SXSheng Xiang

Sheng Xiang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Sheng Xiang has a total of 31 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Study on the Suppression Mechanism of Vibration and Noise in Converter Transformers Under Multi-Physical Field Coupling Using Different Filtering Strategies

    by Yuzhuo Wang, Liwei Xie, Sheng Xiang

    Electromagnetic vibration and noise issues of converter transformers under harmonic operating conditions have become increasingly prominent. To enable a systematic comparison of different filtering strategies, this paper establishes a multiphysical field coupling model incorporating electromagnetic, structural, and acoustic fields, and systematically investigates four filtering configurations: grid-side LC filtering, valve-side LC filtering, inductive filtering, and valve-side capacitive filtering through theoretical analysis, finite-element simulation, and experimental verification on a 12-pulse laboratory HVDC prototype platform. The simulation results show that the maximum vibration acceleration decreases from 3.06 m/s2 under the no-filter condition to 1.02 m/s2 under valve-side capacitive filtering. Experimental measurements further confirm the suppression effect, with the vibration acceleration at Point 8 decreasing from 2.28 m/s2 to 0.42 m/s2, corresponding to a reduction of approximately 82%, while the average A-weighted sound pressure level decreases from 66.1 dB to 58.1 dB. These results indicate that vibration and noise suppression cannot be evaluated solely by total harmonic distortion; the attenuation and distribution of individual harmonic components should also be considered. The findings provide a theoretical and engineering basis for the vibration and noise reduction design of converter transformers.

  • Open Access

    Electro-Hydrogen Synergistic Dispatch for Wind-Solar-Tidal Port Microgrids: A Two-Stage Stochastic Framework with Adaptive Progressive Hedging

    by Yutao Gao, Sheng Xiang, Mingyang Yang

    The decarbonization of multi-energy coupled ports necessitates addressing the complex interplay between renewable energy fluctuations and flexible load management. However, existing research has clear limitations in describing multi-source uncertainties and clarifying the synergistic mechanism of electro-hydrogen energy storage systems. To fill this gap, this study addresses the core problem of the coordinated operation of port microgrids under multiple uncertainties. A comprehensive physical model is established for wind–solar–tidal–hydrogen systems, capturing the intricate dynamics of the “generation–consumption–storage–conversion” chain. A novel two-stage stochastic optimization framework, integrating day-ahead pre-decision with real-time compensation, is proposed. To overcome computational bottlenecks, an adaptive progressive hedging algorithm is introduced. Comparative analyses show that the proposed strategy reduces the total port operational costs by 60.8% and grid transaction costs by 74.4%, compared with the single-stage deterministic mode. The adaptive PH algorithm also achieves 4–6 times higher computational efficiency than quadratic integer Benders decomposition, while maintaining an optimality gap below 2%. These findings elucidate the critical synergy between electro-hydrogen storage and stochastic optimization, offering a theoretical basis for sustainable port operations.

  • Open Access

    An Optimization Ensemble for Integrated Energy System Configuration Strategy Incorporating Demand–Supply Coordination

    by Chenhao Sun, Xiwei Jiang, Zhiwei Jia, Kun Yu, Sheng Xiang, Jianhong Su

    As one representative smart energy infrastructure in smart cities, an integrated energy system (IES) consists of several types of energy sources, thus making more complicated coupling connections between the supply and demand sides than a power grid. This will impact when allocating different energy sources to ensure the appropriate energy utilization in the IES. With this motivation, an IES energy configuration optimization strategy based on a multi-model ensemble is proposed in this paper. Firstly, one coupling model is constructed to assess the underlying collaborative relationships between two sides for a renewable-energy-connected IES. Next, the independent component analysis (ICA) method is implemented for noise reduction in massive heterogeneous input databases, which can effectively improve the computing efficiency under such high-dimensional data conditions. Also, the self-adaptive quantum genetic model (SAQGM) is built for subsequent configuration optimization. Specifically, the quantum bit representation is incorporated to reduce computation complexity in multi-states scenarios, the double-chain formation of chromosomes is deployed to diminish the uncertainty when encoding, and the dynamic adaptation quantum gate is established to successively amend parameters. Finally, an empirical case study is conducted which can demonstrate the benefits of this strategy in terms of feasibility, efficiency, and economy.


