Siyu Cheng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Siyu Cheng has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Maksym Shevchenko
Pyrometallurgy Innovation Laboratory (PyroSearch) School of Chemical Engineering The University of Queensland Brisbane Queensland Australia
11 shared publications - Evgueni Jak
Pyrometallurgy Innovation Laboratory (PyroSearch) School of Chemical Engineering The University of Queensland Brisbane Queensland Australia
10 shared publications - Peter Charles Hayes
The University of Queensland
5 shared publications - Denis Shishin
The University of Queensland
4 shared publications - Evgenii Nekhoroshev
The University of Queensland
4 shared publications Evgueni Jak
2 shared publications
Latest Publications
- Open Access
- 20 April 2026
- Published by Elsevier in Ceramics International
- Vol. 52 (14) , 24342-24362
Phase equilibria in the CaO-“FeO”-AlO1.5 system in equilibrium with Fe metal
- 20 April 2026
- Published by Elsevier in Ceramics International
- Vol. 52 (14) , 24342-24362
Open AccessPhase equilibria in the CaO-“FeO”-AlO1.5 system in equilibrium with Fe metal
- Open Access
- 7 May 2025
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 108 (9)
Reoptimization of the CaO–FeO–Fe 2 O 3 –SiO 2 system integrated with EPMA studies (part I—experimental results)
New experimental measurements have been obtained for phase equilibria in the CaO–FeO–Fe 2 O 3 –SiO 2 system at 1250–1740°C for a wide range of oxygen partial pressures ( p (O 2 ) = 1, 0.21, 10 −5 , 10 −6 , 10 −7 , 10 −8 , 10 −9 atm) as well as in equilibrium with metallic iron ( p (O 2 ) down to 10 −12 atm). The investigation was undertaken using equilibration/quenching technique and electron probe X‐ray microanalysis (EPMA) which allow to measure the elemental compositions of the liquid and solid phases in equilibrium. The current work is a continuation of an extensive earlier work by the coauthors and fills in the gaps concerning mostly low‐SiO 2 areas of the phase diagram in the primary fields of dicalcium and tricalcium silicates. This work is part of a bigger combined experimental/modeling study of the Ca–Fe–Si–O system and its subsystems. The current experimental work a first part of a two‐part manuscript describing the new experimental data in the Ca–Fe–Si–O system and its thermodynamic modeling (part II).
- 7 May 2025
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 108 (9)
Open AccessReoptimization of the CaO–FeO–Fe 2 O 3 –SiO 2 system integrated with EPMA studies (part I—experimental results)
New experimental measurements have been obtained for phase equilibria in the CaO–FeO–Fe 2 O 3 –SiO 2 system at 1250–1740°C for a wide range of oxygen partial pressures ( p (O 2 ) = 1, 0.21, 10 −5 , 10 −6 , 10 −7 , 10 −8 , 10 −9 atm) as well as in equilibrium with metallic iron ( p (O 2 ) down to 10 −12 atm). The investigation was undertaken using equilibration/quenching technique and electron probe X‐ray microanalysis (EPMA) which allow to measure the elemental compositions of the liquid and solid phases in equilibrium. The current work is a continuation of an extensive earlier work by the coauthors and fills in the gaps concerning mostly low‐SiO 2 areas of the phase diagram in the primary fields of dicalcium and tricalcium silicates. This work is part of a bigger combined experimental/modeling study of the Ca–Fe–Si–O system and its subsystems. The current experimental work a first part of a two‐part manuscript describing the new experimental data in the Ca–Fe–Si–O system and its thermodynamic modeling (part II).
