Raj Solanki
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Raj Solanki has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Paul Plachinda
Department of Physics, Portland State University, Portland, OR 97207, USA
4 shared publications - David Russell Evans
Department of Physics, Portland State University, Portland, OR 97205, USA
3 shared publications - Allison M. Whited
Department of Ophthalmology and Visual Sciences, Case Western Reserve University, Cleveland, OH 44106, USA
2 shared publications Gary Goncher
2 shared publications- Neal Kuperman
Physics, Portland State University, Portland State University, Department of Physics, Portland, Oregon, 97207-0751, UNITED STATES
2 shared publications - Allison Cairns
Department of Cell Biology, Yale School of Medicine, New Haven, USA
1 shared publication
Latest Publications
- Open Access
- 24 February 2023
- Published by MDPI AG in Applied Nano
- Vol. 4 (1) , 38-44
Thin Film Deposition of MoP, a Topological Semimetal
MoP is a topological semimetal which has drawn attention due to its unique electrical and optical properties resulting from massless electrons. In order to utilize these properties for practical applications, it is necessary to develop a technique to produce high-quality, large-scale thin films of this 2D material. We report below our initial results of growth of MoP thin films using atomic layer deposition (ALD), where the film grows layer-by-layer. These films were grown on 5 cm × 5 cm silicon oxide coated Si wafers. Resistivity versus temperature measurements show that these films are metallic and includes a partial superconducting phase. The magnetoresistances of both the longitudinal and Hall currents measured at 1.8 K show a strong effect of the magnetic field on the resistivity. Density functional theory was employed to determine the lattice constants of the MoP crystal. These parameters were in good agreement with those obtained from the Rietveld fit to the XRD spectrum of the films.
- 24 February 2023
- Published by MDPI AG in Applied Nano
- Vol. 4 (1) , 38-44
Open AccessThin Film Deposition of MoP, a Topological Semimetal
MoP is a topological semimetal which has drawn attention due to its unique electrical and optical properties resulting from massless electrons. In order to utilize these properties for practical applications, it is necessary to develop a technique to produce high-quality, large-scale thin films of this 2D material. We report below our initial results of growth of MoP thin films using atomic layer deposition (ALD), where the film grows layer-by-layer. These films were grown on 5 cm × 5 cm silicon oxide coated Si wafers. Resistivity versus temperature measurements show that these films are metallic and includes a partial superconducting phase. The magnetoresistances of both the longitudinal and Hall currents measured at 1.8 K show a strong effect of the magnetic field on the resistivity. Density functional theory was employed to determine the lattice constants of the MoP crystal. These parameters were in good agreement with those obtained from the Rietveld fit to the XRD spectrum of the films.
- 1 December 2020
- Published by Elsevier in Electrochimica Acta
- Vol. 362
Structural water enhanced intercalation of magnesium ions in copper hexacyanoferrate nonaqueous batteries
- 1 December 2020
- Published by Elsevier in Electrochimica Acta
- Vol. 362
Structural water enhanced intercalation of magnesium ions in copper hexacyanoferrate nonaqueous batteries
- Open Access
- 8 January 2020
- Published by The Electrochemical Society in ECS Journal of Solid State Science and Technology
- Vol. 9 (6) , 061009
Membraneless H2O2 Fuel Cells Driven by Metallophthalocyanine Electrocatalysts
One-compartment hydrogen peroxide fuel cells with Co, Cu, and Fe phthalocyanine (PC) and iron nitride (FexN) as cathodes and Ni anode have been investigated as sustainable energy sources. The cells were operated under acidic conditions and at room temperature. The potentials for onset of the catalytic currents in these cells were determined via cyclic voltammograms. The reduction current onset potentials of FePC, CoPC, CuPC and FexN were 0.56 V, 0.42 V, 0.51 V and 0.57 V, respectively. Potential-current linear sweep voltammetry was utilized to determine the open circuit potentials (OCP) and the power densities the fuel cells. The OCPs for Co, Cu, and Fe phthalocyanines and FexN were 0.47 V, 0.57 V, 0.56 V and 0.58 V, respectively. The maximum output power densities of FePC and CoPC, CuPC, and FexN were 3.41 mW cm−2, 0.39 mW cm−2, 0.39 mW cm−2 and 0.76 mW cm−2, respectively. These power densities are suitable for powering micro-devices.
