SZSeyed Alireza Zekavat

Seyed Alireza Zekavat

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Seyed Alireza Zekavat has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Novel low‐latency, high‐resolution and low‐cost time synchronisation

    by Ali Aghdaei, Seyed A. (Reza) Zekavat

    This study presents an oversampling‐based low‐latency, high‐resolution and low‐cost timing synchronisation technique for digital receivers. Traditional timing synchronisation employs matched filter to estimate the signal coarse time of arrival. Here, latency increases through oversampling and resolution improves via higher bandwidth. The proposed method uses single bit quantisation to employ XNOR blocks instead of multiplier and accumulator blocks in the traditional method. This substantially decreases complexity incorporating less field‐programmable gate array (FPGA) surface area.


  • Accelerometer-Based Combustion Metrics Reconstruction With Radial Basis Function Neural Network for a 9 L Diesel Engine

    by Libin Jia, Jeffrey Naber, Jason Blough, Seyed Alireza Zekavat

    Accelerometer-based combustion sensing in diesel engines has the potential of providing feedback for combustion control to reduce fuel consumption and engine emissions at a lower cost than in-cylinder pressure sensors. In this work, triaxial block-mounted accelerometers were used to measure the engine vibration, and pressure transducers were installed to measure the in-cylinder pressure. The in-cylinder pressure can be further utilized to compute combustion metrics, including the apparent heat release rate (AHR). Engine tests were conducted for various speeds, torques, and start of injections, on a 9 L in-line six-cylinder diesel engine equipped with a common rail high pressure injection system. The relationship between engine block acceleration and AHR was modeled using a radial basis function neural network (RBFNN). By inputting the accelerometer signal to the fixed network, AHR and other combustion metrics were estimated. As the primary concern for radial basis network training is the hidden layer weight vector selection, two algorithms for weight vector selection (modified Gram–Schmidt orthogonalization and principal component analysis) were evaluated by examining the robustness of the resulting network. One-third of the conducted tests were utilized to train the network. The network was then applied to estimate the AHR for the remaining validation tests which were not used to train the network. Comparisons were made based on the combustion metrics estimation results and the selection efficiency among the two weight vector selection methods and the random selection method. Moreover, the capability concerning the network's tolerance for additive noise was also investigated. Results confirmed that the modified Gram–Schmidt method achieved much more accurately estimated combustion metrics with the highest efficiency. On the basis of this study, a real-time closed-loop control strategy was proposed with the feedback provided based on the application of the trained RBFNN.


  • A Weighted Measurement Fusion Kalman Filter implementation for UAV navigation

    by Shu Ting Goh, Ossama Abdelkhalik, Seyed A. (Reza) Zekavat


  • A New Multi-Antenna Based LOS - NLOS Separation Technique

    by Zhonghai Wang, Wenjie Xu, Seyed A. Zekavat

    This paper introduces a line-of-sight (LOS) and non-LOS (NLOS) separation technique based on the statistics of the phase difference of two received signals. The phase difference is achieved via a co-installed synchronized two-receiver system. The variance of the phase difference is used to separate LOS and NLOS. The probability-density-function (PDF) of the received signal phase generated by NLOS component is theoretically derived. The variance of the phase difference is calculated using the derived PDF numerically and verified via simulations. The LOS and NLOS separation performance versus signal power ratio of LOS to NLOS is evaluated via simulations.


  • Spatially Correlated Multi-User Channels: LOS vs. NLOS

    by Wenjie Xu, Seyed A. Zekavat

    A novel approach for modeling multi-user channels is proposed for the first time. This technique enables the investigation of the received signal correlation across the channel of multiple users for both line-of-sight (LOS) and non-LOS (NLOS) scenarios. The scatterers are modeled as random rough surfaces. Such rough surfaces scatter the incident wave into various directions. The signals scattered from the same part of a rough surface have maintained a correlation across users. This paper derives the cross-user correlation based on Kirchhoff theory, and investigates the impact of LOS versus NLOS. It is depicted that LOS signals have drastically boosted the correlation. This property can be incorporated in order to discriminate LOS signals from NLOS. It is found that the proposed study impacts the performance and capacity analysis of wireless ad-hoc/sensor networks.


