FFFarzan Farhangian

Farzan Farhangian

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Farzan Farhangian has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    An Adaptive RF Front-End Architecture for Multi-Band SDR in Avionics

    by Behnam Shakibafar, Farzan Farhangian, Jean-Marc Gagne, Rene Jr. Landry, Frederic Nabki

    This study introduces a reconfigurable and agile RF front-end (RFFE) architecture that significantly enhances the performance of software-defined radios (SDRs) by seamlessly adjusting to varying signal requirements, frequencies, and protocols. This flexibility greatly enhances spectrum utilization, signal integrity, and overall system efficiency—critical factors in aviation, where reliable communication, navigation, and surveillance systems are vital for safety. A versatile RF front-end is thus indispensable, enhancing connectivity and safety standards. We explore the integration of this flexible RF front-end in SDRs, focusing on the detailed design of essential components, such as receivers, transmitters, RF switches, combiners, and splitters, and their corresponding RF pathways. Comprehensive performance evaluations confirm the architecture’s reliability and functionality, including an extensive analysis of receiver gain, linearity, and two-tone test results. These assessments validate the architecture’s suitability for aviation radios and address considerations of size, weight, and power-cost (SWaP-C), demonstrating significant gains in operational efficiency and cost-effectiveness. The introduction of the new RF front-end on a single SDR board not only substantially reduces size and weight but also adds up to 18 dB gain to the received signal. It also allows for a high level of design flexibility, enabling seamless software transitions between different radios and the capacity to manage three times more radios with the same hardware, thereby significantly boosting the system’s ability to handle multiple radio channels efficiently.


  • High-order pseudorange rate measurement model for multi-constellation LEO/INS integration: Case of Iridium-NEXT, Orbcomm, and Globalstar

    by Farzan Farhangian, Rene Jr Landry

    An inertial navigation method augmented by Signals of Opportunity (SOPs) of three low earth orbit (LEO) constellations is presented. The downlink signal characteristics of the Iridium-NEXT, Orbcomm, and Globalstar LEO constellations are discussed. Furthermore, a tightly coupled integration model of the inertial navigation system and high-order LEO-SOP Doppler measurement model is designed. We presented a second-order measurement model of the LEO-SOP/INS integration using a second-order extended Kalman filter in which all the unknown states of the receiver and LEO satellites are estimated. The state parameters of the second-order EKF model are the position and velocity of both the receiver and the satellites, as well as the receiver’s orientation, the clock bias, and clock drift of the LEO satellites, and the constant bias of the Inertial Measurement Unit. An experiment is performed using a ground aerial vehicle equipped with a Multi-Constellation Software-Defined Receiver (MC-SDR). The Doppler measurements are provided by observing the downlinks from multiple satellites of the Iridium-NEXT and Orbcomm constellations. As well, the predicted measurement of a Globalstar satellite is used in the designed model. The results show the positioning accuracy of less than 10 m being achieved during a dynamic ground experiment, representing an 82% precision gain as compared against the regular single constellation EKF method.


  • Open Access

    Opportunistic In-Flight INS Alignment Using LEO Satellites and a Rotatory IMU Platform

    by Farzan Farhangian, Hamza Benzerrouk, Rene Landry

    With the emergence of numerous low Earth orbit (LEO) satellite constellations such as Iridium-Next, Globalstar, Orbcomm, Starlink, and OneWeb, the idea of considering their downlink signals as a source of pseudorange and pseudorange rate measurements has become incredibly attractive to the community. LEO satellites could be a reliable alternative for environments or situations in which the global navigation satellite system (GNSS) is blocked or inaccessible. In this article, we present a novel in-flight alignment method for a strapdown inertial navigation system (SINS) using Doppler shift measurements obtained from single or multi-constellation LEO satellites and a rotation technique applied on the inertial measurement unit (IMU). Firstly, a regular Doppler positioning algorithm based on the extended Kalman filter (EKF) calculates states of the receiver. This system is considered as a slave block. In parallel, a master INS estimates the position, velocity, and attitude of the system. Secondly, the linearized state space model of the INS errors is formulated. The alignment model accounts for obtaining the errors of the INS by a Kalman filter. The measurements of this system are the difference in the outputs from the master and slave systems. Thirdly, as the observability rank of the system is not sufficient for estimating all the parameters, a discrete dual-axis IMU rotation sequence was simulated. By increasing the observability rank of the system, all the states were estimated. Two experiments were performed with different overhead satellites and numbers of constellations: one for a ground vehicle and another for a small flight vehicle. Finally, the results showed a significant improvement compared to stand-alone INS and the regular Doppler positioning method. The error of the ground test reached around 26 m. This error for the flight test was demonstrated in different time intervals from the starting point of the trajectory. The proposed method showed a 180% accuracy improvement compared to the Doppler positioning method for up to 4.5 min after blocking the GNSS.


