Diego Díaz-Sinche
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Diego Díaz-Sinche has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Jairo Castillo-Calderón
Universidad Nacional de Loja
7 shared publications - Rubén Carrión-Jaura
Universidad Nacional de Loja
6 shared publications Bryan Briceño-Martínez
Universidad Nacional de Loja, Facultad de la Energía, las Industrias y los Recursos Naturales no Renovables, Ciudad Universitaria Guillermo Falconí, Loja, Ecuador. (correo-e:;;; bryan.briceñ
1 shared publication- Bryan Briceño-Martínez
Universidad Nacional de Loja
1 shared publication - Christian Andrés Caraguay Correa
Universidad Nacional de Loja
1 shared publication - Diana Ochoa-Romero
Ministerio de Salud Publica
1 shared publication
Latest Publications
- 2 September 2026
- Published by Springer Nature
- p. 406-417
Methodology for Smoothing the Altitude Profile of Urban Bus Routes in Mountainous Cities
- 2 September 2026
- Published by Springer Nature
- p. 406-417
Methodology for Smoothing the Altitude Profile of Urban Bus Routes in Mountainous Cities
- Open Access
- 9 July 2026
- Published by Elsevier in SSRN Electronic Journal
Are inventory-based CO2 emission factors in Andean corridors reliable enough? Insights from real-world driving
Emission inventories used for regulatory planning in Andean countries rely on standardized driving cycles that do not capture the real operating conditions of mountain intercity corridors, where altitude changes and steep road grades substantially amplify traction energy demand. This limitation is particularly critical in regulatory frameworks that permit public transport fleet units to operate for up to 20 years under a single operating concession, without mandatory reassessment of real-world emission performance. This study proposes a methodology for estimating CO2 emission factors from real driving conditions, experimental fuel consumption measurements, and corridor-specific dynamic modeling, applied to a representative Andean intercity corridor in southern Ecuador using a heterogeneous heavy-duty bus fleet. Weighted Least Squares (WLS) was applied to construct representative driving cycles under typical and critical operating conditions based on traction energy demand. Emission factors were estimated through a carbon-balance approach and contrasted against the International Vehicle Emissions (IVE) model. Carbon-balance factors reached 1,061±128 g/km under typical conditions and 1,243±153 g/km under critical conditions, while the IVE model yielded 684 and 793 g/km respectively, representing a systematic underestimation of approximately 37% relative to real-world measurements. These results demonstrate that inventory-based methods are insufficient to represent altitude-driven emission conditions in Andean corridors and provide a replicable methodological basis for updating regulatory emission inventories, informing fleet renewal policies, and supporting transport decarbonization strategies in high-altitude intercity systems.
- 9 July 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessAre inventory-based CO2 emission factors in Andean corridors reliable enough? Insights from real-world driving
Emission inventories used for regulatory planning in Andean countries rely on standardized driving cycles that do not capture the real operating conditions of mountain intercity corridors, where altitude changes and steep road grades substantially amplify traction energy demand. This limitation is particularly critical in regulatory frameworks that permit public transport fleet units to operate for up to 20 years under a single operating concession, without mandatory reassessment of real-world emission performance. This study proposes a methodology for estimating CO2 emission factors from real driving conditions, experimental fuel consumption measurements, and corridor-specific dynamic modeling, applied to a representative Andean intercity corridor in southern Ecuador using a heterogeneous heavy-duty bus fleet. Weighted Least Squares (WLS) was applied to construct representative driving cycles under typical and critical operating conditions based on traction energy demand. Emission factors were estimated through a carbon-balance approach and contrasted against the International Vehicle Emissions (IVE) model. Carbon-balance factors reached 1,061±128 g/km under typical conditions and 1,243±153 g/km under critical conditions, while the IVE model yielded 684 and 793 g/km respectively, representing a systematic underestimation of approximately 37% relative to real-world measurements. These results demonstrate that inventory-based methods are insufficient to represent altitude-driven emission conditions in Andean corridors and provide a replicable methodological basis for updating regulatory emission inventories, informing fleet renewal policies, and supporting transport decarbonization strategies in high-altitude intercity systems.