- Open Access
- 12 November 2024
- Published by Elsevier in Ceramics International
- Vol. 51 (2) , 1456-1478
Thermodynamic re-optimization of the CaO-FeO-Fe2O3 system integrated with experimental phase equilibria studies (Part II – Thermodynamic optimization)
- 12 November 2024
- Published by Elsevier in Ceramics International
- Vol. 51 (2) , 1456-1478
Open AccessThermodynamic re-optimization of the CaO-FeO-Fe2O3 system integrated with experimental phase equilibria studies (Part II – Thermodynamic optimization)
- Open Access
- 24 August 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (22) , 45438-45452
Thermodynamic re-optimisation of the CaO-FeO-Fe2O3 system integrated with experimental phase equilibria studies (Part I)
- 24 August 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (22) , 45438-45452
Open AccessThermodynamic re-optimisation of the CaO-FeO-Fe2O3 system integrated with experimental phase equilibria studies (Part I)
- Open Access
- 15 June 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (18) , 33686-33702
Thermodynamic re-optimization of the CaO–SiO2 system integrated with experimental phase equilibria studies
- 15 June 2024
- Published by Elsevier in Ceramics International
- Vol. 50 (18) , 33686-33702
Open AccessThermodynamic re-optimization of the CaO–SiO2 system integrated with experimental phase equilibria studies
- 5 December 2022
- Published by Elsevier in Ceramics International
- Vol. 49 (7) , 11513-11528
Experimental phase equilibria study and thermodynamic modelling of the “CuO0.5”-AlO1.5-SiO2 ternary system in equilibrium with metallic copper
- 5 December 2022
- Published by Elsevier in Ceramics International
- Vol. 49 (7) , 11513-11528
Experimental phase equilibria study and thermodynamic modelling of the “CuO0.5”-AlO1.5-SiO2 ternary system in equilibrium with metallic copper
- Open Access
- 11 October 2022
- Published by Darcy & Roy Press Co. Ltd. in Frontiers in Business, Economics and Management
- Vol. 5 (3) , 89-93
The Last Resorts' to Destroy the Democratic Socialist Republic of Sri Lanka
In recent years, many countries have faced severe economic challenges due to the worldwide outbreak of the covid-19. In July 2022, Sri Lanka officially declared bankruptcy. Now, the declining tourism industry caused by the epidemic, unrealistic agricultural reform bills, severe debt crisis, and the failure of religious politics have directly affected the economic health and sustainability of the country. Every country must think about better solutions to overcome the economic crisis during the worldwide pandemic. This paper will use data analysis and logical reasoning to better explore the complex reasons behind the fact. Through research, this paper draws the following conclusions: Firstly, the bankruptcy of Sri Lanka is mainly related to the debt crisis, among which high inflation and civil war have declined the debt repayment ability. Secondly, the external situation and the wrong decision of the Sri Lankan government are the last straw for oppressing the country.
- 11 October 2022
- Published by Darcy & Roy Press Co. Ltd. in Frontiers in Business, Economics and Management
- Vol. 5 (3) , 89-93
Open AccessThe Last Resorts' to Destroy the Democratic Socialist Republic of Sri Lanka
In recent years, many countries have faced severe economic challenges due to the worldwide outbreak of the covid-19. In July 2022, Sri Lanka officially declared bankruptcy. Now, the declining tourism industry caused by the epidemic, unrealistic agricultural reform bills, severe debt crisis, and the failure of religious politics have directly affected the economic health and sustainability of the country. Every country must think about better solutions to overcome the economic crisis during the worldwide pandemic. This paper will use data analysis and logical reasoning to better explore the complex reasons behind the fact. Through research, this paper draws the following conclusions: Firstly, the bankruptcy of Sri Lanka is mainly related to the debt crisis, among which high inflation and civil war have declined the debt repayment ability. Secondly, the external situation and the wrong decision of the Sri Lankan government are the last straw for oppressing the country.
