Amin Seyedzadeh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Amin Seyedzadeh has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Eisa Maroufpoor
Department of Water Engineering, Faculty of Agriculture, University of Kurdistan, Sanandaj, Iran.
8 shared publications Amir Panahi
Department of Irrigation and Reclamation Engineering University of Tehran Tehran Iran
5 shared publications- Amir Panahi
Department of Irrigation and Reclamation Engineering, University of Tehran, Tehran, Iran
3 shared publications Eisa Maroufpoor
Associate Professor, Dept. of Water Engineering, Faculty of Agriculture, Univ. of Kurdistan, Sanandaj 66177-15175, Iran
2 shared publicationsAbdolmajid Liaghat
Professor, Dept. of Irrigation and Reclamation Engineering, Univ. of Tehran, Tehran, Karaj 31587–77871, Iran
1 shared publicationAdel Siosemardeh
Department of Agronomy, Faculty of Agriculture, University of Kurdistan, Sanandaj, Iran
1 shared publication
Latest Publications
- 27 July 2023
- Published by Elsevier in Flow Measurement and Instrumentation
- Vol. 93
Hydraulic characteristics of a sluice gate over a broad-crested weir
- 27 July 2023
- Published by Elsevier in Flow Measurement and Instrumentation
- Vol. 93
Hydraulic characteristics of a sluice gate over a broad-crested weir
- Open Access
- 15 November 2022
- Published by MDPI AG in Sustainability
- Vol. 14 (22) , 15145
Approximation of the Discharge Coefficient of Radial Gates Using Metaheuristic Regression Approaches
Radial gates are widely used for agricultural water management, flood controlling, etc. The existence of methods for the calculation of the discharge coefficient (Cd) of such gates are complex and they are based on some assumptions. The development of new usable and simple models is needed for the prediction of Cd. This study investigates the viability of a metaheuristic regression method, the Gaussian Process (GP), for the determination of the discharge coefficient of radial gates. For this purpose, a total of 2536 experimental data were compiled that cover a wide range of all the effective parameters. The results of GP were compared with the Group Method of Data Handling (GMDH), Multivariate Adaptive Regression Splines (MARS), and linear and nonlinear regression models for predicting Cd of radial gates in both free-flow and submerged-flow conditions. The results revealed that the radial basis function-based GP model performed the best in free-flow condition with a Correlation Coefficient (CC) of 0.9413 and Root Mean Square Error (RMSE) of 0.0190 while the best accuracy was obtained from the Pearson VII kernel function-based GP model for the submerged flow condition with a CC of 0.9961 and RMSE of 0.0132.
- 15 November 2022
- Published by MDPI AG in Sustainability
- Vol. 14 (22) , 15145
Open AccessApproximation of the Discharge Coefficient of Radial Gates Using Metaheuristic Regression Approaches
Radial gates are widely used for agricultural water management, flood controlling, etc. The existence of methods for the calculation of the discharge coefficient (Cd) of such gates are complex and they are based on some assumptions. The development of new usable and simple models is needed for the prediction of Cd. This study investigates the viability of a metaheuristic regression method, the Gaussian Process (GP), for the determination of the discharge coefficient of radial gates. For this purpose, a total of 2536 experimental data were compiled that cover a wide range of all the effective parameters. The results of GP were compared with the Group Method of Data Handling (GMDH), Multivariate Adaptive Regression Splines (MARS), and linear and nonlinear regression models for predicting Cd of radial gates in both free-flow and submerged-flow conditions. The results revealed that the radial basis function-based GP model performed the best in free-flow condition with a Correlation Coefficient (CC) of 0.9413 and Root Mean Square Error (RMSE) of 0.0190 while the best accuracy was obtained from the Pearson VII kernel function-based GP model for the submerged flow condition with a CC of 0.9961 and RMSE of 0.0132.
- 26 January 2022
- Published by Wiley in Irrigation and Drainage
- Vol. 71 (3) , 687-696
Subsurface shape factor for surface irrigation hydraulics
An improved analytic solution is presented to estimate soil water infiltration by surface irrigation methods through a more rigorous determination of the subsurface shape factor, as applied in volume‐balance models. Based on the results of this analysis and by averaging the shape factor of previously published equations, a new relationship is presented, with a maximum error of 0.036%. Also, the effect of these relationships on the empirical parameters for the Kostiakov–Lewis equation and the water infiltration depth were evaluated. Based on this evaluation, the relative error difference of the infiltration depth of the actual subsurface shape factor value and the new relationship was less than 0.01%. Given the high accuracy of the proposed methodology and the simplicity of its form, this relationship is recommended for use in practical work to predict surface irrigation hydraulic performance and irrigation application efficiency.
