JFJakub Flodr

Jakub Flodr

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jakub Flodr has a total of 3 co-authors. Here are the top co-authors by number of shared publications:

  • Martin Krejsa

    Department of Structural Mechanics, Faculty of Civil Engineering, VŠB—Technical University of Ostrava, L. Podéště 1875, 70800 Ostrava, Czech Republic

    2 shared publications
  • Petr Lehner

    Department of Structural Mechanics, Faculty of Civil Engineering, VŠB—Technical University of Ostrava, L. Podéště 1875, 70800 Ostrava, Czech Republic

    2 shared publications
  • Dominik GřEšica

    VSB – Technical University of Ostrava, Faculty of Civil Engineering, Department of Structural Mechanics, Czech Republic

    1 shared publication

Latest Publications

  • Open Access

    Numerical simulation of crack propagation in clinch joints

    by Petr Lehner, Martin Krejsa, Dominik Gřešica, Jakub Flodr

    The mechanical clinching process can be used for the load-bearing structures of thin-walled steel frame halls. Numerical simulation of crack propagation in a clinching joint using finite element method (FEM) software is an important tool for the analysis and prediction of the behavior of materials under load. This study focuses on clinch joints that must withstand high loads and repeated load cycles. Crack propagation in these joints can lead to failure of the entire structure, therefore it is important to understand the mechanisms of crack propagation and predict their behavior. Using specialized software, a numerical simulation of crack propagation was prepared, including modelling of joint geometry, definition of material properties and application of loads. The simulation provides valuable information on the crack propagation process, which allows optimization of the behavior of the whole structure and the reliability of the clinch joints.

  • Open Access

    Experimental and Numerical Evaluation of Clinch Connections of Thin-Walled Building Structures

    by Jakub Flodr, Petr Lehner, Martin Krejsa

    The high energy intensity of industry and the importance of natural resources are currently much-discussed topics. Light steel structures made from thin-walled cold-formed (TWCF) profiles play an important role in this discussion because their increased use has significantly reduced the consumption of conventional structural steel. New, more efficient technologies for connections of the TWCF structures, such as punch riveting and clinching, are being developed, which are advantageous in terms of cost and time. An innovative way to obtain the physical properties of a clinch joint and instructions for a detailed reliability assessment of this type of connection is described in this article. The resulting behaviour of the numerical model based on the tensile test of the basic material and suitable boundary conditions was validated by a physical experiment. The computational procedures presented in the article will facilitate the design of steel structures in the field of global static analysis of TWCF light steel structures because the described methods can be generalised and applied in commonly available commercial software. Two variants of the model were prepared and evaluated—with and without slippage in the press jaws. Comparison of the numerical model and experimental results shows compliance.