- Open Access
- 8 September 2025
- Published by MDPI AG in Sustainability
- Vol. 17 (17) , 8075
Advancing Electric Mobility in Andean Countries: A Systematic Review and Case Study of Ecuador
Electric mobility is emerging as a crucial solution to reduce dependence on fossil fuels and mitigate environmental impact. In Ecuador, the transportation sector significantly contributes to CO2 emissions. However, the transition to electric vehicles faces several challenges, including high initial costs, insufficient charging infrastructure, and limited battery range. This highlights the need for effective public policies and local economic incentives. This study provides a comprehensive analysis of the current state of electric mobility in Andean regions, with a particular focus on Ecuador. It employs a systematic literature review (SLR) adapted from Kitchenham’s methodology, incorporating a multicriteria hierarchical analysis to rank journals according to their relevance. The goal is to assess the growth, implementation, and limitations of electric mobility in Andean countries. Three key research questions are addressed: (i) What are the benefits associated with the transition to electric transportation in Andean countries, with a special focus on Ecuador? (ii) What are the current challenges in transitioning to electric mobility? (iii) What recent public policies are promoting electric transportation? The analysis reveals that the transition to electric mobility could significantly reduce greenhouse gas (GHG) emissions. However, it faces notable challenges due to the insufficient demand for studies in electromobility plans and methodologies for defining charging points. The SLR includes a review of over 90 articles published in high-impact journals over the past six years, providing a solid foundation for decision-making in the current landscape and suggesting strategies to overcome the obstacles faced by government institutions. Finally, the study presents the reality of an installed charging infrastructure in Ecuador and the development of electric mobility in the region.
- 8 September 2025
- Published by MDPI AG in Sustainability
- Vol. 17 (17) , 8075
Open AccessAdvancing Electric Mobility in Andean Countries: A Systematic Review and Case Study of Ecuador
Electric mobility is emerging as a crucial solution to reduce dependence on fossil fuels and mitigate environmental impact. In Ecuador, the transportation sector significantly contributes to CO2 emissions. However, the transition to electric vehicles faces several challenges, including high initial costs, insufficient charging infrastructure, and limited battery range. This highlights the need for effective public policies and local economic incentives. This study provides a comprehensive analysis of the current state of electric mobility in Andean regions, with a particular focus on Ecuador. It employs a systematic literature review (SLR) adapted from Kitchenham’s methodology, incorporating a multicriteria hierarchical analysis to rank journals according to their relevance. The goal is to assess the growth, implementation, and limitations of electric mobility in Andean countries. Three key research questions are addressed: (i) What are the benefits associated with the transition to electric transportation in Andean countries, with a special focus on Ecuador? (ii) What are the current challenges in transitioning to electric mobility? (iii) What recent public policies are promoting electric transportation? The analysis reveals that the transition to electric mobility could significantly reduce greenhouse gas (GHG) emissions. However, it faces notable challenges due to the insufficient demand for studies in electromobility plans and methodologies for defining charging points. The SLR includes a review of over 90 articles published in high-impact journals over the past six years, providing a solid foundation for decision-making in the current landscape and suggesting strategies to overcome the obstacles faced by government institutions. Finally, the study presents the reality of an installed charging infrastructure in Ecuador and the development of electric mobility in the region.
- 23 December 2024
- Published by Springer Nature
- p. 631-645
Epidemiological Modeling of COVID-19, Using the MySQL Database Connection, with Different Platforms such as: Excel, MATLAB® and Node-RED
- 23 December 2024
- Published by Springer Nature
- p. 631-645
Epidemiological Modeling of COVID-19, Using the MySQL Database Connection, with Different Platforms such as: Excel, MATLAB® and Node-RED
- 23 December 2024
- Published by Springer Nature
- p. 920-932
Practical Approach to the Application of IEEE Standard 43-2013 in the Assessment of the Insulation of Rotating Machines
- 23 December 2024
- Published by Springer Nature
- p. 920-932
Practical Approach to the Application of IEEE Standard 43-2013 in the Assessment of the Insulation of Rotating Machines
- 1 February 2023
- Published by Springer Nature
- p. 286-298
Quantification of Contaminants Through Infrared Spectrometry in Naphtha Engine Oils
- 1 February 2023
- Published by Springer Nature
- p. 286-298
Quantification of Contaminants Through Infrared Spectrometry in Naphtha Engine Oils
- Open Access
- 1 February 2022
- Published by SciELO Agencia Nacional de Investigacion y Desarrollo (ANID) in Información tecnológica
- Vol. 33 (1) , 181-192
Análisis termográfico de un motor de encendido provocado, inducido a fallas mediante la aplicación de diseño de experimentos (DoE)
La presente investigación tiene como objetivo realizar un análisis termográfico a un motor de encendido provocado, al inducirle fallas controladas no detectadas por el OBD II (Sistema de Diagnóstico a Bordo de Segunda Generación), mediante diseño de experimentos (DoE). Se aplica un diseño factorial completo de dos niveles y dos factores. La unidad experimental es un vehículo Hyundai Accent que se somete a ocho tratamientos en un banco dinamómetro. Los resultados muestran una variación de temperatura de 18.78 ℃ y NOx de 291 ppm al intervenir sobre la bujía, 18.98 ℃ y NOx de 20 ppm al incidir sobre el filtro de aire, y 55 ℃ y NOx de 25 ppm frente a un efecto combinado. Se concluye que la media cuadrática (RMS) de los datos presentes en una imagen térmica es la característica que mejor permite evaluar el efecto de los factores o fallas sobre el vehículo, al presentar un mejor ajuste y menor desviación estándar.