- 26 January 2022
- Published by Wiley in Irrigation and Drainage
- Vol. 71 (3) , 687-696
Subsurface shape factor for surface irrigation hydraulics
An improved analytic solution is presented to estimate soil water infiltration by surface irrigation methods through a more rigorous determination of the subsurface shape factor, as applied in volume‐balance models. Based on the results of this analysis and by averaging the shape factor of previously published equations, a new relationship is presented, with a maximum error of 0.036%. Also, the effect of these relationships on the empirical parameters for the Kostiakov–Lewis equation and the water infiltration depth were evaluated. Based on this evaluation, the relative error difference of the infiltration depth of the actual subsurface shape factor value and the new relationship was less than 0.01%. Given the high accuracy of the proposed methodology and the simplicity of its form, this relationship is recommended for use in practical work to predict surface irrigation hydraulic performance and irrigation application efficiency.
- 19 January 2022
- Published by Wiley in Irrigation and Drainage
- Vol. 71 (3) , 676-686
Estimating Infiltration in Open‐ended Furrow Irrigation by Modifying Final Infiltration Rate
The Kostiakov–Lewis equation is one of the commonly used infiltration equations in furrow irrigation. Elliott and Walker developed a two‐point method to estimate coefficients of the Kostiakov–Lewis equation. The basic infiltration rate (fo) in the Kostiakov–Lewis equation is usually calculated by the inflow–outflow method to determine the other two Kostiakov–Lewis parameters. In that method the entire furrow is used as an infiltrometer, which can cause overestimation of fo. In this study, by considering a correction factor in the mathematical calculations where the newly calculated value of fo is represented as fo* and the values of the a and k parameters, as calculated during the advance phase, are represented as a* and k*. The amount of infiltration volume estimated by the proposed method was evaluated using 21 open‐ended furrow irrigation data sets by calculating the relative error (RE) index. The value of fo decreased and the values of a and k increased by using the proposed method as compared to the Elliott and Walker method. Therefore, the results showed that the proposed method estimated infiltration volume with greater accuracy (average absolute RE = 4.0%) as compared to the Elliott and Walker method (average absolute RE = 7.8%).
- 19 January 2022
- Published by Wiley in Irrigation and Drainage
- Vol. 71 (3) , 676-686
Estimating Infiltration in Open‐ended Furrow Irrigation by Modifying Final Infiltration Rate
The Kostiakov–Lewis equation is one of the commonly used infiltration equations in furrow irrigation. Elliott and Walker developed a two‐point method to estimate coefficients of the Kostiakov–Lewis equation. The basic infiltration rate (fo) in the Kostiakov–Lewis equation is usually calculated by the inflow–outflow method to determine the other two Kostiakov–Lewis parameters. In that method the entire furrow is used as an infiltrometer, which can cause overestimation of fo. In this study, by considering a correction factor in the mathematical calculations where the newly calculated value of fo is represented as fo* and the values of the a and k parameters, as calculated during the advance phase, are represented as a* and k*. The amount of infiltration volume estimated by the proposed method was evaluated using 21 open‐ended furrow irrigation data sets by calculating the relative error (RE) index. The value of fo decreased and the values of a and k increased by using the proposed method as compared to the Elliott and Walker method. Therefore, the results showed that the proposed method estimated infiltration volume with greater accuracy (average absolute RE = 4.0%) as compared to the Elliott and Walker method (average absolute RE = 7.8%).
- 1 July 2021
- Published by American Society of Civil Engineers (ASCE) in Journal of Irrigation and Drainage Engineering
- Vol. 147 (7) , 06021004
Analytical Head Loss Equation of Center-Pivot Irrigation System
Enhancing water use efficiency is essential in irrigated agriculture owing to declining water resources, increasing population, growing water needs, and greater competition among water users. If properly designed and managed, with good operation and maintenance, a center-pivot irrigation system can have high water-application efficiency. One of the design factors for a center-pivot irrigation system is the hydraulic loss in the lateral pipe. In this study, an analytical relationship is presented as a series for calculating the hydraulic loss in the lateral pipe of a center-pivot irrigation system. Given the difficulty and complexity of using a mathematical series, the equation presented in this study and the equation developed by Anwar turn out to be general and asymptotic relations. The final relationships have 0.6% and 0.4% errors, respectively, relative to the series relationships. Due to the high accuracy and ease of use of the asymptotic relationship presented to calculate the hydraulic loss in the lateral pipe, it is recommended for use in designing center-pivot irrigation systems.