  • Locational Marginal Carbon Emission of Power Grids Approach: Optimal Scheduling of Recycling Electricity/Heat Rural Supply System Based on Waste Feedstock

    by Hongming Yang, Dingzhong Xu, Sheng Xiang, Bangzhe Yin, MingYong Lai, Emmanuel Ackom, Archie James Johnston

    To improve the power supply ability, heat supply ability, and waste recovery rate, a recycling electricity/heat rural supply system with waste feedstock is established. The energy supply system generates electricity/heat from biomass energy produced by wastes, which is also coupled to distributed renewable energy. The optimal scheduling of the established rural system will improve energy efficiency and cause emission reduction. Firstly, the waste recovery process is presented, and the architecture of the energy supply system is designed for the 100% absorption of renewable energy in rural areas. A carbon accounting model based on the locational marginal carbon emission factor is introduced, which considers the power exchange with the bulk power system and the carbon emission of biomass. Secondly, the optimal scheduling model for the recycling energy supply system is proposed to minimize both the total cost of energy supply and carbon emission, based on the constraints of energy balancing of electricity and heat, net carbon emissions, waste supply, etc. Finally, the IEEE 15-node system and PG&E 69-node system are employed for verification purposes. The proposed model contributes to 100% absorption of renewable energy and the efficient utilization of waste through the optimal cooperation of the waste supply, biomass power generation, and biomass heat, thereby supporting the achievement of zero carbon.


  • Optimization of Residential Electricity Consumption based on Multienergy Coordinated Control of Generation, Load, and Storage

    by Jun Tao, Minfu A., Zaixin Yang, Sheng Xiang

    Introduction: The power system is translating to the “generation, network, load, and storage multiple coordination control” model, which helps to increase the proportion of renewable energy consumption and reduce the operation cost. Materiala and Methods: The residential electrical system is an important component in the power system, which includes distributed photovoltaic systems, flexible loads, electric vehicles, and battery storage systems, which have the potential to realize multiple coordination control and minimize the net cost of the electricity consumption in a residential electrical system by the coordinated cooperation of generation, flexible loads, and the battery storage system. The comfort level of the residents is also maintained during control. Therefore, a nonlinear economic model is introduced to represent coordinated cooperation of generation, flexible loads, and the battery storage system, and a nonlinear economic predictive controller is proposed to solve the problems of this model. Results: Based on the forecasted generation/load for a tumbling prediction window, the impact of different control trajectories is estimated, then the minimum cost trajectory for flexible loads and battery is selected, and only the first control action is implemented. Then, the prediction window is moved to the next time interval, and the same process is repeated. The case study shows that the proposed method reduces about 24.36% of the net cost of the residential electrical system. Conclusion: Meanwhile, the hot-water temperature and indoor temperature of the household are maintained without affecting the end-user comfort, and the state-of-charge (SOC) for the electric vehicle and the battery system is always kept under constraints without affecting usage. The proposed method has a good performance for the coordinated cooperation of generation, flexible loads, and battery storage system in the residential electrical system. The proposed method also increases the consumption of PV, with the implementation in more residential buildings that will benefit in achieving carbon neutrality by 2060 in China.


  • A Double-Chain Blockchain With Economic Attributes and Network Constraints of Prosumer Transactions

    by Hongming Yang, Zefeng Yang, Sheng Xiang, Huan Zhao, Emmanuel Ackom

    With the rapid development of distributed energy, traditional power consumers have been transformed into prosumers who both produce and consume power, and can conduct flexible peer-to-peer transactions. Blockchain is a distributed ledger technology suitable for peer-to-peer transactions. However, the single-chain blockchain cannot simultaneously support the network security check and decentralized power transactions. Therefore, a double-chain blockchain and the corresponding transaction model are proposed with the reorganization of the transaction chain and power chain. Peer-to-peer independent decision-making transactions are achieved through the transaction chain to maximize prosumer earnings. The security check and adjusted transaction scheme are achieved through the power chain with constraints. Based on the Ethereum blockchain development platform, peer-to-peer transactions are verified in the IEEE 14-node distribution network. The results show that the designed double-chain blockchain has higher transaction efficiency than the single-chain blockchain. The secure and autonomous transaction of prosumers can be supported by the proposed method.


  • Demand-Side Management and Peak Load Reduction

    by Hongming Yang, Jingshu Yang, Sheng Xiang, Yan Xu, Yibo Wang


  • A Novel Domestic Electric Water Heater Control Method

    by Sheng Xiang, Liuchen Chang, Bo Cao, Yigang He, Chaolong Zhang

    As one of important thermostatically controlled loads (TCLs), domestic electric water heaters (DEWHs) show considerable potential for utilities to shave peak load working with direct load control (DLC). The electricity consumption of DEWHs is high in regard to daily domestic electricity consumption, which shows the potential for peak shifting services through the direct control of DEWHs. In practice, off-control is commonly used to control DEWHs, and finding suitable DEWHs to turn off is the main objective of DLC. However, it is difficult to decide which DEWH can be turned off when end-user comfort is taken into consideration, especially with the absence of temperature measurement information. In this paper, a novel control method is proposed to control DEWHs without temperature information. A time-varied weight matrix is generated based on patterns of DEWHs, and the temperatures of DEWHs can be estimated by the weight matrix and their states. The weight matrix and heating durations are used to generate a customer satisfaction prediction index, which can be used as a reference during DLC. The index can be used to select suitable DEWHs to turn off or to turn back on to maintain end-user comfort. The proposed method only needs the on-off states of DEWHs, which are available in practice. Simulation results prove that the proposed method can work well to reduce peak demand without affecting end-user comfort.