- 8 January 2020
- Published by The Electrochemical Society in ECS Journal of Solid State Science and Technology
- Vol. 9 (6) , 061009
Open AccessMembraneless H2O2 Fuel Cells Driven by Metallophthalocyanine Electrocatalysts
One-compartment hydrogen peroxide fuel cells with Co, Cu, and Fe phthalocyanine (PC) and iron nitride (FexN) as cathodes and Ni anode have been investigated as sustainable energy sources. The cells were operated under acidic conditions and at room temperature. The potentials for onset of the catalytic currents in these cells were determined via cyclic voltammograms. The reduction current onset potentials of FePC, CoPC, CuPC and FexN were 0.56 V, 0.42 V, 0.51 V and 0.57 V, respectively. Potential-current linear sweep voltammetry was utilized to determine the open circuit potentials (OCP) and the power densities the fuel cells. The OCPs for Co, Cu, and Fe phthalocyanines and FexN were 0.47 V, 0.57 V, 0.56 V and 0.58 V, respectively. The maximum output power densities of FePC and CoPC, CuPC, and FexN were 3.41 mW cm−2, 0.39 mW cm−2, 0.39 mW cm−2 and 0.76 mW cm−2, respectively. These power densities are suitable for powering micro-devices.
- Open Access
- 30 March 2017
- Published by MDPI AG in Electronics
- Vol. 6 (2) , 27
Atomic Layer Growth of InSe and Sb2Se3 Layered Semiconductors and Their Heterostructure
Metal chalcogenides based on the C–M–M–C (C = chalcogen, M = metal) structure possess several attractive properties that can be utilized in both electrical and optical devices. We have shown that specular, large area films of γ-InSe and Sb2Se3 can be grown via atomic layer deposition (ALD) at relatively low temperatures. Optical (absorption, Raman), crystalline (X-ray diffraction), and composition (XPS) properties of these films have been measured and compared to those reported for exfoliated films and have been found to be similar. Heterostructures composed of a layer of γ-InSe (intrinsically n-type) followed by a layer of Sb2Se3 (intrinsically p-type) that display diode characteristics were also grown.
- 30 March 2017
- Published by MDPI AG in Electronics
- Vol. 6 (2) , 27
Open AccessAtomic Layer Growth of InSe and Sb2Se3 Layered Semiconductors and Their Heterostructure
Metal chalcogenides based on the C–M–M–C (C = chalcogen, M = metal) structure possess several attractive properties that can be utilized in both electrical and optical devices. We have shown that specular, large area films of γ-InSe and Sb2Se3 can be grown via atomic layer deposition (ALD) at relatively low temperatures. Optical (absorption, Raman), crystalline (X-ray diffraction), and composition (XPS) properties of these films have been measured and compared to those reported for exfoliated films and have been found to be similar. Heterostructures composed of a layer of γ-InSe (intrinsically n-type) followed by a layer of Sb2Se3 (intrinsically p-type) that display diode characteristics were also grown.
