BSBagdat Satybaldiyev

Bagdat Satybaldiyev

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Bagdat Satybaldiyev has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Environmental Impact of Wastewater on Surface and Groundwater in Central Asia

    by Marzhan S. Kalmakhanova, Assel A. Kurtebayeva, Zhanna T. Tleuova, Bagdat Satybaldiev, Seitzhan A. Orynbayev, Arindam Malakar, Helder T. Gomes, Daniel D. Snow

    This review aims to increase attention on present water quality issues on Central Asia, finding gaps in the literature on ways to address treatment needs, and help ensure future use of Central Asia surface waters and groundwater for all beneficial uses. Central Asia is a landlocked region known for its harsh climatic conditions and scarce water resources, despite being home to some of the world’s largest internal drainage basins. The available literature suggests that increasing salinity has rendered water unsuitable for irrigation and consumption; hazardous trace elements are found throughout Central Asia, most often associated with mining and industrial sources; and that legacy pesticides influence water quality, particularly in agriculturally influenced basins. This study also focuses on the effects of municipal and industrial wastewater discharge. Additionally, the impact of inadequately treated wastewater on water resources is analyzed through a review of available data and reports regarding surface and groundwater quantity and quality. Given the challenges of water scarcity and accessibility, the reuse of treated wastewater is becoming increasingly important, offering a valuable alternative that necessitates careful oversight to ensure public health, environmental sustainability, and water security. However, due to insufficient financial and technical resources, along with underdeveloped regulatory frameworks, many urban areas lack adequate wastewater treatment facilities, significantly constraining their safe and sustainable reuse. Proper management of wastewater effluent is critical, as it directly influences the quality of both surface and groundwater, which serve as key sources for drinking water and irrigation. Due to their persistent and biologically active nature even at trace levels, we discuss contaminants of emerging concern such as antibiotics, pharmaceuticals, and modern agrochemicals. This review thus highlights gaps in the literature reporting on impacts of wastewater inputs to water quality in Central Asia. It is recommended that future research and efforts should focus on exploring sustainable solutions for water quality management and pollution control to assure environmental sustainability and public health.


  • Open Access

    Calcite–aragonite transformation in an eggshell: a crucial role of organics and assessment of the impact of milling conditions on its extent using Taguchi design

    by Kairat Kenges, Stephanos Karafiludis, Róbert Džunda, Imelda Octa Tampubolon, Bagdat Satybaldiyev, Franziska Emmerling, Matej Baláž

    Phase transformations during high-energy ball milling, a tool of mechanochemistry, are interesting due to the possible production of metastable phases without the need for artificially introducing high temperatures and pressures. In our work, the transformation of calcite to aragonite in an eggshell is studied in detail. The presence of organic material, in either the naturally present eggshell membrane, or artificially supplied L-cysteine, was found to be crucial for the phase transformation to occur, its decomposition leading to a pressure increase necessary for aragonite formation. The presence of sulfur in the organics seems to be crucial, as corroborated by much lower phase transformation extent when utilizing sulfur-free organics for comparison. The degree of the transformation in an eggshell was strongly dependent on the used milling conditions. The optimization was assessed using the Taguchi method, namely using a 44 orthogonal array. The optimized parameters encompassed milling time, sample mass, milling speed and duration of breaks and it was shown that sample mass has a decisive effect on the amount of obtained aragonite. Under the most efficient conditions, 73.7% of aragonite was obtained. Prolonging milling until 4 hours further boosts the transformation, reaching 89.9% of aragonite, but further milling leads to the collapse of the aragonite structure and pure calcite was observed after 5 hours.


  • Open Access

    Human Health Risk Assessment of the Photocatalytic Oxidation of BTEX over TiO2/Volcanic Glass

    by Madi Smaiyl, Yerzhigit Tulebekov, Nurbek Nurpeisov, Bagdat Satybaldiyev, Daniel D. Snow, Bolat Uralbekov

    This study demonstrates rapid photocatalytic oxidation of a benzene, toluene, ethylbenzene, and xylene (BTEX) mixture over TiO2/volcanic glass. The assessment of the photocatalytic oxidation of BTEX was conducted under conditions simulating those found in indoor environments affected by aromatic hydrocarbon release. We show, under UV-A intensities of 15 mW/cm2 and an air flow rate of 55 m3/h, that low ppmv levels of BTEX concentrations can be reduced to below detectable levels. Solid-phase microextraction technique was employed to monitor the levels of BTEX in the test chamber throughout the photocatalytic oxidation, lasting approximately 21 h. Destruction of BTEX from the gas phase was observed in the following sequence: o-xylene, ethylbenzene, toluene, and benzene. This study identified sequential degradation of BTEX, in combination with the stringent regulatory level set for benzene, resulted in the air quality hazard indexes (Total Hazard Index and Hazard Quotient) remaining relatively high during the process of photocatalytic oxidation. In the practical application of photocatalytic purification, it is crucial to account for the slower oxidation kinetics of benzene. This is of particular importance due to not only its extremely low exposure limits, but also due to the classification of benzene as a Group 1 carcinogenic compound by the International Agency for Research on Cancer (IARC). Our study underscores the importance of taking regulatory considerations into account when using photocatalytic purification technology.


  • Open Access

    Reaction Steps in Heterogeneous Photocatalytic Oxidation of Toluene in Gas Phase—A Review

    by Yerzhigit Tulebekov, Zhandos Orazov, Bagdat Satybaldiyev, Daniel D. Snow, Raphaël Schneider, Bolat Uralbekov

    A review of the current literature shows there is no clear consensus regarding the reaction mechanisms of air-borne aromatic compounds such as toluene by photocatalytic oxidation. Potential oxidation reactions over TiO2 or TiO2-based catalysts under ultraviolet and visible (UV/VIS) illumination are most commonly considered for removal of these pollutants. Along the pathways from a model pollutant, toluene, to final mineralization products (CO2 and H2O), the formation of several intermediates via specific reactions include parallel oxidation reactions and formation of less-reactive intermediates on the TiO2 surface. The latter may occupy active adsorption sites and causes drastic catalyst deactivation in some cases. Major hazardous gas-phase intermediates are benzene and formaldehyde, classified by the International Agency for Research on Cancer (IARC) as Group 1 carcinogenic compounds. Adsorbed intermediates leading to catalyst deactivation are benzaldehyde, benzoic acid, and cresols. The three most typical pathways of toluene photocatalytic oxidation are reviewed: methyl group oxidation, aromatic ring oxidation, and aromatic ring opening.