David J. Ciufo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
David J. Ciufo has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
Allan M. Grant
Department of Orthopaedic Surgery, Beaumont Health, Royal Oak, MI
1 shared publicationCorinn K. Gehrke
Beaumont Health, Departments of Orthopaedic Surgery and Research, Beaumont Research Institute, 3601 West 13 Mile Road, Suite 404, Royal Oak, MI 48073, USA
1 shared publicationErin A. Baker
Beaumont Health, Departments of Orthopaedic Surgery and Research, Beaumont Research Institute, 3601 West 13 Mile Road, Suite 404, Royal Oak, MI 48073, USA
1 shared publicationJohn P. Ketz
University of Rochester, Department of Orthopaedics and Rehabilitation
1 shared publicationPaul T. Fortin
Beaumont Health, Departments of Orthopaedic Surgery and Research, Beaumont Research Institute, 3601 West 13 Mile Road, Suite 404, Royal Oak, MI 48073, USA
1 shared publicationZachary M. Vaupel
Beaumont Health, Departments of Orthopaedic Surgery and Research, Beaumont Research Institute, 3601 West 13 Mile Road, Suite 404, Royal Oak, MI 48073, USA
1 shared publication
Latest Publications
- 1 April 2022
- Published by Elsevier in Foot and Ankle Surgery
- Vol. 28 (3) , 354-361
Tibial torsion correlates with talar morphology
- 1 April 2022
- Published by Elsevier in Foot and Ankle Surgery
- Vol. 28 (3) , 354-361
Tibial torsion correlates with talar morphology
- 14 January 2021
- Published by Wolters Kluwer Health in Techniques in Foot & Ankle Surgery
- Vol. 21 (1) , 40-47
Orthogonal Locked Plating for Tibiotalocalcaneal Arthrodesis
Management of concomitant tibiotalar and subtalar arthrosis, particularly in the setting of talar avascular necrosis or deformity, is a challenging problem. There are poor union rates and risk of stress fracture at the proximal aspect of intramedullary devices. Fixation can be poor in the calcaneus and talus with current methods. This study describes the technique of orthogonal plating, using an anatomic precontoured plating system, for tibiotalocalcaneal arthrodesis, with and without bulk allograft. We feel this technique provides increased construct stability and good outcomes, and 2 of our cases are presented that underwent arthrodesis using this construct at a single academic center. Level of Evidence: Therapeutic level IV, case series. See Instructions for Authors for a complete description of levels of evidence.
- 14 January 2021
- Published by Wolters Kluwer Health in Techniques in Foot & Ankle Surgery
- Vol. 21 (1) , 40-47
Orthogonal Locked Plating for Tibiotalocalcaneal Arthrodesis
Management of concomitant tibiotalar and subtalar arthrosis, particularly in the setting of talar avascular necrosis or deformity, is a challenging problem. There are poor union rates and risk of stress fracture at the proximal aspect of intramedullary devices. Fixation can be poor in the calcaneus and talus with current methods. This study describes the technique of orthogonal plating, using an anatomic precontoured plating system, for tibiotalocalcaneal arthrodesis, with and without bulk allograft. We feel this technique provides increased construct stability and good outcomes, and 2 of our cases are presented that underwent arthrodesis using this construct at a single academic center. Level of Evidence: Therapeutic level IV, case series. See Instructions for Authors for a complete description of levels of evidence.
- 2 July 2020
- Published by Wolters Kluwer Health in Journal of Orthopaedic Trauma
- Vol. 35 (2) , 87-91
Proximal Femoral Shortening and Varus Collapse After Fixation of “Stable” Pertrochanteric Femur Fractures
Objectives: To evaluate and compare femoral neck shortening and varus collapse in stable pertrochanteric femur fractures treated with sliding hip screws (SHSs) or cephalomedullary nails (CMNs). Design: Retrospective review. Setting: Academic medical center. Patients: A total of 290 patients were included in the study. The average age was 82 years, and most were women. All sustained low-energy pertrochanteric femur fractures (OTA/AO A1.1, 1.2, 1.3, 2.2) treated operatively with SHSs or CMNs. Minimum radiographic follow-up was 3 months, with an average of 28 (range 3–162) months. Intervention: CMN or SHS fixation. Main Outcome Measures: Varus collapse of the femoral neck-shaft angle and proximal femoral shortening. Results: Both implants allowed some varus collapse. Univariate analysis demonstrated a significantly greater portion of patients with SHSs progressed to varus collapse >5 degrees (P = 0.02), mild horizontal shortening >5 mm (P < 0.01), and severe horizontal shortening >10 mm (P < 0.01). There was no statistical difference in vertical shortening (P = 0.3). There was no difference in implant failure (P = 0.5), with failure rates of 3% for cephalomedullary implants and 5% for SHS constructs. Conclusions: The SHS group experienced greater varus collapse and horizontal shortening. There was no difference in overall implant failure. These findings suggest that the CMN is a superior construct for maintenance of reduction in stable pertrochanteric fractures, which may lead to improved functional outcomes as patients recover. Level of Evidence: Therapeutic Level III. See Instructions for Authors for a complete description of levels of evidence.
- 2 July 2020
- Published by Wolters Kluwer Health in Journal of Orthopaedic Trauma
- Vol. 35 (2) , 87-91
Proximal Femoral Shortening and Varus Collapse After Fixation of “Stable” Pertrochanteric Femur Fractures
Objectives: To evaluate and compare femoral neck shortening and varus collapse in stable pertrochanteric femur fractures treated with sliding hip screws (SHSs) or cephalomedullary nails (CMNs). Design: Retrospective review. Setting: Academic medical center. Patients: A total of 290 patients were included in the study. The average age was 82 years, and most were women. All sustained low-energy pertrochanteric femur fractures (OTA/AO A1.1, 1.2, 1.3, 2.2) treated operatively with SHSs or CMNs. Minimum radiographic follow-up was 3 months, with an average of 28 (range 3–162) months. Intervention: CMN or SHS fixation. Main Outcome Measures: Varus collapse of the femoral neck-shaft angle and proximal femoral shortening. Results: Both implants allowed some varus collapse. Univariate analysis demonstrated a significantly greater portion of patients with SHSs progressed to varus collapse >5 degrees (P = 0.02), mild horizontal shortening >5 mm (P < 0.01), and severe horizontal shortening >10 mm (P < 0.01). There was no statistical difference in vertical shortening (P = 0.3). There was no difference in implant failure (P = 0.5), with failure rates of 3% for cephalomedullary implants and 5% for SHS constructs. Conclusions: The SHS group experienced greater varus collapse and horizontal shortening. There was no difference in overall implant failure. These findings suggest that the CMN is a superior construct for maintenance of reduction in stable pertrochanteric fractures, which may lead to improved functional outcomes as patients recover. Level of Evidence: Therapeutic Level III. See Instructions for Authors for a complete description of levels of evidence.