- 1 February 2022
- Published by SciELO Agencia Nacional de Investigacion y Desarrollo (ANID) in Información tecnológica
- Vol. 33 (1) , 181-192
Open AccessAnálisis termográfico de un motor de encendido provocado, inducido a fallas mediante la aplicación de diseño de experimentos (DoE)
La presente investigación tiene como objetivo realizar un análisis termográfico a un motor de encendido provocado, al inducirle fallas controladas no detectadas por el OBD II (Sistema de Diagnóstico a Bordo de Segunda Generación), mediante diseño de experimentos (DoE). Se aplica un diseño factorial completo de dos niveles y dos factores. La unidad experimental es un vehículo Hyundai Accent que se somete a ocho tratamientos en un banco dinamómetro. Los resultados muestran una variación de temperatura de 18.78 ℃ y NOx de 291 ppm al intervenir sobre la bujía, 18.98 ℃ y NOx de 20 ppm al incidir sobre el filtro de aire, y 55 ℃ y NOx de 25 ppm frente a un efecto combinado. Se concluye que la media cuadrática (RMS) de los datos presentes en una imagen térmica es la característica que mejor permite evaluar el efecto de los factores o fallas sobre el vehículo, al presentar un mejor ajuste y menor desviación estándar.
- 28 September 2021
- Published by Springer Nature
- p. 755-768
Vibrations Associated with the Quality of Combustion Derived from Induced Failures in a Spark Ignition Engine
- 28 September 2021
- Published by Springer Nature
- p. 755-768
Vibrations Associated with the Quality of Combustion Derived from Induced Failures in a Spark Ignition Engine
- Open Access
- 30 June 2020
- Published by Salesian Polytechnic University of Ecuador in INGENIUS
- No. 24,p. 36-48
Propuesta de implantación de invernadero de secado de café con cubierta parabólica y estructura modular adaptada
El presente trabajo propone un invernadero destinado al secado de café formado por una cubierta solar parabólica y estructura modular adaptada. Se inició a través de un levantamiento planimétrico elaborado por diferentes softwares de ingeniería y arquitectura como: SolidWorks y Revit Architecture. Para el experimento se utilizó principios de ingeniería inversa, tomando como base, una estructura ya existente para desarrollar un modelo de acople modular, con el fin de establecer interacciones entre mecanismos y estructura. El estudio demostró que el diseño de los acoples de armado, facilitan su movilización, reducen costos y permiten la aplicación de materiales accesibles para el secador parabólico solar (marquesina), adicionalmente se presentan curvas de secado de café en un secador solar tipo parabólico y su tiempo representados en Statgraphics. El resultado del modelo con acoples de armado modular se asoció correctamente con resultados experimentales existentes, permitiendo realizar comparaciones entre tiempo y eficiencia del secado de café.
- 30 June 2020
- Published by Salesian Polytechnic University of Ecuador in INGENIUS
- No. 24,p. 36-48
Open AccessPropuesta de implantación de invernadero de secado de café con cubierta parabólica y estructura modular adaptada
El presente trabajo propone un invernadero destinado al secado de café formado por una cubierta solar parabólica y estructura modular adaptada. Se inició a través de un levantamiento planimétrico elaborado por diferentes softwares de ingeniería y arquitectura como: SolidWorks y Revit Architecture. Para el experimento se utilizó principios de ingeniería inversa, tomando como base, una estructura ya existente para desarrollar un modelo de acople modular, con el fin de establecer interacciones entre mecanismos y estructura. El estudio demostró que el diseño de los acoples de armado, facilitan su movilización, reducen costos y permiten la aplicación de materiales accesibles para el secador parabólico solar (marquesina), adicionalmente se presentan curvas de secado de café en un secador solar tipo parabólico y su tiempo representados en Statgraphics. El resultado del modelo con acoples de armado modular se asoció correctamente con resultados experimentales existentes, permitiendo realizar comparaciones entre tiempo y eficiencia del secado de café.