- 20 May 2022
- Published by Wiley in ChemElectroChem
- Vol. 9 (13)
Synthesis of VS2/NiS Nanocomposites by In Situ Growing NiS Clusters on VS2 Ultrathin Nanoplates for High Performance Supercapacitors
Novel transition metal sulfide composite VS2/NiS nanomaterials are synthesized through a two‐step route, where VS2 was synthesized by colloidal chemical method, and NiS was in situ grown between the ultrathin and defective VS2 through a hydrothermal method. The composites showed VS2 nanoplates wrapped with a NiS clusters structure. Under the 1 : 7 optimal composite ratio, the VS2/NiS electrode exhibits a specific capacitance of 2416.5 F/g at 1 A/g, the specific capacitance stays at 930.2 F/g when the current density increases to 20 A/g. The asymmetric supercapacitor assembled with VS2/NiS‐1 : 7 and activated carbon electrodes also exhibits an ultrahigh energy density of 69.58 Wh/kg at a power density of 874.9 W/kg and showed good cycling performance with 74.9 % capacitance retention after 3000 cycles. This work not only demonstrates the excellent performance of the VS2/NiS composites in supercapacitors, but also provided a new compound strategy for transition metal sulfides.
- 20 May 2022
- Published by Wiley in ChemElectroChem
- Vol. 9 (13)
Synthesis of VS2/NiS Nanocomposites by In Situ Growing NiS Clusters on VS2 Ultrathin Nanoplates for High Performance Supercapacitors
Novel transition metal sulfide composite VS2/NiS nanomaterials are synthesized through a two‐step route, where VS2 was synthesized by colloidal chemical method, and NiS was in situ grown between the ultrathin and defective VS2 through a hydrothermal method. The composites showed VS2 nanoplates wrapped with a NiS clusters structure. Under the 1 : 7 optimal composite ratio, the VS2/NiS electrode exhibits a specific capacitance of 2416.5 F/g at 1 A/g, the specific capacitance stays at 930.2 F/g when the current density increases to 20 A/g. The asymmetric supercapacitor assembled with VS2/NiS‐1 : 7 and activated carbon electrodes also exhibits an ultrahigh energy density of 69.58 Wh/kg at a power density of 874.9 W/kg and showed good cycling performance with 74.9 % capacitance retention after 3000 cycles. This work not only demonstrates the excellent performance of the VS2/NiS composites in supercapacitors, but also provided a new compound strategy for transition metal sulfides.
- Open Access
Iron Ore Sinter Macro- and Micro-Structures, and Their Relationships to Breakage Characteristics
A systematic analysis of industrial iron ore sinter product and associated sinter returns was undertaken. The samples were characterised through identification of the major macro- and micro-structural types present in these materials. Examination of the breakage surfaces of the particles indicates a strong correlation between mechanical sinter strength and sinter microstructure. Preferential breakage was observed to occur in sinter materials having high porosity and those microstructures consisting of isolated hematite grains in a glass matrix. The bulk of the sinter product consisted of material with a microstructure of magnetite and silico-ferrite of calcium and aluminium (SFCA). The phases formed and the reaction sequences responsible for the formation of the principal microstructure types are explained by the non-equilibrium solidification of melts in the “Fe2O3”-Al2O3-CaO-SiO2 system.
Open AccessIron Ore Sinter Macro- and Micro-Structures, and Their Relationships to Breakage Characteristics
A systematic analysis of industrial iron ore sinter product and associated sinter returns was undertaken. The samples were characterised through identification of the major macro- and micro-structural types present in these materials. Examination of the breakage surfaces of the particles indicates a strong correlation between mechanical sinter strength and sinter microstructure. Preferential breakage was observed to occur in sinter materials having high porosity and those microstructures consisting of isolated hematite grains in a glass matrix. The bulk of the sinter product consisted of material with a microstructure of magnetite and silico-ferrite of calcium and aluminium (SFCA). The phases formed and the reaction sequences responsible for the formation of the principal microstructure types are explained by the non-equilibrium solidification of melts in the “Fe2O3”-Al2O3-CaO-SiO2 system.
- 1 April 2022
- Published by Elsevier in Ceramics International
- Vol. 48 (7) , 9927-9938
Experimental phase equilibria studies in the “CuO0.5”-CaO-SiO2 ternary system in equilibrium with metallic copper
- 1 April 2022
- Published by Elsevier in Ceramics International
- Vol. 48 (7) , 9927-9938
Experimental phase equilibria studies in the “CuO0.5”-CaO-SiO2 ternary system in equilibrium with metallic copper