- 1 July 2021
- Published by American Society of Civil Engineers (ASCE) in Journal of Irrigation and Drainage Engineering
- Vol. 147 (7) , 06021004
Analytical Head Loss Equation of Center-Pivot Irrigation System
Enhancing water use efficiency is essential in irrigated agriculture owing to declining water resources, increasing population, growing water needs, and greater competition among water users. If properly designed and managed, with good operation and maintenance, a center-pivot irrigation system can have high water-application efficiency. One of the design factors for a center-pivot irrigation system is the hydraulic loss in the lateral pipe. In this study, an analytical relationship is presented as a series for calculating the hydraulic loss in the lateral pipe of a center-pivot irrigation system. Given the difficulty and complexity of using a mathematical series, the equation presented in this study and the equation developed by Anwar turn out to be general and asymptotic relations. The final relationships have 0.6% and 0.4% errors, respectively, relative to the series relationships. Due to the high accuracy and ease of use of the asymptotic relationship presented to calculate the hydraulic loss in the lateral pipe, it is recommended for use in designing center-pivot irrigation systems.
- 9 June 2021
- Published by Wiley in Irrigation and Drainage
- Vol. 70 (5) , 1095-1106
Investigating the midpoint of a two‐point method for predicting advance and infiltration in surface irrigation*
- 9 June 2021
- Published by Wiley in Irrigation and Drainage
- Vol. 70 (5) , 1095-1106
Investigating the midpoint of a two‐point method for predicting advance and infiltration in surface irrigation*
- 4 May 2021
- Published by Springer Nature in Environment, Development and Sustainability
- Vol. 24 (1) , 558-575
Numerical and artificial intelligence models for predicting the water advance in border irrigation
- 4 May 2021
- Published by Springer Nature in Environment, Development and Sustainability
- Vol. 24 (1) , 558-575
Numerical and artificial intelligence models for predicting the water advance in border irrigation
- 1 March 2021
- Published by Taylor & Francis in Ish Journal of Hydraulic Engineering
- Vol. 28 (3) , 303-312
Irrigation management evaluation of multiple irrigation methods using performance indicators
Six plots include three plots of solid-set sprinkler and three plots of border irrigation methods in Kangavar plain (Iran), were evaluated under farmers’ management standards. Wheat was grown in each of the plots and all the irrigation events were evaluated. The average values of irrigation indexes, distribution uniformity, potential application efficiency of the low quarter, application efficiency of the low quarter, application efficiency, deep percolation ratio, adequacy of irrigation, and water requirement efficiency in border-irrigated plots were 80.4%, 80.4%, 69.1%, 80.5%, 19.5%, 53.1%, and 80.8%, respectively. Those values indicated much better performance than the average values for the movable solid-set sprinkler-irrigated plots, which were 55.8%, 44.7%, 37.2%, 41.5%, 38.6%, 85.0% and 96.5%, respectively. So the system design and the farmers’ management are suitable with border irrigation in accordance with the experiences they have gained with time. That was not the case for the movable sprinkler irrigation system, in which the performance indexes are below the recommended minimum values. Therefore, the efficiency of an irrigation system is not independent of its management, and the farmer’s skill on the irrigation system is one of the most important indices for selecting a suitable irrigation system. Also, improving farmer’s management is the most appropriate way for improving irrigation performance.
- 1 March 2021
- Published by Taylor & Francis in Ish Journal of Hydraulic Engineering
- Vol. 28 (3) , 303-312
Irrigation management evaluation of multiple irrigation methods using performance indicators
Six plots include three plots of solid-set sprinkler and three plots of border irrigation methods in Kangavar plain (Iran), were evaluated under farmers’ management standards. Wheat was grown in each of the plots and all the irrigation events were evaluated. The average values of irrigation indexes, distribution uniformity, potential application efficiency of the low quarter, application efficiency of the low quarter, application efficiency, deep percolation ratio, adequacy of irrigation, and water requirement efficiency in border-irrigated plots were 80.4%, 80.4%, 69.1%, 80.5%, 19.5%, 53.1%, and 80.8%, respectively. Those values indicated much better performance than the average values for the movable solid-set sprinkler-irrigated plots, which were 55.8%, 44.7%, 37.2%, 41.5%, 38.6%, 85.0% and 96.5%, respectively. So the system design and the farmers’ management are suitable with border irrigation in accordance with the experiences they have gained with time. That was not the case for the movable sprinkler irrigation system, in which the performance indexes are below the recommended minimum values. Therefore, the efficiency of an irrigation system is not independent of its management, and the farmer’s skill on the irrigation system is one of the most important indices for selecting a suitable irrigation system. Also, improving farmer’s management is the most appropriate way for improving irrigation performance.
- 12 September 2020
- Published by Springer Nature in Irrigation Science
- Vol. 39 (2) , 293-297
Correction to: A new analytical method for derivation of infiltration parameters
- 12 September 2020
- Published by Springer Nature in Irrigation Science
- Vol. 39 (2) , 293-297
Correction to: A new analytical method for derivation of infiltration parameters
- 4 July 2020
- Published by Springer Nature in Irrigation Science
- Vol. 38 (4) , 449-460
A new analytical method for derivation of infiltration parameters
- 4 July 2020
- Published by Springer Nature in Irrigation Science
- Vol. 38 (4) , 449-460
A new analytical method for derivation of infiltration parameters