Damian Connolly
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Damian Connolly has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Brett Paull
Australian Centre for Research on Separation Science (ACROSS), School of Natural Sciences, University of Tasmania, Hobart 7001, Australia
2 shared publications - Andrew Quigley
National Institute for Bioprocessing Research and Training
1 shared publication Eoin Gillespie
Centre for BioAnalytical Sciences, Dublin City University, Glasnevin, Dublin 9, Ireland
1 shared publication- Hassan Alwael
Irish Separation Science Cluster, National Centre for Sensor Research, Dublin City University, Dublin 9, Ireland
1 shared publication - Pavel N. Nesterenko
Department of Chemistry, Moscow State University, Moscow, Russia
1 shared publication Wayne Cummins
Pharmaceutical and Molecular Biotechnology Research Centre, Department of Science, Waterford Institute of Technology, Waterford, Ireland
1 shared publication
Latest Publications
- Open Access
- 31 October 2016
- Published by Wiley in Journal of Chemistry
- Vol. 2016, 1-12
Dispersive Liquid-Liquid Microextraction in the Analysis of Milk and Dairy Products: A Review
Dispersive liquid-liquid microextraction (DLLME) is an extraction technique developed within the last decade, which involves the dispersion of fine droplets of extraction solvent in an aqueous sample. Partitioning of analytes into the extraction phase is instantaneous due to the very high collective surface area of the droplets. This leads to very high enrichment factors and very low solvent consumption, relative to other liquid or solid phase extraction methods. A comprehensive review of the various modes of DLLME in the analysis of organic and inorganic analytes in dairy products (milk, cheese, infant formula, yogurt, and breast milk) is presented here. Dairy products present a complex sample matrix and the removal of interfering matrix components can prove troublesome. This review focuses on sample pretreatment prior to the appropriate DLLME procedure, the extraction and dispersive solvents chosen, derivatisation methods, and analytical figures of merit. Where possible, a critical comparison of DLLME methods has been undertaken. The overall suitability, and limitations, of DLLME as a sample preparation technique for dairy products has been assessed.
- 31 October 2016
- Published by Wiley in Journal of Chemistry
- Vol. 2016, 1-12
Open AccessDispersive Liquid-Liquid Microextraction in the Analysis of Milk and Dairy Products: A Review
Dispersive liquid-liquid microextraction (DLLME) is an extraction technique developed within the last decade, which involves the dispersion of fine droplets of extraction solvent in an aqueous sample. Partitioning of analytes into the extraction phase is instantaneous due to the very high collective surface area of the droplets. This leads to very high enrichment factors and very low solvent consumption, relative to other liquid or solid phase extraction methods. A comprehensive review of the various modes of DLLME in the analysis of organic and inorganic analytes in dairy products (milk, cheese, infant formula, yogurt, and breast milk) is presented here. Dairy products present a complex sample matrix and the removal of interfering matrix components can prove troublesome. This review focuses on sample pretreatment prior to the appropriate DLLME procedure, the extraction and dispersive solvents chosen, derivatisation methods, and analytical figures of merit. Where possible, a critical comparison of DLLME methods has been undertaken. The overall suitability, and limitations, of DLLME as a sample preparation technique for dairy products has been assessed.
- 6 July 2012
- Published by Royal Society of Chemistry (RSC) in Analytical Methods
- Vol. 4 (9) , 2668-2673
Rapid and sensitive chromatographic determination of free sialic acid in complex bio-pharma fermentation media samples
This paper describes a rapid, sensitive and reproducible liquid chromatographic method specifically for the quantitative determination of total free sialic acid, employing thiobarbituric acid as pre-column tagging agent, following the oxidation of sialic acid with periodic acid. The derivatised sialic acid was separated from 2-deoxy-D-ribose and the other components utilising a short C18 monolithic column, with total run-times of under 90 s per sample. The method was successfully applied to quantify sialic acid in a range of complex samples, e.g. yeastolate powders, basal media and in-process samples supplied from the biopharmaceutical industry. The selective method was highly reproducible (%RSD for method (n = 6) = n = 6) = 1.3, for retention time (n = 6) = 0.6), linear (R2 = 0.9994, range 0.25–25 μmol L−1) and sensitive (LOD = 842 fmol based upon a 100 μL inj. vol.).
- 6 July 2012
- Published by Royal Society of Chemistry (RSC) in Analytical Methods
- Vol. 4 (9) , 2668-2673
Rapid and sensitive chromatographic determination of free sialic acid in complex bio-pharma fermentation media samples
This paper describes a rapid, sensitive and reproducible liquid chromatographic method specifically for the quantitative determination of total free sialic acid, employing thiobarbituric acid as pre-column tagging agent, following the oxidation of sialic acid with periodic acid. The derivatised sialic acid was separated from 2-deoxy-D-ribose and the other components utilising a short C18 monolithic column, with total run-times of under 90 s per sample. The method was successfully applied to quantify sialic acid in a range of complex samples, e.g. yeastolate powders, basal media and in-process samples supplied from the biopharmaceutical industry. The selective method was highly reproducible (%RSD for method (n = 6) = n = 6) = 1.3, for retention time (n = 6) = 0.6), linear (R2 = 0.9994, range 0.25–25 μmol L−1) and sensitive (LOD = 842 fmol based upon a 100 μL inj. vol.).
- Open Access
- 3 April 2008
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 133 (7) , 874-876
Accurate non-invasive determination of pKa of surface functionalised ion exchange monoliths using capacitively coupled contactless conductivity detection
The use of on-column capacitively coupled contactless conductivity detection for the accurate non-invasive visualisation of the pH dependence of covalently bound boronic acid groups within a monolithic polymeric capillary column is demonstrated.
- 3 April 2008
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 133 (7) , 874-876
Open AccessAccurate non-invasive determination of pKa of surface functionalised ion exchange monoliths using capacitively coupled contactless conductivity detection
The use of on-column capacitively coupled contactless conductivity detection for the accurate non-invasive visualisation of the pH dependence of covalently bound boronic acid groups within a monolithic polymeric capillary column is demonstrated.