  • Open Access

    Applying a ToF/IMU-Based Multi-Sensor Fusion Architecture in Pedestrian Indoor Navigation Methods

    by Farzan Farhangian, Mohammad Sefidgar, Rene Jr. Landry

    The advancement of indoor Inertial Navigation Systems (INS) based on the low-cost Inertial Measurement Units (IMU) has been long reviewed in the field of pedestrian localization. There are various sources of error in these systems which lead to unstable and unreliable positioning results, especially in long term performances. These inaccuracies are usually caused by imperfect system modeling, inappropriate sensor fusion models, heading drift, biases of IMUs, and calibration methods. This article addresses the issues surrounding unreliability of the low-cost Micro-Electro-Mechanical System (MEMS)-based pedestrian INS. We designed a novel multi-sensor fusion method based on a Time of Flight (ToF) distance sensor and dual chest- and foot-mounted IMUs, aided by an online calibration technique. An Extended Kalman Filter (EKF) is accounted for estimating the attitude, position, and velocity errors, as well as estimation of IMU biases. A fusion architecture is derived to provide a consistent velocity measurement by operative contribution of ToF distance sensor and foot mounted IMU. In this method, the measurements of the ToF distance sensor are used for the time-steps in which the Zero Velocity Update (ZUPT) measurements are not active. In parallel, the chest mounted IMU is accounted for attitude estimation of the pedestrian’s chest. As well, by designing a novel corridor detection filter, the heading drift is restricted in each straightway. Compared to the common INS method, developed system proves promising and resilient results in two-dimensional corridor spaces for durations of up to 11 min. Finally, the results of our experiments showed the position RMS error of less than 3 m and final-point error of less than 5 m.


  • Open Access

    Multi-Constellation Software-Defined Receiver for Doppler Positioning with LEO Satellites

    by Farzan Farhangian, René Landry

    A Multi-Constellation Software-Defined Receiver (MC-SDR) is designed and implemented to extract the Doppler measurements of Low Earth Orbit (LEO) satellite’s downlink signals, such as Orbcomm, Iridium-Next, Globalstar, Starlink, OneWeb, SpaceX, etc. The Doppler positioning methods, as one of the main localization algorithms, need a highly accurate receiver design to track the Doppler as a measurement for Extended Kalman Filter (EKF)-based positioning. In this paper, the designed receiver has been used to acquire and track the Doppler shifts of two different kinds of LEO constellations. The extracted Doppler shifts of one Iridium-Next satellite as a burst-based simplex downlink signal and two Orbcomm satellites as continuous signals are considered. Also, with having the Two-Line Element (TLE) for each satellite, the position, and orbital elements of each satellite are known. Finally, the accuracy of the designed receiver is validated using an EKF-based stationary positioning algorithm with an adaptive measurement matrix. Satellite detection and Doppler tracking results are analyzed for each satellite. The positioning results for a stationary receiver showed an accuracy of about 132 m, which means 72% accuracy advancements compared to single constellation positioning.


  • Open Access

    Accuracy Improvement of Attitude Determination Systems Using EKF-Based Error Prediction Filter and PI Controller

    by Farzan Farhangian, Rene Landry

    Accurate attitude and heading reference system (AHRS) play an essential role in navigation applications and human body tracking systems. Using low-cost microelectromechanical system (MEMS) inertial sensors and having accurate orientation estimation, simultaneously, needs optimum orientation methods and algorithms. The error of attitude estimation may lead to imprecise navigation and motion capture results. This paper proposed a novel intermittent calibration technique for MEMS-based AHRS using error prediction and compensation filter. The method, inspired from the recognition of gyroscope’s error and by a proportional integral (PI) controller, can be regulated to increase the accuracy of the prediction. The experimentation of this study for the AHRS algorithm, aided by the proposed prediction filter, was tested with real low-cost MEMS sensors consists of accelerometer, gyroscope, and magnetometer. Eventually, the error compensation was performed by post-processing the measurements of static and dynamic tests. The experimental results present about 35% accuracy improvement in attitude estimation and demonstrate the explicit performance of proposed method.