Anup Dey
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Anup Dey has a total of 45 co-authors. Here are the top co-authors by number of shared publications:
Subir Kumar Sarkar
Jadavpur University
18 shared publicationsBikram Biswas
Jadavpur Univ, Dept ETCE, Kolkata 700032, W Bengal, India
11 shared publicationsSubhashis Roy
8 shared publications- Subhashis Roy
Jadavpur University
4 shared publications - Subir Kumar Sarkar
Jadavpur University
4 shared publications Komal Kumari
Jadavpur University
3 shared publications
Latest Publications
- 5 May 2026
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 60 (5) , 483-503
Design and Performance Investigation of a Dual p-GaN Recessed Gate High Electron Mobility Transistors for High Threshold Voltage Applications
- 5 May 2026
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 60 (5) , 483-503
Design and Performance Investigation of a Dual p-GaN Recessed Gate High Electron Mobility Transistors for High Threshold Voltage Applications
- Open Access
- 10 December 2024
- Published by Wiley
Device-Circuit Performance Analysis of a High-VT Recessed-p-Gate HEMT Employing Doped-Buried Layer
Nowadays, one of the appealing choice of transistors for the next generation of high power devices is, AlGaN/GaN high-electron-mobility transistor (AlGaN/GaN-HEMT). Prior to now, numerous experiments were conducted utilizing various gate engineering techniques to propose high threshold voltage enhancement-mode HEMT architectures. In this paper, two new e-mode HEMT structures are proposed by taking motivation from our previously reported structure of Recessed p-GaN gate HEMT. By incorporating p-doped buried layer with recessed p-GaN gate in one HEMT structure, the threshold voltage is significantly increased. In first experiment, a p-doped GaN region is buried in to the Gallium Nitride (GaN) substrate of conventional p-GaN gate HEMT. In second experiment, a p-GaN buried layer is inserted in to GaN substrate of recessed p-GaN gate HEMT. V th of above 3V is obtained from the proposed structures, which is suitable to be implemented for high-frequency power switching applications. The proposed structures provides flexibility to tune V th and I d . The digital circuit compatibility is also tested by using both the proposed structures in a resistive-load inverter circuit. The transient analysis confirms that the HEMTs work properly in inverter circuit and the VTC analysis shows 98.5% of output voltage swing at input voltage of 5V. Highest NM H and NM L is measured as 2.85V and 2.65V respectively. The device simulation, calibration and circuit simulation is done in Silvaco TCAD software.
- 10 December 2024
- Published by Wiley
Open AccessDevice-Circuit Performance Analysis of a High-VT Recessed-p-Gate HEMT Employing Doped-Buried Layer
Nowadays, one of the appealing choice of transistors for the next generation of high power devices is, AlGaN/GaN high-electron-mobility transistor (AlGaN/GaN-HEMT). Prior to now, numerous experiments were conducted utilizing various gate engineering techniques to propose high threshold voltage enhancement-mode HEMT architectures. In this paper, two new e-mode HEMT structures are proposed by taking motivation from our previously reported structure of Recessed p-GaN gate HEMT. By incorporating p-doped buried layer with recessed p-GaN gate in one HEMT structure, the threshold voltage is significantly increased. In first experiment, a p-doped GaN region is buried in to the Gallium Nitride (GaN) substrate of conventional p-GaN gate HEMT. In second experiment, a p-GaN buried layer is inserted in to GaN substrate of recessed p-GaN gate HEMT. V th of above 3V is obtained from the proposed structures, which is suitable to be implemented for high-frequency power switching applications. The proposed structures provides flexibility to tune V th and I d . The digital circuit compatibility is also tested by using both the proposed structures in a resistive-load inverter circuit. The transient analysis confirms that the HEMTs work properly in inverter circuit and the VTC analysis shows 98.5% of output voltage swing at input voltage of 5V. Highest NM H and NM L is measured as 2.85V and 2.65V respectively. The device simulation, calibration and circuit simulation is done in Silvaco TCAD software.
- 17 September 2024
- Published by Wiley in International Journal of Numerical Modelling: Electronic Networks, Devices and Fields
- Vol. 37 (5)
Study and optimising performance of enhancement‐mode monolithically integrated white‐light HEMT‐LED by inserting of InGaN quantum wells
In this paper five enhancement‐mode monolithically integrated white‐light High electron mobility transistors‐light emitting diodes (HEMT‐LED) structures are proposed and simulated to obtain maximum light intensity, drain current Id and maximum trans‐conductance gm. In first four HEMT‐LED structures white light is generated by combining inbuilt yellow and blue lights and in fifth proposed structure the white light is generated with the combination of inbuilt red, green and blue lights. The InGaN quantum wells (QWs) are inserted in to e‐mode ITO/p‐GaN gate HEMT structures and the desired wavelength of light spectrums are generated by changing the in content (mole fraction), to obtain inbuilt white light. Among five proposed structures one shows Maximum Id‐max of 925 mA and maximum gm of 250 mS, which is significantly higher than any HEMT‐LED structures reported before. All the proposed structures are simulated in Silvaco TCAD software.
