode measurements, point to an ionomer poisoning effect for the oxygen evolution reaction. The ionomer-free porous transport electrodes demonstrate a voltage reduction of > 600 mV compared to conventional ionomer-coated porous transport electrodes at 1.8 A cm−2 and Ir cm−2, and a voltage degradation of 29 mV at average rate of 0.58 mV per 1000-cycles after 50k cycles of accelerated-stress tests at 4 A cm−2. Moreover, the ionomer-free feature enables facile recycling of multiple components of PEMWEs, which is critical to a circular clean hydrogen economy.
- 31 July 2023
- Published by Springer Nature in Nature Communications
- Vol. 14 (1) , 1-11
Open AccessIonomer-free and recyclable porous-transport electrode for high-performing proton-exchange-membrane water electrolysis
Clean hydrogen production requires large-scale deployment of water-electrolysis technologies, particularly proton-exchange-membrane water electrolyzers (PEMWEs). However, as iridium-based electrocatalysts remain the only practical option for PEMWEs, their low abundance will become a bottleneck for a sustainable hydrogen economy. Herein, we propose high-performing and durable ionomer-free porous transport electrodes (PTEs) with facile recycling features enabling Ir thrifting and reclamation. The ionomer-free porous transport electrodes offer a practical pathway to investigate the role of ionomer in the catalyst layer and, from microelectrode measurements, point to an ionomer poisoning effect for the oxygen evolution reaction. The ionomer-free porous transport electrodes demonstrate a voltage reduction of > 600 mV compared to conventional ionomer-coated porous transport electrodes at 1.8 A cm−2 and Ir cm−2, and a voltage degradation of 29 mV at average rate of 0.58 mV per 1000-cycles after 50k cycles of accelerated-stress tests at 4 A cm−2. Moreover, the ionomer-free feature enables facile recycling of multiple components of PEMWEs, which is critical to a circular clean hydrogen economy.
- Top Cited PapersOpen Access
- 16 March 2023
- Published by Elsevier in Journal of Power Sources
- Vol. 567
Design and operating principles for high-performing anion exchange membrane water electrolyzers
- 16 March 2023
- Published by Elsevier in Journal of Power Sources
- Vol. 567
Top Cited PapersOpen AccessDesign and operating principles for high-performing anion exchange membrane water electrolyzers
- Open Access
- 23 January 2023
- Published by Royal Society of Chemistry (RSC) in RSC Sustainability
- Vol. 1 (2) , 346-356
Mechanocatalytic hydrogenolysis of benzyl phenyl ether over supported nickel catalysts
Mechanocatalytic hydrogenolysis of benzyl phenyl ether, a model lignin ether, is performed under solvent-free conditions in a ball mill.
- 23 January 2023
- Published by Royal Society of Chemistry (RSC) in RSC Sustainability
- Vol. 1 (2) , 346-356
Open AccessMechanocatalytic hydrogenolysis of benzyl phenyl ether over supported nickel catalysts
Mechanocatalytic hydrogenolysis of benzyl phenyl ether, a model lignin ether, is performed under solvent-free conditions in a ball mill.
- 8 December 2022
- Published by Royal Society of Chemistry (RSC) in Faraday Discussions
- Vol. 243, 65-76
Structural evolution of TiN catalysts during mechanocatalytic ammonia synthesis
During milling in N2and H2, Ti metal is converted into TiN. Once formed, TiN acts as a mechanocatalyst for ammonia formation. The evolution of the structure and reactivity of the TiN catalyst with milling time are discussed.
- 8 December 2022
- Published by Royal Society of Chemistry (RSC) in Faraday Discussions
- Vol. 243, 65-76
Structural evolution of TiN catalysts during mechanocatalytic ammonia synthesis
During milling in N2and H2, Ti metal is converted into TiN. Once formed, TiN acts as a mechanocatalyst for ammonia formation. The evolution of the structure and reactivity of the TiN catalyst with milling time are discussed.
- 15 June 2020
- Published by Wiley in ChemSusChem
- Vol. 13 (17) , 4624-4632
Similarities in Recalcitrant Structures of Industrial Non‐Kraft and Kraft Lignin
This work compares the structure of industrially isolated lignin samples from kraft pulping and three alternative processes: butanol organosolv, supercritical water hydrolysis, and sulfur dioxide/ethanol/water fractionation. Kraft processes are known to produce highly condensed lignin, with reduced potential for catalytic depolymerization, whereas the alternative processes have been hypothesized to impact the lignin less. The structural properties most relevant to catalytic depolymerization are characterized by elemental analysis, quantitative 13C and 2 D HQSC NMR spectroscopy, gel permeation chromatography, and thermogravimetric analysis. Quantification of the β‐O‐4 ether bond content shows partial depolymerization, with all samples having less than 12 bonds per 100 aromatic units. This results in theoretical monomer yields of less than 5 %, strongly suggesting the alternative fractionation processes generate highly condensed lignin structures that are no more suitable for catalytic depolymerization than kraft lignin. However, the different thermal degradation profiles suggest there are physicochemical differences that could be leveraged in other valorization strategies.
- 15 June 2020
- Published by Wiley in ChemSusChem
- Vol. 13 (17) , 4624-4632
Similarities in Recalcitrant Structures of Industrial Non‐Kraft and Kraft Lignin
This work compares the structure of industrially isolated lignin samples from kraft pulping and three alternative processes: butanol organosolv, supercritical water hydrolysis, and sulfur dioxide/ethanol/water fractionation. Kraft processes are known to produce highly condensed lignin, with reduced potential for catalytic depolymerization, whereas the alternative processes have been hypothesized to impact the lignin less. The structural properties most relevant to catalytic depolymerization are characterized by elemental analysis, quantitative 13C and 2 D HQSC NMR spectroscopy, gel permeation chromatography, and thermogravimetric analysis. Quantification of the β‐O‐4 ether bond content shows partial depolymerization, with all samples having less than 12 bonds per 100 aromatic units. This results in theoretical monomer yields of less than 5 %, strongly suggesting the alternative fractionation processes generate highly condensed lignin structures that are no more suitable for catalytic depolymerization than kraft lignin. However, the different thermal degradation profiles suggest there are physicochemical differences that could be leveraged in other valorization strategies.