- Open Access
- 1 January 2017
- Published by American Institute of Mathematical Sciences (AIMS) in AIMS Materials Science
- Vol. 4 (2) , 340-362
Electrical properties of covalently functionalized graphene
We have employed first-principle calculations to study transformation of graphene’s electronic structure under functionalization by covalent bonds with di erent atomic and molecular groups - epoxies, amines, PFPA. It is shown that this functionalization leads to an opening in the graphene’s band gap on order of tens meV, but also leads to reduction of electrical conductivity. We also discuss the influence of charge exchange between the functionalizing molecule and graphene’s conjugated electrons on electron transport properties
- 1 January 2017
- Published by American Institute of Mathematical Sciences (AIMS) in AIMS Materials Science
- Vol. 4 (2) , 340-362
Open AccessElectrical properties of covalently functionalized graphene
We have employed first-principle calculations to study transformation of graphene’s electronic structure under functionalization by covalent bonds with di erent atomic and molecular groups - epoxies, amines, PFPA. It is shown that this functionalization leads to an opening in the graphene’s band gap on order of tens meV, but also leads to reduction of electrical conductivity. We also discuss the influence of charge exchange between the functionalizing molecule and graphene’s conjugated electrons on electron transport properties
- 8 October 2012
- Published by Elsevier in Solid-State Electronics
- Vol. 79, 262-267
Electrical conductivity of PFPA functionalized graphene
- 8 October 2012
- Published by Elsevier in Solid-State Electronics
- Vol. 79, 262-267
Electrical conductivity of PFPA functionalized graphene
- 5 October 2012
- Published by Wiley in Journal of Heat Transfer
- Vol. 134 (12) , 122401
Thermal Conductivity of Graphene Nanoribbons: Effect of the Edges and Ribbon Width
We have calculated thermal conductance of graphene nanoribbons (GNRs) and their dependence on the type of ribbon edge termination (zigzag or armchair) and the width of the ribbon, which ranges from 50 Å to 50 μm. Our model incorporates the effect of edge roughness and includes edge roughness correlation functions for both types of termination. The dependence of thermal conductance on the width of the ribbons and relative contribution of different scattering mechanisms are also analyzed by means of the Green’s function approach to the edge scattering. High temperature thermal conductance of the nanoribbons was found to be 0.15 nW/K and 0.18 nW/K (corresponding to thermal conductivity, 4641 and 5266 W/mK, respectively, for 10 μm long GNRs) which is in a good agreement with the experimental results.
- 5 October 2012
- Published by Wiley in Journal of Heat Transfer
- Vol. 134 (12) , 122401
Thermal Conductivity of Graphene Nanoribbons: Effect of the Edges and Ribbon Width
We have calculated thermal conductance of graphene nanoribbons (GNRs) and their dependence on the type of ribbon edge termination (zigzag or armchair) and the width of the ribbon, which ranges from 50 Å to 50 μm. Our model incorporates the effect of edge roughness and includes edge roughness correlation functions for both types of termination. The dependence of thermal conductance on the width of the ribbons and relative contribution of different scattering mechanisms are also analyzed by means of the Green’s function approach to the edge scattering. High temperature thermal conductance of the nanoribbons was found to be 0.15 nW/K and 0.18 nW/K (corresponding to thermal conductivity, 4641 and 5266 W/mK, respectively, for 10 μm long GNRs) which is in a good agreement with the experimental results.
- 29 September 2012
- Published by Springer Nature in BioNanoScience
- Vol. 2 (4) , 161-170
An Electronic Sensor for Detection of Early-Stage Biomarker/s for Ovarian Cancer
- 29 September 2012
- Published by Springer Nature in BioNanoScience
- Vol. 2 (4) , 161-170
An Electronic Sensor for Detection of Early-Stage Biomarker/s for Ovarian Cancer
- Open Access
- 22 July 2011
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 135 (4) , 044103
Electronic properties of metal-arene functionalized graphene
We have employed first-principles density-functional calculations to study the electronic characteristics of covalently functionalized graphene by metal-bis-arene chemistry. It is shown that functionalization with M-bis-arene (M = Ti, V, Cr, Mn, Fe) molecules leads to an opening in the bandgap of graphene (up to 0.81 eV for the Cr derivative), and as a result, transforms it from a semimetal to a semiconductor. The bandgap induced by attachment of a metal atom topped by a benzene ring is attributed to modification of π-conjugation and depends on the concentration of functionalizing molecules. This approach offers a means of tailoring the band structure of graphene and potentially its applications for future electronic devices.
- 22 July 2011
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 135 (4) , 044103
Open AccessElectronic properties of metal-arene functionalized graphene
We have employed first-principles density-functional calculations to study the electronic characteristics of covalently functionalized graphene by metal-bis-arene chemistry. It is shown that functionalization with M-bis-arene (M = Ti, V, Cr, Mn, Fe) molecules leads to an opening in the bandgap of graphene (up to 0.81 eV for the Cr derivative), and as a result, transforms it from a semimetal to a semiconductor. The bandgap induced by attachment of a metal atom topped by a benzene ring is attributed to modification of π-conjugation and depends on the concentration of functionalizing molecules. This approach offers a means of tailoring the band structure of graphene and potentially its applications for future electronic devices.
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1236
Label-free Electrochemical Impedance Detection of Ovarian Cancer Markers CA-125 and CEA
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1236
Label-free Electrochemical Impedance Detection of Ovarian Cancer Markers CA-125 and CEA