- 17 September 2024
- Published by Wiley in International Journal of Numerical Modelling: Electronic Networks, Devices and Fields
- Vol. 37 (5)
Study and optimising performance of enhancement‐mode monolithically integrated white‐light HEMT‐LED by inserting of InGaN quantum wells
In this paper five enhancement‐mode monolithically integrated white‐light High electron mobility transistors‐light emitting diodes (HEMT‐LED) structures are proposed and simulated to obtain maximum light intensity, drain current Id and maximum trans‐conductance gm. In first four HEMT‐LED structures white light is generated by combining inbuilt yellow and blue lights and in fifth proposed structure the white light is generated with the combination of inbuilt red, green and blue lights. The InGaN quantum wells (QWs) are inserted in to e‐mode ITO/p‐GaN gate HEMT structures and the desired wavelength of light spectrums are generated by changing the in content (mole fraction), to obtain inbuilt white light. Among five proposed structures one shows Maximum Id‐max of 925 mA and maximum gm of 250 mS, which is significantly higher than any HEMT‐LED structures reported before. All the proposed structures are simulated in Silvaco TCAD software.
- Open Access
- 5 April 2024
- Published by Qeios Ltd
Review of: "IoT Noise And Air Quality Observation System"
REVIEW COMMENTS: * Authors must modify the abstract as per the workflow, which is missing. * A numerous amount of work based on IoT Noise and Air Quality Observation Systems has already been proposed and published. What major impact and novelty th...
- 5 April 2024
- Published by Qeios Ltd
Open AccessReview of: "IoT Noise And Air Quality Observation System"
REVIEW COMMENTS: * Authors must modify the abstract as per the workflow, which is missing. * A numerous amount of work based on IoT Noise and Air Quality Observation Systems has already been proposed and published. What major impact and novelty th...
- Open Access
- 23 May 2023
- Published by Qeios Ltd
Review of: "Visualization of Home Security Sensor System Based on IoT Server"
This manuscript carried out using an experimental method with several steps, namely testing the system both from the hardware and software side. In addition to this the author wants to examine how effective the home security system with this IoT-base...
- 23 May 2023
- Published by Qeios Ltd
Open AccessReview of: "Visualization of Home Security Sensor System Based on IoT Server"
This manuscript carried out using an experimental method with several steps, namely testing the system both from the hardware and software side. In addition to this the author wants to examine how effective the home security system with this IoT-base...
- 19 January 2022
- Published by Springer Nature in Silicon
- Vol. 14 (14) , 8919-8925
Polyaniline Based Field Effect Transistor for Humidity Sensor
- 19 January 2022
- Published by Springer Nature in Silicon
- Vol. 14 (14) , 8919-8925
Polyaniline Based Field Effect Transistor for Humidity Sensor
- 19 August 2020
- Published by Springer Nature in Silicon
- Vol. 13 (9) , 3031-3037
Fabrication and Application of TiO2 Based Thin Film Capacitive Biosensor towards Fruit Freshness Detection on Silicon Substrate
- 19 August 2020
- Published by Springer Nature in Silicon
- Vol. 13 (9) , 3031-3037
Fabrication and Application of TiO2 Based Thin Film Capacitive Biosensor towards Fruit Freshness Detection on Silicon Substrate
- 18 July 2020
- Published by Springer Nature
- p. 201-209
Room Temperature Pt-Modified WO3/p–Si Film Gas Sensor for Detection of Methanol
- 18 July 2020
- Published by Springer Nature
- p. 201-209
Room Temperature Pt-Modified WO3/p–Si Film Gas Sensor for Detection of Methanol
- 18 July 2020
- Published by Springer Nature
- p. 269-279
Designing Memristor-Based Timing Circuits and Performance Comparison with CMOS Counterparts
- 18 July 2020
- Published by Springer Nature
- p. 269-279
Designing Memristor-Based Timing Circuits and Performance Comparison with CMOS Counterparts
- 16 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 20 (21) , 12602-12609
Room Temperature ZnO and Au-ZnO Quantum Dots Thin Film Gas Sensor Fabrication for Detecting of Volatile Organic Compound Gases
In the current work, nomal ZnO and Au textured ZnO based quantum dot (QD) thin film sensors have been fabricated and characterized. The uniqueness of the present sensor is its operating temperature of 35°C and can be employed to detect minute fraction of organic compound gases like: methanol, ethanol, propanol, butanol etc with better response and improved repeatability/stability at (little elevated) room temperature. Sol-gel growths along with spin coating methods have been used in the fabrication of the proposed sensor. To improve the response of the sensors annealing treatment at 350°C temperature is imposed. Different material characteristics like, TEM, XRD, AFM, UV spectroscopy, FTIR and electrical characteristics have been reported for better understanding the morphology, molecular compositions and mechanism of the fabricated sensors.
- 16 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 20 (21) , 12602-12609
Room Temperature ZnO and Au-ZnO Quantum Dots Thin Film Gas Sensor Fabrication for Detecting of Volatile Organic Compound Gases
In the current work, nomal ZnO and Au textured ZnO based quantum dot (QD) thin film sensors have been fabricated and characterized. The uniqueness of the present sensor is its operating temperature of 35°C and can be employed to detect minute fraction of organic compound gases like: methanol, ethanol, propanol, butanol etc with better response and improved repeatability/stability at (little elevated) room temperature. Sol-gel growths along with spin coating methods have been used in the fabrication of the proposed sensor. To improve the response of the sensors annealing treatment at 350°C temperature is imposed. Different material characteristics like, TEM, XRD, AFM, UV spectroscopy, FTIR and electrical characteristics have been reported for better understanding the morphology, molecular compositions and mechanism of the fabricated sensors.