  • Super-Resolution Direction-of-Arrival Estimation via Blind Signal Separation Methods

    by J. Pourrostam, Seyed A. Zekavat, M. Pourkhaatoun

    In this paper, we present a novel high-resolution DOA estimation method based on second-order blind signal separation (BSS) techniques. In this approach, unlike other high-resolution methods such as MUSIC, finding DOA's doesn't involve searching for peak values in the estimated spectrum. Furthermore, in this algorithm, considering a uniform linear array (ULA), the angular distance between two sources is multiplied by L - 1: L is the number of antenna elements in the array. Therefore, the proposed algorithm exhibits excellent resolution property compared to other techniques. Moreover, BSS techniques enable this approach to carry out source association along with DOA estimation. Here, we introduce the proposed algorithm and define the corresponding probability of resolution (PR). Simulation results demonstrate the superiority of the presented approach in comparison with the existing methods such as MUSIC.


  • Novel Direction-of-Arrival Estimation Techniques for Periodic-Sense Local Positioning Systems

    by J. Pourrostam, Seyed A. Zekavat, Hui Tong

    This paper introduces novel direction-of-arrival (DOA) estimation techniques for periodic sense positioning systems (e.g., pulse radar systems and wireless local positioning systems). Periodic signaling between a tracker (e.g., dynamic base station) and a target (e.g., transceiver) in these systems introduces a nature of cyclostationarity to the received signal at the receiver of the tracker. The cyclostationary nature of the received signal is analyzed theoretically and via simulations in terms of system parameters such as number of targets, average speed of targets, bandwidth, coverage range and HPBW (half power beam width) of the tracker antenna array. Exploiting the introduced cyclostationarity property, novel DOA estimation schemes are proposed to improve DOA estimation performance of the tracker. The performance measure is the DOA estimation mean square error (MSE). Simulations are conducted to study the performance in terms of signal to noise ratio and number of targets. The results confirm the superiority of the proposed approaches.


  • A Novel High Resolution ICA-Based TOA Estimation Technique

    by M. Pourkhaatoun, Seyed A. Zekavat, J. Pourrostam

    In this paper, a novel high resolution time of arrival (TOA) technique is proposed for multipath wireless environments. The technique is based on frequency domain independent component analysis (ICA). The proposed technique has applications in radar, sonar, wireless local positioning system, and, mobile adhoc networks (MANETS). The proposed algorithm is compared to the traditional techniques such as delay lock loop (DLL) and super-resolution multiple signal classification (MUSIC). Simulations are conducted to compare performance measures that include: (1) sensitivity to bandwidth, (2) resolution: Capability of resolving closely spaced reflections in a multi-path environment, (3) sensitivity to number-of-observations, and (4) sensitivity to signal-to-noise ratio (SNR). Simulation results confirm that the proposed algorithm leads to lower sensitivity to SNR, number-of-observations, and, bandwidth. In addition, the technique possesses a high resolution and can be simply implemented via FPGA (field programmable gate array) and DSP (digital signal processor).


  • A Novel Implementation of DOA Estimation for Node Localization on Software Defined Radios: Achieving High Performance with Low Complexity

    by Seyed A Zekavat, Andrew Kolbus, Xiaofeng Yang, Zhonghai Wang, Jafar Pourrostam, Mohsen Pourkhaatoun

    This paper introduces a novel implementation of direction-of-arrival (DOA) estimation for localization of nodes in (mobile) ad-hoc networks. The localization technique is being implemented on a software defined radio (SDR) system. The SDR system needs DOA estimation for: (a) beam-forming and detection, and (b) localization. The detection process needs coarse DOA estimation, while the localization needs a fine one. The technique fuses two known DOA estimation techniques: delay-and-sum and root-MUSIC. The former is a simple technique suitable for on-line (high speed) implementation required for detection. Hence, it would consume less power. The latter is a complex technique that needs higher processing time and consumes more power and would be suitable for off-line DOA estimation. Hence, the fused DOA estimation technique offers high performance with low complexity and power consumption.